Drosophila melanogaster Meigen: 3. sensibilidade ao carbofuran e biomonitoramento de seus resíduos em repolho

The susceptibility of Drosophila melanogaster to carbofuran and the use of this organism in biomonitoring residues of the insecticide in cabbage was evaluated. Under the conditions of the bioassay, residues-film bioassay in Petri dish, carbofuran degraded depending on the temperature and time of exposure. Bioassays conducted with D. melanogaster showed that its toxicity increases with temperature (20 to 35 °C). LC50 values, calculated as a function of temperature, ranged from 3.6 to 10.5 mg/g body weight (bw) for males and from 2.9 to 8.7 mg/g bw for females. The formulated product Furadan® G was applied on cabbage (Brassica oleracea, var. capitata) and the residues of carbofuran were determined by bioassay. The determination limit of the bioassay was 0.1 mg/kg and the method presented reproducibility with coefficient variation of 17 %. The validation of the bioassay by high performance liquid chromatography confirms the viability of the bioassay with D. melanogaster in monitoring the residues of carbofuran in cabbage.

Análise de resíduos de pesticidas em tomates por cromatografia em camada delgada

Pesticide residues are determined by thin layer chromatography (TLC) using the Hill reaction as a detection method. Tomatoes samples without pesticide were fortified with atrazine, diuron, chloroxuron and metribuzin, and were applyed in silica gel plates with the help of a microsyringe. The pesticides were elued with ethyl acetate. There was no need of cleaning up because no interference was noticed. After the revelation of the plates, the diameters of the spots were measure by using a rule. The range of the determined concentration for all the pesticides was from 0.1 to1.0 ng/muL. The results obtained through TLC can be used for semi-quantitative analysis.The results obtained were compared to gas and liquid chromatography, showing good agreement between both techniques.

Medidas de resistividade elétrica DC em sólidos: como efetuálas corretamente

This paper deals with the most common methods for determining the dc electrical resistivity in solid materials. A brief overview of the fundamental concepts related to the electrical resistivity on materials is introduced. Undoubtedly, the most common and useful procedure to determine the electrical resistivity (rho) is the fourpoint probe method. Some crucial mistakes regarding the experimental procedure and the appropriated correction factors are found in the literature. Thus, the correction factor for the most common sample geometries were gathered and revised in order to provide an easy way to use and apply them.

Agentes antineoplásicos biorredutíveis: uma nova alternativa para o tratamento de tumores sólidos

A problem often encountered in cancer therapy is the presence of tumor cell subpopulation that are resistant to treatment. Solid tumors frequently contain hypoxic cells that are resistant to killing by ionizing radiation and also by many chemotherapeutic agents. However, these hypoxic cells can be exploited for therapy by non-toxic hypoxic-activated prodrugs. Bioreductive drugs require metabolic reduction to generate cytotoxic metabolites. This process is facilitated by appropriate reductases and the lower oxygen conditions present in solid tumors. The unique presence of hypoxic cells in human tumors provides an important target for selective cancer therapy.

Breve revisão de métodos de determinação de resíduos do herbicida ácido 2,4-diclorofenoxiacético (2,4-D)

This paper supplies a revision about the main techniques of extraction, clean-up and pre-concentration of the herbicide 2,4-dichlorophenoxyacetic acid (2,4-D) in water and soil samples, as well as chromatographic methods and immune assays for its identification and quantification.

Laboratório de resíduos químicos do campus USP-São Carlos: resultados da experiência pioneira em gestão e gerenciamento de resíduos químicos em um campus universitário

A novel and unique in a brazilian university experience for rigorous handling of chemical residues of research and teaching is described. The activities since 1998 of a laboratory for the adequate treatment and recovery of chemicals at the São Carlos Campus of the University of São Paulo are summarized. The necessity of environment conscience future professional is enhanced.

Gerenciamento de resíduos laboratoriais: recuperação de elementos e preparo para descarte final

This work shows some laboratory waste management developed in order to recover some elements or to prepare the waste for a correct final disposal. The 25 elements chosen cover basically all chemical behaviors found for the metals in the Periodic Table. The treatments adopted were based on the classical behavior in aqueous solution (wet chemistry) but an important condition for a full success was the previous knowledge of the qualitative composition of the wastes treated. Some general trends were found: the final liquid waste was always saline and normally presented a higher volume than the original waste; most original wastes were acid in nature; steps such as solid-liquid separation, washing, evaporating and calcining were currently performed. This work was also a very good experience in chemistry in solution for students and showed them the need of treating wastes for a better environment.

