Fine-grained Pleistocene deepwater turbidite channel system on the slope of Qiongdongnan Basin, northern South China Sea

Recently, as oil exploitation has become focused on deepwater slope areas. more multi-channel high resolution 2D and 3D seismic data were acquired in the deepwater part of the Qiongdongnan Basin, northern South China Sea. Based on 3D seismic data and coherence time slice, RMS and 3D visualization, a series of deepwater channels were recognized on the slope that probably developed in the late Quaternary period. These channels trend SW-NE to W-E and show bifurcations, levees, meander loops and avulsions. High Amplitude Reflections (HARs), typical for channel-levee complexes, are of only minor importance and were observed in one of the channel systems. Most of the detected channels are characterized by low-amplitude reflections, and so are different from the typical coarse-grained turbidite channels that had been discovered worldwide. The absence of well data in the study area made it difficult to determine the age and lithology of these channels. Using a neighboring drill hole and published data about such depositional systems worldwide, the lithology of these channels is likely to be dominated by mudstones with interbedded thin sandstones. These channels are formed by turbidity currents originated from the little scale mountain river of mid-Vietnam in SW direction and were probably accompanied by a relative sea level drop in the last glacial age. These channels discovered on the northern South China Sea slope are likely to be fine-grained, mud-dominant and low N:G deposits in a deepwater paleogeographic setting. (C) 2009 Elsevier Ltd. All rights reserved.

Seismic stratigraphy of the Qiongdongnan deep sea channel system, northwest South China Sea

Based on more than 4000 km 2D seismic data and seismic stratigraphic analysis, we discussed the extent and formation mechanism of the Qiongdongnan deep sea channel. The Qiongdongnan deep sea channel is a large incised channel which extends from the east boundary of the Yinggehai Basin, through the whole Qiongdongnan and the Xisha trough, and terminates in the western part of the northwest subbasin of South China Sea. It is more than 570 km long and 4-8 km wide. The chaotic (or continuous) middle (or high) amplitude, middle (or high) continuity seismic facies of the channel reflect the different lithological distribution of the channel. The channel formed as a complex result of global sea level drop during early Pliocene, large scale of sediment supply to the Yinggehai Basin, inversion event of the Red River strike-slip fault, and tilted direction of the Qiongdongnan Basin. The large scale of sediment supply from Red River caused the shelf break of the Yinggehai Basin to move torwards the S and SE direction and developed large scale of prograding wedge from the Miocene, and the inversion of the Red River strike-slip fault induced the sediment slump which formed the Qiongdongnan deep sea channel.

Geomorphology, sedimentary processes and development of the Zenisu deep-sea channel, northern Philippine Sea

The Zenisu deep-sea channel originates on the Izu-Ogasawara island arc, and disappears in the Shikoku Basin of the Philippine Sea. The geomorphology, sedimentary processes, and the development of the Zenisu deep-sea channel were investigated on the basis of swath bathymetry, side-scan sonar imagery, submersible observations, and seismic data. The deep-sea channel can be divided into three segments according to the downslope gradient and channel orientation. They are the Zenisu Canyon, the E-W fan channel, and the trough-axis channel. The sediment fill is characterized by turbidite and debrite deposition and blocky-hummocky avalanche deposits on the flanks of the Zenisu Ridge. In the Zenisu Canyon and the Zenisu deep-sea channel, sediment transport by turbidity currents generates sediment waves (dunes) observed during the Shinkai 6500 dive 371. The development of the Zenisu Canyon is controlled by a N-S shear fault, whereas the trough-axis channel is controlled by basin subsidence associated with the Zenisu Ridge. The E-W fan channel was probably affected by the E-W fault and the basement morphology.

