Preliminary chemical and physical evaluation of some formulated feeds for P. monodon

The culture of Penaeus monodon has explicitly defined the need for diet formulations or supplementary feeds that would promote optimum growth and survival of the animal. A total of 28 feed combinations were developed for P. monodon. Fish meal, shrimp head meal, squid head meal, Ascetes spp. rice bran, and soybean cake were used as primary ingredients in these feeds. The commercial vitamin mix No. 22 was added to the dry ingredients. Gelatinized corn starch and wheat flour were used as binders. The pellets were extruded using a portable kitchen grinder with a diameter of 4 mm. The products were either sun-dried for 8 hours or oven-dried overnight at 50 degree C to stabilize moisture at 8-10%. The pellets were then kept in covered glass bottles and stored in the laboratory at room temperature. The cost of the feeds excluding labour were also computed. The pellets were analyzed for protein, fat, carbohydrate, crude fiber, ash, and moisture contents using standard procedures. They were also analyzed for water stability. To test the stability of pellets in water, 2-g samples were placed in plankton nets (mesh #40) and suspended in water for two, and six hours. The undissolved samples were then vacuum-dried and the moisture determined. Cost of the feeds ranged from P1.10 to P2.60 per kg depending on the feed ingredient. Squid and Ascetes spp. were rather expensive for use as basic ingredients. Proximate analysis of dry weight showed percentage protein content ranged from 20-63 g; fat, 8-20 g; carbohydrate (by difference), 11-36 g; ash, 8-28 g; moisture, 6-11 g; and crude fiber, 5 . 13 g. Stability tests showed that after two hours, 35-88% of solids remained intact and after 6 hours, 20-55% of the pellets remained undissolved. When a pellet disintegrates easily, pollution of the water occurs. Chances for the shrimp to feed on the pellet is minimized when the pellet is unstable. Thus, the search for a more compact feed pellet has to be continued.

Preliminary biological evaluation of some formulated feeds for P. monodon

Rice bran is widely used by fish farmers as supplementary feed while soybean cake is used both as feed and as fertilizer in fishponds. Both fish meal and shrimp head have been found acceptable as feed ingredients. However, not much is known of the acceptability and efficiency of a mixture of these ingredients as feed for Penaeus monodon larvae. Ninety 127-day old P. monodon were measured for length and weight and were randomly divided into nine aquaria each containing 20 liters of water. These were fed 'lampirong' for two months previous to the study. There were three replications for each treatment. Length, weight, and survival rates were used to compare the efficiency of the diets. Weighed amounts of pellets equivalent to 100% of the body weight were fed during the first three days and reduced to 50% thereafter. A stopwatch was used to determine the length of time that elapsed before the shrimps would approach the pellet. Ten shrimps approximately 4 months in age were placed in 10 liters of water in a 25-liter aquarium. Two grams of each pellet type were placed simultaneously on opposite sides of the aquarium. The time that elapsed from the moment the pellets sunk to the bottom up to the time that any one shrimp approached the pellets was recorded. The group fed the imported pellets gained the most. Those fed FP-2s-77 elongated faster than those fed FP-1s-77. Survival rate of those fed FP-2s-77 was 37% while those fed imported pellets was 73%. Both 1s and 2s pellets disintegrated in water easily but the imported pellets were stable even after six hours in water. The attractability test for the pellets showed that the prawns were more readily attracted to the pellets 1s and 2s than to the imported pellets.

Effect of nitrite, ammonia, and temperature on P. monodon larvae

P. monodon larvae were studied for the effects of temperature, ammonia, and nitrite on survival. Toxicity levels of nitrite were found to vary with larval stage. Larvae could tolerate ammonia up to about 10 ppm, with the effect more clearly shown by the zoea stage. Survival and growth were not significantly affected by temperature, although moulting was enhanced at temperatures higher than 29 C. Larvae of P. monodon have lower tolerance toward nitrite and ammonia compared to postlarvae. Although high survival was obtained at low levels of nitrite and ammonia, it is still necessary to know their effects on metabolism, in order to examine possible biochemical parameters for diagnosing sublethal toxicity or stress.

