Estudo das propriedades termofísicas com variação da expansibilidade de compósito desenvolvido com matriz PUR-NOP e carga funcional de argilomineral

In this study were conducted experimental procedures for determination of variation of the expandability of rigid polyurethane foam (PUR) from a natural oil polyol (NOP), specifically the Castor oil plant, Ricinus communis, pure and additions of the vermiculite in phase dispersed in different percentage within a range from 0% to 20%, mass replacement. From the information acquired, were defined the parameters for production of bodies of test, plates obtained through controlled expansion, with the final volume fixed. Initially, the plates were subjected to thermal performance tests and evaluated the temperature profiles, to later be extracted samples duly prepared in accordance with the conditions required for each test. Was proceeded then the measurement of the coefficient of thermal conductivity, volumetric capacity heat and thermal diffusivity. The findings values were compared with the results obtained in the tests of thermal performance, contributing to validation of the same. Ultimately, it was investigated the influence that changes in physical-chemical structure of the material had exerted on the variation of thermophysical quantities through gas pycnometry, scanning electron microscopy (SEM) combined with energy dispersive X-ray fluorescence spectroscopy (EDXRF), infrared spectroscopy using Fourier transform (FTIR), thermogravimetric analysis (TGA) and differential thermal analysis (DTA). Based on the results obtained was possible to demonstrate that all load percentage analyzed promoted an increase in the potential expansion (PE) of the resin. In production of the plates, the composites with density near at the free expansion presented high contraction during the cure, being the of higher density adopted as definitive standard. In the thermal performance tests, the heating and cooling curves of the different composites had presented symmetry and values very close for lines of the temperature. The results obtained for the thermophysical properties of composites, showed little difference in respect of pure foam. The percentage of open pores and irregularities in the morphology of the composites were proportionate to the increment of vermiculite. In the interaction between the matrix and dispersed phase, there were no chemical transformations in the region of interface and new compounds were not generated. The composites of PUR-NOP and vermiculite presented thermal insulating properties near the foam pure and percentage significantly less plastic in its composition, to the formulation with 10% of load

Estudo e caracterização de matérias-primas para o desenvolvimento de blocos sílico-calcários

The types of products manufactured calcium silicate blocks are very diversified in its characteristics. They include accessory bricks, blocks, products in dense material, with or without reinforcements of hardware, great units in cellular material, and thermal insulating products. The elements calcium silicate are of great use in the prefabricated construction, being formed for dense masses and hardened by autoclaving. This work has for objective develop formulations that make possible the obtaining of calcium silicate blocks with characteristics that correspond the specifications technical, in the State of the Rio Grande of the North, in finality of obtaining technical viability for use in the civil construction. The work studied the availability raw materials from convenient for the production of calcium silicate blocks, and the effect of variations of the productive process on the developed products. The studied raw materials were: the quartz sand from the city of São Gonçalo do Amarante/RN, and two lime, a hydrated lime and a pure lime from the city of Governador Dix-Sept Rosado/RN. The raw materials collected were submitted a testes to particle size distribution, fluorescence of X rays, diffraction of X rays. Then were produced 8 formulations and made body-of-test by uniaxial pressing at 36 MPa, and cured for 7 hours at about 18 kgf/cm2 pressing and temperature of approximately 180 °C. The cure technological properties evaluated were: lineal shrinkage, apparent density, apparent porosity, water absorption, modulus of rupture flexural (3 points), resistance compression, phase analysis (XRD) and micromorphological analysis (SEM). From the results presented the technological properties, was possible say that utilization of hydrated lime becomes more viable its utilization in mass limestone silica, for manufacture of calcium silicate blocks

Effect of Usnic Acid on Candida orthopsilosis and C. parapsilosis

The activity of usnic acid against Candida orthopsilosis and Candida parapsilosis on planktonic and biofilm conditions was investigated by using a broth microdilution and microplate methods. Potent in vitro activities against different Candida species were obtained. The metabolic activity of sessile cells of C. parapsilosis complex was reduced by 80% at four times the 80% inhibitory concentration. The in vitro studies support further efforts to determine whether usnic acid can be used clinically to cure patients with Candida infections.

