Chemical kinetics and reactive species in atmospheric pressure helium-oxygen plasmas with humid-air impurities

In most applications helium-based plasma jets operate in an open-air environment. The presence of humid air in the plasma jet will influence the plasma chemistry and can lead to the production of a broader range of reactive species. We explore the influence of humid air on the reactive species in radio frequency (rf)-driven atmospheric-pressure helium-oxygen mixture plasmas (He-O, helium with 5000 ppm admixture of oxygen) for wide air impurity levels of 0-500 ppm with relative humidities of from 0% to 100% using a zero-dimensional, time-dependent global model. Comparisons are made with experimental measurements in an rf-driven micro-scale atmospheric pressure plasma jet and with one-dimensional semi-kinetic simulations of the same plasma jet. These suggest that the plausible air impurity level is not more than hundreds of ppm in such systems. The evolution of species concentration is described for reactive oxygen species, metastable species, radical species and positively and negatively charged ions (and their clusters). Effects of the air impurity containing water humidity on electronegativity and overall plasma reactivity are clarified with particular emphasis on reactive oxygen species. © 2013 IOP Publishing Ltd.

Application of fibre assemblies as damping elements in the automotive industry

This investigation aims to characterise the damping properties of the nonwoven materials with potential applications in automotive and aerospace industry. Nonwovens are a popular choice for many applications due to their relatively low manufacturing cost and unique properties. It is known that nonwovens are efficient energy dispersers for certain applications such as acoustic damping and ballistic impact. It is anticipated that these energy absorption properties could eventually be used to provide damping for mechanical vibrations. However the behaviour of nonwovens under dynamic load and vibration has not been investigated before. Therefore we intend to highlight these aspects of the behaviour of the nonwovens through this research. In order to obtain an insight to the energy absorption properties of the nonwoven fabrics, a range of tests has been performed. Forced vibration of the cantilever beam is used to explore damping over a range of resonance modes and input amplitudes. The tests are conducted on aramid, glass fibre and polyester fabrics with a range of area densities and various coatings. The tests clarified the general dynamic behaviour of the fabrics tested and the possible response in more real application condition as well. The energy absorption in both thickness and plane of the fabric is tested. The effects of the area density on the results are identified. The main absorption mechanism is known to be the friction. The frictional properties are improved by using a smaller fibre denier and increasing fibre length, this is a result of increasing contact surface between fibres. It is expected the increased friction result in improving damping. The results indicate different mechanism of damping for fiber glass fabrics compared to the aramid fabrics. The frequency of maximum efficiency of damping is identified for the fabrics tested. These can be used to recommend potential applications.

Comparison of methods used to calculate typical threshold values for potentially toxic elements in soil

The environmental quality of land can be assessed by calculating relevant threshold values, which differentiate between concentrations of elements resulting from geogenic and diffuse anthropogenic sources and concentrations generated by point sources of elements. A simple process allowing the calculation of these typical threshold values (TTVs) was applied across a region of highly complex geology (Northern Ireland) to six elements of interest; arsenic, chromium, copper, lead, nickel and vanadium. Three methods for identifying domains (areas where a readily identifiable factor can be shown to control the concentration of an element) were used: k-means cluster analysis, boxplots and empirical cumulative distribution functions (ECDF). The ECDF method was most efficient at determining areas of both elevated and reduced concentrations and was used to identify domains in this investigation. Two statistical methods for calculating normal background concentrations (NBCs) and upper limits of geochemical baseline variation (ULBLs), currently used in conjunction with legislative regimes in the UK and Finland respectively, were applied within each domain. The NBC methodology was constructed to run within a specific legislative framework, and its use on this soil geochemical data set was influenced by the presence of skewed distributions and outliers. In contrast, the ULBL methodology was found to calculate more appropriate TTVs that were generally more conservative than the NBCs. TTVs indicate what a "typical" concentration of an element would be within a defined geographical area and should be considered alongside the risk that each of the elements pose in these areas to determine potential risk to receptors.

Interference Investigation for Cognitive Spectrum Sharing Networks with Reactive DF Relay Selection

Cognitive radio (CR) with spectrum-sharing has been envisioned as emerging technology for the next generation of mobile and wireless networks by allowing the unlicensed customers simultaneously utilize the licensed radio frequency spectrums. However, the CR has faced some practical challenges due to its deduced system performance as compared to non spectrum-sharing counterpart. In this paper, we therefore consider the potential of incorporating the cooperative communications into CR by introducing the concept of reactive multiple decode-and-forward (DF) relays. In particular, we derive new results for exact and asymptotic expressions for the performance of cognitive relay networks with K-th best relay selection. Our novel results have exhibited the significance of using relay networks to enhance the system performance of CR.