Survival, growth and production of Penaeus monodon and P. indicus at different density combinations with milkfish

Penaeus monodon and P. indicus juveniles were stocked and reared for about 3 months in earthen ponds at different density combinations with Chanos chanos. The presence of either Penaeus species at any density ratio did not affect significantly the C. chanos survival. Survival rates of the penaeids indicated that intraspecific and interspecific competition occurred and were reduced with the reduction in stocking rate. It is concluded that further studies on higher density ratios and feeding and economic consideration would be of help to the development of this kind of fishpond management system.

Anti Human Immunodeficiency Virus Type 1 (HIV-1) Agents 4. Discovery of 5,5 '-(p-Phenylenebisazo)-8-hydroxyquinoline Sulfonates as New HIV-1 Inhibitors in Vitro

To search for compounds with superior anti-human immunodeficiency virus type 1 (HIV-1) activity, ten 5,5'-(p-phenylenebisazo)-8-hydroxyquinoline sulfonates (4a-j) were synthesized and preliminarily evaluated as HIV-1 inhibitors in vitro for the first time. Some compounds demonstrated anti-HIV-1 activity, especially 5,5'-(p-phenylenebisazo)-8-hydroxyquinoline p-ethylbenzenesulfonate (4g) and 5,5'-(p-phenylenebisazo)-8-hydroxyquinoline p-chlorobenzenesulfonate (41) showed the more potent anti-HIV-1 activity with 50% effective concentration (EC50) values of 2.59 and 4.01 mu g/ml, and therapeutic index (TI) values of 31.77 and 24.51, respectively.

猫基底前脑胆碱能皮质投射神经元区的P物质样免疫反应神经元

在猫基底前脑内侧隔核-斜角带核-基底核,P物质能神经元主要分布在内侧隔核-斜角带核,多数P物质能和胆碱能神经元各自归属不同的神经元亚群。

The study of biological characteristics and determination of population dynamic parameters of sawtooth barracuda (Sphyraena putnamae) in the Persian Gulf (Hormozgun Province waters)

The biological characteristics and population dynamisms of Sphyraena putnamae, were studied in the northern Persian Gulf and Oman Sea restricted to Hormuzgan province waters within 13 months period, from November 2006 up to November 2007. Biometrical and anatomical measurements were carried out, and biological surveys were conducted on 486 specimens. On the other hand, the growth and mortality parameters were estimated by using 3096 samples. These samples were collected from 3 landings, namely Bandar Abbas, Bandar Lengeh and Bandar Jask. The measurements of the minimum and maximum Fork lengths and weights were 11.7 to 8.03 cm and 135.0 to 4140.0 g, respectively. The results indicated that this species, having the Relative Length of Gut, RLG=0.34±0.002, is strongly carnivorous (often fish-eater), proven by the fact that more than 98% of its stomach contents were fish pieces. Examining the changes in the index of stomach emptiness by the percentage of CV = 0.47% indicates that this fish is Moderate feeder. The level of feeding increased in March, before spawning and decreased in June and September, simultaneously with the spawning season. There are 2 peaks of reproduction or spawning seasons during the months of April-May and September, of which the prior is assumed as the main spawning. The sex ratio (M:F) was calculated 0.5:1.0(X2 =2.11), which did not show a significant difference with expected level of 1:1 (P>0.05). The average absolute and relative reproduction rates of Sphyraena putnamae is respectively as follows: 1866827.1±255448.9 and 1097.7±94.3. The highest and the lowest diameter of matured egg are from 200 to 750 μ, and its average diameter is 402.10 ± 0.190 μ. A parameter for Saw-tooth barracuda length measurement, Lm50, based on the Fork-length, was calculated as 54.01 cm. In other words, as far as the fisheries management is concerned, the fish whose lengths are less than 54.01 cm should not be caught. The calculated level of (R2) (correlations of total length & weight), indicated strong correlations between length and weight of this fish, and the obtained formula included W =0.007100 FL 2.9295 and reinforced this assumption. The “K” Index for this fish in 3 above mentioned landings (Jask, Bandar-Abbas and Bandar-Length) were 1.24, 0.37 and 0.46 per year, respectively and the FL index for the same landings were estimated as 129, 110 and 134 cm, respectively. The growth coefficient (MONRO) for the above mentioned regions were calculated as 3.601, 3.647 and 3.917, respectively; and in the surveyed regions there were no significant differences in populations. The Total mortality coefficient (Z) was calculated 0.76, 1.12 and 1.07 per year, the Natural mortality coefficient was 0.46, 0.63 and 0.70, and the Fishing mortality coefficient (rate) (F) was found to be 0.30, 0.49 and 0.37 per year. The value of the exploitation rate (E) is equal to 0.39 per year, indicating that this species is an under-exploited resource, and there is no excessive fishing pressure on the fish supply of this species in the afore-said regions. The highest level of exploitation was found for ‘Bandar Abbas’ fishing region and the lowest level of exploitation is in ‘Bandar Lengeh’ waters.

