菜籽粕对异育银鲫免疫应答能力的影响

试验鱼以投喂饲料的不同和是否注射抗原共分为10组,即免疫组:A、B、C、D、E组,免疫对照组:a、b、c、de、组,饲料对照组:A、a组。饲料试验组B、C、D、E、bc、、d、e组。其中,饲料对照组以豆粕和鱼粉为基础蛋白源,饲料试验组分别以双低菜籽粕和普通菜籽粕等氮替代对照组中50%(B、b;D、d)和100%(C、c;E、e)的豆粕蛋白,测定异育银鲫血液白细胞和头肾吞噬细胞的吞噬活性、血清溶菌酶活性、血清补体(C3,C4)含量、血清凝集抗体效价及免疫保护率。结果表明:从免疫后21 d开始,饲料试验组E、

滇池典型区域磷与铁的形态分布规律

通过调查滇池三个湖湾不同深度水层磷与铁的形态分布,研究三个湖湾内源磷的释放规律.结果表明,在海埂湾间隙水中,磷的释放强度远高于另外两个湖湾,根据水体中各种形态磷和铁的关系,推测出在这三个湖湾中,铁结合态磷是湖水悬浮物和沉积物中一种重要的可释放磷.

洗涤剂禁(限)磷对流域水质影响预测

本文在确定流域洗涤剂的磷在水体磷负荷中所占的比重及贡献率的基础上 ,采用Thomoamn数学模型 ,对在实施洗涤剂禁限磷措施后 ,流域水质的响应进行预测 ,并评估洗涤剂禁限磷的环境效果 .水质预测结果表明 ,实行限、禁磷措施后 ,供水水质磷含量将从目前的 0 .2 4mg/L降至 0 .18mg/L ,磷负荷削减了 2 5 % ;如严格控制流域禽畜散养 ,削减非点源磷盐 6 0 % ,供水水质处于地面水Ⅱ类水质 (0 .1mg/L)标准临界水平

中华鳖病毒的血清学检测

中华鳖病毒（ＴＳＶ）是从病鳖中分离到的一种病毒病原。经细胞培养和差异离心制备ＴＳＶ抗原，肌注家兔获 ＴＳＶ抗体（ＴＳＶ－Ａｂ），中和效价为 １：２０。用 ＴＳＶ－Ａｂ进行双向免疫扩散和间接ＥＬＩＳＡ检测，被检样品有健康和病鳖组织匀浆液、ＴＳＶ细胞培养液、提纯的ＴＳＶ，以及鱼传染性胰脏坏死病毒（ＩＰＮＶ）、草鱼呼肠孤病毒（ＧＣＶ）、鱼病毒性出血败血症病毒（ＶＨＳＶ）、鲤痘疮病毒（Ｃａｒｐ ｐｏｘ ｖｉｒｕｓ）和斑节对虾杆状病毒（ＭＢＶ）。检测结果显示：ＩＰＮＶ、ＧＣＶ、ＶＨＳＶ、Ｃａｒｐ ｐｏｘ ｖｉｒｕｓ

我国早期的一篇淡水藻类分类学论文及其作者

在国立武昌高等师范学校编辑出版的《博物学会杂志》第一卷到第四卷 (共 4期 )上刊载的毕祖高撰写的“武昌长湖之藻类”一文是迄今所知由中国科学家研究中国标本所正式发表的淡水藻类分类学的第一篇论文 .此篇论文的发表 ,标志着中国淡水藻类的采集、调查研究和发表完全由中国人己独立承担任务并取得成绩的开始 .毕祖高是国立武昌高师博物部 1917年的毕业生 ,发表此文时 ,他是国立武昌高师附属中学的博物学教员 .

中国真缓步纲三新种及六新纪录种记述(近爪目:大生熊虫科,高生熊虫科)

记述了大生熊虫科大生熊虫属Macrobiotus一新种和三新纪录种,即神农大生熊虫,新种M.shennongensissp.nov.、桃形大生熊虫M.persimilisBinda&Pilato,1972,卷形大生熊虫M.rolleiHeinis,1921,陆栖大生熊虫M.terricolaMihelcic,1949以及趾生熊虫属一新种,即水生趾生熊虫,新种Dactylobiotusaquatilissp.nov.;高生熊虫科等高熊虫属Isohypsibius一新种和二新纪录种,即长白等高熊虫,Is.ch

草鱼出血病病毒的研究进展

根据80－90年代中国关于草鱼出血病病毒研究的进展，就草鱼出血病病毒的发现、形态结构特征、理化特性、基因组结构及其所编码的多肽、基因组的转录和翻译过程，病毒的繁殖动态、体外细胞培养特性，病毒对鱼体的致病机理和宿主范围，草鱼出血病的诊断和防治等问题进行综合评述，总结概括了草鱼出血病病毒的研究现状以及研究中需要亟待解决的问题，并提出该领域以后的重点研究方向。

Slow peaking and low-gain designs for global stabilization of nonlinear systems

This paper presents an analysis of the slow-peaking phenomenon, a pitfall of low-gain designs that imposes basic limitations to large regions of attraction in nonlinear control systems. The phenomenon is best understood on a chain of integrators perturbed by a vector field up(x, u) that satisfies p(x, 0) = 0. Because small controls (or low-gain designs) are sufficient to stabilize the unperturbed chain of integrators, it may seem that smaller controls, which attenuate the perturbation up(x, u) in a large compact set, can be employed to achieve larger regions of attraction. This intuition is false, however, and peaking may cause a loss of global controllability unless severe growth restrictions are imposed on p(x, u). These growth restrictions are expressed as a higher order condition with respect to a particular weighted dilation related to the peaking exponents of the nominal system. When this higher order condition is satisfied, an explicit control law is derived that achieves global asymptotic stability of x = 0. This stabilization result is extended to more general cascade nonlinear systems in which the perturbation p(x, v) v, v = (ξ, u) T, contains the state ξ and the control u of a stabilizable subsystem ξ = a(ξ, u). As an illustration, a control law is derived that achieves global stabilization of the frictionless ball-and-beam model.

