Inner-shell photoexcitation of Fe XV and Fe XVI

The configuration-interaction method as implemented in the computer code CIV3 is used to determine energy levels, electric dipole radiative transition wavelengths, oscillator strengths and transition probabilities for inner-shell excitation of transitions in Fe XV and Fe XVI. Specifically, transitions are considered of the type 1s(2) 2s(2) 2p(6) 3s(2) -1s(2) 2s(2) 2p(5) 3l3l' 3l" (l, l' and l" = s,p or d) in FeXV and 1s(2) 2s(2) 2p(6) 3s- 1s(2) 2s(2) 2p(5) 3l3l' (l and l' = s,p or d) in FeXVI, using the relativistic Breit-Pauli approach. An assessment of the accuracy of the derived atomic data is performed.

Energy levels and radiative rates for Li-like Ar XVI and Fe XXIV

Energy levels for transitions among the lowest 24 fine- structure levels belonging to the 1s(2)nl(n greater than or equal to 5) configurations of Li-like Ar XVI and Fe XXIV have been calculated using the fully relativistic GRASP code. Oscillator strengths, radiative rates and line strengths have also been generated among these levels for the four types of transitions: electric dipole (E1), magnetic dipole (M1), electric quadrupole (E2) and magnetic quadrupole (M2). Comparisons are made for the electric dipole transitions with other available results, and the accuracy of the present data is assessed.

Entanglement between collective operators in a linear harmonic chain

We investigate entanglement between collective operators of two blocks of oscillators in an infinite linear harmonic chain. These operators are defined as averages over local operators (individual oscillators) in the blocks. On the one hand, this approach of "physical blocks" meets realistic experimental conditions, where measurement apparatuses do not interact with single oscillators but rather with a whole bunch of them, i.e., where in contrast to usually studied "mathematical blocks" not every possible measurement is allowed. On the other, this formalism naturally allows the generalization to blocks which may consist of several noncontiguous regions. We quantify entanglement between the collective operators by a measure based on the Peres-Horodecki criterion and show how it can be extracted and transferred to two qubits. Entanglement between two blocks is found even in the case where none of the oscillators from one block is entangled with an oscillator from the other, showing genuine bipartite entanglement between collective operators. Allowing the blocks to consist of a periodic sequence of subblocks, we verify that entanglement scales at most with the total boundary region. We also apply the approach of collective operators to scalar quantum field theory.

Reconstructing the dynamics of a movable mirror in a detuned optical cavity

We consider the dynamics of a movable mirror in a Fabry-Perot cavity coupled through radiation pressure to the cavity field and in contact with a thermal bath at finite temperature. In contrast to previous approaches, we consider arbitrary values of the effective detuning between the cavity and an external input field. We analyse the radiation-pressure effect on the Brownian motion of the mirror and its significance in the density noise spectrum of the output cavity field. Important properties of the mirror dynamics can be gathered directly from this noise spectrum. The presented reconstruction provides an experimentally useful tool in the characterization of the energy and rigidity of the mirror as modified by the coupling with light. We also give a quantitative analysis of the recent experimental observation of self-cooling of a micromechanical oscillator.

Strong configuration mixing among the fine-structure levels of Cl+

A large-scale configuration interaction (Cl) calculation using Program CIV3 of Hibbert is performed for the lowest 62 fine- structure levels of the singly charged chlorine ion. Our calculated energy levels agree very well with most of the NIST results and confirm the identification of the lowest P-1(o) as actually 3s(2)3p(3)(D-2(o))3d P-1(o) rather than the generally employed 3s3p(5) P-1(o) in measurements and calculations. Discrepancies in the energy positions of some symmetries are found and discussed. Some large oscillator strengths for allowed and intercombination transitions in both length and velocity gauges are presented. Their close agreement gives credence to the accuracy of our CI wavefunctions.

