Ion and solvent dynamics in gel electrolytes based on ethylene oxide grafted acrylate polymers

Multinuclear pulsed field gradient NMR measurements and rheological viscosity measurements were performed on three series of polymer gel electrolytes. The gels were based on a lithium salt electrolyte swollen into a copolymer matrix comprising an acrylate backbone and ethylene oxide side chains. In each series the side chains differed in length and number, but the acrylate-to-ethylene oxide ratio was kept constant. It was found that the self-diffusion coefficient of the cations was much lower than that of the anions, and that it decreased rapidly when the side chains got longer. In contrast, the self-diffusion coefficient of the anions was found to be independent of chain length. In the gel electrolytes, the diffusion coefficients of the solvent molecules are relatively constant despite an increased viscosity with increasing length of the side chains. However, in salt-free gels made for comparison, the diffusion coefficients of the solvent molecules decreased with increasing length of the side chains, which is consistent with an increased viscosity.

Cation dynamics in dimethyl-pyrrolidinium-based solid-state ion conductors

Dimethyl-pyrrolidinum-based salts have been investigated by means of DSC, conductivity, NMR and Raman spectroscopy. The investigation aims to study the effect of the anion on the behaviour of the salt, in terms of plastic properties as well as rotational degrees of freedom of the cation. The materials range from the non-plastic iodide salt to the highly plastic BF₄ salt, which flows under its own weight at elevated temperatures. The different rotational and translational motions of the cations, and the difference between rotator and plastic phases are discussed.

Plastic crystal behaviour in tetraethylammonium dicyanamide

The plastic crystal tetraethylammonium dicyanamide ([N_2,2,2,2][dca]) has been investigated with an emphasis on structure and dynamics in the plastic phase. It was found that almost all of the volume expansion occurs at the II → I transition, with no volume expansion at the melt transition (as normally observed for crystals). The conductivity of this material shows a rapid increase at temperatures below the II → I transition, reaching values ~ 10^{− 3} S/cm in Phase I, and 0.1 S/cm in the melt. The NMR measurements show that there is a sudden onset of rotational motions of the cations at the plastic transition; below this temperature the cations appear static. The rotational motion of the cation in Phase I has been discussed in terms of isotropic tumbling.

Assembly of 3-D network structures containing oxydiacetate and CeIII or CeIV

Reaction of CeCl₃·7H₂O with Na₂(oda) (oda = O(CH₂CO₂)₂²— oxydiacetate) in a 2:3 ratio gives the neutral cerium(III) complex [Ce₂(oda)₃(H₂O)₃]·9H₂O (1). Treatment of a 1:3 mixture of CeCl₃·7H₂O and H₂oda in water with 4 molar equivalents of NaOH also gives 1 but, with a larger excess of NaOH, the tri-sodium salt Na₃[Ce(oda)₃]·9H₂O (2) is isolated. Formation of a tri-ammonium analogue of 2 can be achieved by neutralisation of an aqueous solution of CeCl₃·7H₂O and H₂(oda) in a 1:3 ratio by NH₄OH, giving (NH₄)₃[Ce(oda)₃]·7H₂O (3). Use of the cerium(IV) reagent (NH₄)₂[Ce(NO₃)₆] with Na₂(oda) results in reduction to cerium(III) under ambient conditions and isolation of 1. However, in the absence of light this reaction yields crystals of the novel cerium(IV) heterobimetallic [Ce(oda)₃Na₄(NO₃)₂] (4). Each of these complexes exhibit a 3-D network structure having a common nine-coordinate [Ce(oda)₃]ⁿ— (n = 2 or 3) subunit, irrespective of the oxidation state of cerium. In 1, six [Ce(oda)₃]³— anions are connected, through bridging bidentate carboxylates, to a second Ce³⁺ site further coordinated by three water molecules. In contrast, the ammonium salt 2, displays isolated [Ce(oda)₃]³— anions, devoid of further carboxylate bonding, but enmeshed within a network of hydrogen-bonded NH₄⁺ cations and water molecules. The remarkable structure of 4 consists of infinite 2-D sheets of [Na₂(NO₃)]+ pillared by [Ce(oda)₃]^2— units, the connectivity arising by multidentate nitrate and carboxylate bridging.

