Simulation of a-Si PV system grid connected by boost and inverter

This paper is about a PV system connected to the electric grid by power electronic converters, using classical PI controller. The modelling for the converters emulates the association of a DC-DC boost with a two-level power inverter (TwLI) or three-level power inverter (ThLI) in order to follow the performance of a testing experimental system. Pulse width modulation (PWMo) by sliding mode control (SMCo) associated with space vector modulation (SVMo) is applied to the boost and the inverter. The PV system is described by the five parameters equivalent circuit. Parameter identification and simulation studies are performed for comparison with the testing experimental system.

PV systems linked to the grid: parameter identification with a heuristic procedure

This paper focuses on a PV system linked to the electric grid by power electronic converters, identification of the five parameters modeling for photovoltaic systems and the assessment of the shading effect. Normally, the technical information for photovoltaic panels is too restricted to identify the five parameters. An undemanding heuristic method is used to find the five parameters for photovoltaic systems, requiring only the open circuit, maximum power, and short circuit data. The I- V and the P- V curves for a monocrystalline, polycrystalline and amorphous photovoltaic systems are computed from the parameters identification and validated by comparison with experimental ones. Also, the I- V and the P- V curves under the effect of partial shading are obtained from those parameters. The modeling for the converters emulates the association of a DC-DC boost with a two-level power inverter in order to follow the performance of a testing commercial inverter employed on an experimental system. © 2015 Elsevier Ltd.

Numerical and Experimental Analysis of Balanced and Unbalanced Adhesive Single-Lap Joints between Aluminium Adherends

The single-lap joint is the most commonly used, although it endures significant bending due to the non-collinear load path, which negatively affects its load bearing capabilities. The use of material or geometric changes is widely documented in the literature to reduce this handicap, acting by reduction of peel and shear peak stresses or alterations of the failure mechanism emerging from local modifications. In this work, the effect of using different thickness adherends on the tensile strength of single-lap joints, bonded with a ductile and brittle adhesive, was numerically and experimentally evaluated. The joints were tested under tension for different combinations of adherend thickness. The effect of the adherends thickness mismatch on the stress distributions was also investigated by Finite Elements (FE), which explained the experimental results and the strength prediction of the joints. The numerical study was made by FE and Cohesive Zone Modelling (CZM), which allowed characterizing the entire fracture process. For this purpose, a FE analysis was performed in ABAQUS® considering geometric non-linearities. In the end, a detailed comparative evaluation of unbalanced joints, commonly used in engineering applications, is presented to give an understanding on how modifications in the bonded structures thickness can influence the joint performance.

Análise experimental de um murete de alvenaria de pedra tradicional reforçado com confinamento transversal contínuo por fitas metálicas

Dissertação apresentada para obtenção do grau de Mestre em Engenharia Civil, Perfil de Construção, pela Faculdade de Ciências e Tecnologias da Universidade Nova de Lisboa

Study in real conditions and in laboratory of the application of expanded agglomerated cork as exterior wall covering

The interest of the study on the implementation of expanded agglomerated cork as exterior wall covering derives from two critical factors in a perspective of sustainable development: the use of a product consisting of a renewable natural material-cork-and the concern to contribute to greater sustainability in construction. The study aims to assess the feasibility of its use by analyzing the corresponding behaviour under different conditions. Since this application is relatively recent, only about ten years old, there is still much to learn about the reliability of its long-term properties. In this context, this study aims to deepen and approach aspects, some of them poorly studied and even unknown, that deal with characteristics that will make the agglomerate a good choice for exterior wall covering. The analysis of these and other characteristics is being performed by testing both under actual exposure conditions, on an experimental cell at LNEC, and on laboratory. In this paper the main laboratory tests are presented and the obtained results are compared with the outcome of the field study. © (2015) Trans Tech Publications, Switzerland.

The effect of chronic ingestion of ethanol on modulation of granulomatous inflammation in experimental schistosomiasis in mice

We studied the role of ethanol on the modulation of liver granulomata around Schistosoma mansoni eggs in mice. Albino mice, receiving 7% ethanol as the sole drinking liquid, at 60 and 90 days post-infection, presented smaller granulomata than controls did, when sacrificed at 120 days post-infection. No differences in diameters could be observed, when ethanol was given 4 months before up to 120 days after infection. The results suggested that modulation of schistosome granulomata by ethanol ingestion varies with time and duration of drug consumption.

