Oxygen consumption under copper and zinc stress in Perna viridis

The rate of oxygen consumption by Perna viridis pre-exposed to copper and zinc was studied. Those test individuals pre-exposed to various zinc concentrations showed variability in oxygen consumption irrespective of concentrations and pre-exposure period. While those animals pre-exposed to various copper concentrations registered decrease in oxygen consumption at concentrations above 0.06 p.p.m. copper, pre-exposure to concentrations below 0.02 p.p.m. copper did not result in any clear cut change in the rate of oxygen consumption.

Land-based mass production of prawn (Penaeus monodon Fabricius) spawners

The first spawnings were obtained 12 days after ablation with 4 spawners yielding 784,000 eggs and a harvest of 250,000 P SUB-10 fry. Survival of females after 1 month was approximately 30%. Mortalities were mostly due to handling stress during the regular ovarian samplings as well as disease frm the accumulated excess feeds on the bottom of the tank. Male survival could not be recorded because of transfers to other tanks and addition of new stocks. Development seemed to peak 3 weeks after ablation. The average number of eggs per ablated spawner was 120,000. However, many of the partially spawned females were removed from the spawning tanks the following day so that remaining eggs released in the next 2 to 3 days could not be recorded. Estimate of the average number of eggs per ablated spawner is 120,000-150,000 in contrast to 500,000 per wild spawner. However, the low production cost more than compensates for the difference. Fry reared in the Wet Laboratory were used for experiments, mostly on feeding. Therefore, survival at harvest is not to be taken as a reflection of stock quality. Although fewer in number, larvae from ablated prawns are as healthy in terms of vigor in swimming and feeding as those from wild females. Most mortalities are due to inability to molt caused by lower water temperatures and inadequate feeding.

Mass production of Penaeus monodon Fabricius juveniles in earthen nursery ponds

Different culture techniques were tried for rearing larvae of Penaeus monodon, in order to obtain preliminary data on stocking density, water management, fertilization versus feeding and effect of different types of vertical substrate. The results of the experiments showed that: (1) older fry have greater chances of survival; (2) the traditional nursery pond designs and practices used for milkfish in the Philippines are applicable to prawn only at very low densities and give acceptable high survival rates only when used with the older postlarval stage.

Effect of temperature on the oxygen consumption of Penaeus monodon postlarvae

The study aimed to determine the oxygen consumption of P. monodon postlarvae at different temperatures. Results suggest dependence of oxygen consumption on both weight of postlarvae and temperature. The relationships appear linear at the temperature range examined. Temperature dependence of oxygen consumption suggests that oxygen requirement (and metabolism) increases with temperature.

Feasibility study of biofuel production from freshwater fern, Azolla sp in Anzali Wetland

Production of bioethanol through acidic and enzymatic hydrolysis of aquatic Azolla sp., as a new source of bio-mass, has been performed, as a means to control increasing growth and reducing undesirable effects of this plant in Anzali lagoon. After sampling, drying and crushing, Azolla was hydrolyzed, using diluted acid and enzyme. Diluted acid hydrolysis was done using both autoclave and a high-pressure system (Batch Synth® Microwave synthesizer). The effects of temperature and time (in autoclave) and concentration of acid (in both) were compared. Cellubrix®, a ommercial cellulase source, was used for enzymatic hydrolysis process. The amounts of reducing sugars, glucose and furfural, released from hydrolyzate, were measured. To produce alcohol, Sacchromyces cerevisiae (to ferment sixcarbon sugars), Zygowilliopsis californica and Pichia stipitis (to ferment five-carbon and sixcarbon sugars) were used. Maximum amounts of glucose (4.83% w/w) and reducing sugars (14.15% w/w) were obtained using acid hydrolysis in autoclave. In the microwave oven, maximum glucose (5.04% w/w) and reducing sugars (13.27 w/w) were obtained at 180 and 200 °C, respectively. Under these conditions, maximum produced furfural was 1.54 g/L. The difference between amounts of furfural obtained from acid hydrolysis of Azolla in microwave oven compared to autoclave was statistically significant. Amounts of alcohol produced and its yields were 3.99 g/L and 33.13% for S. cerevisiae in 48 hours, 3.73 g/L and 30.45% for Pichia stipites in 48 hours, and 3.73 g/L and 30.45% for Z. californica in 24 hours after inoculation, respectively, with significant differences. Statistical comparison of results showed significant differences (P<0.05) in glucose production, at different conditions. Amounts of reducing sugars and glucose increased after optimization of levels of acid, time, and temperature. The overall optimum released sugar and glucose were obtained with 1.67% (w/v) acid using autoclave. Higher temperatures in microwave oven caused a significant increase (P<0.05) in furfural. Furfural severely inhibits fermentation. Hence, regarding the issues of energy consumption and time, amounts of inhibiting substances and sugar production, autoclave is found to be superior to the high temperature and pressure, generated in microwave oven, for hydrolyzing Azolla. Furthermore, given the amounts of Azolla in Anzali lagoon, it may be recommendable to use this plant as a biomass resource.