High mobility I− / I3− redox couple in a molecular plastic crystal: A potential new generation of electrolyte for solid-state photoelectrochemical cells

A series of new electrolyte materials based on a molecular plastic crystal doped by different iodide salts together with iodine have been prepared and characterized by thermal analysis, ionic conductivity, electrochemical and solid-state NMR diffusion measurements. In these materials, the plastic crystal phase of succinonitrile acts as a good matrix for the quaternary ammonium based iodides and iodine and appears to act in some cases as a solid-state “solvent” for the binary dopants. The materials were prepared by mixing the components in the molten state with subsequent cooling into the plastic crystalline state. This resulted in waxy-solid electrolytes in the temperature range from − 40 to 60 °C. The combination of structural variation of the cations, and fast redox couple diffusion (comparable with liquid-based electrolytes), as well as a high ionic conductivity of up to 3 × 10^{− 3} S cm^{− 1} at ambient temperature, make these materials very attractive for potential use in solid-state photoelectrochemical cells.

Structural characterization of novel ionic materials incorporating the bis(trifluoromethanesulfonyl)amide anion

A range of low melting salts of the bis(trifluoromethanesulfonyl)amide (TFSA) anion with hindered organic cations (N-methyl-1-methylpyrrolinium, N,N-dimethylpyrrolidinium, N,N,N,-trimethylammonium, and N,N,N,N-tetrakis(n-propyl)ammonium) have been crystallized. Single-crystal X-ray diffraction data show these materials to consist of discrete ions with only weak C−H···O (or for Me₃NH N−H···O) contacts between the constituent atoms of the cations and anions close to the limits of van der Waals separations. Consequently, the observed physical properties of these materials presumably result from the diffuse negative charge on the TFSA anion and inefficient packing of these large and irregularly shaped ions.

Liquids intermediate between 'molecular' and 'ionic' liquids : liquid ion pairs?

Ionic liquids comprised of tetradecyltrihexyl- and tetrabutyl- phosphonium cations paired with chloride or sulfonyl amide anions exhibit properties that reflect strong ion association, including comparatively low viscosity as well as a degree of volatility, and hence exemplify an interesting intermediate state between true ionic and true molecular liquids.

Use of ionic liquids for π-conjugated polymer electrochemical devices

π-Conjugated polymers that are electrochemically cycled in ionic liquids have enhanced lifetimes without failure (up to 1 million cycles) and fast cycle switching speeds (100 ms). We report results for electrochemical mechanical actuators, electrochromic windows, and numeric displays made from three types of π-conjugated polymers: polyaniline, polypyrrole, and polythiophene. Experiments were performed under ambient conditions, yet the polymers showed negligible loss in electroactivity. These performance advantages were obtained by using environmentally stable, room-temperature ionic liquids composed of 1-butyl-3-methyl imidazolium cations together with anions such as tetrafluoroborate or hexafluorophosphate.

Structural studies of ambient temperature plastic crystal ion conductors

A number of novel organic ionic compounds based on the pyrrolidinium cation are described which have been found to be ion conductors in their solid states around room temperature. The properties of the compounds are consistent with their exhibiting plastic crystal phases. In order to understand some of the molecular origins of the plastic crystal behaviour and the ion conductivity that it promotes, a number of related compounds based on the imidazolium and ammonium cations are also described which have structural elements in common with the pyrrolidinium cation, but which do not show the plastic behaviour. It is found therefore that the nature of the cation is quite critical to the development of this behaviour. The alkyl methyl pyrrolidinium cation is found to produce plastic crystal phases when the alkyl chains are short, thereby preserving the ability of the cation to rotate with minimal steric hindrance. The ammonium and imidazolium cations of comparable size and structure are less able to produce these plastic phases, in many cases because the low temperature phase proceeds to melt rather than forming a stable rotator phase.

High conductivity molten salts based on the imide ion

The bis(trifluoromethanesulfonyl)imide ion has recently been used in its lithium salt as a useful ion in solid polymer electrolytes because of the reduced degree of ion interaction its diffuse charge generates. In this work we have synthesised a number of novel salts based on the ammonium and pyrrolidinium cations of this anion. The salts all show reduced melting points compared with analogous halide salts. In some cases they are molten at room temperature. This latter group of salts have been characterized with respect to their properties as ionic liquids; the highest room temperature conductivity 2 mS cm⁻¹ being exhibited by methyl butyl pyrrolidinium imide. Many of the salts are glass forming, exhibiting glass transition temperatures in the region of −90°C.

