Wave-front analysis method of circular aperture sampling for collimation testing

A new type of wave-front analysis method for the collimation testing of laser beams is proposed. A concept of wave-front height is defined, and, on this basis, the wave-front analysis method of circular aperture sampling is introduced. The wave-front height of the tested noncollimated wave can be estimated from the distance between two identical fiducial diffraction planes of the sampled wave, and then the divergence is determined. The design is detailed, and the experiment is demonstrated. The principle and experiment results of the method are presented. Owing to the simplicity of the method and its low cost, it is a promising method for checking the collimation of a laser beam with a large divergence. © 2005 Optical Society of America.

Development of a sampling expert system:"FISHMAP"

This research program consisted of three major component areas: (I) development of experimental design, (II) calibration of the trawl design, and (III) development of the foundation for stock assessment analysis. The products which have I. EXPERIMENTAL DESIGN resulted from - the program are indicated below: The study was successful in identifying spatial and temporal distribution characteristics of the several key species, and the relationships between given species catches and environmental and physical factors which are thought to influence species abundance by areas within the mainstem of the Chesapeake Bay and tributaries

Aspects of the washout of salmonid eggs. 1. Observations on the physical characteristics of real and artificial eggs, their rate of fall in a water column and their pattern of settlement in an experimental channel

When salmonid redds are disrupted by spates, the displaced eggs will drift downstream. The mean distance of travel, the types of locations in which the eggs resettle and the depth of reburial of displaced eggs are not known. Investigation of these topics under field conditions presents considerable practical problems, though the use of artificial eggs might help to overcome some of them. Attempts to assess the similarities and/or differences in performance between real and artificial eggs are essential before artificial eggs can validly be used to simulate real eggs. The present report first compares the two types of egg in terms of their measurable physical characteristics (e.g. dimensions and density). The rate at which eggs fall in still water will relate to the rate at which they are likely to resettle in flowing water in the field. As the rate of fall will be influenced by a number of additional factors (e.g. shape and surface texture) which are not easily measured directly, the rates of fall of the two types of egg have been compared directly under controlled conditions. Finally, comparisons of the pattern of settlement of the two types of egg in flowing water in an experimental channel have been made. Although the work was primarily aimed at testing the value of artificial eggs as a simulation of real eggs, several side issues more directly concerned with the properties of real eggs and the likely distance of drift in natural streams have also been explored. This is the first of three reports made on this topic by the author in 1984.

The rate and mechanism of the partial oxidation of acetaldehyde by PPM concentrations of nitrogen dioxide

The thermal reaction between nitrogen dioxide and acetaldehyde in the gas phase was investigated at room temperature and atmospheric pressure. The initial rate of disappearance of nitrogen dioxide was 1.00 ± 0.03 order with respect to nitrogen dioxide and 1.00 ± 0.07 order with respect to acetaldehyde. An initial second order rate constant of (8.596 ± 0.189) x 10^-3 1.mole^-1 sec^-1 was obtained at 22.0 ± 0.1 °C and a total pressure of one atmosphere. The activation energy of the reaction was 12,900 cal/mole in the temperature range between 22°C and 122°C.

The products of the reaction were nitric oxide, carbon dioxide, methyl nitrite, nitromethane and a trace amount of trans-dimeric nitrosomethane. The addition of nitric oxide increased the rate of formation of nitromethane and decreased the rate of formation of methyl nitrite. There were no measurable surface effects due to the addition of glass wool or glass beads to the reactor.

Reactants and products were analyzed by gas chromatography. A mechanism was proposed incorporating the principal features of the reaction.

Description of sampling stations, methods of benthic sampling and biological water quality assessment; with some consideration of the influence of sample variation on the assessment values obtained

The first bilateral study of methods of biological sampling and biological methods of water quality assessment took place during June 1977 on selected sampling sites in the catchment of the River Trent (UK). The study was arranged in accordance with the protocol established by the joint working group responsible for the Anglo-Soviet Environmental Agreement. The main purpose of the bilateral study in Nottingham was for some of the methods of sampling and biological assessment used by UK biologists to be demonstrated to their Soviet counterparts and for the Soviet biologists to have the opportunity to test these methods at first hand in order to judge the potential of any of these methods for use within the Soviet Union. This paper is concerned with the nine river stations in the Trent catchment.