Gerenciamento de resíduos químicos e águas servidas no laboratório de isótopos estáveis do CENA/USP

A system for disposal and recovery of the main effluents and chemical waist from isotope separation plants and enriched compounds-15N and 34S production has been carried out at the Stable Isotope Laboratory (LIE) of the CENA/USP. Around four hundred thousand liters of effluents has been recovered yearly. Among the recovered chemical wastes, the more relevant are: ammonia; brome; ammonium and sodium sulfate; sodium hydroxide; sulfur dioxide; and hydrochloric acid. Chemical wastes containg recoverable heavy metals (Ag, Cr and Cu) and solvents (methanol, ethanol and acetone) are processed and recovered. Gaseous emissions, mainly H2S are used for recovery of heavy metals solutions. The minimization of the residues waters, as well the reduction of electric energy consume was established using a water deionization system. A cost/effect balance of the process is reported.

Tratamento dos resíduos gerados na síntese de polianilina em escala pré-piloto

Polyaniline (PAni) is one of the most studied conducting polymer. It can be synthesized by two methods: electrochemical or chemical oxidation. The chemical oxidation is more adequate to produce large quantities of polymer. Regardless of the synthesis scale, the treatment of the residues before its final destination is very important and necessary because it contains toxic aniline derivatives (carcinogens in some cases), acids and inorganic salts, both with low toxicity. In this work we discuss the methods used to treat these residues and to eliminate and discard the toxic substances. These were extracted from the reaction residues by using activated coal and the pH of the residue was neutralized.

Transformações químicas da matéria orgânica durante a compostagem de resíduos da indústria madeireira

Composting of sawdust and paper mill sludge, using a "Kneer" process reactor, was studied in an attempt to elaborate upon organic matter (OM) transformation during the process and to define parameters to measure the compost maturity level. Temperature, electron paramagnetic resonance (EPR) data, ash and C, H, N and S contents, and a spectroscopic method using ultraviolet-visible (UV-VIS) for alkaline (pH = 8.5) and solid samples was used to study the maturity of the compost samples. These parameters were measured in 6 humic acids (HA) extracted from the compost samples during 29 days. The results of this work show that the "Kneer" process is efficient in transforming ligno-celulitic residues in a short time (29 days), into an organic fertilizer material with application perspectives.

Identificação de resíduos de disparos de armas de fogo por meio da técnica de espectrometria de massas de alta resolução com fonte de plasma indutivo

The violence derived from crimes involving firearms represents one of the main concerns of society. For this reason modern techniques have emerged in forensic science to identify suspects at crime scenes. This work describes a methodology to identify residues present in the hands of suspect by using a high resolution inductively coupled plasma mass spectrometry and collection procedure based on ethylenediaminetetraacetic acid (EDTA) solution as a complexing agent in moistened swabs. In order to distinguish real gunshot residues from others types of residues present in the hand of suspect, ternary ratio per cent diagrams were developed for antimony (Sb), barium (Ba) and lead (Pb) detected on the hands of volunteers, before and immediately after shooting tests, revealing a remarkable difference in both situations.

Programa de gerenciamento de resíduos dos laboratórios de graduação da Universidade Regional Integrada do Alto Uruguai e das Missões - Campus Erechim

This work presents a proposal for the management of residues from teaching laboratories. The main goals of the proposal are: scale reduction of experiments, reuse of residues as raw materials for new experiments and appropriate treatment and storage of residues. The methodology includes standardized labels for residue classification and registration of experimental classes and their residues in files. The management seemed to be efficient, resulting in a reduction of the amount of reagents utilized and residues generated, and an increase of reutilization of residues. A considerable decrease of needed storage space and suitable methods for correct residue disposal were achieved. We expect that all laboratories, including those exclusively for research activities, become involved, in a near future, in the Residue Management Project of URI - Campus Erechim.

Análise sistemática de reagentes e resíduos sem identificação

This work presents a detailed routine applied to the identification of unknown chemicals and wastes. 786 specimens were analyzed during 20 months. Unknown materials fell into three basic classes: (i) commercial chemicals without labels or illegible ones; (ii) laboratory synthesis products; (iii) used solvents (including mixtures). Uranium and thorium were recovered form their wastes. Unknown chemicals were mainly inorganic compounds, many of which had never been opened. Alkaline salts were dominant, but also precious metal compounds were identified. Laboratory synthesis products were organic compounds. The final destination depended on the nature of the chemical. Most organic compounds were sent to incineration; inorganic salts were distributed among several public organizations, including secondary and technical schools. The work described in this paper greatly reduced the amount of wastes that had to be sent to disposal.

Implantação de um programa de gerenciamento de resíduos químicos e águas servidas nos laboratórios de ensino e pesquisa no CENA/USP

The aim of this work is to establish a program for the treatment of chemical residues and waste waters at the Centro de Energia Nuclear na Agricultura (CENA/USP), for environmental preservation and training of staff. Five tons of stored residues and the ones currently generated in the laboratories have to be treated. Rational use of water is also part of the program. The traditional purification by distillation has been replaced by purification with ion exchange resins. Lower energy consumption and better water quality were achieved.