Variations in year-class strength and estimates of the catchability coefficient of yellowfin tuna, Thunnus albacares, in the Eastern Pacific Ocean

ENGLISH: Year-class composition of catch, virtual population size and yearclass strength were determined from serial samples of size composition of catches and catch records. Murphy's Solution to the catch equation, which is free from the effects caused by changes in fishing pressure, was used to estimate year-class strength, i.e. the total population of fish age 3/4 years. The resultant estimates indicated that the X55, X56, X57, X62 and X63 year classes were above average and the X58, X59, X60, X61 and X64 year classes were below average. The year-class designation refers to the year of actual entry or presumed year of entry into the commercial fishery (at approximately 1 year of age). The strongest and poorest year classes were the X57 and X61 classes, respectively. The ratio of the strongest to the weakest year class was 2.6. This amount of variation is small compared to that found for other species of fish. It was found that the relationship between stock size and yearclass strength is of no value in predicting year-class strength. As a by-product of the analysis, estimates of the catchability coefficients (qN) of the age groups in the fishery were obtained, These estimates were found to vary with age and time. Age-two fish apparently showed the greatest vulnerability to fishing gear, followed by ages three and one, respectively. The average estimate of the catchability coefficient in weight was calculated and found to compare favorably with Schaefer's estimate. The influence of sea-surface water temperature upon year-class strength was investigated to determine whether the latter can be predicted from a knowledge of sea-surface temperatures prevailing during and following spawning. No correlation was evident. SPANISH: La composición de la clase anual en la captura, el tamaño de la población virtual y la fuerza de clase anual, fueron determinados según una serie de muestras de la composición de tamaño de las capturas y de los registros de captura. La Solución de Murphy de la ecuación de captura, que está libre de los efectos causados por los cambios de la presión de pesca, fue usada para estimar la fuerza de la clase anual, i.e. la población total de peces de 3/4 años. Las estimaciones resultantes indican que las clases anuales X55, X56, X57, X62 y X63 fueron superiores al promedio y que las clases anuales X58, X59, X60, X61 y X64 fueron inferiores al promedio. La designación de la clase anual se refiere al año actual de entrada o al año supuesto de entrada en la pesca comercial (aproximadamente a la edad de 1 año). Las clases anuales más fuertes y más pobres fueron la X57 y X61 respectivamente. La razón de la clase anual más fuerte en relación a la más débil fue 2.6. Esta cantidad de variación es pequeña comparada con la encontrada para otras especies de peces. Se encontró que la relación entre en tamaño del stock y la fuerza de la clase anual no tiene valor en predecir la fuerza de la clase anual. Se obtuvieron estimaciones de los coeficientes de capturabilidad (qN) de los grupos de edad en la pesquería como un producto derivado del análisis. Se encontraron que estas estimaciones variaron con la edad y tiempo. Los peces de edad dos aparentemente presentaron la vulnerabilidad más grande en relación al arte pesquero, seguidos por las edades tres y una, respectivamente. La estimación promedio del coeficiente de capturabilidad en peso fue calculada y se encontró que podía compararse favorablemente con la estimación de Schaefer. La influencia de la temperatura del agua superficial del mar sobre la fuerza de la clase anual fue investigada para determinar si se podía predecir esta última según el conocimíento de las temperaturas superficiales del mar prevalecientes durante el desove y después de éste. No hubo correlación evidente. (PDF contains 44 pages.)

Transfer of Medical Sensor Technologies to Environmental Monitoring, Solomons, Maryland, April 6-8, 2005: workshop proceedings

(pdf contains 23 pages)

Strategies for transfer of aquaculture technology to small-scale fish farmers in Nigeria

There is increasing awareness of aquaculture in Nigeria today for a number of reasons namely: water pollution, declining catch and the awareness of the attractiveness of aquaculture as an investment area and a pivotal point for national development. The development of aquaculture in Nigeria, requires the building up of institutions at the grassroot level and the formulation of policies and programmes for the small fishfarmer. This of course would be backed up by a sound technology generation, verification and packaging, dissemination and use programme

Size- And Temperature-Dependent Thermal Expansion Coefficient Of A Nanofilm

The thermal expansion coefficient (TEC) of an ideal crystal is derived by using a method of Boltzmann statistics. The Morse potential energy function is adopted to show the dependence of the TEC on the temperature. By taking the effects of the surface relaxation and the surface energy into consideration, the dimensionless TEC of a nanofilm is derived. It is shown that with decreasing thickness, the TEC can increase or decrease, depending on the surface relaxation of the nanofilm.

Ab Initio Study Of Zno-Based Gas-Sensing Mechanisms: Surface Reconstruction And Charge Transfer

Density functional theory (DFT) calculations were employed to explore the gas-sensing mechanisms of zinc oxide (ZnO) with surface reconstruction taken into consideration. Mix-terminated (10 (1) over bar0) ZnO surfaces were examined. By simulating the adsorption process of various gases, i.e., H-2, NH3, CO, and ethanol (C2H5OH) gases, on the ZnO (10 (1) over bar0) surface, the changes of configuration and electronic structure were compared. Based on these calculations, two gas-sensing mechanisms were proposed and revealed that both surface reconstruction and charge transfer result in a change of electronic conductance of ZnO. Also, the calculations were compared with existing experiments.