Solid state NMR analysis of polypyrrole grown in a phosphonium ionic liquid

³¹P, ¹⁹F and ¹³C solid state NMR analysis has been used to investigate the intercalation/de-intercalation of both anions and cations in electrochemically synthesized polypyrrole films. Use of a phosphonium-based ionic liquid, tri(hexyl)(tetradecyl)phosphonium bis(trifluoromethanesulfonyl)amide, allows the separate detection of the cation and anion by analysis of the phosphorous and fluorine resonances, respectively. Initial results indicate the incorporation of both cations and anions during film growth in the ionic liquid. There is a notable change in the ³¹P chemical shift of the cation on incorporation into the film, consistent with a significant change in environment compared to the pure ionic liquid. Despite its large size, the phosphonium cation can be completely expelled from the film by oxidation.

Synthesis and properties of ambient temperature molten salts based on the quaternary ammonium ion

The synthesis of 16 tetraalkyl ammonium bis(trifluoromethane sulfonyl) imide salts, (C_nH_2n+1)₄ +N -N (SO₂CF₃)₂ (n = 1, 2, 3, 4),  (C₂H₅)₂(i-C₃H₇)₂ +N -N(SO₂CF₃)₂, (C₂H₅)(CH₃)(i-C₃H₇)₂+N-N(SO₂CF₃)₂, (n-C₇H₁₅)(C₂H₅)i-C₃H₇)₂+N-N(SO₂CF₃)₂ and (C_nH_2n+1)(C_mH_2m+1)₃+N-N(SO₂CF₃)₂ (n = 6,7,8; m = 1, 2, 4) are reported in this paper. Trends in properties of these salts are discussed. The symmetrical tetraalkyl ammonium salts with the bis(trifluoromethyl sulfonyl) imide anion exhibited a lower melting point than that of corresponding ammonium halides. The salts with low symmetry ammonium cations were found to be of generally lower melting point, and many were stable liquids at room temperature. Several of these did not crystallize during cooling below room temperature and exhibited glass transition temperatures in the region of −60 °C∼−80 °C. A comparison of properties between the ammonium imide salts and corresponding trifluoromethane sulfonates is also presented.

Lithium polyelectrolyte–ionic liquid systems

Novel lithium polyelectrolyte–ionic liquid systems, using poly(lithium 2-acrylamido-2-methyl propanesulfonate) and its copolymer with N-vinyl formamide, have been developed in this work. The ionic liquid used in this work is from a novel family of methanesulfonate ionic liquids, specifically N-hexyl-N,N,N-tributyl ammonium methanesulfonate, which is chosen because of the similarity with the anionic functionality of the polymer. The ionic liquid thereby acts as a good solvating medium for the polyelectrolyte. It was found that the copolymer-based polyelectrolyte–ionic liquid system exhibits two to three times higher conductivity than that of the homopolymer system. The results of solid-state ⁷Li-NMR have shown that lithium cations in the copolymer system are mobile whereas in the homopolymer, only a fraction appears to be mobile even at 80 °C. This supports the hypothesis that separation of the charged groups on the polymer backbone via the co-monomer encourages the dissociation of lithium cations from the sulfonate groups bonded to the polymer chains, and hence, results in an increase in conductivity of the polyelectrolyte material.

Conductive plastic crystal phases of the 1-alkyl-2-methyl pyrrolinium TFSA salts

Characterization of a new family of salts, based on a number of 1-alkyl-2-methyl pyrrolinium cations and the bis(trifluoromethane sulfonyl) amide anion (TFSA), is presented. From the thermal analysis, conductivity and X-ray diffraction (XRD) measurements, at least one of the compounds of the family, 1-ethyl-2-methyl pyrrolinium TFSA, was found to exhibit plastic crystal phases before melting and to exhibit high conductivity in the solid state (1×10⁻⁴ S cm⁻¹ at 25 °C). This plastic crystal behaviour is discussed in comparison with other members of this pyrrolinium salt family.

A new family of ionic liquids based on the 1-alkyl-2-methyl pyrrolinium cation

Five new salts based on 1-alkyl-2-methyl pyrrolinium ion are reported, two involving the iodide ion and three involving the bis(trifluoromethanesulfonyl) amide ion. The iodide salts have melting points around 100 °C, while the amide salts have melting points around room temperature. Two of the amide salts can be easily quenched into the glassy state and exhibit glass transition temperatures around −70 °C. The 2-methyl pyrrolinium cation bears structural similarities to the aromatic imidazolium cations on one hand and the cyclic ammonium cation family based on the pyrrolidinium cation on the other. The properties of the salts reported here are compared within these two related families of salts.