A tapestry of land uses and land covers typify our study site. Here, a commercial farm surrounds a new residential development.

This material is based upon work supported by the National Science Foundation through the Florida Coastal Everglades Long-Term Ecological Research program under Cooperative Agreements #DBI-0620409 and #DEB-9910514. This image is made available for non-commercial or educational use only.

Design and analysis of micro-channel heat-exchanger embedded in Low Temperature Co-fire Ceramic (LTCC)

Increased device density, switching speeds of integrated circuits and decrease in package size is placing new demands for high power thermal-management. The convectional method of forced air cooling with passive heat sink can handle heat fluxes up-to 3-5W/cm2; however current microprocessors are operating at levels of 100W/cm2, This demands the usage of novel thermal-management systems. In this work, water-cooling systems with active heat sink are embedded in the substrate. The research involved fabricating LTCC substrates of various configurations - an open-duct substrate, the second with thermal vias and the third with thermal vias and free-standing metal columns and metal foil. Thermal testing was performed experimentally and these results are compared with CFD results. An overall thermal resistance for the base substrate is demonstrated to be 3.4oC/W-cm2. Addition of thermal vias reduces the effective resistance of the system by 7times and further addition of free standing columns reduced it by 20times.

Review of greenhouse gas emissions from the storage and land application of farm dairy effluent

The amounts of farm dairy effluent stored in ponds and irrigated to land have steadily increased with the steady growth of New Zealand's dairy industry. About 80% of dairy farms now operate with effluent storage ponds allowing deferred irrigation. These storage and irrigation practices cause emissions of greenhouse gases (GHG) and ammonia. The current knowledge of the processes causing these emissions and the amounts emitted is reviewed here. Methane emissions from ponds are the largest contributor to the total GHG emissions from effluent in managed manure systems in New Zealand. Nitrous oxide emissions from anaerobic ponds are negligible, while ammonia emissions vary widely between different studies, probably because they depend strongly on pH and manure composition. The second-largest contribution to GHG emissions from farm dairy effluent comes from nitrous oxide emissions from land application. Ammonia emissions from land application of effluent in New Zealand were found to be less than those reported elsewhere from the application of slurries. Recent studies have suggested that New Zealand's current GHG inventory method to estimate methane emissions from effluent ponds should be revised. The increasing importance of emissions from ponds, while being a challenge for the inventory, also provides an opportunity to achieve mitigation of emissions due to the confined location of where these emissions occur. © 2015 © 2015 The Royal Society of New Zealand.

EFFECT OF FARMING PRACTICES AND FARM HISTORY ON INCIDENCE OF COCONUT LETHAL YELLOWING IN MOZAMBIQUE

Management of coconut ( Cocos nucifera ) lethal yellowing disease (CLYD), which has killed about eight million coconut trees in Mozambique, has proved challenging. The objective of this study was to investigate the impact of farming practices and related history, on the CLYD incidence in Mozambique. The methodology included a socioeconomic questionnaire to the households and direct observations on the palm farms. The collected data were analysed using logistic regression. Five out of 11 explanatory variables tested, namely farm age, availability of other palm species on the coconut farm, type of coconut varieties grown, root cut practices, and intercropping had a significant (P< 0.05) effect on CLYD incidence. Coconut farms <10 years had higher odds of higher disease incidence compared to the farms between 10 to 40 years old. The presence of other palm species in the coconut farms had two times higher odds of having higher disease incidence levels compared to farms without other palm species. Tall coconut varieties were likely to be more tolerant to CLYD compared to dwarf varieties. Coconut farms with some kind of intercropping had two times higher odds of having higher disease incidence levels compared to pure stands. The practice of cutting coconut roots had three times higher odds of having high disease incidence levels compared to non-practicing farms. Farm age, availability of other palm species on the coconut farm, type of coconut varieties grown, root cut practices and intercropping need to be considered for integrated CLYD management.

Topographical map of Jersey City, Hoboken, and the adjacent country : describing minutely the courses of rivers and brooks, the township and original patent lines, railways, turnpike, carriage and bridle roads, the present farm boundaries with the names of their proprietors : a correct plan of public grounds and gentlemen's country seats, the position of farm houses, forests, swamps, and marshes, showing a complete view of the face of the country /

Shows cadastral and topographic data (land tracts with proprietors' names) in unurbanized areas.

Mathematical analysis of maximum power generated by photovoltaic systems and fitting curves for standard test conditions

The rural electrification is characterized by geographical dispersion of the population, low consumption, high investment by consumers and high cost. Moreover, solar radiation constitutes an inexhaustible source of energy and in its conversion into electricity photovoltaic panels are used. In this study, equations were adjusted to field conditions presented by the manufacturer for current and power of small photovoltaic systems. The mathematical analysis was performed on the photovoltaic rural system I- 100 from ISOFOTON, with power 300 Wp, located at the Experimental Farm Lageado of FCA/UNESP. For the development of such equations, the circuitry of photovoltaic cells has been studied to apply iterative numerical methods for the determination of electrical parameters and possible errors in the appropriate equations in the literature to reality. Therefore, a simulation of a photovoltaic panel was proposed through mathematical equations that were adjusted according to the data of local radiation. The results have presented equations that provide real answers to the user and may assist in the design of these systems, once calculated that the maximum power limit ensures a supply of energy generated. This real sizing helps establishing the possible applications of solar energy to the rural producer and informing the real possibilities of generating electricity from the sun.

