Determinação direta de Ca, Mg, Mn e Zn em amostras de leite de búfala da Ilha de Marajó por espectrometria de absorção atômica com chama (FAAS)

This work proposes an analytical procedure for direct determination of calcium, magnesium, manganese and zinc in buffalo milk by flame atomic absorption spectrometry (FAAS). Samples were diluted with a solution containing 10% (v/v) of water-soluble tertiary amines (CFA-C) at pH 8. For comparison, buffalo milk samples were digested with HNO3 and H2O2. According to a paired t-test, the results obtained in the determination of Ca, Mg, Mn and Zn in digested samples and in 10% (v/v) CFA-C medium were in agreement at a 95% confidence level. The developed procedure is simple, rapid, decrease the possibility of contamination and can be applied for the routine determination of Ca, Mg, Mn and Zn in buffalo milk samples without any difficulty caused by matrix constituents, such as fat content, and particle size distribution in the milk emulsion.

Desenvolvimento e aplicação de sistema passivo de coleta de poluentes atmosféricos para monitoramento de Cd, Cr, Pb, Cu, Fe, Mn, Zn e particulados totais

The objective of this study was to assess a new monitoring technique of particulate and trace metals in the atmosphere via the use of a passive sampler of air pollutants in the city of Goiânia. The average particulate weight and average concentrations of metals Fe, Cr, Zn, Pb, Cu, Mn, and Cd were 0.1104 g and 257.5; 23.4; 17.8; 6.7; 1.9; 0.8; 0.2 μg/m²/day, respectively. Higher Pb and Cr concentrations were obtained in areas with intense traffic. This study revealed that it is possible to monitor trace metals with passive sampling, developed at a low cost and operational facility.

Variações no teor e na composição volátil de Hyptis marrubioides EPL: cultivada no campo e em casa de vegetação

This work describes the chemical composition of the volatile oil of Hyptis marrubioides cultivated in field and greenhouse. The experimental design was completely randomized, with ten replications for each type of cultivation. The volatile oil was extracted by hydrodistillation and analyzed by GC-MS. The highest content of volatile oil was found for plants grown in field. The highest percentage of the compounds present in oils was observed in samples grown in the field, such as germacra-4(15),5,10(14)-trien-1-α-ol (16.34%), β-caryophyllene (10.42%), γ-muurolene (12.83%) and trans-thujone (9.98%). However, some compounds were found only in plants grown in a greenhouse, such as cis-muurol-5-en-4α-ol (10.84%), α-cadinol (3.06%) and eudesma-4(15),7-dien-1β-ol (6.82%).

Determinação do teor de ésteres graxos em biodiesel metílico de soja por cromatografia gasosa utilizando oleato de etila como padrão interno

A method for ester content determination in soybean methyl biodiesel was studied, using ethyl oleate as internal standard. A biodiesel sample was analyzed and had its purity estimated as 92.8%. Method accuracy was evaluated by comparison with the result obtained via EN14103, with a relative difference of 0.1%. Repetitivity and intermediate precision were estimated as 2 and 1.5%, respectively.

Recovery of manganese and zinc from spent Zn-C and alkaline batteries in acidic medium

The anode and the internal paste of spent Zn-C and alkaline batteries were leached with 2 mol L-1 H2SO4 at 80 ºC for 2 h. Solid/liquid ratio was 1/10 (g mL-1). The leachate was treated with Na2S in order to precipitate Hg, Cd and Pb. Zn was quantitatively isolated at pH 1,5-2 by adding Na2S. Mn can be precipitated at pH close to 7. Na2S may be replaced by oxalic acid. Zn precipitated at pH around 0, whereas Mn was quantitatively recovered at pH > 4. Acidity control is a critical parameter. Na2SO4 and carbon are the end products.

Concentrações e associações geoquímicas de Pb e Zn em sedimentos do rio São Francisco impactados por rejeitos da produção industrial de zinco

Surface sediments from the River São Francisco were analyzed to investigate the impact, due to the presence of metals (Cd, Cu, Pb, Zn) in wastes from a metallurgical industry in the city of Três Marias/MG, Brazil. The concentrations and geochemical associations of Pb, Zn and trace metals associated with the minerals employed in zinc production were measured. Sediments close to discharge locations were highly contaminated with Pb (332-512 μg g-1) and Zn (7872-10780 μg g-1), with values decreasing rapidly due to dilution and hydraulic sorting. Evaluation of toxicity according to the Consensus-based Sediment Quality Guidelines indicated for Cd, Pb and Zn a high probability of adverse effects on aquatic biota at these sites.

Resposta antioxidante, formação de fitoquelatinas e composição de pigmentos fotoprotetores em Brachiaria decumbens Stapf submetida à contaminação com Cd e Zn

In order to evaluate the response of Brachiaria decumbens Stapf to Cd and Zn, plants were hydroponically exposed to 50 and 100 mmol L-1 of Cd and 500 and 2000 mmol L-1 of Zn. Metal content of shoots and roots was determined, as well as alterations in photosynthetic and photoprotective pigments, antioxidant metabolites and phytochelatin synthesis. Plants concentrated elevated levels of Cd and Zn, especially in roots. Zinc exposure negatively affected chlorophyll and β-carotene content, whereas the highest dose of Cd reduced VAZ cycle pigments and tocopherol levels in plant shoots. Cadmium was the maximum inducer of the phytochelatin synthesis pathway.

