Zn~(2+)、Co~(2+)和Mn~(2+)对人工湿地基质生物膜的影响

研究了金属离子Zn2+,Co2+和Mn2+对复合垂直流人工湿地基质生物膜脱氢酶活性和多糖含量的影响.结果表明,在生物膜混合液中添加Zn2+能在短时间内(6h)迅速提高生物膜的酶活性,增加多糖含量,浓度为2mg/L的Zn2+可以在较长时间(72h)内保持生物膜的酶活性并且促进多糖的积累.Co2+和Mn2+对生物膜脱氢酶活性及多糖含量的影响较为相似.当Co2+浓度<1mg/L、Mn2+浓度<2mg/L条件下,6h时,对脱氢酶活性呈现了不同程度的促进作用,但随着Co2+和Mn2+离子浓度的增加,对脱氢酶活性的影

鲫鱼干扰素调节因子1功能初步研究

将鲫鱼IRF1基因的ORF与真核表达质粒pcDNA3.1(+)相连,构建了真核重组表达载体,转染并通过G418筛选获得了稳定转染IRF1基因的细胞株。同时利用原核表达系统成功获得了包含鲫鱼IRF1 C端165个氨基酸的多肽,制备了抗鲫鱼IRF1的多克隆抗体。进一步从RNA和蛋白水平证明,在稳定转染IRF1基因的细胞株中IRF1能够组成型的过量表达,并且IRF1的过量表达伴随IFN基因的表达水平增强。同时PolyI:C的诱导能使稳定表达IRF1的细胞中干扰素系统基因STAT1和IFI58的表达显著增强。研究

FPGA, physics-based modeling of IGBT and pin diode for hardware co-simulation of complex power electronic converters and systems

This paper presents the steps and the challenges for implementing analytical, physics-based models for the insulated gate bipolar transistor (IGBT) and the PIN diode in hardware and more specifically in field programmable gate arrays (FPGAs). The models can be utilised in hardware co-simulation of complex power electronic converters and entire power systems in order to reduce the simulation time without compromising the accuracy of results. Such a co-simulation allows reliable prediction of the system's performance as well as accurate investigation of the power devices' behaviour during operation. Ultimately, this will allow application-specific optimisation of the devices' structure, circuit topologies as well as enhancement of the control and/or protection schemes.

Pb~(2+)胁迫对绿球藻(Chlorococcum sp.)的影响研究

研究了不同Pb2+浓度(0.1、1、10、50、100、200、400 mg/L)处理对绿球藻(Chlorococcum sp.)生长、形态结构及生理特性的影响。与对照BG11培养的绿球藻比较,Pb2+浓度≤50 mg/L条件下培养的绿球藻细胞壁无明显增厚,色素变化不大;而暴露到Pb2+浓度>50 mg/L条件下培养,绿球藻细胞壁明显增厚,蛋白核消失。低浓度Pb2+(0.1~10 mg/L)对绿球藻生长基本没有影响;浓度在50 mg/L时,绿球藻仍能维持一定的生长速率;但当Pb2+浓度≥100 mg/L时

饲料中硒元素对中华米虾SOD活性的影响

研究了饲料中添加不同剂量的硒元素对中华米虾体内超氧化物歧化酶(SOD)活力的影响.实验表明,饲料中添加微量元素硒对中华米虾体内SOD的激活作用显著,并表现出明显的剂量效应.饲料中添加亚硒酸钠浓度应控制在一定范围内,若高于一定浓度,随着养殖时间的增长,虾体SOD的活性反而会降低.

瓦氏黄颡鱼的繁殖生物学研究

研究了长江中游嘉鱼至新滩口江段瓦氏黄颡鱼的繁殖生物学。性腺发育可分为6个时期。4-7月性成熟系数较高,为繁殖季节。雌、雄鱼的肥满度和脂肪系数在繁殖前和繁殖后各出现1个峰值,繁殖期出现最小值。绝对繁殖力为1088-19765(粒),平均7728±4093(粒);相对繁殖力为23-88(粒),平均55±16(粒)。绝对繁殖力与体长、体重和年龄呈显著的正相关,其中体重与绝对繁殖力的关系最密切。群体性比接近1:1。属一次性产卵类型。两性最小性成熟年龄均为2龄。为补充群体占优势的繁殖群体。

武汉鼓藻类新分类群

<正>与原变种不同为半细胞前面观中部具有6个颗粒，颗粒间具5个圆孔纹，缢部上端具有 1个颗粒。细胞宽25～31μm，长34～42μm，厚17～21μm，缢部宽7～11μm。

有机磷农药在水生态系中生物净化机理研究---- ----4. Pseudomonas sp. CTP-01 的对硫磷水解酶诱导合成性质

Pseudomonas sp.CTP-01的对硫磷水解酶具有底物诱导合成性质。停滞生长期的细胞接触底物半小时即产生相应酶的合成,而指数生长期的细胞接触底物48小时后才发生酶的合成。甲基对硫磷及对硝基酚也具有诱导作用,可见合成对硫磷水解酶的诱导特异基团可能与对硝基酚及其苯环上的取代基有密切关系。