富营养浅水湖泊的退化与生态恢复

初步讨论了富营养浅水湖泊的退化现象和造成退化的主要原因，对湖泊生态恢复的目标和对策等问题也作了探讨。以武汉东湖为例，提出以水源保护地为主要功能的富营养浅水湖泊的恢复和整体优化对策，即恢复沉水植被、建立控制面源污染的半自然的人工湿地生态系统、优化水产养殖结构和恢复湖泊生物多样性等。对生物操纵在长江中下游富营养浅水湖泊恢复中的作用也进行了讨论

Growth, structural and optical properties of GaAs/AlGaAs Core/shell nanowires with and without quantum well shells

We have investigated the growth, structural properties and photoluminescence of novel GaAs/AlGaAs radial heterostructure nanowires, fabricated by metalorganic chemical vapour deposition. The effect of growth temperature on nanowire morphology is discussed. Strong photoluminescence is observed from GaAs nanowires with AlGaAs shells. Core/multishell nanowires, of GaAs cores clad in several alternating layers of thick AlGaAs barrier shells and thin GaAs quantum well shells, exhibit a blue-shifted photoluminescence peak believed to arise from quantum confinement effects. A novel two-temperature growth procedure for obtaining GaAs cores is introduced, and other nanowire heterostructures are addressed. © 2006 IEEE.

鱼腥藻7120质膜、类囊体膜和细胞壁的分离及特性分析

于1987－1989年对鱼腥藻7120质膜、类囊体膜和细胞壁进行分离纯化和基本的色素与蛋白质特性分析。采用机械性方法破碎细胞，以非连续蔗糖密度梯度离心分离纯化鱼腥藻7120营养细胞的质膜和类囊体膜，以TritonX－100处理方法获得细胞壁。色谱分析和电泳结果表明，其质膜、类囊体膜的色素和蛋白质特性与单细胞蓝藻相类似；Triton不溶细胞壁未发现可见光谱吸收，其两条主要蛋白带52KD和14KD均为精蛋白，并且14KD蛋白为肽聚糖层连结蛋白，细胞壁蛋白质全部对胰蛋白酶处理敏感，其上未发现“热修饰”蛋白。

Application of scalar dissipation rate model to siemens DLE combustors

The standard design process for the Siemens Industrial Turbomachinery, Lincoln, Dry Low Emissions combustion systems has adopted the Eddy Dissipation Model with Finite Rate Chemistry for reacting computational fluid dynamics simulations. The major drawbacks of this model have been the over-prediction of temperature and lack of species data limiting the applicability of the model. A novel combustion model referred to as the Scalar Dissipation Rate Model has been developed recently based on a flamelet type assumption. Previous attempts to adopt the flamelet philosophy with alternative closure models have failed, with the prediction of unphysical phenomenon. The Scalar Dissipation Rate Model (SDRM) was developed from a physical understanding of scalar dissipation rate, signifying the rate of mixing of hot and cold fluids at scales relevant to sustain combustion, in flames and was validated using direct numerical simulations data and experimental measurements. This paper reports on the first industrial application of the SDRM to SITL DLE combustion system. Previous applications have considered ideally premixed laboratory scale flames. The industrial application differs significantly in the complexity of the geometry, unmixedness and operating pressures. The model was implemented into ANSYS-CFX using their inbuilt command language. Simulations were run transiently using Scale Adaptive Simulation turbulence model, which switches between Large Eddy Simulation and Unsteady Reynolds Averaged Navier Stokes using a blending function. The model was validated in a research SITL DLE combustion system prior to being applied to the actual industrial geometry at real operating conditions. This system consists of the SGT-100 burner with a glass square-sectioned combustor allowing for detailed diagnostics. This paper shows the successful validation of the SDRM against time averaged temperature and velocity within measurement errors. The successful validation allowed application of the SDRM to the SGT-100 twin shaft at the relevant full load conditions. Limited validation data was available due to the complexity of measurement in the real geometry. Comparison of surface temperatures and combustor exit temperature profiles showed an improvement compared to EDM/FRC model. Furthermore, no unphysical phenomena were predicted. This paper presents the successful application of the SDRM to the industrial combustion system. The model shows a marked improvement in the prediction of temperature over the EDM/FRC model previously used. This is of significant importance in the future applications of combustion CFD for understanding of hardware mechanical integrity, combustion emissions and dynamics of the flame. Copyright © 2012 by ASME.

Initial investigation into the use of GGBS-MgO in soil stabilisation

Portland cement (PC) is the most widely used binder for ground improvement. However, there are significant environmental impacts associated with its production in terms of high energy consumption and CO2 emissions. Hence, the use of industrial by-products materials or new low-carbon footprint alternative cements has been encouraged. Ground granulated blastfurnace slag (GGBS), a by-product of the steel industry, has been successfully used for such an application, usually activated with an alkali such as lime or PC. In this study the use of MgO as a novel activator for GGBS in ground improvement of soft soils is addressed and its performance was compared to the above two conventional activators as well as PC alone. The GGBS:activator ratio used in this study was 9:1. A range of tests was performed at three curing periods (7, 28 and 90 days), including unconfined compressive strength (UCS), permeability and microstructure analysis. The results show that the MgO performed as the most efficient activator yielding the highest strength and the lowest permeability indicating a very high stabilisation efficiency of the system. © 2012 American Society of Civil Engineers.