983 resultados para 10,09
Resumo:
The dataset is based on samples taken during October 2008 in the North-Eastern Aegean Sea. NH4 excretion rate: Mesozooplankton is collected by vertical tows within the Black sea water body mass layer in the NE Aegean, using a WP-2 200 µm net equipped with a large non-filtering cod-end (10 l). Macrozooplankton organisms are removed using a 2000 µm net. A few unsorted animals (approximately 100) are placed inside 8 bottles of 350 or 650 ml filled with GF/F or 0.2 µm Nucleopore filtered seawater and then on a wheell at dim light and maintaining the in situ temperature. 4 bottles without animals are used as control. After 24hours bottles are opened and water samples taken for NH4 chemical analysis. Then the bottle content is filtered on pre-combusted preweighted CF/F filters, which are then dried at 60 C and weighted. Calculations are made as described by Ikeda et al. (2000). Samples for the NH4 determination were collected in pre-cleaned 50 ml Duran bottles and analysed onboard immediately after collection. Ammonium concentration was measured on a Perkin Elmer Lambda 25 UV/VIS Spectrometer according to the method of Koroleff (1970). PO4 excretion rate: Mesozooplankton is collected by vertical tows within the Black sea water body mass layer in the NE Aegean, using a WP-2 200 µm net equipped with a large non-filtering cod-end (10 l). Macrozooplankton organisms are removed using a 2000 µm net. A few unsorted animals (approximately 100) are placed inside 8 bottles of 350 or 650 ml filled with GF/F or 0.2 µm Nucleopore filtered seawater and then on a wheell at dim light and maintaining the in situ temperature. 4 bottles without animals are used as control. After 24hours bottles are opened and water samples taken for PO4 chemical analysis. Then the bottle content is filtered on pre-combusted preweighted CF/F filters, which are then dried at 60 C and weighted. Calculations are made as described by Ikeda et al. (2000). Samples for the determination of PO4 were collected in pre-cleaned 50 ml polyethylene volumetric tubes and analysed on board immediately after collection. PO4 concentration was measured on a Perkin Elmer Lambda 25 UV/VIS Spectrometer following the protocol of Murphy and Riley (1962). O2 consumption rate: Mesozooplankton is collected by vertical tows within the Black sea water body mass layer in the NE Aegean, using a WP-2 200 µm net equipped with a large non-filtering cod-end (10 l). Macrozooplankton organisms are removed using a 2000 µm net. A few unsorted animals (approximately 100) are placed inside 8 bottles of 350 or 650 ml filled with GF/F or 0.2 µm Nucleopore filtered seawater and then on a wheell at dim light and maintaining the in situ temperature. 4 bottles without animals are used as control. After 24hours bottles are opened and water samples taken for O2 chemical analysis. Then the bottle content is filtered on pre-combusted preweighted CF/F filters, which are then dried at 60 C and weighted. Calculations are made as described by Ikeda et al. (2000). For the dissolved O2 determination, the samples were fixed immediately after collection and analysed with the Winkler method as modified by Carpenter (1965a and 1965b). Carbon specific CO2 respiration rate: O2 consumption rate was converted to CO2 production using a RQ value of 0.87 (Mayzaud et al. 2005). Conversion of mesozooplankton dry weight to carbon was done using the % of carbon content measured in the same station from the SESAME dataset of zooplankton biomass. Carbon specific NH4 excretion rate: Conversion of mesozooplankton dry weight to carbon was done using the % of carbon content measured in the same station from the SESAME dataset of zooplankton biomass. Carbon specific PO4 excretion rate: Conversion of mesozooplankton dry weight to carbon was done using the % of carbon content measured in the same station from the SESAME dataset of zooplankton biomass.
Resumo:
This paper is dedicated to the geochemical studies of two bottom sediment cores that were taken during cruise 28 of the R/V Professor Logachev in the Mid-Atlantic Ridge (MAR) 16°38'N area in 2006. The chemical compositions of background metalliferous and ore (ore-bearing) carbonate sediments are presented and inter-element correlations are examined. Individual episodes are distinguished in the accumulation history of the ore-bearing and metalliferous sediments on the basis of element factor analysis.
Resumo:
Fil: Castaño Marín, Juan Camilo. Universidad Nacional de La Plata. Facultad de Humanidades y Ciencias de la Educación; Argentina.
Resumo:
Reconstructing ocean temperature values is a major target in paleoceanography and climate research. However, most temperature proxies are organism-based and thus suffer from an "ecological bias". Multiproxy approaches can potentially overcome this bias but typically require more investment in time and resources, while being susceptible to errors induced by sample preparation steps necessary before analysis. Three lipid-based temperature proxies are widely used: UK'37 (based on long chain alkenones from phytoplanktonic haptophytes), TEX86 [based on glycerol dialkyl glycerol tetraethers (GDGTs) from pelagic archaea] and LDI (based on long chain diols from phytoplanktonic eustigmatophytes). So far, separate analytical methods, including gas chromatography (GC) and liquid chromatography (LC), have been used to determine these proxies. Here we present a sensitive method for determining all three in a single normal phase high performance LC-atmospheric pressure chemical ionization mass spectrometry (NP-HPLC-APCI-MS) analysis. Each of the long chain alkenones and long chain diols was separated and unambiguously identified from the accurate masses and characteristic fragmentation during multiple stage MS analysis (MS2). Comparison of conventional GC and HPLC-MS methods showed similar results for UK'37 and LDI, respectively, using diverse environmental samples and an Emiliania huxleyi culture. Including the three sea surface temperature (SST) proxies; the NP-HPLC-APCI-MS method in fact allows simultaneous determination of nine paleoenvironmental proxies. The extent to which the ecology of the source organisms (ecological bias) influences lipid composition and thereby the reconstructed temperature values was demonstrated by applying the new method to a sediment core from the Sea of Marmara, covering the last 21 kyr BP. Reconstructed SST values differed considerably between the proxies for the Last Glacial Maximum (LGM) and the period of Sapropel S1 formation at ca. 10 kyr BP, whereas the trends during the late Holocene were similar. Changes in the composition of alkenone-producing species at the transition from the LGM to the Bølling/Allerød (B/A) were inferred from unreasonably high UK'37-derived SST values (ca. 20 °C) during the LGM. We ascribe discrepancies between the reconstructed temperature records during S1 deposition to habitat change, e.g. a different depth due to changes in nutrient availability.