Comparison of echogram measurements against data expectations and assumptions for distinguishing seafloor substrates

Defining types of seafloor substrate and relating them to the distribution of fish and invertebrates is an important but difficult goal. An examination of the processing steps of a commercial acoustics analyzing software program, as well as the data values produced by the proprietary first echo measurements, revealed potential benef its and drawbacks for distinguishing acoustically distinct seafloor substrates. The positive aspects were convenient processing steps such as gain adjustment, accurate bottom picking, ease of bad data exclusion, and the ability to average across successive pings in order to increase the signal-to-noise ratio. A noteworthy drawback with the processing was the potential for accidental inclusion of a second echo as if it were part of the first echo. Detailed examination of the echogram measurements quantified the amount of collinearity, revealed the lack of standardization (subtraction of mean, division by standard deviation) before principal components analysis (PCA), and showed correlations of individual echogram measurements with depth and seafloor slope. Despite the facility of the software, these previously unknown processing pitfalls and echogram measurement characteristics may have created data artifacts that generated user-derived substrate classifications, rather than actual seafloor substrate types.

Aspects of quality control of wind profiler measurements in complex topography

It is well known in the scientific community that some remote sensing instruments assume that sample volumes present homogeneous conditions within a defined meteorological profile. At complex topographic sites and under extreme meteorological conditions, this assumption may be fallible depending on the site, and it is more likely to fail in the lower layers of the atmosphere. This piece of work tests the homogeneity of the wind field over a boundary layer wind profiler radar located in complex terrain on the coast under different meteorological conditions. The results reveal the qualitative importance of being aware of deviations in this homogeneity assumption and evaluate its effect on the final product. Patterns of behavior in data have been identified in order to simplify the analysis of the complex signal registered. The quality information obtained from the homogeneity study under different meteorological conditions provides useful indicators for the best alternatives the system can offer to build wind profiles. Finally, the results are also to be considered in order to integrate them in a quality algorithm implemented at the product level.

Measurements of total scattering spectra from bocaccio (Sebastes paucispinis)

Marine sportfishing in southern California is a huge industry with annual revenues totaling many billions of dollars. However, the stocks of lingcod and six rockfish species have been declared overfished by the Pacific Fisheries Management Council. As part of a multifaceted fisheries management plan, marine conservation areas, covering many million square nautical miles, have been mandated. To monitor the recovery of the rockfish stocks in these areas, scientists are faced with the following challenges: 1) multiple species of rockfish exist in these areas; 2) the species reside near or on the bottom at depths of 80 to 300 m; and 3) they are low in numerical density. To meet these challenges, multifrequency echosounders, multibeam sonar, and cameras mounted on remotely operated vehicles are frequently used (Reynolds et al., 2001). The accuracy and precision of these echosounder results are largely dependent upon the accuracy of the species classification and target strength estimation (MacLennan and Simmonds, 1992).

hp-Adaptive simulation and inversion of magnetotelluric measurements

xlix, 121 p.

Precision and accuracy of fish length measurements obtained with two visual underwater methods

During the VITAL cruise in the Bay of Biscay in summer 2002, two devices for measuring the length of swimming fish were tested: 1) a mechanical crown that emitted a pair of parallel laser beams and that was mounted on the main camera and 2) an underwater auto-focus video camera. The precision and accuracy of these devices were compared and the various sources of measurement errors were estimated by repeatedly measuring fixed and mobile objects and live fish. It was found that fish mobility is the main source of error for these devices because they require that the objects to be measured are perpendicular to the field of vision. The best performance was obtained with the laser method where a video-replay of laser spots (projected on fish bodies) carrying real-time size information was used. The auto-focus system performed poorly because of a delay in obtaining focus and because of some technical problems.