Experimental and Numerical Analysis of Gas Flows in Microchannels and Micro Heat Exchanger

Due to increased interest in miniaturization, great attention has been given in the recent decade to the micro heat exchanging systems. Literature survey suggests that there is still a limited understanding of gas flows in micro heat exchanging systems. The aim of the current thesis is to further the understanding of fluid flow and heat transfer phenomenon inside such geometries when a compressible working fluid is utilized. A combined experimental and numerical approach has been utilized in order to overcome the lack of employable sensors for micro dimensional channels. After conducting a detailed comparison between various data reduction methodologies employed in the literature, the best suited methodology for gas microflow experimentalists is proposed. A transitional turbulence model is extensively validated against the experimental results of the microtubes and microchannels under adiabatic wall conditions. Heat transfer analysis of single microtubes showed that when the compressible working fluid is used, Nusselt number results are in partial disagreement with the conventional theory at highly turbulent flow regime for microtubes having a hydraulic diameter less than 250 microns. Experimental and numerical analysis on a prototype double layer microchannel heat exchanger showed that compressibility is detrimental to the thermal performance. It has been found that compressibility effects for micro heat exchangers are significant when the average Mach number at the outlet of the microchannel is greater than 0.1 compared to the adiabatic limit of 0.3. Lastly, to avoid a staggering amount of the computational power needed to simulate the micro heat exchanging systems with hundreds of microchannels, a reduced order model based on the porous medium has been developed that considers the compressibility of the gas inside microchannels. The validation of the proposed model against experimental results of average thermal effectiveness and the pressure loss showed an excellent match between the two.

Evaluation of the sustainability level of a dairy and poultry farm: The Response-Inducing Sustainability Evaluation (RISE) method

Within this master thesis, various aspects related to the issue of sustainability in the food sector were addressed, focusing on the greenhouse gas emissions derived from livestock production. The increment in population number and wealth is directly related to the growing demand for meat products, which is, in turn, related to an increase in greenhouse gas emissions. Consumers are becoming more and more aware of these environmental issues and, therefore, sustainability factors are becoming even more relevant also from the environmental point of view. A very useful tool in this field is Response-Inducing Sustainability Evaluation (RISE), a software that allows you to determine the sustainability of a farm under many aspects, like energy consumption, livestock management and soil use. The RISE software processes the information obtained through a questionnaire submitted by the farmer, in which 10 different areas of sustainability in the farm are covered. For each theme, the results are expressed clearly with a score that goes from 0 to 100. The experimentation discussed in this work included two different projects, one regarding a dairy farm and the other regarding a poultry farm. The first one was conducted on a dairy farm in Germany and the results allowed to highlight the weakest areas of the farm on which recommendations were given for ecological improvement. The second project was conducted on a chicken broiler farm in Italy, on an experimental basis since it was the first time that the software was applied to poultry. The results pointed out the aspects that can be improved in the RISE software in order to make it more suitable for future poultry studies.

Multivariate analysis of the effects of soil parameters and environmental factors on the flavonoid content of leaves of Passiflora incarnata L., Passifloraceae

The aim of the present study was to evaluate the effect of soil characteristics (pH, macro- and micro-nutrients), environmental factors (temperature, humidity, period of the year and time of day of collection) and meteorological conditions (rain, sun, cloud and cloud/rain) on the flavonoid content of leaves of Passiflora incarnata L., Passifloraceae. The total flavonoid contents of leaf samples harvested from plants cultivated or collected under different conditions were quantified by high-performance liquid chromatography with ultraviolet detection (HPLC-UV/PAD). Chemometric treatment of the data by principal component (PCA) and hierarchic cluster analyses (HCA) showed that the samples did not present a specific classification in relation to the environmental and soil variables studied, and that the environmental variables were not significant in describing the data set. However, the levels of the elements Fe, B and Cu present in the soil showed an inverse correlation with the total flavonoid contents of the leaves of P. incarnata.

Fractionation of Zn, Cd and Pb in a Tropical Soil After Nine-Year Sewage Sludge Applications

A long-term field experiment was carried out in the experiment farm of the Sao Paulo State University, Brazil, to evaluate the phytoavailability of Zn, Cd and Pb in a Typic Eutrorthox soil treated with sewage sludge for nine consecutive years, using the sequential extraction and organic matter fractionation methods. During 2005-2006, maize (Zea mays L.) was used as test plants and the experimental design was in randomized complete blocks with four treatments and five replicates. The treatments consisted of four sewage sludge rates (in a dry basis): 0.0 (control, with mineral fertilization), 45.0, 90.0 and 127.5 t ha(-1), annually for nine years. Before maize sowing, the sewage sludge was manually applied to the soil and incorporated at 10 cm depth. Soil samples (0-20 cm layer) for Zn, Cd and Pb analysis were collected 60 days after sowing. The successive applications of sewage sludge to the soil did not affect heavy metal (Cd and Pb) fractions in the soil, with exception of Zn fractions. The Zn, Cd and Pb distributions in the soil were strongly associated with humin and residual fractions, which are characterized by stable chemical bonds. Zinc, Cd and Pb in the soil showed low phytoavailability after nine-year successive applications of sewage sludge to the soil.