Sedimentary processes and development of the Zenisu deep-sea channel, Philippine Sea

Zenisu deep-sea channel originated from a volcanic arc region, Izu-Ogasawara Island Arc, and vanished in the Shikoku Basin of the Philippine Sea. According to the swath bathymetry, the deep-sea channel can be divided into three,segments. They are Zenisu canyon, E-W fan channel and trough-axis channel. A lot of volcanic detritus were deposited in the Zenisu Trough via the deep-sea channel because it originated from volcanic arc settings. On the basis of the swath bathymetry, submersible and seismic reflection data, the deposits are characterized by turbidite and debrite deposits as those in the other major deep-sea channels. Erosion or few sediments were observed in the Zenisu canyon, whereas a lot of turbidites and debrites occurred in the E-W channel and trough axis channel. Cold seep communities, active fault and fluid flow were discovered along the lower slope of the Zenisu Ridge. Vertical sedimentary sequences in the Zenisu Trough consist of the four post-rift sequence units of the Shikoku Basin, among which Units A and B are two turbidite units. The development of Zenisu canyon is controlled by the N-S shear fault, the E-W fan channel is related to the E-W shear fault, and the trough-axis channel is related to the subsidence of central basin.

Suspended particulate matter fluxes through the Straits of Dover, English Channel: observations and modelling

Suspended Particulate Matter (SPM) concentrations at various levels within the water column, together with salinity and temperature, were measured using water samples collected from six stations across the Straits of Dover. The sampling programme covered a 16-month period, undertaken during 23 cruises. On the basis of the spatial variability in the concentrations, the water bodies are divided by several boundaries, controlled by tidal and wind conditions. Within the water column, SPM concentrations were higher near the sea bed than in the surface waters. Throughout the cross-section, maximum concentrations occurred adjacent to the coastlines. Temporal variability in the SPM concentration exists on daily and seasonal scales within the coastal waters (4.2 to 74.5 mg L-1): resuspension processes, in response to semi-diurnal tidal cycles (with a period of around 12.4 h) and spring-neap cycles (with a period of 15 days) make significant contributions. Distinctive seasonal/annual concentration changes have also been observed. In the offshore waters, such variability is much less significant (0.9 to 6.0 mg L-1). In the summer the English Coastal Zone is associated with relatively high SPM concentrations: the Central Zone has a low and stable SPM concentration between these zones, there is a Transitional Zone, where there is a rapid response of SPM concentration to wind forcing. Finally, the French Coastal Zone is characterized by variable (sometimes high) SPM concentrations. Because of the zonation, SPM fluxes within the Dover Strait are controlled by different transport mechanisms. Within the Central Zone, the flux can be represented by the product of mean water discharges and SPM concentrations. However, within the coastal zones fluctuations in SPM concentrations on various time-scales must be considered. In order to calculate the maximum and minimum SPM fluxes, 10 cells were divided in the strait. A simple modelling calculation has been proposed for this complex area. The effect of spring-neap tidal cycles and seasonal changes can contribute significantly to the overall flux, which is of the order of 20 x 10(6) t.yr(-1) (through the Dover Strait, towards the North Sea). Such an estimate is higher than most obtained previously. (C) 2000 Ifremer/CNRS/IRD/Editions scientifiques et medicales Elsevier SAS.

Resuspension and advection processes affecting suspended particulate matter concentrations in the central English Channel

Suspended particulate matter (SPM) measurements obtained along a cross-section in the central English Channel (Wight-Cotentin transect) indicate that the area may be differentiated into: (1) an English coastal zone, associated with the highest concentrations; (2) a French coastal zone, with intermediate concentrations; and (3) the offshore waters of the Channel, characterised by a very low suspended-sediment load. The SPM particle-size distribution was modal close to the English coast (main mode 10-12 mu m); the remainder of the area was characterised by flat SPM distributions. Examination of the diatom communities in the SPM suggest:; that material resuspended in the intertidal zone and the estuarine environments was advected towards the offshore waters of the English Channel. Considerable variations in SPM concentrations occurred during a tidal cycle: maximum concentrations were sometimes up to 3 times higher than the minimum concentrations, Empirical orthogonal function (EOF) analysis of the SPM concentration time series indicates that, although the bottom waters were more turbid than the surficial waters, this was not likely to be the result of in situ sediment resuspension. Instead, the observed variations appear to be controlled mainly by advective mechanisms. The limited resuspension was probably caused by: (1) the limited availability of fine-grained material within the bottom sediments, and (2) 'bed-armouring' processes which protect the finer-grained fractions of the seabed material from erosion and entrainment within the overlying flow during the less energetic stages of the tide.