Analytical calculation of far infrared spectra of ice in terms of a molecular model

Wideband far infrared (FIR) spectra of complex permittivity e(p) of ice are calculated in terms of a simple analytical theory based on the method of dipolar autocorrelation functions. The molecular model represents a revision of the model recently presented for liquid water in Adv. Chem. Phys. 127 (2003) 65. A composite two-fractional model is proposed. The model is characterised by three phenomenological potential wells corresponding to the three FIR bands observed in ice. The first fraction comprises dipoles reorienting in a rather narrow and deep hat-like well; these dipoles generate the librational band centred at the frequency approximate to 880 cm(-1). The second fraction comprises elastically interacting particles; they generate two nearby bands placed around frequency 200 cm(-1). For description of one of these bands the harmonic oscillator (HO) model is used, in which translational oscillations of two charged molecules along the H-bond are considered. The other band is produced by the H-bond stretch, which governs hindered rotation of a rigid dipole. Such a motion and its dielectric response are described in terms of a new cut parabolic (CP) model applicable for any vibration amplitude. The composite hat-HO-CP model results in a smooth epsilon(nu) ice spectrum, which does not resemble the noise-like spectra of ice met in the known literature. The proposed theory satisfactorily agrees with the experimental ice spectrum measured at - 7 degrees C. The calculated longitudinal optic-transverse optic (LO-TO) splitting occurring at approximate to 250 cm(-1) qualitatively agrees with the measured data. (c) 2004 Elsevier B.V. All rights reserved.

Self-cooling of a micro-mirror by radiation pressure

Cooling of mechanical resonators is currently a popular topic in many fields of physics including ultra-high precision measurements, detection of gravitational waves and the study of the transition between classical and quantum behaviour of a mechanical system. Here we report the observation of self-cooling of a micromirror by radiation pressure inside a high-finesse optical cavity. In essence, changes in intensity in a detuned cavity, as caused by the thermal vibration of the mirror, provide the mechanism for entropy flow from the mirror's oscillatory motion to the low-entropy cavity field. The crucial coupling between radiation and mechanical motion was made possible by producing free-standing micromirrors of low mass (m approximately 400 ng), high reflectance (more than 99.6%) and high mechanical quality (Q approximately 10,000). We observe cooling of the mechanical oscillator by a factor of more than 30; that is, from room temperature to below 10 K. In addition to purely photothermal effects we identify radiation pressure as a relevant mechanism responsible for the cooling. In contrast with earlier experiments, our technique does not need any active feedback. We expect that improvements of our method will permit cooling ratios beyond 1,000 and will thus possibly enable cooling all the way down to the quantum mechanical ground state of the micromirror.

Energy levels, radiative rates, and excitation rates for transitions in OIV

Aims. In this paper we report calculations for energy levels, radiative rates, and excitation rates for transitions in O IV. Methods. The grasp (general-purpose relativistic atomic structure package) and FAC (flexible atomic code) were adopted for calculating energy levels and radiative rates, and the Dirac atomic R-matrix code (DARC) used to determine the excitation rates. Results. Oscillator strengths and radiative rates are reported for all E1, E2, M1, and M2 transitions among the lowest 75 levels of O IV. Additionally, lifetimes are reported for all levels and comparisons made with those available in the literature. Finally, effective collision strengths are reported for all transitions over a wide temperature range below 106 K. Comparisons are made with earlier results and the accuracy of the data is assessed.

Radiative rates and electron impact excitation rates for H-like Ar XVIII

Aims. In this paper we report on calculations for energy levels, radiative rates, collision strengths, and effective collision strengths for
transitions among the lowest 25 levels of the n ≤ 5 configurations of H-like Ar xviii.
Methods. The general-purpose relativistic atomic structure package (grasp) andDirac atomic R-matrix code (darc) are adopted for
the calculations.
Results. Radiative rates, oscillator strengths, and line strengths are reported for all electric dipole (E1), magnetic dipole (M1), electric
quadrupole (E2), and magnetic quadrupole (M2) transitions among the 25 levels. Furthermore, collision strengths and effective
collision strengths are listed for all 300 transitions among the above 25 levels over a wide energy (temperature) range up to 800 Ryd
(107.4 K).

