Abundance of mesozooplankton in the Cilician Basin during the Bilim 2 cruise in March 2008

The Sesame dataset contains mesozooplankton data collected during March 2008 in the Cilician Basin (between between 35.40'- 36.79 N latitude and 33.19- 36.07 E ). Mesozooplankton samples were collected by using a WP-2 closing net with 200 micron mesh size during day hours (07:00-18:00). Samples were taken in the 0-50, 50-100, 100-200 m layer at 6 stations in the Cilician Basin. The dataset includes samples analyzed for mesozooplankton species composition, abundance and total biomass (Dry weight(mg/m**3)). Taxon-specific mesozooplankton abundance: 1/2 sample or an aliquot was analyzed under the binocular microscope. Copepod species were identified and enumerated; the other mesozooplankters were identified and enumerated at higher taxonomic level (commonly named as mesozooplankton groups). Taxonomic identification was done at the METU-Institute of Marine Sciences by Tuba Terbiyik using the relevant taxonomic literatures. Mesozooplankton total abundance: 1/2 sample or an aliquot was analyzed under the binocular microscope. Copepod species were identified and enumerated; the other mesozooplankters were identified and enumerated at higher taxonomic level (commonly named as mesozooplankton groups). Taxonomic identification was done at the METU-Institute of Marine Sciences using the relevant taxonomic literatures

Micro-granulometry of sedimentary dykes, Kathmandu basin, Nepal

Soft-sediment deformation structures have been analyzed at six sites of the Kathmandu valley. Microgranulometric study (this Supplement and Fig. 3B of Mugnier et al., Tectonophysics, 2011) reveals that silty levels (60 to 80% silt) favor the development of soft-sediment deformation structures, while sandy levels (60 to 80% sand) are passively deformed. Nonetheless well sorted sand levels (more than 80% sand) generate over-fluid pressure during compaction if located beneath a silty cap, leading to fluidization and dike development. 3-D geometry of seismites indicates a very strong horizontal shearing during their development. Using a physical approach based on soil liquefaction during horizontal acceleration, we show that the fluidization zone progressively grows down-section during the shaking, but does not exactly begin at the surface. The comparison of bed-thickness and strength/depth evolution indicates three cases: i) no soft-sediment deformation occurs for thin (few centimeters) silty beds; ii) the thickness of soft-sediment deformation above sandy beds is controlled by the lithological contrast; iii) the thickness of soft-sediment deformation depends on the shaking intensity for very thick silty beds. These 3 cases are evidenced in the Kathmandu basin. We use the 30 cm-thick soft-sediment deformation level formed during the 1833 earthquake as a reference: the 1833 earthquake rupture zone extended very close to Kathmandu, inducing there MMI IX-X damages. A 90 cm-thick sediment deformation has therefore to be induced by an event greater than MMI X. From a compilation of paleo and historic seismology studies, it is found that the great (M ~ 8.1) historical earthquakes are not characteristic of the greatest earthquakes of Himalaya; hence earthquakes greater than M ~ 8.6 occurred. Kathmandu is located above one of the asperities that laterally limits the extent of mega-earthquake ruptures and two successive catastrophic events already affected Kathmandu, in 1255 located to the west of this asperity and in ~ 1100 to the east.

Composition of Fe-Mn nodules and crusts from the Cape Basin

Facies zonation of the Cape basin with respect to Fe-Mn nodules based on data from Cruise 43 of R/V Akademik Kurchatov and published data is presented. Three facies regions are distinguished: the southern end of the Walvis Ridge and seamounts, the continental slope of the Southwest Africa and the deep-water Cape Basin. Iron-manganese nodules in the first of these areas are predominantly sedimentary, those in the second area are diagenetic and those in the third are sedimentary-diagenetic. Chemical characteristics and type of metallogenic specialization for each of the regions are identified.

Chemical and isotope compositions of interstitial water in sediments from Mediterranean basin at DSDP Sites 42-372 and 42-374

The Br/Cl, Li/Cl and B/Cl ratios and boron isotope compositions of hypersaline pore fluids from DSDP Sites 372 and 374 were measured in an attempt to evaluate the origin of the brines. In Site 374 the relationships between the Cl concentrations (up to 5000 mM) and Br/Cl (~0.012), Na/Cl (as low as 0.1), B/Cl (0.0025), and d11B values (43-55?) of the deep pore water between 380 and 405 mbsf, located within the Messinian sediments, reflect remnants of ~65-fold evaporated sea water. The original evaporated sea water was modified by: (1) dilution with overlying or less saline water by about 30%; and (2) slight dissolution of NaCl evaporites. The variations in d11B show a continuous increase in d11B values with depth in Site 374, up to 66.7? at a depth of 300 mbsf (Upper Pliocene marl sediments). The conspicuous 11B enrichment trend is consistent with elemental boron depletion, which was calculated from the expected boron concentrations of evaporated sea water with corresponding Br/Cl and Na/Cl ratios. Li/Cl variations also show a depletion of Li relative to evaporated sea water. The apparent depletions of B and Li, as well as the 11B enrichment, reflect uptake of these elements by clay minerals at low water/sediment ratios.