Serum amyloid A-related inflammation is lowered by increased fruit and vegetable intake, while high-sensitive C-reactive protein, IL-6 and E-selectin remain unresponsive

The present study assessed whether increased fruit and vegetable (F&V) intake reduced the concentrations of the inflammatory marker serum amyloid A (SAA) in serum, HDL2 and HDL3 and whether the latter reduction influenced any of the functional properties of these HDL subfractions. The present study utilised samples from two previous studies: (1) the FAVRIT (Fruit and Vegetable Randomised Intervention Trial) study - hypertensive subjects (systolic blood pressure (BP) range 140-190 mmHg; diastolic BP range 90-110 mmHg) were randomised to receive a 1-, 3- or 6-portion F&V/d intervention for 8 weeks, and (2) the ADIT (Ageing and Dietary Intervention Trial) study - older subjects (65-85 years) were randomised to receive a 2- or 5-portion F&V/d intervention for 16 weeks. HDL2 and HDL3 were isolated by rapid ultracentrifugation. Measurements included the following: serum high-sensitive C-reactive protein (hsCRP) by an immunoturbidimetric assay; serum IL-6 and E-selectin and serum-, HDL2- and HDL3-SAA by ELISA procedures; serum-, HDL2- and HDL3-cholesterol ester transfer protein (CETP) activity by a fluorometric assay. Although the concentrations of hsCRP, IL-6 and E-selectin were unaffected by increasing F&V intake in both studies (P>0·05 for all comparisons), those of SAA in HDL3 decreased in the FAVRIT cohort (P= 0·049) and those in HDL2 and HDL3 decreased in the ADIT cohort (P= 0·035 and 0·032), which was accompanied by a decrease in the activity of CETP in HDL3 in the FAVRIT cohort (P= 0·010) and in HDL2 in the ADIT cohort (P= 0·030). These results indicate that SAA responds to increased F&V intake, while other inflammatory markers remain unresponsive, and this leads to changes in HDL2 and HDL3, which may influence their antiatherogenic potential. Overall, the present study provides tangible evidence of the effectiveness of increased F&V intake, which may be of use to health policy makers and the general public.

Mineralogical Characteristics and Transformations during Long-Term Operation of a Zerovalent Iron Reactive Barrier

Design and operation of Fe⁰ permeable reactive barriers (PRBs) can be improved by understanding the long-term mineralogical transformations that occur within PRBs. Changes in mineral precipitates, cementation, and corrosion of Fe⁰ filings within an in situ pilot-scale PRB were examined after the first 30 months of operation and compared with results of a previous study of the PRB conducted 15 months earlier using X-ray diffraction and scanning electron microscopy employing energy dispersive X-ray and backscatter electron analyses. Iron (oxy)hydroxides, aragonite, and maghemite and/or magnetite occurred throughout the cores collected 30 mo after installation. Goethite, lepidocrocite, mackinawite, aragonite, calcite, and siderite were associated with oxidized and cemented areas, while green rusts were detected in more reduced zones. Basic differences from our last detailed investigation include (i) mackinawite crystallized from amorphous FeS, (ii) aragonite transformed into calcite, (iii) akaganeite transformed to goethite and lepidocrocite, (iv) iron (oxy)hydroxides and calcium and iron carbonate minerals increased, (v) cementation was greater in the more recent study, and (vi) oxidation, corrosion, and disintegration of Fe⁰ filings were greater, especially in cemented areas, in the more recent study. If the degree of corrosion and cementation that was observed from 15 to 30 mo after installation continues, certain portions of the PRB (i.e., up-gradient entrance of the ground water to the Fe⁰ section of the PRB) may last less than five more years, thus reducing the effectiveness of the PRB to mitigate contaminants.

Impact of sample preparation on mineralogical analysis of zero-valent iron reactive barrier materials

Permeable reactive barriers (PRBs) of zero-valent iron (Fe⁰) are increasingly being used to remediate contaminated ground water. Corrosion of Fe⁰ filings and tbe formation of precipitates can occur when the PRB material comes in contact with ground water and may reduce the lifespan and effectiveness of the barrier. At present, there are no routine procedures for preparing and analyzing the mineral precipitates from Fe⁰ PRB material. These procedures are needed because mineralogical composition of corrosion products used to interpret the barrier processes can change with iron oxidation and sample preparation. The objectives of this study were (i) to investigate a method of preparing Fe⁰ reactive barrier material for mineralogical analysis by X-ray diffraction (XRD), and (ii) to identify Fe mineral phases and rates of transformations induced by different mineralogical preparation techniques. Materials from an in situ Fe⁰ PRB were collected by undisturbed coring and processed for XRD analysis after different times since sampling for three size fractions and by various drying treatments. We found that whole-sample preparation for analysis was necessary because mineral precipitates occurred within the PRB material in different size fractions of the samples. Green rusts quickly disappeared from acetone-dried samples and were not present in air-dried and oven-dried samples Maghemite/magnetite content increased over time and in oven-dried samples, especially after heating to 105°C. We conclude that care must be taken during sample preparation of Fe⁰ PRB material, especially for detection of green rusts, to ensure accurate identification of minerals present within the barrier system.

