Nonlinear Device Noise Models:Thermodynamic Requirements

This paper proposes three tests to determine whether a given nonlinear device noise model is in agreement with accepted thermodynamic principles. These tests are applied to several models. One conclusion is that every Gaussian noise model for any nonlinear device predicts thermodynamically impossible circuit behavior: these models should be abandoned. But the nonlinear shot-noise model predicts thermodynamically acceptable behavior under a constraint derived here. Further, this constraint specifies the current noise amplitude at each operating point from knowledge of the device v - i curve alone. For the Gaussian and shot-noise models, this paper shows how the thermodynamic requirements can be reduced to concise mathematical tests involving no approximatio

A unified approach for representing rows and columns in contingency tables

By using suitable parameters, we present a uni¯ed aproach for describing four methods for representing categorical data in a contingency table. These methods include: correspondence analysis (CA), the alternative approach using Hellinger distance (HD), the log-ratio (LR) alternative, which is appropriate for compositional data, and the so-called non-symmetrical correspondence analysis (NSCA). We then make an appropriate comparison among these four methods and some illustrative examples are given. Some approaches based on cumulative frequencies are also linked and studied using matrices. Key words: Correspondence analysis, Hellinger distance, Non-symmetrical correspondence analysis, log-ratio analysis, Taguchi inertia

VLSI architecture for an Underwater Robot Vision System

It is well known that image processing requires a huge amount of computation, mainly at low level processing where the algorithms are dealing with a great number of data-pixel. One of the solutions to estimate motions involves detection of the correspondences between two images. For normalised correlation criteria, previous experiments shown that the result is not altered in presence of nonuniform illumination. Usually, hardware for motion estimation has been limited to simple correlation criteria. The main goal of this paper is to propose a VLSI architecture for motion estimation using a matching criteria more complex than Sum of Absolute Differences (SAD) criteria. Today hardware devices provide many facilities for the integration of more and more complex designs as well as the possibility to easily communicate with general purpose processors

Proposal of a parallel architecture for a motion detection algorithm

This paper proposes a parallel architecture for estimation of the motion of an underwater robot. It is well known that image processing requires a huge amount of computation, mainly at low-level processing where the algorithms are dealing with a great number of data. In a motion estimation algorithm, correspondences between two images have to be solved at the low level. In the underwater imaging, normalised correlation can be a solution in the presence of non-uniform illumination. Due to its regular processing scheme, parallel implementation of the correspondence problem can be an adequate approach to reduce the computation time. Taking into consideration the complexity of the normalised correlation criteria, a new approach using parallel organisation of every processor from the architecture is proposed

On AUV control architecture

This paper surveys control architectures proposed in the literature and describes a control architecture that is being developed for a semi-autonomous underwater vehicle for intervention missions (SAUVIM) at the University of Hawaii. Conceived as hybrid, this architecture has been organized in three layers: planning, control and execution. The mission is planned with a sequence of subgoals. Each subgoal has a related task supervisor responsible for arranging a set of pre-programmed task modules in order to achieve the subgoal. Task modules are the key concept of the architecture. They are the main building blocks and can be dynamically re-arranged by the task supervisor. In our architecture, deliberation takes place at the planning layer while reaction is dealt through the parallel execution of the task modules. Hence, the system presents both a hierarchical and an heterarchical decomposition, being able to show a predictable response while keeping rapid reactivity to the dynamic environment

G+: Enhanced Traffic Grooming in WDM Mesh Networks using Lighttours

In this article, a new technique for grooming low-speed traffic demands into high-speed optical routes is proposed. This enhancement allows a transparent wavelength-routing switch (WRS) to aggregate traffic en route over existing optical routes without incurring expensive optical-electrical-optical (OEO) conversions. This implies that: a) an optical route may be considered as having more than one ingress node (all inline) and, b) traffic demands can partially use optical routes to reach their destination. The proposed optical routes are named "lighttours" since the traffic originating from different sources can be forwarded together in a single optical route, i.e., as taking a "tour" over different sources towards the same destination. The possibility of creating lighttours is the consequence of a novel WRS architecture proposed in this article, named "enhanced grooming" (G+). The ability to groom more traffic in the middle of a lighttour is achieved with the support of a simple optical device named lambda-monitor (previously introduced in the RingO project). In this article, we present the new WRS architecture and its advantages. To compare the advantages of lighttours with respect to classical lightpaths, an integer linear programming (ILP) model is proposed for the well-known multilayer problem: traffic grooming, routing and wavelength assignment The ILP model may be used for several objectives. However, this article focuses on two objectives: maximizing the network throughput, and minimizing the number of optical-electro-optical conversions used. Experiments show that G+ can route all the traffic using only half of the total OEO conversions needed by classical grooming. An heuristic is also proposed, aiming at achieving near optimal results in polynomial time

What is the Web? The Web Architecture

The Introductory Lecture is a discussion about "What is the Web". It involves lots of calling out TLAs and writing them on the blackboard, dividing things into servers, clients, protocols, formats, and the punchline is that the one unique and novel thing about the web is the hypertext link. This follows naturally into the Web architecture - the answer to the question "what is the web".

COMP6218 Web Architecture - Web Content Formats

Plain Text - ASCII, Unicode, UTF-8 Content Formats - XML-based formats (RSS, MathML, SVG, Office) + PDF Text based data formats: CSV, JSON

Enterprise Architecture notes/white papers

A collection of notes and white papers regarding Enterprise Architecture

WAIS seminar: Application Performance Monitoring and Architecture Discovery with Kieker

Wednesday 23rd April 2014 Speaker(s): Willi Hasselbring Organiser: Leslie Carr Time: 23/04/2014 14:00-15:00 Location: B32/3077 File size: 802Mb Abstract The internal behavior of large-scale software systems cannot be determined on the basis of static (e.g., source code) analysis alone. Kieker provides complementary dynamic analysis capabilities, i.e., monitoring/profiling and analyzing a software system's runtime behavior. Application Performance Monitoring is concerned with continuously observing a software system's performance-specific runtime behavior, including analyses like assessing service level compliance or detecting and diagnosing performance problems. Architecture Discovery is concerned with extracting architectural information from an existing software system, including both structural and behavioral aspects like identifying architectural entities (e.g., components and classes) and their interactions (e.g., local or remote procedure calls). In addition to the Architecture Discovery of Java systems, Kieker supports Architecture Discovery for other platforms, including legacy systems, for instance, inplemented in C#, C++, Visual Basic 6, COBOL or Perl. Thanks to Kieker's extensible architecture it is easy to implement and use custom extensions and plugins. Kieker was designed for continuous monitoring in production systems inducing only a very low overhead, which has been evaluated in extensive benchmark experiments. Please, refer to http://kieker-monitoring.net/ for more information.