Síntese hidrotermal assistida por micro-ondas como metodologia sintética eficiente para obtenção da rede metalorgânica [ZN(BDC)(H2O)2]n

This work presents the optimization of the microwave-assisted hydrothermal synthesis of [Zn(BDC)(H2O)2]n . The reactions were carried out at the fixed temperature of 120 ºC for 10, 20, 30 and 40 min. Pure crystalline [Zn(BDC)(H2O)2]n was obtained in high yield (ca. 90%) with a reaction time of 10 min. The phase obtained and its purity was confirmed by Rietveld refinement, with a final value for Rwp/Rexp equal to 1.48. Increased reaction times (20, 30 and 40 min) favored the formation of unwanted by products, resulting in mixtures of several crystalline phases.

Desenvolvimento e validação de método analítico para determinação do teor de sinvastatina em cápsulas magistrais

Simvastatin is an oral anti-hyperlipidemic that has been widely used to reduce the cardiovascular disease risk. There isn't any pharmacopoeic method to assay this drug in capsules. It was proposed and validated a method for determining the content of simvastatin in capsules by UV/visible spectrophotometry (l = 237 nm), a more affordable method for the compounding pharmacy. The method was validated for linearity, specificity, range, accuracy, precision, performance, robustness, and limits of detection and quantification.

Efeito da temperatura do ar de secagem sobre o teor e a composição química do óleo essencial de Pectis brevipedunculata

Leaves and flower heads of P. brevipedunculata were submitted to four drying-air temperatures (room temperature, 40, 50 and 60 ºC). Room temperature (approximately 30 ºC) and higher temperature drying (50 and 60 ºC) had a deleterious effect on the essential oil content. The recommended drying-air temperature for the species is 40 ºC for it results in the same amount of essential oil observed in fresh cut plants. Overall, 13 components accounting for more than 92% of the total composition were identified. Citral was the major component, followed by α-pinene and limonene. The essential oil showed high toxicity against Artemia salina larvae.

Síntese da perovsquita do tipo LaNiO3 através do método dos precursores quelantes usando EDTA: otimização do teor de agente quelante

The perovskites are strategic materials due their catalytic, electronic and magnetic properties. These properties are influenced by the calcination and synthesis conditions. In this work was carried out the synthesis of LaNiO3 perovskite-type by chelating precursor method using EDTA and also was studied the optimization of the EDTA content in the synthesis. The synthesized materials were characterized by X-ray diffraction (XRD), thermal gravimetric analysis (TG) and Infrared Spectroscopy (FTIR). In the optimization of the EDTA content the lowest ratio of metal / EDTA used was 1.0 / 0.1, where it was possible to obtain monophasic perovskite.

Quantificação de antimônio em garrafas de politereftalato de etileno (PET) brasileiras por fluorescência de raios-X e avaliação quimiométrica para verificar a presença de pet reciclado através do teor de ferro

Antimony is a common catalyst in the synthesis of polyethylene terephthalate used for food-grade bottles manufacturing. However, antimony residues in final products are transferred to juices, soft drinks or water. The literature reports mentions of toxicity associated to antimony. In this work, a green, fast and direct method to quantify antimony, sulfur, iron and copper, in PET bottles by X-ray fluorescence spectrometry is presented. 2.4 to 11 mg Sb kg-1 were found in 20 samples analyzed. The coupling of the multielemental technique to chemometric treatment provided also the possibility to classify PET samples between bottle-grade PET/recycled PET blends by Fe content.

Aplicação de métodos quimiométricos na otimização da extração de Ca, Mg, K, Fe, Zn, Cu e Mn em folhas de braquiária

This work applied a 2² factorial design to the optimization of the extraction of seven elements (calcium, magnesium, potassium, iron, zinc, copper and manganese) in brachiaria leaves, determined by flame atomic absorption spectrometry. The factors sample mass and digestion type were evaluated at two levels: 200/500 mg, and dry/wet, respectively. Principal component analysis allowed simultaneous discrimination of all the significant effects in one biplot. Wet digestion and mass of 200 mg were considered the best conditions. The decrease of 60% in sample mass allowed to save costs and reagents. The method was validated through the estimation of figures of merit.

Ternary surface complex: coadsorption of Cu(II), Zn(II), Cd(II) and nitrilotris(methylenephosphonic) acid onto boehmite

This work studies the effect of NTMP (nitrilotris(methylenephosphonic acid)) on the adsorption of Cu(II), Zn(II), and Cd(II) onto boehmite in the pH range 5-9.5. The data were analyzed using the 2-pK constant capacitance model (CCM) assuming ternary surface complex formation. Under stoichiometric conditions, NTMP is more effective for removing Cu(II) than Zn(II) from solution and the contribution of ternary surface complexes are important to model the adsorption of both metals. Under nonstoichiometric conditions and high surface loading with a Me(II)/NTMP ratio of 1:5, Cu(II) and Zn(II) adsorption is significantly suppressed. In the case of Cd(II) the free metal adsorption is the most dominant species.

Determinação de Mn e Zn em arroz empregando espectrometria de fluorescência de raios x de energia dispersiva

A simple, fast and inexpensive method was developed to determine essential elements in pellets of rice samples using energy dispersive X-ray fluorescence spectrometry (EDXRF). The accuracy and precision were evaluated using Standard Reference Material (rice flour NIST 1568a), and yielding relative standard deviation below 5%. The paired t-test showed good agreement within 95% confidence values. The detection limits (3σ) of Mn and Zn were 5.1 and 2.2 mg kg-1, respectively. The proposed method proved to be effective when used to determine Mn and Zn in commercial samples of rice without go by stage of decomposition.