(Table 1) Stable carbon and oxygen isotopes of planktonic and benthic foraminifera in ODP Hole 1006A

During ODP Leg 166, the recovery of cores from a transect of drill sites across the Bahamas margin from marginal to deep basin environments was an essential requirement for the study of the response of the sedimentary systems to sea-level changes. A detailed biostratigraphy based on planktonic foraminifera was performed on ODP Hole 1006A for an accurate stratigraphic control. The investigated late middle Miocene-early Pliocene sequence spans the interval from about 12.5 Ma (Biozone N12) to approximately 4.5 Ma (Biozone N19). Several bioevents calibrated with the time scale of Berggren et al. (1995a,b) were identified. The ODP Site 1006 benthic oxygen isotope stratigraphy can be correlated to the corresponding deep-water benthic oxygen isotope curve from ODP Site 846 in the Eastern Equatorial Pacific (Shackleton et al., 1995. Proc. ODP Sci. Res. 138, 337-356), which was orbitally tuned for the entire Pliocene into the latest Miocene at 6.0 Ma. The approximate stratigraphic match of the isotopic signals from both records between 4.5 and 6.0 Ma implies that the paleoceanographic signal from the Bahamas is not simply a record of regional variations but, indeed, represents glacio-eustatic fluctuations. The ODP Site 1006 oxygen and carbon isotope record, based on benthic and planktonic foraminifera, was used to define paleoceanographic changes on the margin, which could be tied to lithostratigraphic events on the Bahamas carbonate platform using seismic sequence stratigraphy. The oxygen isotope values show a general cooling trend from the middle to late Miocene, which was interrupted by a significant trend towards warmer sea-surface temperatures (SST) and associated sea-level rise with decreased ice volume during the latest Miocene. This trend reached a maximum coincident with the Miocene/Pliocene boundary. An abrupt cooling in the early Pliocene then followed the warming which continued into the earliest Pliocene. The late Miocene paleoceanographic evolution along the Bahamas margin can be observed in the ODP Site 1006 delta13C values, which support other evidence for the beginning of the closure of the Panama gateway at 8 Ma followed by a reduced intermediate water supply of water from the Pacific into the Caribbean at about 5 Ma. A general correlation of lower sedimentation rates with the major seismic sequence boundaries (SSBs) was observed. Additionally, the SSBs are associated with transitions towards more positive oxygen isotope excursions. This observed correspondence implies that the presence of a SSB, representing a density impedance contrast in the sedimentary sequence, may reflect changes in the character of the deposited sediment during highstands versus those during lowstands. However, not all of the recorded oxygen isotope excursions correspond to SSBs. The absence of a SSB in association with an oxygen isotope excursion indicates that not all oxygen isotope sea-level events impact the carbonate margin to the same extent, or maybe even represent equivalent sea-level fluctuations. Thus, it can be tentatively concluded that SSBs produced on carbonate margins do record sea-level fluctuations but not every sea-level fluctuation is represented by a SSB in the sequence stratigraphic record.

Measurements of fracture toughness applying a four-point-bending technique of ice core B34 from Kohnen Station, Dronning Maud Land, Antarctica

The critical fracture toughness is a material parameter describing the resistance of a cracked body to further crack extension. It is an important parameter to simulate and predict the break-up behaviour of ice shelves from calving of single icebergs to the disintegration of entire ice shelves over a wide range of length scales. The fracture toughness values are calculated with equations that are derived from an elastic stress analysis. Additionally, an X-ray computer tomography (CT scanner) was used to identify the density as a function of depth. The critical fracture toughness of 91 Antarctic inland ice samples with densities between 840 to 870 kg/m**3 has been determined by applying a four-point-bending technique on single edge v-notched beam samples. The examined ice core was drilled 70m north of Kohnen Station, Dronnning Maud Land (75°00' S, 00°04' E, 2882 m).