Investigation of cytotoxic and mutagenic effects of Malpighia glabra L. (barbados cherry) fruit pulp and vitamin C on plant and animal test systems

Fruits are important sources of nutrients in human diet, and Barbados Cherry (Malpighia glabra L.) is of particular interest due to its high content of antioxidants. Diets rich in fruits and vegetables protect individuals against diseases and cancer, but excessive intake of vitamins may act as pro-oxidant and generate changes in DNA. To evaluate the effect of different in natura (BAN) and frozen (BAF) Barbados Cherry pulp concentrations and synthetic vitamin C in liquid form (VC) on the chromosome level and the cell cycle division, root meristeme cells of Allium cepa L. and bone marrow cells of Wistar rats Rattus norvegicus, were used as test system. In Allium cepa L., BAN, at the highest concentration (0.4 mg.mL-1) and BAF, at the lowest concentration (0.2 mg.mL-1), inhibited cell division, and there was recovery of cell division after the recovery period in water only for BAN. In the Wistar rats, all treatments with Barbados Cherry, either acute or subchronic, were not cytotoxic or mutagenic; only the highest concentration of VC increased significantly the rate of chromosomal abnormalities. The data obtained are important to reinforce the use of Barbados Cherry fruit in the diet.

Detection of exopolysaccharide production and biofilm-related genes in Staphylococcus spp. isolated from a poultry processing plant

Staphylococcus spp. can survive in biofilms for long periods of time, and they can be transferred from one point to another and cause environmental contamination in food processing. The aim of this study was to detect Staphylococcus strains isolated from a poultry processing plant by the presence of adhesion genes and the phenotypic production of exopolysaccharide. In the present study, the production of exopolysaccharide and the presence of adhesion genes in 65 strains of Staphylococcus spp. were evaluated. All strains of Staphylococcus spp. produced exopolysaccharide, as confirmed by formation of black and opaque colonies in Congo Red Agar. The variation of sucrose content was critical for the production of exopolysaccharide in Congo Red Agar since at low sucrose concentrations all strains presented a characteristic result, i.e., there was no exopolysaccharide production. The atl gene was found in all strains, and the icaA and icaD genes were found in 97% of them. The data obtained suggest that Staphylococcus spp. isolated from the poultry processing plant evaluated has a potential for biofilm formation. An efficient control of this microorganism in food processing environment is necessary as they may represent a potential risk to consumers.

Seed moisture range in a soybean plant

It is common to see in any soybean plant that seeds reach maturity at different times. Thus the objective of the present study was to determine the magnitude of the seed moisture range at different stages of maturation in a soybean plant. The field study was conducted in a tropical region in the state of Mato Grosso - Brazil, established with foundation seeds of the MTBR-45 cultivar, and at flowering, 100 plants were marked at the same maturity stage. Harvesting began when seeds still were at high moisture content (MC). At each of eight harvesting times, during 16 days, all pods from two plants were harvested and the seeds from each pod were hand threshed individually and determined the moisture content . The results revealed that there is a great distribution of seed MC in a soybean plant, where at physiological maturity, the magnitude can reach more than 30 percentage points. Also, even with an average MC below 12%, there were more than 20 % of the seeds with MC above 13% and some seeds at this point had been waiting to be harvested for more than a week. The following conclusions and/or recommendations can be taken: 1- The great seed MC range in a soybean seed lot harvested at field maturity leads to the presence of seeds susceptible to mechanical damage and with MC unsafe for adequate storage; 2 - It is recommended that harvesting be accomplished when the seeds are in the 15-18% MC range, in order to minimize field deterioration and the percentage of seeds with high MC; 3- Drying is recommended, even when soybean seeds are in their average MC safe for storage.

Heliotropism and water availability effects on flowering dynamics and seed production in Macroptilium lathyroides

The experiment was carried out in pots in a glasshouse, with one plant per pot and nine repetitions per treatment. The treatments consisted of free or restricted leaves, submited to 90-100% or 60-70% soil field capacity (FC). Only independent effects of water availability or leaf movement were observed on yield components. Plants under well-watered conditions and with freely orienting leaves were taller, and had a larger number of ramifications. The greater development favored the setting of a higher number of inflorescences per plant in these treatments. This behavior resulted in a high number of flowers, green and mature legumes per plant, thus resulting in high seed production which was the most evident response to water availability. Although individual seed weight was higher in the water stress treatment, total seed production was higher for well-watered plants, with no statistically significant effect of leaf movements.

Changes in canola plant architecture and seed physiological quality in response to different sowing densities

The aim of this study was to evaluate changes in canola yield components and seed physiological quality in response to different sowing densities. The study was made in a greenhouse at the REIPESOL Company Technological Center, Madrid - Spain, with the commercial "Toccata" hybrid variety. The initial sowing density was 360,000 plants/ha and the plant population was later thinned down to include treatments of 250 and 180 thousand plants/ha. Harvested seeds were sent to the Seed Technology Center Laboratory (CATES) at the Madrid Polytechnic University (UPM) to evaluate changes in plant architecture and yield components, as well as the seed physiological quality of different plant parts. Results demonstrated that canola plants showed changes in morphology and yield components in response to different sowing densities. The population of 250,000 plants/ha showed the best seed yield demonstrating that maximum yield is directly related to a correct sowing density. The number of pods/plant was the most important component for increased seed yield/plant and seed yield/area. The spatial distribution of canola seeds in the plant and canola sowing density did not affect seed physiological quality.

