Studies on the probable sources of fungal infection and the control measures in a fish seed farm

The causes of mortality of fry of cultivable fishes in a fish seed farm were investigated. The mortality was due to fungal infection and the pathogen was Saprolegnia sp. The sources of infection were unhygienic breeding hapas, spawnery hapas in the cemented ponds, hatching jars and excess feeding. Application of one kg slaked lime followed by 75g of CuSo sub(4)(l-0.5 p.p.m.) and 150g of KMno sub(4)(2-1 p.p.m.) per each nursery (158m³ water) controlled the pathogen.

Evidence for Positive Selection on the Osteogenin (BMP3) Gene in Human Populations

Background: Human skeletal system has evolved rapidly since the dispersal of modern humans from Africa, potentially driven by selection and adaptation. Osteogenin (BMP3) plays an important role in skeletal development and bone osteogenesis as an antagonist of the osteogenic bone morphogenetic proteins, and negatively regulates bone mineral density. Methodology/Principal Findings: Here, we resequenced the BMP3 gene from individuals in four geographically separated modern human populations. Features supportive of positive selection in the BMP3 gene were found including the presence of an excess of nonsynonymous mutations in modern humans, and a significantly lower genetic diversity that deviates from neutrality. The prevalent haplotypes of the first exon region in Europeans demonstrated features of long-range haplotype homogeneity. In contrast with findings in European, the derived allele SNP Arg192Gln shows higher extended haplotype homozygosity in East Asian. The worldwide allele frequency distribution of SNP shows not only a high-derived allele frequency in Asians, but also in Americans, which is suggestive of functional adaptation. Conclusions/Significance: In conclusion, we provide evidence for recent positive selection operating upon a crucial gene in skeletal development, which may provide new insight into the evolution of the skeletal system and bone development.

Land-based mass production of prawn (Penaeus monodon Fabricius) spawners

The first spawnings were obtained 12 days after ablation with 4 spawners yielding 784,000 eggs and a harvest of 250,000 P SUB-10 fry. Survival of females after 1 month was approximately 30%. Mortalities were mostly due to handling stress during the regular ovarian samplings as well as disease frm the accumulated excess feeds on the bottom of the tank. Male survival could not be recorded because of transfers to other tanks and addition of new stocks. Development seemed to peak 3 weeks after ablation. The average number of eggs per ablated spawner was 120,000. However, many of the partially spawned females were removed from the spawning tanks the following day so that remaining eggs released in the next 2 to 3 days could not be recorded. Estimate of the average number of eggs per ablated spawner is 120,000-150,000 in contrast to 500,000 per wild spawner. However, the low production cost more than compensates for the difference. Fry reared in the Wet Laboratory were used for experiments, mostly on feeding. Therefore, survival at harvest is not to be taken as a reflection of stock quality. Although fewer in number, larvae from ablated prawns are as healthy in terms of vigor in swimming and feeding as those from wild females. Most mortalities are due to inability to molt caused by lower water temperatures and inadequate feeding.

Effect of substrate types on fecundity and nauplii production of ablated Penaeus monodon Fabricius

Experiments were undertaken to assess the survival, spawning, fecundity and nauplii production of ablated P. monodon females reared in flow-through broodstock tanks with white coralline and black sand substrate for 62 days. The similar trend observed in mortality rates in both substrates suggests that variation in substrate material for broodstock tanks is not a likely cause of prawn mortality. There were also no significant differences observed between rematurtion rates, i.e. number of spawnings, under the different treatments. Singnificantly higher nauplii production were observed in females in tanks with white substrates. At present, the land-based broodstock tanks in SEAFDEC utilize white coralline substrates due to higher hatching rate of eggs and nauplii production, convenience in siphoning out debris and excess food that tend to accumulte in the tank, and contrast provided by the white substrate during nightly observations of ovaries.

