Effects of rotating inlet distortion on multistage compressor stability

In multi-spool engines, rotating stall in an upstream compressor will impose a rotating distortion on the downstream compressor, thereby affecting its stability margin. In this paper experiments are described in which this effect was simulated by a rotating screen upstream of several multistage low-speed compressors. The measurements are complemented by, and compared with, a theoretical model of multistage compressor response to speed and direction of rotation of an inlet distortion. For co-rotating distortions (i.e., distortions rotating in the same direction as rotor rotation), experiments show that the compressors exhibited significant loss in stability margin and that they could be divided into two groups according to their response. The first group exhibited a single peak in stall margin degradation when the distortion speed corresponded to roughly 50% of rotor speed. The second group showed two peaks in stall margin degradation corresponding to distortion speeds of approximately 25-35% and 70-75% of rotor speed. These new results demonstrate that multistage compressors can have more than a single resonant response. Detailed measurements suggest that the two types of behavior are linked to differences between the stall inception processes observed for the two groups of compressors and that a direct connection thus exists between the observed forced response and the unsteady flow phenomena at stall onset. For counter-rotational distortions, all the compressors tested showed minimal loss of stability margin. The results imply that counter-rotation of the fan and core compressor, or LP and HP compressors, could be a worthwhile design choice. Calculations based on the two-dimensional theoretical model show excellent agreement for the compressors which had a single peak for stall margin degradation. We take this first-of-a-kind comparison as showing that the model, though simplified, captures the essential fluid dynamic features of the phenomena. Agreement is not good for compressors which had two peaks in the curve of stall margin shift versus distortion rotation speed. The discrepancy is attributed to the three-dimensional and short length scale nature of the stall inception process in these machines; this includes phenomena that have not yet been addressed in any model.

Some examples of multiple solutions in limiting flaw calculations using PD6493:1991 fracture mechanics analyses

The use of PC-based PD6493:1991 fracture assessment procedures has revealed that, under certain circumstances, flaws of different dimensions may be found as being limiting or critical for identical applied conditions. The main causes for multiple solutions are a steep applied stress gradient, residual stress relaxation and flaw re-characterisation. This work uses several case studies to illustrate some of the circumstances under which multiple solutions occurs.

CALCULATIONS OF INLET DISTORTION INDUCED COMPRESSOR FLOWFIELD INSTABILITY.

Calculations are presented predicting the onset of flow instability for a multistage low speed axial compressor operating in circumferentially distorted inlet flow. The most important feature of the model used is that it attempts to properly account for the fluid dynamic interaction between the spoiled and unspoiled sectors of the compressor. The calculations show that there is an approximate stability criterion, the annulus averaged slope of the compressor pressure rise characteristic equal to zero, that is valid whenever the dynamics of the compressor distorted flowfield can be considered independent of the compressor environment. This approximate criterion is used to investigate the relationship between the present model and the 'parallel compressor' model. Further calculations are performed to investigate cases of interest when the dynamics of the compressor flowfield are coupled to the environment. Resonant cases and cases when the distortion is unsteady are studied.

Monitoring tunnel deformation induced by close-proximity bored tunneling using distributed optical fiber strain measurements

The paper describes the use of optical fiber Brillouin Optical Time Domain Reflectometry (BOTDR) to monitor the strain distribution in an existing tunnel while a twin tunnel was bored at close-proximity. The twin circular bored tunnels between Serangoon and Bartley stations on the new Circle Line Stage 3 subway in Singapore were constructed at close-proximity to avoid underpinning the foundations of adjacent buildings. The minimum clear separation of the two tunnels is 2.3m (0.4 times the tunnel diameter). The Outer Tunnel was constructed first, followed by the Inner Tunnel, with the earth-pressure balance tunnel boring machines maintained at a minimum of 100m apart. In this trial application of BOTDR, the strain distribution along the Outer Tunnel was measured, in order to monitor its deformation due to the boring of the Inner Tunnel at close-proximity. The aim of the trial application was to determine the practicality of this monitoring method for future use in 'live' tunnels. This paper compares the measurements obtained from optical fiber BOTDR with conventional methods of tunnel monitoring and describes preliminary installation and workmanship guidelines derived from lessons learnt during this trial. © 2007 ASCE.