Distribution of toxins in various tissues of crucian carp intraperitoneally injected with hepatotoxic microcystins

An acute toxicity experiment was conducted to examine the distribution and depuration of microcystins (MCS) in crucian carp (Carassius aurutus) tissues. Fish were injected intraperitoneally with extracted MCs at a dose of 200 mu g MC-LR (where L = leucine and R = arginine) equivalent/kg body weight. Microcystin concentrations in various tissues and aquaria water were analyzed at 1, 3, 12, 24, and 48 h postinjection using liquid chromatography coupled with mass spectrometry. Microcystins were detected mainly in blood (3.99% of injected dose at 1 h), liver (1.60% at I h), gonad (1.49% at 3 h), and kidney (0.14% at 48 h). Other tissues, such as the heart, gill, gallbladder, intestine, spleen, brain, and muscle, contained less than 0.1% of the injected MCs. The highest concentration of MCs was found in blood (526-3,753 ng/g dry wt), followed by liver (103-1,656 ng/g dry wt) and kidney (279-1,592 ng/g dry wt). No MC-LR was detectable in intestine, spleen, kidney, brain, and muscle, whereas MC-RR was found in all examined fish tissues, which might result from organ specificity of different MCs. Clearance of MC-RR in brain tissue was slow. In kidney, the MC-RR content was negatively correlated with that in blood, suggesting that blood was important in the transportation of MC-RR to kidney for excretion.

Compact phase shifter based on highly anisotropic liquid crystals for microwave frequency

A compact microwave phase shifter was designed and fabricated using highly anisotropic liquid crystals (LCs). It comprises a thin LC layer between a ground plane and a directly coupled and inverted microstrip line. The proposed folding configuration is beneficial for size reduction. Both simulation and experimental results confirm the compact size devices with reasonably good performance.

Design and control of a climbing robot based on hot melt adhesion

Robust climbing in unstructured environments has been one of the long-standing challenges in robotics research. Among others, the control of large adhesion forces is still an important problem that significantly restricts the locomotion performance of climbing robots. The main contribution of this paper is to propose a novel approach to autonomous robot climbing which makes use of hot melt adhesion (HMA). The HMA material is known as an economical solution to achieve large adhesion forces, which can be varied by controlling the material temperature. For locomotion on both inclined and vertical walls, this paper investigates the basic characteristics of HMA material, and proposes a design and control of a climbing robot that uses the HMA material for attaching and detaching its body to the environment. The robot is equipped with servomotors and thermal control units to actively vary the temperature of the material, and the coordination of these components enables the robot to walk against the gravitational forces even with a relatively large body weight. A real-world platform is used to demonstrate locomotion on a vertical wall, and the experimental result shows the feasibility and overall performances of this approach. © 2013 Elsevier B.V. All rights reserved.

Synthesis and characterization of ZnO nanoflowers grown on AIN films by solution deposition

ZnO nanoflowers are synthesized on AIN films by solution method. The synthesized nanoflowers are composed of nanorods, which are pyramidal and grow from a central point, thus forming structures that are flower-shaped as a whole. The nanoflowers have two typical morphologies: plate-like and bush-like. The XRD spectrum corresponds to the side planes of the ZnO nanorods made up of the nanoflowers. The micro-Raman spectrum of the ZnO nanoflowers exhibits the E-2 (high) mode and the second order multiple-phonon mode. The photoluminescence spectrum of the ZnO nanoflowers exhibits ultraviolet emission centred at 375 nm and a broad green emission centred at 526 nm.

Synthesis and characterization of ZnO nanorods and nanoflowers grown on GaN-based LED epiwafer using a solution deposition method

We report the growth of hexagonal ZnO nanorods and nanoflowers on GaN-based LED epiwafer using a solution deposition method. We also discuss the mechanisms of epitaxial nucleation and of the growth of ZnO nanorods and nanoflowers. A GaN-based LED epiwafer was first deposited on a sapphire substrate by MOCVD with no electrode being fabricated on it. Vertically aligned ZnO nanorods with an average height of similar to 2.4 mu m were then grown on the LED epiwafer, and nanoflowers were synthesized on the nanorods. The growth orientation of the nanorods was perpendicular to the surface, and the synthesized nanoflowers were composed of nanorods. The micro-Raman spectra of the ZnO nanorods and nanoflowers are similar and both exhibit the E-2 (high) mode and the second-order multiple-phonon mode. The photoluminescence spectrum of ZnO nanostructures exhibits ultraviolet emission centred at about 380 nm and a broad and enhanced green emission centred at about 526 nm. The green emission of the ZnO nanostructures combined with the emission of InGaN quantum wells provides a valuable method to improve the colour rendering index (CRI) of LEDs.