Battery-Powered RF Pre-Ionization System for the Caltech Magnetohydrodynamically-Driven Jet Experiment: RF Discharge Properties and MHD-Driven Jet Dynamics

This thesis describes investigations of two classes of laboratory plasmas with rather different properties: partially ionized low pressure radiofrequency (RF) discharges, and fully ionized high density magnetohydrodynamically (MHD)-driven jets. An RF pre-ionization system was developed to enable neutral gas breakdown at lower pressures and create hotter, faster jets in the Caltech MHD-Driven Jet Experiment. The RF plasma source used a custom pulsed 3 kW 13.56 MHz RF power amplifier that was powered by AA batteries, allowing it to safely float at 4-6 kV with the cathode of the jet experiment. The argon RF discharge equilibrium and transport properties were analyzed, and novel jet dynamics were observed.

Although the RF plasma source was conceived as a wave-heated helicon source, scaling measurements and numerical modeling showed that inductive coupling was the dominant energy input mechanism. A one-dimensional time-dependent fluid model was developed to quantitatively explain the expansion of the pre-ionized plasma into the jet experiment chamber. The plasma transitioned from an ionizing phase with depressed neutral emission to a recombining phase with enhanced emission during the course of the experiment, causing fast camera images to be a poor indicator of the density distribution. Under certain conditions, the total visible and infrared brightness and the downstream ion density both increased after the RF power was turned off. The time-dependent emission patterns were used for an indirect measurement of the neutral gas pressure.

The low-mass jets formed with the aid of the pre-ionization system were extremely narrow and collimated near the electrodes, with peak density exceeding that of jets created without pre-ionization. The initial neutral gas distribution prior to plasma breakdown was found to be critical in determining the ultimate jet structure. The visible radius of the dense central jet column was several times narrower than the axial current channel radius, suggesting that the outer portion of the jet must have been force free, with the current parallel to the magnetic field. The studies of non-equilibrium flows and plasma self-organization being carried out at Caltech are relevant to astrophysical jets and fusion energy research.

超短脉冲激光光束被局域体全息光栅衍射的性质分析

利用二维耦合波理论,分析了超短脉冲激光光束被完全重叠型的局域体全息光栅衍射的时空变化性质,给出了衍射和透射脉冲激光光束沿光栅出射边界的强度时空分布。以LiNbO3晶体为例,数值研究了衍射光脉冲强度沿光栅出射边界的分布和脉冲波形的变化及光栅的总衍射效率受光栅二维尺寸、入射角度、光栅折射率调制度及入射脉冲的脉冲时域半峰全宽等条件的影响而变化的情况。与一维体全息光栅对超短脉冲激光光束衍射的性质,及此光栅对连续光衍射的性质作比较,给出了合理选择光栅参量及入射条件以在光栅出射边界上得到总衍射效率较大且分布较均匀的衍

Local thermal fixing of a photorefractive LiNbO3 hologram by use of a CO2 laser

A real-time, in situ fixing method by use of heating with a CO2 laser beam is suggested for thermal fixing of a small local hologram in the bulk of a Fe:LiNbO3 photorefractive crystal. For heating up to 100 degrees C-200 degrees C a volume with a shape similar to that of the laser beam a heat-guiding technique is developed. On the basis of the heat-transfer equations, different heating modes with or without metal absorbers for heat guiding-obtained by use of a continuous or pulsed laser beam are analyzed. The optimal mode may be pulsed heating with absorbers. On this basis experiments have been designed and demonstrated. It is seen that the fixing process with CO2 laser beam is short compared with the process by use of an oven, and the fixing efficiency is quite high. (C) 1998 Optical Society of America.

Avaliação de diferentes estratégias de biorremediação de solo argiloso contaminado por óleo em biorreator de fase semi-sólida

A prática da troca de óleo lubrificante usado, particularmente óleos automotivos, representa um grave problema ambiental em função de sua natureza perigosa, do manuseio incorreto e do descarte indiscriminado no meio ambiente. A investigação quanto à remediação de áreas contaminadas por esse resíduo torna-se necessária, particularmente para solo de natureza argilosa. O presente estudo teve por objetivo avaliar a biorremediação de um solo argiloso contaminado por óleo lubrificante utilizando biorreatores de fase semi-sólida. Frascos tipo Erlenmeyer, contendo 20 g de solo contaminado com 3% (m/m) de óleo lubrificante, em triplicata, foram mantidos em temperatura e agitação constantes, segundo as seguintes estratégias de tratamento: (i) Bioestímulo com ajuste de nutrientes (BIOE); (ii) Bioaumento com adição de inóculo microbiano aclimatado (BIOA); (iii) Bioestímulo e adição de surfactante sintético Tween-80 (BIOES); (iv) Bioaumento, bioestímulo e surfactante sintético Tween-80 (BIOAS) e (iv) controle, com água destilada purificada (CONT). A eficiência de remoção do contaminante foi avaliada após 68 dias de tratamento por análises de evolução de CO2, redução de COT, decaimento de HTP, de n-alcanos e frações de hidrocarbonetos saturados, aromáticos e compostos polares. O tratamento BIOAS resultou na maior produção de CO2 acumulada (1247,0 mg.20g-1 de solo) seguida pelo tratamento BIOES (1077,6 mg.20g-1 de solo). Ao final do experimento, todos os tratamentos reduziram significativamente os teores de HTPs quando comparados ao controle (11,14,2%). Os tratamentos BIOAS e BIOES não apresentaram diferenças significativas quanto à redução de HTPs (42,03,7% e 37,46,3%, respectivamente). Tanto o bioestímulo quanto o bioaumento mostraram-se estratégias com potencial para aumentar a eficácia da biorremediação de solos argilosos, sendo que a adição de surfactante foi o fator mais importante, tendo aumentado significativamente a capacidade de remoção em ambas as estratégias. O uso de biorreatores em fase semi-sólida na biorremediação de solo argiloso contaminado com óleo lubrificante mostrou-se bastante promissor e tal estratégia pode ser aplicada em escala imediatamente superior