Energy levels and radiative rates for transitions in B-like to F-like Kr ions (Kr XXXII-XXVIII)

Energy levels, radiative rates, oscillator strengths, line strengths, and lifetimes have been calculated for transitions in B-like to F-like Kr ions, Kr XXXIII-XXVIII. For the calculations, the fully relativistic GRASP code has been adopted, and results are reported for all electric dipole (E1), electric quadrupole (E2), magnetic dipole (M1), and magnetic quadrupole (M2) transitions among the lowest 125, 236, 272, 226, and 113 levels of Kr XXXII, Kr XXXI, Kr XXX, Kr XXIX, and Kr XXVIII, respectively, belonging to the n

Energy levels, radiative rates and excitation rates for transitions in Ni XI

Aims. In this paper we report calculations for energy levels, radiative rates and excitation rates for transitions in Ni xi.
Methods. The grasp (General-purpose Relativistic Atomic Structure Package) and fac (Flexible Atomic Code) have been adopted
for calculating energy levels and radiative rates, and the Dirac Atomic R-matrix Code (darc) has been used to determine the excitation
rates.
Results. Oscillator strengths, radiative rates and line strengths are reported for all E1, E2, M1 and M2 transitions among the lowest
250 levels of Ni xi. Additionally, lifetimes are also reported for all levels. However, results for excitation rates are presented only for
transitions among the lowest 17 levels.

Electron impact excitation of S-like iron

Energy levels and radiative rates for transitions among the lowest 48 fine-structure levels belonging to the (1s(2) 2s(2) 2p (6)) 3s (2)3p (4) , 3s3p(5), 3s (2)3p (3) 3d and 3p(6) configurations of Fe xi have been calculated using the fully relativistic grasp code. Additionally, collision strengths for transitions among these levels have also been computed using the Dirac Atomic R-matrix Code (darc) of Norrington & Grant. Radiative rates and oscillator strengths are tabulated for all allowed transitions among the 48 fine-structure levels, while collision strengths are reported at three energies above thresholds, i.e. 8, 16 and 24 Ryd for a few representative transitions. Furthermore, excitation rates have been calculated in a wide electron temperature range below 5 x 10(6) K, and the contribution of resonances has been included in the threshold regions. Comparisons are made with the earlier available theoretical and experimental rates, and it is concluded that the experimental rates are overestimated by up to a factor of 2.

'Travails of Truth: Achieving Justice for Victims of Impunity in Nigeria”'

Following its transition to democracy from an authoritarian military rule marked by gross violations of human rights, Nigeria established the Human Rights Violations Investigations Commission (HRVIC) in 1999. This paper critically examines the contributions of the HRVIC, popularly known as the ‘Oputa Panel,’ to the field of transitional justice and the rule of law. It sets out the process of establishing the Commission, its mandate and how this mandate was interpreted during the course of the Commission’s work. The challenges faced by the Oputa Panel, particularly those that relate to its legal status and relationship with the judiciary, are analyzed in an attempt to draw useful guidelines from these challenges for other truth commissions. Recourse by powerful individuals to the judicial process in a bid to shield themselves from the HRVIC merits particular review as it raises questions regarding the transformation of the judiciary and the rule of law in the wake of an authoritarian regime.

Incorporation of multiwalled carbon nanotubes to acrylic based bone cements: Effects on mechanical and thermal properties

Polymethyl methacrylate (PMMA) bone cement–multiwalled carbon nanotube (MWCNT) nanocomposites with a weight loading of 0.1% were prepared using 3 different methods of MWCNT incorporation. The mechanical and thermal properties of the resultant nanocomposite cements were characterised in accordance with the international standard for acrylic resin cements. The mechanical properties of the resultant nanocomposite cements were influenced by the type of MWCNT and method of incorporation used. The exothermic polymerisation reaction for the PMMA bone cement was significantly reduced when thermally conductive functionalised MWCNTs were added. This reduction in exotherm translated in a decrease in thermal necrosis index value of the respective nanocomposite cements, which potentially could reduce the hyperthermia experienced in vivo. The morphology and degree of dispersion of the MWCNTs in the PMMA matrix at different scales were analysed using scanning electron microscopy. Improvements in mechanical properties were attributed to the MWCNTs arresting/retarding crack propagation through the cement by providing a bridging effect into the wake of the crack, normal to the direction of crack growth. MWCNT agglomerations were evident within the cement microstructure, the degree of these agglomerations was dependent on the method used to incorporate the MWCNTs into the cement.