Sparbanks-statistik ... Sparbanksinspektörens underdåniga årsberättelse, jemte öfversigt öfver sparbankernas tillstånd och förvaltning ... Compte-rendu officiel sur l'état et l'administration des caisses d'épargne de Finlande ...

Sub-title varies.

Bericht der Königl. Lehransalt für obst- nd gartenbau.

Mode of access: Internet.

Origin of the Archean Sask craton and its extent within the Trans-Hudson orogen: evidence from Pb and Nd isotopic compositions of basement rocks and post-orogenic intrusions

U-Pb zircon ages from the exposed Sask craton are 2450-3100 Ma, from the Peter Lake Domain 2575-2640 Ma, and from rocks of the Trans-Hudson orogen 1840-1880 Ma. U-Pb monazite and zircon ages of post-orogenic pegmatites and aplites are 1770-1800 Ma. Common Pb and Sm-Nd isotopic compositions of post-orogenic intrusions, as probes of crust beneath the orogen, were compared to Sask craton rocks and ca. 1850 Ma orogenic rocks to infer the origin and subsurface distribution of the Sask craton within the internides of the Trans-Hudson orogen. Results show that post-orogenic intrusions within most of the Glennie Domain and Hanson Lake block were derived, at least in part, from Archean source materials, demonstrating that the Sask craton lies beneath Paleoproterozoic orogenic rocks present at the surface. In contrast, common Pb and Sm-Nd isotopic compositions from pegmatites and aplites of the La Ronge Domain are essentially identical with those of the Paleoproterozoic orogenic rocks into which they are intruded, indicating derivation by partial melting of similar rocks. Thus, if the Sask craton extended to the west beneath the La Ronge Domain, it was beneath the zone of melting that produced the post-orogenic intrusions, making it unlikely that the Sask craton is a detached part of the Hearne craton. Many samples from the Sask craton have elevated Pb-208/Pb-204 ratios, unlike Superior craton or Hearne craton rocks, suggesting that the Sask craton was derived from an exotic source, such as the Wyoming craton, which shares similar elevated Pb-208/Pb-204 ratios.

Geochemical and Sr, Nd, Pb isotope investigation of the New Caledonia ophiolite

The New Caledonia ophiolite hosts one of the largest obducted mantle section in the world, hence providing a unique insight for the study of upper mantle processes. These mantle rocks belong to an “atypical” ophiolitic sequence, which is dominated by refractory harzburgites but it also includes minor spinel and plagioclase lherzolites. Upper crust is notably absent in the ophiolite, with the exception of some mafic-ultramafic cumulates cropping out in the southern part of the island. Although the New Caledonia ophiolite has been under investigation for decades, its ultra-depleted nature has made its characterization an analytical challenge, so that few trace element data are available, while isotopic data are completely missing. In this thesis a comprehensive geochemical study (major, trace element and Sr-Nd-Pb isotopes) of the peridotites and the associated intrusive mafic rocks from the New Caledonia ophiolite has been carried out. The peridotites are low-strain tectonites showing porphyroclastic textures. Spinel lherzolites are undepleted lithotypes, as attested by the presence of 7-8 vol% of Na2O and Al2O3-rich clinopyroxene (up to 0.5 wt% Na2O; 6.5 wt% Al2O3), Fo content of olivine (88.5-90.0 mol%) and low Cr# of spinel (13-17). Conversely, harzburgites display a refractory nature, proven by the remarkable absence of primary clinopyroxene, very high Fo content in olivine (90.9-92.9 mol%), high Mg# in orthopyroxene (89.8-94.2) and Cr# in spinel (39-71). REE contents show abyssal-type patterns for spinel lherzolites, while harzburgites display U-shaped patterns, typical of fore-arc settings. Spinel lherzolites REE compositions are consistent with relatively low degree (8-9%) of fractional melting of a DMM source, starting in the garnet stability field. Conversely, REE models for harzburgites indicate high melting degrees (20-25%) of a DMM mantle source under spinel faies conditions, consistent with hydrous melting in forearc setting. Plagioclase lherzolites exhibit melt impregnation microtextures, Cr- and TiO2-enriched spinels and REE, Ti, Y, Zr progressive increase with respect to spinel lherzolites. Impregnation models indicate that plagioclase lherzolites may derive from spinel lherzolites by entrapment of highly depleted MORB melts in the shallow oceanic lithosphere. Mafic intrusives are olivine gabbronorites with a very refractory composition, as attested by high Fo content of olivine (87.3-88.9 mol.%), very high Mg# of clinopyroxene (87.7-92.2) and extreme anorthitic content of plagioclase (An = 90-96 mol%). The high Mg#, low TiO2 concentrations in pyroxenes and the anorthitic composition of plagioclase point out an origin from ultra-depleted primitive magmas in a convergent setting. Geochemical trace element models show that the parental melts of gabbronorites are primitive magmas with striking depleted compositions, bearing only in part similarities with the primitive boninitic melts of Bonin Islands. The first Sr, Nd and Pb isotope data obtained for the New Caledonia ophiolite highlight the presence of DM mantle source variably modified by different processes. Nd-Sr-Pb isotopic ratios for the lherzolites (+6.98≤epsilon Ndi≤+10.97) indicate a DM source that suffered low-temperature hydrothermal reactions. Harzburgites are characterized by a wide variation of Sr, Nd and Pb isotopic values, extending from DM-type to EM2 compositions (-0.82≤ epsilon Ndi≤+17.55), suggesting that harzburgite source was strongly affected by subduction-related processes. Conversely, combined trace element and Sr-Nd-Pb isotopic data for gabbronorites indicate a derivation from a source with composition similar to Indian-type mantle, but affected by fluid input in subduction environment. These geochemical features point out an evolution in a pre-Eocenic marginal basin setting, possibly in the proximity of a transform fault, for the lherzolites. Conversely, the harzburgites acquired their main geochemical and isotopic fingerprint in subduction zone setting.