Electrochromic effect in domain-inversion process LiNbO3 : Ru : Fe crystals

A reversible electrochromic effect accompanying domain-inversion during the electrical poling process in LiNbO3: Ru: Fe crystals at room temperature has been observed. In electrode area, both electrochromism and domain-inversion occur alternately, and electrochromism is also reversible during back-switch poling, which is experimentally verified and whose mechanism is briefly explained using a microstructure ferroelectric model. In addition, because of the enhancing elcctrochromic effect, different from the undoped LiNbO3 crystals, the coercive riled (21.0 kV/mm or so) measured in LiNbO3: Ru: Fe is lower than its breakdown field, thus providing a possible new technique for realizing the domain-inversion by constant electric field rather than a pulsed one.

Reversible electrochromic effect accompanying domain-inversion in LiNbO3 : Ru : Fe crystals

A reversible electrochromic effect during the electrical poling process in LiNbO3:Ru:Fe crystals at room temperature is observed. In electrode area, both electrochromism and domain-inversion occur mutually and electrochromism is reversible during back-switch poling, which are experimentally verified, and a microstructure model to explain the mechanism is proposed. In addition, different from the undoped LiNbO3 crystals, the breakdown field (> 25.0 kV/mm) is higher than the coercive (21.0 kV/mm) measured in LiNbO3:Ru:Fe, which proves a possible new technique to realize domain-inversion by constant electric field rather than pulsed one. (c) 2005 American Institute of Physics.

Excitation energies and decay properties of T = 3/2 states in ^(17)O, ^(17)F and ^(21)Na

The two lowest T = 3/2 levels in ²¹Na have been studied in the ¹⁹F(³He, n), ²⁰Ne (p,p) and ²⁰Ne (p,p’) reactions, and their excitation energies, spins, parities and widths have been determined. In a separate investigation, branching ratios were measured for the isospin-nonconserving particle decays of the lowest T = 3/2 levels in ¹⁷O and ¹⁷F to the ground state and first two excited states of ¹⁶O, by studying the ¹⁵N(³He,n) ¹⁷F*(p) ¹⁶O and ¹⁸O(³He, α)¹⁷O*(n) ¹⁶O reactions.

The ¹⁹F(³He,n) ²¹Na reaction was studied at incident energies between 4.2 and 5.9 MeV using a pulsed-beam neutron-time-of-flight spectrometer. Two T = 3/2 levels were identified at excitation energies of 8.99 ± 0.05 MeV (J > ½) and 9.22 ± 0.015 MeV (J ^π = ½⁺, Γ ˂ 40 keV). The spins and parities were determined by a comparison of the measured angular distributions with the results of DWBA calculations.

These two levels were also obsesrved as isospin-forbidden resonances in the ²⁰Ne(p,p) and ²⁰Ne(p,p’) reactions. Excitation energies were measured and spins, parities, and widths were determined from a single level dispersion theory analysis. The following results were obtained:

E_x = 8.973 ± 0.007 MeV, J ^π = 5/2 ⁺ or 3/2⁺, Γ ≤ 1.2 keV,

^Γp_o = 0.1 ± 0.05 keV; E_x = 9.217 ± 0.007 MeV, J^π = ½ ⁺,

Γ = 2.3 ± 0.5 keV, ^Γp_o = 1.1 ± 0.3 keV.

Isospin assignments were made on the basis of excitation energies, spins, parities, and widths.

Branching ratios for the isospin-nonconserving proton decays of the 11.20 MeV, T = 3/2 level in ¹⁷F were measured by the ¹⁵N(³He,n) ¹⁷ F*(p) ¹⁶O reaction to be 0.088 ± 0.016 to the ground state of ¹⁶O and 0.22 ± 0.04 to the unresolved 6.05 and 6.13 MeV levels of ¹⁶O. Branching ratios for the neutron decays of the analogous T = 3/2 level, at 11.08 MeV in ¹⁷O, were measured by the ¹⁶O(³He, α)¹⁷O*(n)¹⁶O reaction to be 0.91 ± 0.15 to the ground state of ¹⁶O and 0.05 ± 0.02 to the unresolved 6.05 and 6.13 MeV states. By comparing the ratios of reduced widths for the mirror decays, the form of the isospin impurity in the T = 3/2 levels is shown to depend on T_z.