River mouth bar formation, riverbed aggradation and channel migration in the modern Huanghe (Yellow) River delta, China

This paper addresses the recent (1970s-1990s) processes of river mouth bar formation, riverbed aggradation and distributary migration in the Huanghe River mouth area, in the light of station-based monitoring, field measurements and remote sensing interpretation. The results show that the morphological changes of the river mouth bar have been closely associated with the largely reduced fluvial discharge and sediment load. Landforrn development such as bar progradation occurred in two phases, i.e. before and after 1989, which correspond to faster and lower bar growth rates, respectively. Fast riverbed aggradation in the mouth channel was strongly related to river mouth bar progradation. During 1976-1996, about 2.8% of the total sediment loads were deposited in the river channel on the upper to middle delta. Therefore, the river water level rose by a few meters from 1984 to 1996. The frequent distributary channel migration, which switched the radial channel pattern into the SE-directed pattern in the mid-1980s, was linked with mouth bar formation. Marine conditions also constrain seaward bar progradation. Furthermore, the history of river mouth bar formation reflects human impacts, such as dredging and dyking in order to stabilize the coastal area. (c) 2005 Elsevier B.V. All rights reserved.

The release behavior of inorganic nitrogen and phosphorus in sediment during disturbance

Sediments and surface water were sampled in a tide flat in the Huiquan Bay, Qingdao, China in January 2004 to simulate the exchange of NH4-N/NO3-N/PO43- between sediments and surface water. A working system was designed with which samples were shaken at 60, 120 and 150 revolutions per minute (r/min). Experiment results show that NH4-N concentration in water at shaking rate of 60 r/min decreased gradually, while at 120 r/min increased gradually. In resuspension, fine-grained sediments contributed most NH4-N to the seawater, followed by medium-grained and coarse-grained sediments. The NO3-N concentration in water had a negative relation, with the shaking rate; the medium-grained sediments contributed more NO3-N to seawater than the coarse- and fine-grained sediments. The PO43- concentration is positively related with the shaking rate, the fine-grained sediments were the main N and P contributor to the seawater, followed by medium- and coarse-grained sediments.

Endothelial cells release phenotypically and quantitatively distinct microparticles in activation and apoptosis

Background: Endothelial cells (EC) shed endothelial microparticles (EMP) in activation and apoptosis. Objectives: We compared the antigenic expression of EMP species released during activation as compared to apoptosis, in three cell lines. Methods: EC from renal and brain microvascular (MiVEC) and coronary macrovascular (MaVEC) origin were incubated with TNF-alpha to induce activation, or deprived of growth factors to induce apoptosis. Antigens expressed on EMP and EC were assayed flow cytometrically and included constitutive markers (CD31, CD51/61, CD105), inducible markers (CD54, CD62E and CD106), and annexin V binding. Results: It was found that in apoptosis, constitutive markers in EMP were markedly increased (CD31>CD105), with a concomitant decrease in expression in EC. Annexin V EC surface binding and annexin V+ EMP were more sharply increased in apoptosis than in activation. In contrast, in activation, inducible markers in EMP were markedly increased in both EMP and EC (CD62E>CD54>CD 106). Coronary MaVEC released significantly less EMP than MiVEC. Conclusion: EC release qualitatively and quantitatively distinct EMP during activation compared to apoptosis. Analysis of EMP phenotypic signatures may provide clinically useful information on the status of the endothelium. (C) 2003 Elsevier Science Ltd. All rights reserved.