A critical evaluation of the expression of parasitemia in experimental Chagas' disease

This paper aims to study the best way to express the parasitemia of Trypanosoma cruzi's experimentally infected animals. Individual scores may have a great variability, not emphasized by the majority of the authors. A group of 50 rats infected with 1x10(6) trypomastigotes of T. cruzi Y strain was used and the parasitemia was estimated by BRENER' s method. The results showed that the median can avoid false results due to very high or low parasitemias but it does not have the mathematic properties necessary for analysis of variance. The comparison of the means of the original and transformed data, with their respective coefficients of variability (CV), showed that the logarithmic mean (Mlog) have the minor value of CV. Therefore, the Mlog is the best way to express the parasitemia when the data show great variability. The number of the animal for group did not affect the variability of data when the Mlog and CV were used.

Experimental pulmonary schistosomiasis: lack of morphological evidence of modulation in schistosomal pulmonary granulomas

Numerous pulmonary schistosome egg granulomas were present in mice submitted to partial portal vein ligation (Warren's model). The granulomas were characterized by cellular aggregations formed within alveolar tissue. Main cellular types were macrophages (epithelioid cells), eosinophils, plasma cells and lymphocytes. These cells were supported by scanty fibrous stroma and exhibited close membrane contact points amongst themselves, but without forming specialized adhesion apparatus. When granulomas involved arterial structures, proliferation of cndothelial and smooth muscle cells occurred and fibrosis associated with angiogenesis became more evident. Granulomas formed around mature eggs in the pulmonary alveolar tissue presented approximately the same size and morphology regardless of the time of infection, the latter being 10, 18 and 25 weeks after cercarial exposure. This persistence of morphological appearance suggests that pulmonary granulomas do not undergo immunological modulation, as is the case with the granulomas in the liver and, to a lesser extent, in the intestines. Probably, besides general immunological factors, local (stromal) factors play an important role in schistosomal granuloma modulation.

Immunomodulatory effect of glucan on the response to experimental antirabies vaccination

The objective of lhe present study was to determine the stimulatory response to antirabies vaccination promoted by glucan in mice. Glucan increased both resistance to infection and antibody titres and this effect was more evident when glucan was used at dose of 0.5 mg, administered intraperitoneally before, during and after immunization and when the challenge virus was applied to the foot-pad.

Experimental dam-break waves profile analysis: horizontal mobile bed

River Flow, Vol. 2

Solubilities of C‑Tetraalkylcalix[4]resorcinarenes in SCCO2: experimental measurements, characterization, and correlation

The solubilities of two C-tetraalkylcalix[4]resorcinarenes, namely C-tetramethylcalix[4]resorcinarene and C-tetrapentylcalix[4]resorcinarene, in supercritical carbon dioxide (SCCO2) were measured in a flow-type apparatus at a temperature range from (313.2 to 333.2) K and at pressures from (12.0 to 35.0) MPa. The C-tetraalkylcalix[4]resorcinarenes were synthesized applying our optimized procedure and fully characterized by means of gel permeation chromatography, infrared and nuclear magnetic resonance spectroscopy. The solubilities of the C-tetraalkylcalix[4]resorcinarenes in SCCO2 were determined by analysis of the extracts obtained by HPLC with ultraviolet (UV) detection methodology adapted by our team. Four semiempirical density-based models, and the SoaveRedlichKwong cubic equation of state (SRK CEoS) with classical mixing rules, were applied to correlate the solubility of the calix[4]resorcinarenes in the SC CO2. The physical properties required for the modeling were estimated and reported.

