Disinfection protocols to prevent cross-contamination between dental offices and prosthetic laboratories

Control of cross-contamination between dental offices and prosthetic laboratories is of utmost importance to maintain the health of patients and dental office staff. The purpose of this study was to evaluate disinfection protocols, considering antimicrobial effectiveness and damage to the structures of prostheses. Solutions of 1% sodium hypochlorite, 2% chlorhexidine digluconate, 50% vinegar and sodium perborate were evaluated. Specimens were contaminated in vitro with standardized suspensions of Candida albicans, Streptococcus mutans, Escherichia coli, Staphylococcus aureus and Bacillus subtilis spores. Disinfection by immersion for 10. min was performed. Final counts of microorganisms were obtained using the plating method. Results were statistically compared by Kruskal-Wallis ANOVA and Dunn's test. The surface roughness of 40 specimens was analyzed before and after 10 disinfection cycles, and results were compared statistically using Student's t test. The solution of 50% vinegar was as effective as 1% sodium hypochlorite and 2% chlorhexidine against C. albicans, E. coli and S. mutans. The sodium perborate solution showed the lowest antimicrobial effectiveness. Superficial roughness increased after cycles in 1% sodium hypochlorite (p=0.02). Solutions of 1% sodium hypochlorite, 2% chlorhexidine and 50% vinegar were effective for the disinfection of heat-polymerized acrylic specimens. Sodium hypochlorite increased the superficial roughness. © 2013 King Saud Bin Abdulaziz University for Health Sciences.

Tribocorrosion behaviour of anodic treated titanium surfaces intended for dental implants

Tribocorrosion plays an important role in the lifetime of metallic implants. Once implanted, biomaterials are subjected to micro-movements in aggressive biological fluids. Titanium is widely used as an implant material because it spontaneously forms a compact and protective nanometric thick oxide layer, mainly TiO2, in ambient air. That layer provides good corrosion resistance, and very low toxicity, but its low wear resistance is a concern. In this work, an anodizing treatment was performed on commercial pure titanium to form a homogeneous thick oxide surface layer in order to provide bioactivity and improve the biological, chemical and mechanical properties. Anodizing was performed in an electrolyte containing β-glycerophosphate and calcium acetate. The influence of the calcium acetate content on the tribocorrosion behaviour of the anodized material was studied. The concentration of calcium acetate in the electrolyte was found to largely affect the crystallographic structure of the resulting oxide layer. Better tribocorrosion behaviour was noticed on increasing the calcium acetate concentration. © 2013 IOP Publishing Ltd.

The effect of the solute on the structure, selected mechanical properties, and biocompatibility of Ti-Zr system alloys for dental applications

New titanium alloys have been developed with the aim of utilizing materials with better properties for application as biomaterials, and Ti-Zr system alloys are among the more promising of these. In this paper, the influence of zirconium concentrations on the structure, microstructure, and selected mechanical properties of Ti-Zr alloys is analyzed. After melting and swaging, the samples were characterized through chemical analysis, density measurements, X-ray diffraction, optical microscopy, Vickers microhardness, and elasticity modulus. In-vitro cytotoxicity tests were performed on cultured osteogenic cells. The results showed the formation essentially of the α′ phase (with hcp structure) and microhardness values greater than cp-Ti. The elasticity modulus of the alloys was sensitive to the zirconium concentrations while remaining within the range of values of conventional titanium alloys. The alloys presented no cytotoxic effects on osteoblastic cells in the studied conditions. © 2013 Elsevier B.V. All rights reserved.

Age assessment based on dental calcification in individuals with Down syndrome

It is important to estimate both chronological age (CA) and maturational age of an individual, in order to perform orthopedic treatment or surgery, and in cases of lost documentation. Use of dental age (DA) for these purposes has been widely studied; however, the literature is scarce with regard to individuals with Down syndrome (DS), a prevalent condition worldwide. In this study the chronology of dental maturation was evaluated by analyzing the DA of individuals with DS based on the Chronological Mineralization Table proposed by Nolla (1960). Thus, second molars were evaluated in 57 panoramic radiographs of male and female individuals with DS, between 5 and 16 years-old. These data were compared with a control group of 191 nonsyndromic individuals of the same age group. Correlation between CA and DA was ascertained using Pearson's correlation coefficient (r), and the difference between these variables was measured using Student's t-test for paired samples and the method proposed by Bland and Altman. The difference between DA and CA was compared between the control and DS groups using Student's t-test for independent samples (α=0.05). DA was slightly lower than the CA; however, this difference was only significant for females. The difference between DA and CA was not significant between individuals with DS and control group (both genders, p=0.945; males, p=0.542; females, p=0.381). We concluded that dental maturation in individuals with DS occurs similarly to that of nonsyndromic individuals. © 2013 Elsevier Ltd.

Resposta pulpar de dentes de ratos após tratamento capeador direto com sistema adesivo monocomponente ou autocondicionante

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Estudo de propriedades físicas de materiais adesivos ortodônticos

Pós-graduação em Ciência dos Materiais - FEIS

Influência de três hemostáticos tópicos no processo de reparo em feridas de extração dental: análise histológica e histométrica em ratos

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Efeito da ativação química do gel de peróxido de carbamida a 10% no clareamento dental

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Influência da adição de surfactantes a géis clareadores à base de peróxido de hidrogênio a 35% e peróxido de carbamida a 10% na efetividade do clareamento dental: estudo in vitro

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Inter-relação do comprimento dos prolongamentos resinosos (tags) e da espessura da camada híbrida de adesão, com a resistência de união de sistemas adesivos ao tecido dentinário

Pós-graduação em Odontologia - FOA

Estudo da rugosidade e ultra-estrutura superficial do esmalte dental humano submetido a diferentes métodos profiláticos

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Avaliação dos efeitos causados por diferentes sistemas de clareamento dental sobre a estrutura superficial do esmalte e resina composta restauradora

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Análise da penetração de material resinoso ao esmalte dental em função de agente clareador e tempo

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Sensibilidade dolorosa e efetividade do clareamento dental de consultório

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Análise da microestrutura do amálgama dental quando associado a diferentes materiais intermediários

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)