Measurements of triggering and transient growth in a model lean-premixed gas turbine combustor

Instability triggering and transient growth of thermoacoustic oscillations were experimentally investigated in combination with linear/nonlinear flame transfer function (FTF) methodology in a model lean-premixed gas turbine combustor operated with CH 4 and air at atmospheric pressure. A fully premixed flame with 10kW thermal power and an equivalence ratio of 0.60 was chosen for detailed characterization of the nonlinear transient behaviors. Flame transfer functions were experimentally determined by simultaneous measurements of inlet velocity fluctuations and heat release rate oscillations using a constant temperature anemometer and OH */CH * chemiluminescence emissions, respectively. The phase-resolved variation of the local flame structure at a limit cycle was measured by planar laser-induced fluorescence of OH. Simultaneous measurements of inlet velocity, OH */CH * emission, and acoustic pressure were performed to investigate the temporal evolution of the system from a stable to a limit cycle operation. This measurement allows us to describe an unsteady instability triggering event in terms of several distinct stages: (i) initiation of a small perturbation, (ii) exponential amplification, (iii) saturation, (iv) nonlinear evolution of the perturbations towards a new unstable periodic state, (v) quasi-steady low-amplitude periodic oscillation, and (vi) fully-developed high-amplitude limit cycle oscillation. Phase-plane portraits of instantaneous inlet velocity and heat release rate clearly show the presence of two different attractors. Depending on its initial position in phase space at infinitesimally small amplitude, the system evolves towards either a high-amplitude oscillatory state or a low-amplitude oscillatory state. This transient phenomenon was analyzed using frequency- and amplitude-dependent damping mechanisms, and compared to subcritical and supercritical bifurcation theories. The results presented in this paper experimentally demonstrate the hypothesis proposed by Preetham et al. based on analytical and computational solutions of the nonlinear G-equation [J. Propul. Power 24 (2008) 1390-1402]. Good quantitative agreement was obtained between measurements and predictions in terms of the conditions for the onset of triggering and the amplitude of triggered combustion instabilities. © 2011 The Combustion Institute.

The effect of remodelling and contractility of the actin cytoskeleton on the shear resistance of single cells: a computational and experimental investigation.

The biomechanisms that govern the response of chondrocytes to mechanical stimuli are poorly understood. In this study, a series of in vitro tests are performed, in which single chondrocytes are subjected to shear deformation by a horizontally moving probe. Dramatically different probe force-indentation curves are obtained for untreated cells and for cells in which the actin cytoskeleton has been disrupted. Untreated cells exhibit a rapid increase in force upon probe contact followed by yielding behaviour. Cells in which the contractile actin cytoskeleton was removed exhibit a linear force-indentation response. In order to investigate the mechanisms underlying this behaviour, a three-dimensional active modelling framework incorporating stress fibre (SF) remodelling and contractility is used to simulate the in vitro tests. Simulations reveal that the characteristic force-indentation curve observed for untreated chondrocytes occurs as a result of two factors: (i) yielding of SFs due to stretching of the cytoplasm near the probe and (ii) dissociation of SFs due to reduced cytoplasm tension at the front of the cell. In contrast, a passive hyperelastic model predicts a linear force-indentation curve similar to that observed for cells in which the actin cytoskeleton has been disrupted. This combined modelling-experimental study offers a novel insight into the role of the active contractility and remodelling of the actin cytoskeleton in the response of chondrocytes to mechanical loading.

Comparison of Civil Infrastructure Optical-based Spatial Data Acquisition Techniques

Infrastructure spatial data, such as the orientation and the location of in place structures and these structures' boundaries and areas, play a very important role for many civil infrastructure development and rehabilitation applications, such as defect detection, site planning, on-site safety assistance and others. In order to acquire these data, a number of modern optical-based spatial data acquisition techniques can be used. These techniques are based on stereo vision, optics, time of flight, etc., and have distinct characteristics, benefits and limitations. The main purpose of this paper is to compare these infrastructure optical-based spatial data acquisition techniques based on civil infrastructure application requirements. In order to achieve this goal, the benefits and limitations of these techniques were identified. Subsequently, these techniques were compared according to applications' requirements, such as spatial accuracy, the automation of acquisition, the portability of devices and others. With the help of this comparison, unique characteristics of these techniques were identified so that practitioners will be able to select an appropriate technique for their own applications.