Assessment of pelagic primary and secondary production in Sefidrud River estuary

Sefid-Rood River Estuary (SRE) is the most important riverine ecosystem in the south Caspian Sea along the Iranian coast lines. The aim of this study was to examine spatial and temporal variability in Phytoplankton and Zooplankton abundance and diversity in SRE. Variability of Chlorophyll a and inorganic nutrient concentration were determined during a year (November 2004– October 2005) in five sampling stations. Primary and secondry production were determined during a year. Total chlorophyll a concentration during the investigation ranged between zero to 22.8 μgl-1 and the highest levels were consistently recorded during summer and the lowest during winter with a annual mean concentration 4.48 μgl-1. Nutrient concentration was seasonally related to river flow with annual mean concentration: NO2 0.05±0.2 mgl-1, NO3 1.13±0.57 mgl-1, NH4 0.51±0.66 mgl-1, total phosphate 0.13±0.1mgl-1 and SiO2 5.68±1.91 mgl-1. Bacillariophytes, Cyanophytes, Chlorophytes, Pyrophytes and Euglenophytes were the dominant phytoplankton groups in this shallow and turbid estuary. The diversity and abundance of phytoplankton had a seasonal pattern while Diatomas and Chrysophytes were dominant throughout the year but Cyanophytes observed only during the summer. Zooplankton community structure was dominated by copepods which 68% of the total zooplankton. In the winter and summer seasons two increased in the number of zooplankton community and usually toward the sea had occurred. Zooplankton also showed a significant spatial and temporal variation. The high turbidity and temperature prime characteristics of SRE seem to be determining factors acting directly on phytoplankton and zooplankton temporal variability and nutrient fluctuations. Everywhere in this estuary nutrients appeared to be in excess of algal requirement and did not influence a phytoplankton and zooplankton composition. Also there was a positive correlation between chlorophyll a and temperature and a negative one with DIN and TP. Primary production determined in this estuary by dark and light butter method and G.P.P. 38.27±34.12 mgcm-2h-1 and N,PP 201.6±289.9 mgcm-2d-1. secondry production determined 15/128 mgc/m3/year. Everywhere in this estuary nutrients appeared to be in excess to algal requirement and did not influence in Chl. a and primary production. The most important factor influence on Chl. a was water temperature.

Shrimp (Penaeus monodon Fabricius) production in brackishwater ponds applied varying fertilizer combinations

Details are given of the production of Penaeus monodon in the Philippines reared in brackishwater earthen ponds applied with different fertilizer combinations, namely diammonium phosphate, urea and chicken manure. Results show that the shrimp showed higher yields in fertilized ponds, but increasing the concentration of fertilizers did not give a marked increase in yield - the excess fertilizer was wasted.

Permeability and stiffness of sands at very low effective stresses

Loose saturated sandy soils may undergo liquefaction under cyclic loading, generating positive excess pore pressures due to their contractile nature and inability to dissipate pore pressures rapidly during earthquake loading. These liquefied soils have a near-zero effective stress state, and hence have very low strength and stiffness, causing severe damage to structures founded upon them. The duration for which this near-zero effective stress state persists is a function of the rate of reconsolidation of the liquefied soil, which in turn is a function of the permeability and stiffness of the soil at this very low effective stress. Existing literature based on observation of physical model tests suggests that the consolidation coefficient C v associated with this reconsolidation of liquefied sand is significantly lower than that of the same soil at moderate stress levels. In this paper, the results of a series of novel fluidisation tests in which permeability k and coefficient of consolidation C v were independently measured will be presented. These results allow calculation of the variation of stiffness E 0 and permeability k with effective stress. It is shown that while permeability increases markedly at very low effective stresses, the simultaneous drop in stiffness measured results in a decrease in consolidation coefficient and hence an increase in the duration for which the soil remains liquefied.

SoC energy savings = reduce+reuse+recycle: A case study using a 660MHz DC-DC converter with integrated output filter

This paper advocates 'reduce, reuse, recycle' as a complete energy savings strategy. While reduction has been common to date, there is growing need to emphasize reuse and recycling as well. We design a DC-DC buck converter to demonstrate the 3 techniques: reduce with low-swing and zero voltage switching (ZVS), reuse with supply stacking, and recycle with regulated delivery of excess energy to the output load. The efficiency gained from these 3 techniques helps offset the loss of operating drivers at very high switching frequencies which are needed to move the output filter completely on-chip. A prototype was fabricated in 0.18μm CMOS, operates at 660MHz, and converts 2.2V to 0.75-1.0V at ∼50mA.1 © 2008 IEEE.

Ultrashort superradiant pulse generation from a GaN/InGaN heterostructure.

Dicke superradiance from a two-section violet GaN/InGaN semiconductor laser diode is demonstrated for the first time. In the superradiance regime, optical pulses with peak powers in excess of 2.8 W and durations as short as 1.4 ps are generated at repetition rates of up to 10 MHz at the emission wavelength of 408 nm. The properties of superradiant pulse generation from these GaN/InGaN laser diodes are very similar to those reported for infrared AlGaAs/GaAs laser diodes.

Ultrafast switching liquid crystals for electro-optic transmissive and reflective displays and microscopic lasers

We report on novel liquid crystals with extremely large flexoelectric coefficients in a range of ultra-fast photonic modes, namely 1) the uniform lying helix, that leads to in-plain switching, birefringence phase devices with 100 μs switching times at low fields, i.e.2-5 V/μm, and analogue or grey scale capability, 2) the uniform standing helix, using planar surface alignment and in-plane fields, with sub ms response times and optical contrasts in excess of 5000:1 with a perfect optically isotropic or black "off state", 3) the wide temperature range blue phase that leads to field controlled reflective color, 4) chiral nematic optical reflectors electric field tunable over a wide wavelength range and 5) high slope efficiency, wide wavelength range tunable narrow linewidth microscopic liquid crystal lasers. © 2011 Materials Research Society.