Feeding stimulatory effects of Cyperus rotundus tuber on Cirrhinus mrigala

Traditionally tubers of cyperus (Cyperus rotundus) and its extracts have been used for alluring fish during harvesting in India. An experiment was conducted to evaluate its feeding stimulatory activity and effect on the growth of a commercially important freshwater fish, Cirrhinus mrigala. Three isonitrogenous and isocaloric formulated diets viz. plant ingredient based control and control supplemented with cyperus tuber (CS) at 1% and 5% levels were fed to the fingerlings of mrigal, C. mrigala (2.68+0.20 g) for a period of 45 days. The growth performance and the activity of metabolic enzymes, aspartate aminotransferase (AST) and alanine aminotransferase (ALT), in liver, gill and muscle tissues of mrigal were studied during every 15 days interval. Highest relative growth (72.28%) was obtained in the mrigal fed with the diet containing 5% cyperus (5% CS), while the relative growths were 66.18% and 43.40% for the fish fed with the 1% CS diet and control respectively. The activities of AST and ALT were significantly higher (p<0.01) in both 1% and 5% CS diets as compared to the control in all the tissues studied. Higher aminotransferase activities were observed in the tissues of 5% CS group than in those of 1% CS group throughout the experimental period. The observed higher enzymatic activity was concomitant with the higher growth rate in fish. The results suggested that cyperus tuber supplementation increased feed palatability and growth.

Carbon nanotube based photocathodes for high frequency amplifiers

The combination of high frequency, high power, high efficiency capabilities is a feature of vacuum tube technology. For most of applications, large bandwidths are required, and therefore the modulation method should also allow large bandwidth operation. Optically modulated cold cathodes, avoiding the use of resonant cavities, should satisfy this requirement. This is the reason why we have developed carbon nanotube based photocathode.© 2009 IEEE.

Use of crude salt in rearing of freshwater giant prawn, Macrobrachium rosenbergii (de Man) larvae

Three different types of culture media: (i) 100% brine (B 100 ), (ii) 75% brine and 25% crude salt (B 75 CS 25 ), and 50% brine and 50% crude salt (B 50 CS 50) were tested to evaluate the possible use of brackish water reconstituted from the crude salt for the production of M. rosenbergii post-larvae. The production rate of 25.26±0.20 PI/l with a corresponding survival rate of 84.20±0.66% was significantly higher (P<0.05) for the larvae reared on B100 than that of 22.10±0.57 Pl/l with a corresponding survival rate of 73.68±1.89% on B50CS50. Larvae cultured on B75CS25 did not show any significant difference (P<0.05) in production as well as in survival of post-larvae than that on B100. The result shows that, for rearing of prawn larvae, use of brine can be replaced up to 25% without any undue reduction in production of post-larvae. However, the production as well as survival rate of post-larvae with 50% replacement (B50CS50) is also appreciable. It is assumed that the mineral constituents of natural seawater might have some triggering effects on prawn larvae in closing their larval cycle.

Recent developments of the Laser-assisted Cold Spray process and deposit characterisation

Laser-assisted Cold Spray (LCS) is a new coating and fabrication process which combines the supersonic powder beam found in Cold Spray (CS) with laser heating of the deposition zone. LCS retains the advantages of CS; solid-state deposition, high build rate and the ability to deposit onto a range of substrates, while reducing operating costs by removing the need to use gas heating and helium as the process gas. Recent improvements in powder delivery and laser energy coupling to workpiece have been undertaken to improve deposition efficiency (DE) and build rate, while real-time temperature logging allows greater management of deposition conditions and deposit characteristics.

Predatory behaviour of a perch, Nandus nandus (Ham.)