Demonstration of Improved Passive UHF RFID Coverage using Optically-Fed Distributed Multi-Antenna System

Optically-fed distributed antenna system (DAS) technology is combined with passive ultra high frequency (UHF) radio frequency identification (RFID). It is shown that RFID signals can be carried on directly modulated radio over fiber links without impacting their performance. It is also shown that a multi-antenna DAS can greatly reduce the number of nulls experienced by RFID in a complex radio environment, increasing the likelihood of successful tag detection. Consequently, optimization of the DAS reduces nulls further. We demonstrate RFID tag reading using a three antenna DAS system over a 20mx6m area, limited by building constraints, where 100% of the test points can be successfully read. The detected signal strength from the tag is also observed to increase by an average of approximately 10dB compared with a conventional switched multi-antenna RFID system. This improvement is achieved at +31dBm equivalent isotropically radiated power (EIRP) from all three antenna units (AUs).

Molecular characteristics of Camallanus spp. (Spirurida : Camallanidae) in fishes from China based on its rDNA sequences

In the,paper, we explored the intra- and interspecific evolutionary variation among species of Camallanus collected from different fish species in various regions of China. We determined the internal transcribed spacers of ribosomal DNA (ITS rDNA) sequences of these nematodes. The divergence (uncorrected p-distance) of ITS 1, ITS2, and ITS rDNA data sets confirmed 2 valid species of Camallanus in China, i.e., C. cotti and C. hypophthalmichthys. The 2 species were distinguished not only by their different morphologies and host ranges but also by a letranucleotide microsatellite (TTGC)n present in the ITS I region of C cotti. Phylogenetic analyses of the nematodes disclosed 2 main clades, corresponding to different individuals of C cotti and C. hypophthalmichthys from different fish species in various geographical locations, although the interior nodes of each clade received poor support.

Effects of iron on growth, pigment content, photosystem II efficiency, and siderophores production of Microcystis aeruginosa and Microcystis wesenbergii

Changes in growth, photosynthetic pigments, and photosystem II (PS II) photochemical efficiency as well as production of siderophores of Microcystis aeruginosa and Microcystis wesenbergii were determined in this experiment. Results showed growths of M. aeruginosa and M. wesenbergii, measured by means of optical density at 665 nm, were severely inhibited under an iron-limited condition, whereas they thrived under an iron-replete condition. The contents of chlorophyll-a, carotenoid, phycocyanin, and allophycocyanin under an iron-limited condition were lower than those under an iron-replete condition, and they all reached maximal contents on day 4 under the iron-limited condition. PS II photochemical efficiencies (maximal PS II quantum yield), saturating light levels (I-k ) and maximal electron transport rates (ETRmax) of M. aeruginosa and M. wesenbergii declined sharply under the iron-limited condition. The PS II photochemical efficiency and ETRmax of M. aeruginosa rose , whereas in the strain of M. wesenbergii, they declined gradually under the iron-replete condition. In addition, I-k of M. aeruginosa and M. wesenbergii under the iron-replete condition did not change obviously. Siderophore production of M. aeruginosa was higher than that of M. wesenbergii under the iron-limited condition. It was concluded that M. aeruginosa requires higher iron concentration for physiological and biochemical processes compared with M. wesenbergii, but its tolerance against too high a concentration of iron is weaker than M. wesenbergii.

Effect of cycles of feed deprivation on growth and food consumption of immature three-spined sticklebacks and European minnows

Individual juvenile three-spined sticklebacks Gasterosteus aculeatus and European minnow Phoxinus phoxinus, from sympatric populations, were subjected to four cycles of I week of food deprivation and 2 weeks of ad libitum feeding. Mean specific growth rate during the weeks of deprivation was negative and did not differ between species. The three-spined stickleback showed sufficient growth compensation to recover to the growth trajectory shown by control fish daily fed ad libitum. The compensation was generated by hyperphagia during the re-feeding periods, and in the last two periods of re-feeding, the gross growth efficiencies of deprived three-spined sticklebacks were greater than in control fish. The expression of the compensatory changes in growth and food consumption became clearer over the successive periods of re-feeding. The European minnow developed only a weak compensatory growth response and the mass trajectory of the deprived fish deviated more and more from the control trajectory During re-feeding periods, there were no significant differences in food consumption or gross growth efficiency between control and deprived European minnows. The differences between the two species are discussed in terms of the possible costs of compensatory growth, the control of growth and differences in feeding biology (C) 2003 The Fisheries Society of the British Isles.