Dynamic Modelling of Circulating Fluidized Bed Plant with Gas Turbine Repowering

Increasing amount of renewable energy source based electricity production has set high load control requirements for power grid balance markets. The essential grid balance between electricity consumption and generation is currently hard to achieve economically with new-generation solutions. Therefore conventional combustion power generation will be examined in this thesis as a solution to the foregoing issue. Circulating fluidized bed (CFB) technology is known to have sufficient scale to acts as a large grid balancing unit. Although the load change rate of the CFB unit is known to be moderately high, supplementary repowering solution will be evaluated in this thesis for load change maximization. The repowering heat duty is delivered to the CFB feed water preheating section by smaller gas turbine (GT) unit. Consequently, steam extraction preheating may be decreased and large amount of the gas turbine exhaust heat may be utilized in the CFB process to reach maximum plant electrical efficiency. Earlier study of the repowering has focused on the efficiency improvements and retrofitting to maximize plant electrical output. This study however presents the CFB load change improvement possibilities achieved with supplementary GT heat. The repowering study is prefaced with literature and theory review for both of the processes to maximize accuracy of the research. Both dynamic and steady-state simulations accomplished with APROS simulation tool will be used to evaluate repowering effects to the CFB unit operation. Eventually, a conceptual level analysis is completed to compare repowered plant performance to the state-of-the-art CFB performance. Based on the performed simulations, considerably good improvements to the CFB process parameters are achieved with repowering. Consequently, the results show possibilities to higher ramp rate values achieved with repowered CFB technology. This enables better plant suitability to the grid balance markets.

Effect of Material Recycling on the Feasibility of Solid Recovered Fuel Fired Power Plant

This master’s thesis examines the effects of increased material recycling on different waste-to-energy concepts. With background study and a developed techno-economic computational method the feasibility of chosen scenarios with different combinations of mechanical treatment and waste firing technologies can be evaluated. The background study covers the waste scene of Finland, and potential market areas Poland and France. Calculated cases concentrate on municipal solid waste treatment in the Finnish operational environment. The chosen methodology to approach the objectives is techno-economic feasibility assessment. It combines calculation methods of literature and practical engineering to define the material and energy balances in chosen scenarios. The calculation results together with other operational and financial data can be concluded to net present values compared between the scenarios. For the comparison, four scenarios, most vital and alternative between each other, are established. The baseline scenario is grate firing of source separated mixed municipal solid waste. Second scenario is fluidized bed combustion of solid recovered fuel produced in mechanical treatment process with metal separation. Third scenario combines a biomaterial separation process to the solid recovered fuels preparation and in the last scenario plastics are separated in addition to the previous operations. The results indicated that the mechanical treatment scenarios still need to overcome some problems to become feasible. Problems are related to profitability, residue disposal and technical reliability. Many uncertainties are also related to the data gathered over waste characteristics, technical performance and markets. With legislative support and development of further processing technologies and markets of the recycled materials the scenarios with biomaterial and plastic separation may operate feasibly in the future.

Understanding the bioactivity of plant tannins: developments in analysis methods and structure-activity studies

Tannins, typically segregated into two major groups, the hydrolyzable tannins (HTs) and the proanthocyanidins (PAs), are plant polyphenolic secondary metabolites found throughout the plant kingdom. On one hand, tannins may cause harmful nutritional effects on herbivores, for example insects, and hence they work as plants’ defense against plant-eating animals. On the other hand, they may affect positively some herbivores, such as mammals, for example by their antioxidant, antimicrobial, anti-inflammatory or anticarcinogenic activities. This thesis focuses on understanding the bioactivity of plant tannins, their anthelmintic properties and the tools used for the qualitative and quantitative analysis of this endless source of structural diversity. The first part of the experimental work focused on the development of ultra-high performance liquid chromatography−tandem mass spectrometry (UHPLC-MS/MS) based methods for the rapid fingerprint analysis of bioactive polyphenols, especially tannins. In the second part of the experimental work the in vitro activity of isolated and purified HTs and their hydrolysis product, gallic acid, was tested against egg hatching and larval motility of two larval developmental stages, L1 and L2, of a common ruminant gastrointestinal parasite, Haemonchus contortus. The results indicated clear relationships between the HT structure and the anthelmintic activity. The activity of the studied compounds depended on many structural features, including size, functional groups present in the structure, and the structural rigidness. To further understand tannin bioactivity on a molecular level, the interaction between bovine serum albumin (BSA), and seven HTs and epigallocatechin gallate was examined. The objective was to define the effect of pH on the formation on tannin–protein complexes and to evaluate the stability of the formed complexes by gel electrophoresis and MALDI-TOF-MS. The results indicated that more basic pH values had a stabilizing effect on the tannin–protein complexes and that the tannin oxidative activity was directly linked with their tendency to form covalently stabilized complexes with BSA at increased pH.