Predatory behaviour of Nandus nandus was studied by offering Cyprinus carpio as prey. The study was conducted with six N. namdus (8.2 ±0.2 cm and 7.60 ±0.3g) represented as P 1, P 2, P 3, P 4, P 5 and P 6. Three size categories of prey (C. carpio) such as small (2.0 ±0.1 cm and 0.23 ±0.01g), large (3.6 ±0.1 cm and 0.57 ±O.O.lg) and mixed group consisting of both small and large prey were used for 14 days of trial. Predatory behavior was classified as targeting, driving, catching, handling, resting and next attempt of catching prey. After introduction of prey into the aquarium predators followed the movement of preys by eye movements and tried to target smaller one first. The predator grasped the head of the prey by its jaws by a drive and engulfed it wholly into the mouth. The average handling time (time taken to manipulate and swallow prey from capture to ceasation of pharyngeal movement) was 42±2 sec and 47±2 sec for small and large prey respectively. N. nandus were ingested more small prey than large prey though the size classes were equally available in case of mixed prey used. Although the prey consumption was higher in number when small prey were ingested but in weight the consumption was higher when ingested large size of prey. The study indicated that N. nandus, ingested more small prey and grasped the headfirst.

An ARGONAUTE4-containing nuclear processing center colocalized with Cajal bodies in Arabidopsis thaliana.

ARGONAUTE4 (AGO4) and RNA polymerase IV (Pol IV) are required for DNA methylation guided by 24 nucleotide small interfering RNAs (siRNAs) in Arabidopsis thaliana. Here we show that AGO4 localizes to nucleolus-associated bodies along with the Pol IV subunit NRPD1b; the small nuclear RNA (snRNA) binding protein SmD3; and two markers of Cajal bodies, trimethylguanosine-capped snRNAs and the U2 snRNA binding protein U2B''. AGO4 interacts with the C-terminal domain of NRPD1b, and AGO4 protein stability depends on upstream factors that synthesize siRNAs. AGO4 is also found, along with the DNA methyltransferase DRM2, throughout the nucleus at presumed DNA methylation target sites. Cajal bodies are conserved sites for the maturation of ribonucleoprotein complexes. Our results suggest a function for Cajal bodies as a center for the assembly of an AGO4/NRPD1b/siRNA complex, facilitating its function in RNA-directed gene silencing at target loci.

Mitochondrial DNA variation in cattle of South China: origin and introgression

Ten restriction endonucleases were used to investigate the mitochondrial DNA restriction fragment length polymorphism (mtDNA RFLP) of 11 native cattle breeds and one cultivated cattle breed in South China. Twenty-three restriction morphs were detected, which can be sorted into five haplotypes, A phylogenetic tree of the haplotypes was constructed by using the 'upgma' method. Our study showed that haplotype I and II are identical to the zebu (Bos indicus) and taurine (Bos taurus) haplotypes, respectively. Zebu and taurine were the two major origins of cattle populations in South China, and the zebu probably had more influence on the native cattle population than taurine did. Haplotype III is identical to haplotype I of yak (Bos grunniens), which was only detected in the Diqing cattle breed. Haplotype IV was detected for the first time. This haplotype, found only in Dehong cattle, might be from an independent domestication event, probably from another Bos indicus population. Divergence of haplotypes I and IV occurred about 268,000-535 000 years ago, much earlier than the 10,000-year history of cattle husbandry. Our results also suggest a secondary introgression of mtDNA from yak to Diqing cattle.

Attention deficit/hyperactivity disorder children with a 7-repeat allele of the dopamine receptor D4 gene have extreme behavior but normal performance on critical neuropsychological tests of attention

An association of the dopamine receptor D4 (DRD4) gene located on chromosome 11p15.5 and attention deficit/hyperactivity disorder (ADHD) has been demonstrated and replicated by multiple investigators. A specific allele [the 7-repeat of a 48-bp variable number of tandem repeats (VNTR) in exon 3] has been proposed as an etiological factor in attentional deficits manifested in some children diagnosed with this disorder. In the current study, we evaluated ADHD subgroups defined by the presence or absence of the 7-repeat allele of the DRD4 gene, using neuropsychological tests with reaction time measures designed to probe attentional networks with neuroanatomical foci in D4-rich brain regions. Despite the same severity of symptoms on parent and teacher ratings for the ADHD subgroups, the average reaction times of the 7-present subgroup showed normal speed and variability of response whereas the average reaction times of the 7-absent subgroup showed the expected abnormalities (slow and variable responses). This was opposite the primary prediction of the study. The 7-present subgroup seemed to be free of some of the neuropsychological abnormalities thought to characterize ADHD.