Long-term changes of planktonic rotifers in a subtropical Chinese lake dominated by filter-feeding fishes

1. The long-term changes (1956-1998) in density and species composition of planktonic rotifers were studied at two sampling stations (I, II) of Lake Donghu, a shallow eutrophic Chinese Lake densely stocked with filter-feeding fishes. Annual average densities of rotifers increased with an increase in fish yield and eutrophication, whilst species number decreased from 82 in 1962-1963 to 62 in 1994-1998. 2. During 1962-98, some species such as Anuraeopsis fissa, Polyarthra spp. (including P. dolichoptera & P. vulgaris), Trichocerca pusilla and Synchaeta oblonga increased their percentage in abundance remarkably, whilst the proportion of Keratella cochlearis decreased at two relatively eutrophic stations from 19 to 4.2% at Station I and from 30 to 3.2% at Station IL 3. The high r(max) of A. fissa probably made it more successful than other rotifers under high predation pressure by planktivorous fish. The decrease in the K. cochlearis population might be attributed partly to predation by Cyclops vicinus. 4. Small rotifers were less vulnerable to fish predation than large-sized cladocerans. Decreases in cladocerans coincided with increases in rotifers, suggesting that the indirect effect of fish predation on cladocerans might have partly contributed to the population development of rotifers in Lake Donghu during recent decades. 5. We also conducted surveys (1994-1998) of seasonal dynamics of rotifers at four sampling stations (I-IV) which have varied in trophic status after fragmentation of the lake in the 1960s. A total of 75 species were identified at the four stations. Both densities and biomass of rotifers were considerably higher in the two more eutrophic stations than in the two less eutrophic stations. This indicates that the population increase of rotifers at Stations I and II during recent decades might be partly attributed to eutrophication of the lake water.

Photoluminescence studies of type-II self-assembled InAlAs/AlGaAs QDs grown on (311)A GaAs substrate

The photoluminescence (PL) spectra of self-assembled In0.55Al0.45As/Al0.45Ga0.5As quantum dots (QD) grown on (311)A GaAs substrate were measured. The type- I character of PL related to the X valley was verified by excitation power dependence of peak position and the PL spectra under different pressure , which was attributed to the type- II transition from X valley in Al0.5Ga0.5As to heavy holes in In0.55Al0.45As The high energy Gamma -related transition was also observed above 70K and assigned as the transition between Gamma valley and heavy holes in In-0.55 Al0.45As. The X-valley split was discussed to interpret the observed second X-related peak under pressure.

咪唑衍生物为配体的铜(I)配合物合成及光物理性质

本论文以咪唑衍生物为配体,合成了新型Cu(I)中性配合物和对应的离子型配合物，考察了它们的光物理和电化学性质。具体工作如下： 设计与合成了分别以2-(2'-吡啶基)苯并咪唑(Hpbm)和2-(2'-喹啉基)苯并咪唑(Hqbm)为配体的Cu(I)中性配合物和四氟硼酸根为抗衡离子的离子型配合物。配合物的晶体结构表明中心铜离子均为扭曲的四面体配位构型，中性配合物的咪唑环中的键长趋于平均化。所有配合物在20wt%浓度的PMMA薄膜中的最大发射处于518.5-597.5nm之间，发光效率为0.097-0.249, 磷光寿命为11.7-25.9µs。中性配合物与对应的离子型配合物相比，其紫外可见吸收光谱发生红移，光致发光光谱发生蓝移。 以2, 2'-联苯并咪唑为配体(H2dbm)，设计和合成了双核和单核Cu(I)配合物，其中双核配合物Cu2(dbm)(PPh3)4在二氯甲烷溶液和PMMA (20 wt%)薄膜中均表现为蓝光发射，在20wt%浓度的PMMA薄膜中的最大发射为448.5和475.5nm。单核离子型配合物[Cu(Hdbm)(PPh3)]2[BF4]在20wt%浓度的PMMA薄膜中的最大发射分别为511，发光效率分别为0.150, 磷光寿命分别为12.0。

Experimental Study on the Subthreshold Swing of Silicon Nanowire Transistors

SOI based wrap-gate silicon nanowire FETs are fabricated through electron beam lithography and wet etching. Dry thermal oxidation is used to further reduce the patterned fins cross section and transfer them into nanowires. Silicon nanowire FETs with different nanowire widths varying from 60 nm to 200 nm are fabricated and the number of the nanowires contained in a channel is also varied. The on-current (I-ON) and off-current (I-OFF) of the fabricated silicon nanowire FET are 0.59 mu A and 0.19 nA respectively. The subthreshold swing (SS) and the drain induced barrier lowering are 580 mV/dec and 149 mVN respectively due to the 30 nm thick gate oxide and 1015 cm(-3) lightly doped silicon nanowire channel. The nanowire width dependence of SS is shown and attributed to the fact that the side-gate parts of a wrap gate play a more effectual role as the nanowires in a channel get narrower. It seems the nanowire number in a channel has no effect on SS because the side-gate parts fill in the space between two adjacent nanowires.