Elements of A New Framework for the principle of Equal Treatment of persons in EC Law

In June and November 2000, the European Parliament and the Council adopted two Directives referring to ‘the principle of equal treatment irrespective of’ in their title, one relating to racial and ethnic origin, the other to disability, age, religion and belief or sexual orientation. A thorough reform of Directive 76/207/EEC on the principle of equal treatment for women and men in employment matters is pending between the European Parliament's second reading and adoption while this is written. Community secondary legislation on equal treatment of persons has thus expanded in scope and number of reasons which must not serve as starting points for differentiation. Does this signify progress in legal protection against personal discrimination? While not providing a ready answer, this article proposes an analytical framework to answer this question, concentrating on conceptions of equality in general and in particular on the problems multi-dimensional discrimination might pose for the law.

Repeated measures of body mass index and C-reactive protein in relation to all-cause mortality and cardiovascular disease: Results from the consortium on health and ageing network of cohorts in Europe and the United States (CHANCES)

Obesity has been linked with elevated levels of C-reactive protein (CRP), and both have been associated with increased risk of mortality and cardiovascular disease (CVD). Previous studies have used a single ‘baseline’ measurement and such analyses cannot account for possible changes in these which may lead to a biased estimation of risk. Using four cohorts from CHANCES which had repeated measures in participants 50 years and older, multivariate time-dependent Cox proportional hazards was used to estimate hazard ratios (HR) and 95 % confidence intervals (CI) to examine the relationship between body mass index (BMI) and CRP with all-cause mortality and CVD. Being overweight (≥25–<30 kg/m2) or moderately obese (≥30–<35) tended to be associated with a lower risk of mortality compared to normal (≥18.5–<25): ESTHER, HR (95 % CI) 0.69 (0.58–0.82) and 0.78 (0.63–0.97); Rotterdam, 0.86 (0.79–0.94) and 0.80 (0.72–0.89). A similar relationship was found, but only for overweight in Glostrup, HR (95 % CI) 0.88 (0.76–1.02); and moderately obese in Tromsø, HR (95 % CI) 0.79 (0.62–1.01). Associations were not evident between repeated measures of BMI and CVD. Conversely, increasing CRP concentrations, measured on more than one occasion, were associated with an increasing risk of mortality and CVD. Being overweight or moderately obese is associated with a lower risk of mortality, while CRP, independent of BMI, is positively associated with mortality and CVD risk. If inflammation links CRP and BMI, they may participate in distinct/independent pathways. Accounting for independent changes in risk factors over time may be crucial for unveiling their effects on mortality and disease morbidity.

Integrating elements of undergraduate curriculum learning

Integrating elements of undergraduate curriculum learning Rapidly advancing practice and recognition of nursing, midwifery and medicine as a vital interrelated workforce, implies a need for a variety of curricula opportunities. This project addresses the challenge for healthcare educators to widen student engagement and participation through inter-professional education by creating learning environments whereby student interactions foster the desire to develop situational awareness, independent learning and contribution to patient advocacy. Overall aim of this ‘Feeding and Nutrition in Infants and Children’ project is to provide opportunities for integrated learning to enable students to advance their knowledge and understanding of current best practice. This Inter-professional (IPE) student-lead workshop was initially implemented in 2006-07 in collaboration with the Centre for Excellence in IPE, within the curricula of medical and nursing programmes¹. Supported by the development of a student resource pack, this project is now being offered to Learning Disability nursing and Midwifery students since September 2014. Methods: Fourth year medical students, undertaking a ‘Child Healthcare module’, alongside nursing and /or midwifery students are divided into groups with three or four students from each profession. Each group focuses on a specific feeding problem that is scenario-based on a common real-life issue prior to the workshop and then present their findings / possible solutions to feeding problem. They are observed by both facilitators and peers, who provide constructive feedback on aspects of performance including patient safety, cultural awareness, communication, decision making skills, teamwork and an appreciation of the role of various professionals in managing feeding problems in infants and children. Results: Participants complete a Likert-scale questionnaire to ascertain their reactions to this integrated learning experience. Ongoing findings suggest that students evaluate this learning activity very positively and have stated that they value the opportunity to exercise their clinical judgement and decision making skills. Most recent comments: ‘appreciate working alongside other student’s / multidisciplinary team approach’ As a group students engage in this team problem-solving exercise, drawing upon their strengths and abilities to learn from each other. This project provides a crucial opportunity for learning and knowledge exchange for all those medical, midwifery and nursing students involved. Reference: 1. Purdy, J. & Stewart, M (2009) ‘Feeding and Nutrition in Infants and Children: An Interprofessional Approach’. The Clinical Teacher, vol 6, no.3. Authors: Dr. Angela Bell, Centre for Medical Education, Queen’s University Belfast. Doris Corkin, Senior Lecturer (education), Children’s Nursing, School of Nursing & Midwifery, Queen’s University Belfast. Carolyn Moorhead, Midwifery Lecturer, School of Nursing & Midwifery, Queen’s University Belfast. Ann Devlin, Lecturer (education), Learning Disability Nursing, School of Nursing & Midwifery, Queen’s University Belfast.