The effect of heat treatment on mechanical properties of pulsed Nd:YAG welded thin Ti6Al4V

Pulsed Nd:YAG has been adopted successfully in welding process of thin (0.7 mm) Ti6Al4V. Laser welding of such thin sheet requires a small focal spot, good laser beam quality and fast travel speed, since too much heat generation can cause distortion for thin sheet weld. The microstructures of Ti6Al4V were complex and strongly affected the mechanical properties. These structures include: a´ martensite, metastable ß, Widmanstätten, bimodal, lamellar and equiaxed microstructure. Bimodal and Widmanstätten structures exhibit a good-balance between strength and ductility. The microstructure of pulsed Nd:YAG welded Ti6Al4V was primarily a´ martensite, which showed the lowest ductility but not significantly high strength. A heat treatment at 950 followed by furnace cooling can transform the microstructure in the weld from a´ martensite structure into Widmanstätten structure.

Low loss depressed cladding waveguide inscribed in YAG:Nd single crystal by femtosecond laser pulses

A depressed cladding waveguide with record low loss of 0.12 dB/cm is inscribed in YAG:Nd(0.3at.%) crystal by femtosecond laser pulses with an elliptical beam waist. The waveguide is formed by a set of parallel tracks which constitute the depressed cladding. It is a key element for compact and efficient CW waveguide laser operating at 1064 nm and pumped by a multimode laser diode. Special attention is paid to mechanical stress resulting from the inscription process. Numerical calculation of mode distribution and propagation loss with the elasto-optical effect taken into account leads to the conclusion that the depressed cladding is a dominating factor in waveguide mode formation, while the mechanical stress only slightly distorts waveguide modes.

Low loss depressed cladding waveguide inscribed in YAG:Nd single crystal by femtosecond pulses

A depressed cladding waveguide with record low loss of 0.12 dB/cm is inscribed in YAG:Nd(0.3at.%). It is shown that depressed cladding is a dominating factor in waveguide formation, and mechanical stress has a minor contribution. © 2012 OSA.

Pain response in patients undergoing panretinal photocoagulation by continuos wave Nd-YAG laser

Purpose: Current panretinal laser photocoagulative parameters are based on the Diabetic Retinopathy Study, which used exposures of 0.1 - 0.5 second to achieve moderate intensity retinal burns. Unfortunately, many patients find these settings painful. We wanted to investigate whether reducing exposure time and increasing power to give the same endpoint, is more comfortable and effective. Methods: 20 patients having panretinal photocoagulation for the first time underwent random allocation to two forms of laser treatment: half of the retinal area scheduled for treatment was treated with Green Yag laser with conventional parameters {exposure time 0.1 second (treatment A), power density sufficient to produce a visible grey - white burns}. The other half treated with shorter exposure 0.02 second (treatment B). All patient were asked to evaluate severity of pain on a visual analogue scale ranging from 0 - 10 (0 = no pain, 10 = most severe pain). All patients were masked as to the type of treatment. The order of carrying out the treatment on each patient was randomised. Fundus photographs were taken of each hemifundus to confirm treatment. Results: Of the 20 patients, 17 had proliferative diabetic retinopathy, 2 had ischaemic central retinal vein occlusion and one had ocular ischaemic syndrome. The average pain response to treatment A was 5.11 on a visual analogue scale with a mean power of 0.178 Watt; the average pain response to treatment B was 1.40 with a mean power of 0.489 Watt. Short exposure laser burns were significantly less painful (P < 0.001). Conclusion: Shortening exposure time with increased power is more comfortable for patients undergoing panretinal photocoagulation than conventional parameters.

Direct laser writing of a channel waveguide in Al2O3:Nd thin film

The femtosecond laser modification of refractive index in amorphous Al2O3:Nd thin film prepared by rf magnetron sputtering is investigated. Modifications of the refractive index in a sample with a single Al2O3:Nd layer and in a sample composed of the Al2O3:Nd layer and SiO2 layer on the top were compared. Advantages arising from addition of the SiO2 layer are shown. The film was patterned in order to form an active waveguide. Waveguide loss and mode composition were investigated experimentally and theoretically. Spectrum and kinetics of luminescence in the region of 1.06 μm were measured.

Nd, Pb and Sr isotopes in sediment cores from the Gulf of Cadiz and the Portuguese margin

Mediterranean Outflow Water (MOW) is characterised by higher temperatures and salinities than other ambient water masses. MOW spreads at water depths between 500 and 1500 m in the eastern North Atlantic and has been a source of salinity for the Atlantic Meridional Overturning Circulation in the North Atlantic. We used high-resolution Nd and Pb isotope records of past ambient seawater obtained from authigenic ferromanganese coatings of sediments in three gravity cores at 577, 1745 and 1974 m water depth in the Gulf of Cadiz and along the Portuguese margin complemented by a selection of surface sediments to reconstruct the extent and pathways of MOWover the past 23 000 years. The surface and downcore Nd isotope data from all water depths exhibit only a very small variability close to the present day composition of MOW but do not reflect the present day Nd isotopic stratification of the water column as determined from a nearby open ocean hydrographic station. In contrast, the Pb isotope records show significant and systematic variations, which provide evidence for a significantly different pattern of the MOW pathways between 20 000 and 12 000 years ago compared with the subsequent period of time.