A high-speed image sensing technique with adjustable frame rate based on an ordinary CCD

In the sinusoidal phase modulating interferometer technique, the high-speed CCD is necessary to detect the interference signals. The reason of ordinary CCD's low frame rate was analyzed, and a novel high-speed image sensing technique with adjustable frame rate based on ail ordinary CCD was proposed. And the principle of the image sensor was analyzed. When the maximum frequency and channel bandwidth were constant, a custom high-speed sensor was designed by using the ordinary CCD under the control of the special driving circuit. The frame rate of the ordinary CCD has been enhanced by controlling the number of pixels of every frame; therefore, the ordinary of CCD can be used as the high frame rate image sensor with small amount of pixels. The multi-output high-speed image sensor has the deficiencies of low accuracy, and high cost, while the high-speed image senor with small number of pixels by using this technique can overcome theses faults. The light intensity varying with time was measured by using the image sensor. The frame rate was LIP to 1600 frame per second (f/s), and the size of every frame and the frame rate were adjustable. The correlation coefficient between the measurement result and the standard values were higher than 0.98026, and the relative error was lower than 0.53%. The experimental results show that this sensor is fit to the measurements of sinusoidal phase modulating interferometer technique. (c) 2007 Elsevier GmbH. All rights reserved.

Repetition rate stabilization of the SBS Q-switched fiber laser by external injection

Repetition rate fluctuation is one of the main drawbacks of the low-threshold stimulated Brillouin scattering (SBS) Q-switched fiber laser. A method to stabilize the repetition rate is proposed in this paper by injecting a square-wave modulated light. It is measured experimentally that variance of the repetition rate can be improved from similar to 20% to similar to 1% of the period. It is also found that effectiveness of the method depends on modulation frequency and duty cycle of the injection. Its working mechanism is analyzed qualitatively. (C) 2009 Optical Society of America

Bertso transformation with pattern-based sampling

This paper presents a method to generate new melodies, based on conserving the semiotic structure of a template piece. A pattern discovery algorithm is applied to a template piece to extract significant segments: those that are repeated and those that are transposed in the piece. Two strategies are combined to describe the semiotic coherence structure of the template piece: inter-segment coherence and intra-segment coherence. Once the structure is described it is used as a template for new musical content that is generated using a statistical model created from a corpus of bertso melodies and iteratively improved using a stochastic optimization method. Results show that the method presented here effectively describes a coherence structure of a piece by discovering repetition and transposition relations between segments, and also by representing the relations among notes within the segments. For bertso generation the method correctly conserves all intra and inter-segment coherence of the template, and the optimization method produces coherent generated melodies.

Trapping success and population analysis of Siren lacertina and Amphiuma means

Siren and Amphiuma are two poorly known genera of aquatic salamanders that occur in the Southeastern United States. A primarily bottom-dwelling existence makes these salamanders difficult to detect with conventional sampling methodologies. Therefore, the current status of their populations is unknown. I compared the capture success of modified crayfish traps and plastic minnow traps in capturing these salamanders. In addition, a mark-recapture study of S. lacertina (Greater siren) and A. means (Two-toed amphiuma) was conducted at Okefenokee National Wildlife Refuge (southern Georgia) and at Katharine Ordway Preserve (north-central Florida) from August 2001 until September 2002. Crayfish traps were much more successful than minnow traps in catching siren and amphiuma. Crayfish traps yielded 270 captures for an overall capture success of 16%, whereas minnow traps yielded only 13 captures for an overall success rate of 0.05%. In addition, several marking techniques were evaluated, and of these, only passive integrated transponder (PIT) tags were retained for the duration of the study. Therefore, I recommend this marking technique for long-term monitoring of S. lacertina and A. means. Several variables were found to have significant effects on capture rates of salamanders. A. means were most often captured in summer and the number of captures was positively correlated with water temperature, water level, and rainfall. S. lacertina were most often captured during winter and spring. Number of captures was negatively correlated with water temperature, while no relationship was found with water level or rainfall. Trap day and baiting had no significant effect on number of A. means or S. lacertina captured. Recapture probabilities of both species were low, 0.025-0.03 for S. lacertina and 0.08-0.11 for A. means. Monthly survival rates were high, 0.77-0.97 for A. means and 0.88-1.00 for S. lacertina. Density estimates of 1.3 salamanders/m2 (S. lacertina) and 0.28 salamanders/m2 (A. means) were obtained for Lake Suggs using Jolly-Seber models. Siren and amphiuma make up a substantial part of wetland biomass and can impact many other wetland species. Thus, more attention must be focused on evaluating and monitoring their populations.