Ineficácia do antiveneno botrópico na neutralização da atividade coagulante do veneno de Lachesis muta muta: relato de caso e comprovação experimental

No Estado do Amazonas, nas regiões circunvizinhas à cidade de Manaus, as principais espécies de serpentes causadoras de acidentes são Bothrops atrox e Lachesis muta muta com um percentual de ocorrência, dos acidentes confirmados, de 76% e 17%, respectivamente. Rotineiramente, na ausência dos soros antilaquético e antibotrópico-laquético o Instituto de Medicina Tropical de Manaus (IMTM), utiliza-se do soro antibotrópico no tratamento do acidente laquético. Neste trabalho relatamos um caso de acidente por L m. muta, onde o paciente foi tratado com 20 ampolas do soro antibotrópico e permaneceu com o sangue incoagulável até o 13º dia após o acidente. Experimentos foram realizados para obtenção das potências do soro antibotrópico para as atividades coagulante e hemorrágica dos venenos de L. m. muta e de B. atrox. Os resultados mostram que as potências do soro para a atividade hemorrágica dos venenos de L. m. muta e de B. atrox foram similares enquanto que a potência, para a atividade coagulante do veneno de L. m. muta, foi 9,2 vezes menor. Os títulos de anticorpos de três diferentes lotes de soro antibotrópico variaram para o veneno de L. m. muta e foram constantes para o veneno de B. atrox. Devido a ineficácia do soro antibotrópico em neutralizar, principalmente, a atividade coagulante do veneno de L. m. muta, sugerimos a não utilização do antibotrópico no tratamento dos acidentes por L. m. muta.

Railway vehicle modelling for the vehicle-track interaction compatibility analysis

Railway vehicle homologation, with respect to running dynamics, is addressed via dedicated norms. The results required, such as, accelerations and/or wheel-rail contact forces, obtained from experimental tests or simulations, must be available. Multibody dynamics allows the modelling of railway vehicles and their representation in real operations conditions, being the realism of the multibody models greatly influenced by the modelling assumptions. In this paper, two alternative multibody models of the Light Rail Vehicle 2000 (LRV) are constructed and simulated in a realistic railway track scenarios. The vehicle-track interaction compatibility analysis consists of two stages: the use of the simplified method described in the norm "UIC 518-Testing and Approval of Railway Vehicles from the Point of View of their Dynamic Behaviour-Safety-Track Fatigue-Running Behaviour" for decision making; and, visualization inspection of the vehicle motion with respect to the track via dedicated tools for understanding the mechanisms involved.

Estimation of rotational frequency response functions

As it is widely known, in structural dynamic applications, ranging from structural coupling to model updating, the incompatibility between measured and simulated data is inevitable, due to the problem of coordinate incompleteness. Usually, the experimental data from conventional vibration testing is collected at a few translational degrees of freedom (DOF) due to applied forces, using hammer or shaker exciters, over a limited frequency range. Hence, one can only measure a portion of the receptance matrix, few columns, related to the forced DOFs, and rows, related to the measured DOFs. In contrast, by finite element modeling, one can obtain a full data set, both in terms of DOFs and identified modes. Over the years, several model reduction techniques have been proposed, as well as data expansion ones. However, the latter are significantly fewer and the demand for efficient techniques is still an issue. In this work, one proposes a technique for expanding measured frequency response functions (FRF) over the entire set of DOFs. This technique is based upon a modified Kidder's method and the principle of reciprocity, and it avoids the need for modal identification, as it uses the measured FRFs directly. In order to illustrate the performance of the proposed technique, a set of simulated experimental translational FRFs is taken as reference to estimate rotational FRFs, including those that are due to applied moments.

Experimental paracoccidioidomycosis in hamster: transmission electron microscopy of inoculation site lesion

Interaction between Paracoccidioides brasiliensis (Pb) and inflammatory cells in hamster testis was studied sequentially by transmission electron microscopy. In early lesions (six hours after inoculation), polymorphonuclear neutrophils (PMNs) were the major and mononuclear cells and eosinophils were the minor constituents of the inflammatory cells. PMNs were later replaced by mononuclear cells. Viable Pb cells were phagocytosed or surrounded by inflammatory cells. Preserved Pb cells usually had broad host-parasite interphases, whereas dying ones had narrow interphases. The outer layer of the fungus wall was sometimes broken by PMN in some focal points, broken pieces being peeled off and phagocytosed. Small Pb cells were uninuclear, and were often related to broad interphase. Large Pb cells were multinucleated with irregularly shaped wall, and sometimes had lomasome and/or myelin like structures. Different interaction patterns of Pb with inflammatory cells may be due to functionally different host cell flow to the inoculation site or due to the age of Pb cells or both.