Desenvolvimento de sistemas farmacêuticos emulsionados para veiculação gênica

Broadly speaking, the concept of gene therapy involves the transfer of a genetic material into a cell, tissue, or organ in order to cure a disease or at least improve the clinical status of a patient. Making it simple, gene therapy consists in the insertion of functional genes into cells containing defective genes by substituting, complementing or inhibiting them. The achievement of a foreigner DNA expression into a population of cells requires its transfer to the target. Therefore, it is a key issue to create systems able to transfer and protect the DNA until it reaches the target, the vectors. The disadvantages related to the use of viral vectors have encouraged efforts to develop emulsions as non-viral vectors. In fact, they are easily produced, present controllable stability and enable transfection. The aim of this work was to develop an emulsion for gene therapy and evaluate its ability to compact nucleic acids by the development of a complex with the plasmid pIRES2-EGFP. The first step was to determine the Hydrophilic Lipophilic Balance (HLB) of the Captex® 355 (oily internal phase of the emulsion) through long and short term stability assays. Based on the results, emulsions composed of Captex® 355, Tween 20® and Span 60® with 10.7 HLB were produced by three different methods: phase inversion, spontaneous emulsification and sonication. The results showed that the lowest diameter and best stability of the emulsions were achieved by the sonication method. The cationic emulsions were made by adding DOTAP to the basic emulsion. Its association with pIRES2-EGFP was evaluated by electrophoresis. Several rates of emulsion and DNA were evaluated and the results showed that 100% of the complex was formed when the rate DOTAP/DNA(nmol/µg) was 130. In conclusion, the overall results show the ability of the proposed emulsion to compact pIRES2-EGFP, which is a requirement to a successful transfection. Therefore, such formulation may be considered a promising candidate for gene therapy

Modelos de sobrevivência com fração de cura e erro de medida nas covariáveis

In this work, we study the survival cure rate model proposed by Yakovlev et al. (1993), based on a competing risks structure concurring to cause the event of interest, and the approach proposed by Chen et al. (1999), where covariates are introduced to model the risk amount. We focus the measurement error covariates topics, considering the use of corrected score method in order to obtain consistent estimators. A simulation study is done to evaluate the behavior of the estimators obtained by this method for finite samples. The simulation aims to identify not only the impact on the regression coefficients of the covariates measured with error (Mizoi et al. 2007) but also on the coefficients of covariates measured without error. We also verify the adequacy of the piecewise exponential distribution to the cure rate model with measurement error. At the end, model applications involving real data are made

Modelos de sobrevivência com fração de cura e omissão nas covariáveis

In this work we study the survival cure rate model proposed by Yakovlev (1993) that are considered in a competing risk setting. Covariates are introduced for modeling the cure rate and we allow some covariates to have missing values. We consider only the cases by which the missing covariates are categorical and implement the EM algorithm via the method of weights for maximum likelihood estimation. We present a Monte Carlo simulation experiment to compare the properties of the estimators based on this method with those estimators under the complete case scenario. We also evaluate, in this experiment, the impact in the parameter estimates when we increase the proportion of immune and censored individuals among the not immune one. We demonstrate the proposed methodology with a real data set involving the time until the graduation for the undergraduate course of Statistics of the Universidade Federal do Rio Grande do Norte

Recidiva de câncer labial em pacientes atendidos no hospital DR. Luiz Antônio (Natal-RN) entre 1997-2004

Introduction: Cancer of the lip is very common in tropical countries, being noticeable the squamous cell carcinoma as the main histological type. Objective: Evaluate the socialdemographic profile, habits, occupation, clinical characteristics of the cancer lesions and the aftermath of treatment of the patients treated on the Luiz Antônio Hospital (Natal-RN). Design: Retrospective cohort. Methods: We analyzed 181 medical records of patients from the Luiz Antônio Cancer Hospital (Natal-RN) in the period between 1997 and 2004. The statistic evaluation of time between the diagnosis and the relapse or the cure of the patient were done through the Kaplan-Meier method and the comparison of survivor functions were done through the Log-rank test. Later, was estimated the proportional risk model of Cox. Results: The study population were composed by 69,1% males, 95,2% unlettered, the mean age of 66,5 years, 89,0% of smokers and 64,1% had an occupation involving sun exposure. In regard to the clinical characteristics, most lesions were in the lower lip (77,9%), the size of the tumor was smaller than 2 cm (51,8%), 92,6% had localized lesions. Were verified 16,3% of local relapse and 13% of regional. Almost the totally of the cases corresponded to squamous cell carcinoma (97,2%). We observed smaller accumulated probability of not occurrence of local relapse when the base and borders were free of lesions (p=0,041), as well as a smaller probability of regional relapse when the sort of treatment was surgery, associated with other therapeutics modalities (p=0,001). The patients with advanced pathologic stage (p=0,016), treated with surgery associated with other therapeutics modalities (p=0,001) and diameter above 4cm (p=0,019) presented a bigger possibility of any kind of relapse. The multivariable analysis pointed the complex treatments (surgery plus other therapeutics modalities) as a predictor variable for occurrence of new local lesions (p=0,001) and total (p=0,046), besides the age above 70 years to the regional relapse (p=0,050). Conclusion: Cancer of the lip occur in the lower lip, in males, smokers and individuals exposed to Sun light. The relapse was frequent, even being localized and without great consequences to the patient s health. The probability of relapse is related to the size and borders of the lesion and to the histological exam, as well as to the patient s age and complexity of the treatment chosen