Switching characteristics of diamond-based m-i-p+ diodes in power electronic applications

Modeling and numerical analysis of diamond m-i-p+ diode have been performed for static and transient analysis using TCAD Sentaurus platform. The simulation results are compared with experimental measurements. Prediction of transient turn-off characteristics of diamond m-i-p+ diode at high temperature is performed for the first time. It was found that unlike conventional Si diode, peak reverse current in diamond m-i-p+ diode reduces with increasing temperature while on-state voltage drop increases. © 2011 IEEE.

Low temperature (< 100 °c) deposited P-type cuprous oxide thin films: Importance of controlled oxygen and deposition energy

With the emergence of transparent electronics, there has been considerable advancement in n-type transparent semiconducting oxide (TSO) materials, such as ZnO, InGaZnO, and InSnO. Comparatively, the availability of p-type TSO materials is more scarce and the available materials are less mature. The development of p-type semiconductors is one of the key technologies needed to push transparent electronics and systems to the next frontier, particularly for implementing p-n junctions for solar cells and p-type transistors for complementary logic/circuits applications. Cuprous oxide (Cu2O) is one of the most promising candidates for p-type TSO materials. This paper reports the deposition of Cu2O thin films without substrate heating using a high deposition rate reactive sputtering technique, called high target utilisation sputtering (HiTUS). This technique allows independent control of the remote plasma density and the ion energy, thus providing finer control of the film properties and microstructure as well as reducing film stress. The effect of deposition parameters, including oxygen flow rate, plasma power and target power, on the properties of Cu2O films are reported. It is known from previously published work that the formation of pure Cu2O film is often difficult, due to the more ready formation or co-formation of cupric oxide (CuO). From our investigation, we established two key concurrent criteria needed for attaining Cu2O thin films (as opposed to CuO or mixed phase CuO/Cu2O films). First, the oxygen flow rate must be kept low to avoid over-oxidation of Cu2O to CuO and to ensure a non-oxidised/non-poisoned metallic copper target in the reactive sputtering environment. Secondly, the energy of the sputtered copper species must be kept low as higher reaction energy tends to favour the formation of CuO. The unique design of the HiTUS system enables the provision of a high density of low energy sputtered copper radicals/ions, and when combined with a controlled amount of oxygen, can produce good quality p-type transparent Cu2O films with electrical resistivity ranging from 102 to 104 Ω-cm, hole mobility of 1-10 cm2/V-s, and optical band-gap of 2.0-2.6 eV. These material properties make this low temperature deposited HiTUS Cu 2O film suitable for fabrication of p-type metal oxide thin film transistors. Furthermore, the capability to deposit Cu2O films with low film stress at low temperatures on plastic substrates renders this approach favourable for fabrication of flexible p-n junction solar cells. © 2011 Elsevier B.V. All rights reserved.

黑叶猴(Presbytis francoisi)和菲氏叶猴(P.phayrei)的动脉

首次报道了对黑叶猴和菲氏叶猴的动脉的系统解剖观察, 记述了这二种叶猴 动脉分支的主要特征。并与其他灵长类比较结果表明, 叶猴的动脉除具有猴超 科共同特征外, 有些特征与类人猿相似, 比其他猴类更为进化, 部分特征似为 叶猴所特有。图5参18

黑叶猴(Presbytis francoisi)和菲氏叶猴(P.phayrei)四肢肌的主要特征

黑叶猴和菲氏叶猴的上肢肌和下腩肌系统解剖结果表明, 大部分与猴超科的 共同特征相一致, 也有一些差异。通过与其他灵长类的比较对存在差异的20条 上肢肌和17条下肢肌作了描述和讨论。参14