Mass culture of marine diatom Skeletonema costatum (Greville) Cleve collected from the Bay of Bengal

The growth of Skeletonema costatum in two artificial nutrient media was studied using various culture vessels. Skeletonema costatum was collected from the Cox's Bazar coast around the Bay of Bengal. Different growths stages i.e. lag phase, exponential phase, prestationary phase, stationary and death phase were observed during the culture period. The number of cells increased during the active division period and decreased after the beginning of the prestationary phase. The average densities of S. costatum in primary and secondary cultures were 0.55 x 10 super(6) cells mlˉ¹ and 0.93x10 super(6) cells mlˉ¹, respectively. In mass culture of S. costatum two, types of media were used. Highest cells densities of S. costatum cement tank culture were recorded 1.23x10 super(6) cell mlˉ¹ and 0.78x10 super(6) cells mlˉ¹ in their respective f/4 medium and commercial fertilizer medium. In the cement tanks culture fertilizer medium was found to be the best medium for mass culture of S. costatum in respect of production efficiency and culture stability.

Indigenous traditional technical knowledge of disease cure and prevention through fish consumption

Our knowledge regarding ethno-medico zoology is scanty and scattered. The present work is an endeavour to collect information on indigenous traditional knowledge (ITK) of disease cure through fish consumption, prepare a consolidated report on this aspect and to document our ITK so that in the long run after due verification (by Medical experts), such ITK can be patented. We also suggest for the recognition of the age old tribal medicine and establishment of a national research institute for tribal medicines at suitable place for the welfare of all the human beings.

Ecological limits of high-density milkfish farming

In the Philippines at present, milkfish farming in ponds includes a wide range of intensities, systems and practices. To make aquaculture possible, ecosystems are used as sources of energy and resources and as sinks for wastes. The growth of aquaculture is limited by the life-support functions of the ecosystem, and sustainability depends on matching the farming techniques with the processes and functions of the ecosystems, for example, by recycling some degraded resources. The fish farm has many interactions with the external environment. Serious environmental problems may be avoided if high-intensity farms are properly planned in the first place, at the farm level and at the level of the coastal zone where it can be integrated with other uses by other sectors. It is believed that the key to immediate success in the mass production of milkfish for local consumption and for export of value-added forms may be in semi-intensive farming at target yields of 3 tons per ha per year, double the current national average. Intensive milkfish farming will be limited by environmental, resource and market constraints. Integrated intensive farming systems are the appropriate long-term response to the triple needs of the next century: more food, more income, and more jobs for more people, all from less land, less resources, and less non-renewable energy.

Building more sustainable solutions in production-consumption systems: the case of food for people with reduced access

In new product development, the ability to integrate different dimensions of sustainability at a value chain level is still a complex, problematic goal. As product-service approaches are increasingly enabling the introduction of more sustainable paths, this paper describes the authors' experience thus far when building insights into conditions for the implementation of integrated solutions in a process of co-development and testing in real life conditions, which are driven by a social need focusing on food for people with reduced access. Throughout this process, which brought together producers, consumers and other stakeholders to design and test industrialised, sustainable solutions, empirical evidence demonstrates feasibility and usefulness of the approach and insight into the conditions for implementing interactive, comprehensive multi-stakeholder processes in real life situations. In addition, results show that the delivery of innovative solutions enabled to offer social added value, economic profits and environmental improvements under specific experimental conditions. © 2006 Elsevier Ltd. All rights reserved.

Mass rearing of Aphidius gifuensis (Hymenoptera : Aphidiidae) for biological control of Myzus persicae (Homoptera : Aphididae)

The green peach aphid, Myzus persicae, is a major pest of tobacco, Nicotiana tabacum, in Yunnan province, China, where its control still depends on the use of insecticides. In recent years, the local government and farmers have sought to improve the biological control of this tobacco pest. In this paper, we present methods for mass rearing Aphidius gifuensis, a dominant endoparasitoid of M. persicae on tobacco plants in this region. The tobacco cultivar K326 (N. tabacum) was used as the host plant and M. persicae as the host insect. In the greenhouse, we collected tobacco seedlings for about 35 days (i.e., until the six-true-leaf stage), transferred them to 7.5-cm diameter pots, and kept these plants in the greenhouse for another 18 days. These pots were then transferred to an insectary-greenhouse, where the tobacco seedlings were inoculated with five to seven wingless adult M. persicae per pot. After 3 days, the infested seedlings were moved to a second greenhouse to allow the aphid population to increase, and after an additional 4 +/- 1 days when 182 +/- 4.25 aphid adults and nymphs were produced per pot, they were inoculated with A. gifuensis. With this rearing system, we were able to produce 256 +/- 8.8 aphid mummies per pot, with an emergence rate of 95.6 +/- 2.45%; 69% were females. The daily cost of parasite production (recurring costs only) was US$ 0.06 per 1000 aphid mummies. With this technique, we released 109 800 parasitoids in 1998, 196 000 in 1999, 780 000 in 2000, and 5 600 000 in 2001 during a 2-month period each year This production method is discussed with respect to countrywide usage in biological control and integrated control of M. persicae.