Heat Transfer of Aviation Kerosene at Supercritical Conditions

The heat transfer characteristics of China no. 3 kerosene were investigated experimentally and analytically under conditions relevant to a regenerative cooling system for scramjet applications. A test facility developed for the present study can handle kerosene in a temperature range of 300-1000 K, a pressure range of 2.6-5 MPa, and a mass How rate range of 10-100 g/s. In addition, the test section was uniquely designed such that both the wall temperature and the bulk fuel temperature were measured at the same location along the flowpath. The measured temperature distributions were then used to analytically deduce the local heat transfer characteristics. A 10-component kerosene surrogate was proposed and employed to calculate the fuel thermodynamic and transport properties that were required in the heat transfer analysis. Results revealed drastic changes in the fuel flow properties and heat transfer characteristics when kerosene approached its critical state. Convective heat transfer enhancement was also found as kerosene became supercritical. The heat transfer correlation in the relatively low-fuel-temperature region yielded a similar result to other commonly used jet fuels, such as JP-7 and JP-8, at compressed liquid states. In the high-fuel-temperature region, near and beyond the critical temperature, heat transfer enhancement was observed; hence, the associated correlation showed a more significant Reynolds number dependency.

Boiling heat transfer enhancement by using micro-pin-finned surface for electronics cooling

For efficiently cooling electronic components with high heat flux, experiments were conducted to study the flow boiling heat transfer performance of FC-72 over square silicon chips with the dimensions of 10 × 10 × 0.5 mm3. Four kinds of micro-pin-fins with the dimensions of 30 × 60, 30 × 120, 50 × 60, 50 × 120 μm2 (thickness, t × height, h) were fabricated on the chip surfaces by the dry etching technique for enhancing boiling heat transfer. A smooth surface was also tested for comparison. The experiments were made at three different fluid velocities (0.5, 1 and 2 m/s) and three different liquid subcoolings (15, 25 and 35 K). The results were compared with the previous published data of pool boiling. All micro-pin-fined surfaces show a considerable heat transfer enhancement compared with a smooth surface. Flow boiling can remarkably decrease wall superheat compared with pool boiling. At the velocities lower than 1 m/s, the micro-pin-finned surfaces show a sharp increase in heat flux with increasing wall superheat. For all surfaces, the maximum allowable heat flux, qmax, for the normal operation of LSI chips increases with fluid velocity and subcooling. For all micro-pin-finned surfaces, the wall temperature at the critical heat flux (CHF) is less than the upper limit for the reliable operation of LSI chips, 85◦C. The largest value of qmax can reach nearly 148 W/cm2 for micro-pin-finned chips with the fin height of 120 μm at the fluid velocity of 2 m/s and the liquid subcooling of 35 K. The perspectives for the boiling heat transfer experiment of the prospective micro-pin-finned sur- faces, which has been planned to be made in the Drop Tower Beijing/NMLC in the future, are also presented.

Two-phase flow and pool boiling heat transfer in microgravity

Researches on two-phase flow and pool boiling heat transfer in microgravity, which included groundbased tests, flight experiments, and theoretical analyses, were conducted in the National Microgravity Laboratory/CAS. A semi-theoretical Weber number model was proposed to predict the slug-to-annular flow transition of two-phase gas–liquid flows in microgravity, while the influence of the initial bubble size on the bubble-to-slug flow transition was investigated numerically using the Monte Carlo method. Two-phase flow pattern maps in microgravity were obtained in the experiments both aboard the Russian space station Mir and aboard IL-76 reduced gravity airplane. Mini-scale modeling was also used to simulate the behavior of microgravity two-phase flow on the ground. Pressure drops of two-phase flow in microgravity were also measured experimentally and correlated successfully based on its characteristics. Two space experiments on pool boiling phenomena in microgravity were performed aboard the Chinese recoverable satellites. Steady pool boiling of R113 on a thin wire with a temperature-controlled heating method was studied aboard RS-22, while quasi-steady pool boiling of FC-72 on a plate was studied aboard SJ-8. Ground-based experiments were also performed both in normal gravity and in short-term microgravity in the drop tower Beijing. Only slight enhancement of heat transfer was observed in the wire case, while enhancement in low heat flux and deterioration in high heat flux were observed in the plate case. Lateral motions of vapor bubbles were observed before their departure in microgravity. The relationship between bubble behavior and heat transfer on plate was analyzed. A semi-theoretical model was also proposed for predicting the bubble departure diameter during pool boiling on wires. The results obtained here are intended to become a powerful aid for further investigation in the present discipline and development of two-phase systems for space applications.