Breakdown voltage for superjunction power devices with charge imbalance: An analytical model valid for both punch through and non punch through devices

An analytical model for the electric field and the breakdown voltage (BV) of an unbalanced superjunction (SJ) device is presented in this paper. The analytical technique uses a superposition approach treating the asymmetric charge in the pillars as an excess charge component superimposed on a balanced charge component. The proposed double-exponentialmodel is able to accurately predict the electric field and the BV for unbalanced SJ devices in both punch through and non punch through conditions. The model is also reasonably accurate at extremely high levels of charge imbalance when the devices behave similarly to a PiN diode or to a high-conductance layer. The analytical model is compared against numerical simulations of charge unbalanced SJ devices and against experimental results. © 2009 IEEE.

Influence of fluid viscosity on the response of buried structures in earthquakes

The use of high viscous pore fluid has been widely established to match the rate of excess pore pressure generation and subsequent dissipation in dynamic centrifuge tests. The appropriate viscosity is linked to the geometric and gravity scaling factors which corresponds to the use of pore fluid of 'N' cSt in a 'N'g centrifuge test. The use of either water (1 cSt) or pore fluid lower than 'N' cSt can influence the behaviour of soil liquefaction in a centrifuge test. In this paper, the floatation of a tunnel following soil liquefaction is investigated using pore fluids with two different viscosities. The results show that the uplift displacement of the tunnel is significantly affected by the pore fluid viscosity. © 2010 Taylor & Francis Group, London.

Effects of preferential transport in turbulent bluff-body-stabilized lean premixed CH 4/air flames

Preferential species diffusion is known to have important effects on local flame structure in turbulent premixed flames, and differential diffusion of heat and mass can have significant effects on both local flame structure and global flame parameters, such as turbulent flame speed. However, models for turbulent premixed combustion normally assume that atomic mass fractions are conserved from reactants to fully burnt products. Experiments reported here indicate that this basic assumption may be incorrect for an important class of turbulent flames. Measurements of major species and temperature in the near field of turbulent, bluff-body stabilized, lean premixed methane-air flames (Le=0.98) reveal significant departures from expected conditional mean compositional structure in the combustion products as well as within the flame. Net increases exceeding 10% in the equivalence ratio and the carbon-to-hydrogen atom ratio are observed across the turbulent flame brush. Corresponding measurements across an unstrained laminar flame at similar equivalence ratio are in close agreement with calculations performed using Chemkin with the GRI 3.0 mechanism and multi-component transport, confirming accuracy of experimental techniques. Results suggest that the large effects observed in the turbulent bluff-body burner are cause by preferential transport of H 2 and H 2O through the preheat zone ahead of CO 2 and CO, followed by convective transport downstream and away from the local flame brush. This preferential transport effect increases with increasing velocity of reactants past the bluff body and is apparently amplified by the presence of a strong recirculation zone where excess CO 2 is accumulated. © 2011 The Combustion Institute.

Experimental study on an SFCL using series-connected YBCO thin films

Superconducting Fault Current Limiters (SFCLs) are able to reduce fault currents to an acceptable value, reducing potential mechanical and thermal damage and allowing more flexibility in an electric power system's design. Due to limitations in current YBCO thin film manufacturing techniques, it is necessary to connect a number of thin films in different series and parallel configurations in order to realise a practical SFCL for electric power system applications. The amount of resistance generated (i.e. the degree of current limitation), the characteristics of the S-N transition, and the time at which they operate is different depending on their comparative characteristics. However, it is desirable for series-connected thin films to have an operating time difference as small as possible to avoid placing an excess burden on certain thin films. The role of a parallel resistance, along with the influence of thin film characteristics, such as critical current (Ic), are discussed in regards to the design of SFCLs using YBCO thin films. © 2008 IOP Publishing Ltd.

Drain groups in liquefiable soil

One of the major concerns for engineers in seismically active regions is the prevention of damage caused by earthquake-induced soil liquefaction. Vertical drains can aid dissipation of excess pore pressures both during and after earthquakes. Drain systems are designed using standard design charts based around the concept of a unit cell, assuming each drain is surrounded by more drains. It is unclear how predictable drain performance is outside that unit cell concept, for example, drains at the edge of a group. Centrifuge testing is a logical method of performing controlled experiments to establish the efficacy of vertical drains. Centrifuge testing is used to identify the effect of drains dealing with very different catchment areas. The importance of this is further highlighted by the results of a test where the same drains have been modified so that each should behave as a unit cell. It is shown that drains with large catchment areas perform more poorly than unit cells, and also have a knock-on detrimental effect on other drains. Copyright © 2011, IGI Global.