Pollen record from Golkow, Poland

Janczyk-Kopikowa (1966): The series of the organic deposits, developed in the vicinity of Golkow near Warsaw as oil shales and peats, was laid down in a grough valley and now rests on the deposits of the Middle Polish Glaciation (Riss). The organic deposits are overlain by the fluviale deposits of the North Polish Glaciation (Würm). The locality Golkow occurs beyond the extent of the continental glacier of this glaciation. Polen analysis completed by microfloristic examinations allows to determine the age of the organic series that is thought to be Eemian. The pollen diagram from Golkow does not call in question the stratigraphical position of the deposits investigated mainly due to its characteristic features such as minimum content of coniferous trees in the climatic optimum - about 5%, high percentage of Corylus - 77.5% and well developed phase of hornbeam. It may be well compared with other Eemian diagrams from the area of Poland and reveals much similar features. The development of vegetation at Golkow has depended upon the prevailing climate. At first, the cool climate brings about the development of plants having small thermal requirements. Here belong thin, park-like forests with pine and birch (Pinus, Betula) accompanied by the heliophilic plants such as Hippohäe and Ephedra. Improvement of climate that becomes warm and humid provides for development of deciduous forests prevailing in the climatic optimum, of the interglacial. Decrease of temperature causes a repeated change in the type of forest. This latter changes into coniferous forest with prevailing spruce (Picea) and fir (Abies) at the beginning, and then with pine (Pinus) and birch (Betula). During the Eemian Interglacial, the development of plants at Golkow terminates with a new and long-lasting predominance of pine-birch forests. However, such a longevity may be apparent only. Apparent character of this phenomenon is proved by a fact that the pollen spectra of the warm climatic periods have found their reflex in the oil shale that increased considerably slower than the layers off feebly decomposed peat evidencing the existence of cool pine-birch forests from the decline of the Interglacial. The water basin, in which the polen grains were laid down from surrounding plants is characterized by a calm sedimentation as proved by the occurrence of the oil shale. An insignificant water flow left behind some thin sand laminae. The not too deep basin becomes shallower owing to the growing water vegetation, and marshy vegetation. The growing of the plants causes a complete shallowing of the basin and formation of peat bog in situ, as proved by the peat beds occurring in the section. ---- Gadomska (1966): In the vicinity of Golków a series of organic deposits occurs amounting to 6.5-9.3 m in thickness, and consisting of oil shales, lacustrine silts and sands, as well as peats and peaty silts. The organic deposits fill up an old, small, but fairly deep lake basin, probably of finger-lake origin. It may be seen to-day as a slight lowering of the relief, filled up with soaked ground, stretching from north to south. On the basis of palaeobotanical examinations the organic deposits considered are of Eemian Interglacial age (Z. Janczyk-Kopikowa, 1063). The lower part of the organic series consists of a compact oil shale horizon, the maximum thickness of which may attain up to 8 m. The oil shales contain particularly in their upper part, numerous intercalations of arenaceous silts, dark grey or black in colour, or of sands mainly of lacustrine provenance. At the top of the oil shales are found peats, up to 2.5 m in thickness, covered by black, humus silts with numerous plant remains. The Eemian Interglacial deposits are covered by a series of fluviatile sands belonging partly to the Baltic Glaciation (bottom part of the series), partly to the Holocene (top part of the series). The thickness of the sands is 0.5-3.7 m. Higher up, there are found the Holocene and present-day deposits developed as clayey alluvion, or arenaceous slide rocks, or arenaceous-silty soil.

Geochemistry of DSDP Hole 83-504B minerals

Leg 83 of the Deep Sea Drilling Project has deepened Hole 504B to over 1 km into basement, 1350 m below the seafloor (BSF). The hole previously extended through 274.5 m of sediment and 561.5 m of pillow basalts altered at low temperature (< 100°C), to 836 m BSF. Leg 83 drilling penetrated an additional 10 m of pillows, a 209-m transition zone, and 295 m into a sheeted dike complex. Leg 83 basalts (836-1350 m BSF) generally contain superimposed greenschist and zeolite-facies mineral parageneses. Alteration of pillows and dikes from 836 to 898 m BSF occurred under reducing conditions at low water/rock ratios, and at temperatures probably greater than 100°C. Evolution of fluid composition resulted in the formation of (1) clay minerals, followed by (2) zeolites, anhydrite, and calcite. Alteration of basalts in the transition zone and dike sections (898-1350 m BSF) occurred in three basic stages, defined by the opening of fractures and the formation of characteristic secondary minerals. (1) Chlorite, actinolite, pyrite, albite, sphene, and minor quartz formed in veins and host basalts from partially reacted seawater (Mg-bearing, locally metal-and Si-enriched) at temperatures of at least 200-250°C. (2) Quartz, epidote, and sulfides formed in veins at temperatures of up to 380°C, from more evolved (Mg-depleted, metal-, Si-, and 18O-enriched) fluids. (3) The last stage is characterized by zeolite formation: (a) analcite and stilbite formed locally, possibly at temperatures less than 200°C followed by (b) formation of laumontite, heulàndite, scolecite, calcite, and prehnite from solutions depleted in Mg and enriched in Ca and 18O, at temperatures of up to 250°C. The presence of small amounts of anhydrite locally may be due to ingress of relatively unaltered seawater into the system during Stage 3. Alteration was controlled by the permeability of the crust and is characterized by generally incomplete recrystallization and replacement reactions among secondary minerals. Secondary mineralogy in the host basalts is strongly controlled by primary mineralogy. The alteration of Leg 83 basalts can be interpreted in terms of an evolving hydrothermal system, with (a) changes in solution composition because of reaction of seawater fluids with basalts at high temperatures; (b) variations in permeability caused by several stages of sealing and reopening of cracks; and (c) a general cooling of the system, caused either by the cooling of a magma chamber beneath the spreading center and/or the movement of the crust away from the heat source. The relationship of the high-temperature alteration in the transition zone and dike sections to the low-temperature alteration in the overlying pillow section remains uncertain.

Composition of soil samples from injection location

CO2 leakage from subsurface storage sites is one of the main concerns connected with the CCS technology. As CO2 leakages into near surface formations appear to be very unlikely within pilot CCS projects, the aim of this work is to emulate a leakage by injecting CO2 into a near surface aquifer. The two main questions pursued by the injection test are (1) to investigate the impact of CO2 on the hydrogeochemistry of the groundwater as a base for groundwater risk assessment and (2) to develop and apply monitoring methods and monitoring concepts for detecting CO2 leakages in shallow aquifers. The presented injection test is planned within the second half of 2010, as a joint project of the University of Kiel (Germany), the Helmholtz-Centre for Environmental Research (Leipzig, Germany) and the Engineering Company GICON (Dresden, Germany). The test site has been investigated in detail using geophysical methods as well as direct-push soundings, groundwater well installation and soil and groundwater analyses. The present paper presents briefly the geological and hydrogeological conditions at the test site as well as the planned injection test design and monitoring concept.