Wire bond reliability for power electronic modules - effect of bonding temperature

In this paper, thermal cycling reliability along with ANSYS analysis of the residual stress generated in heavy-gauge Al bond wires at different bonding temperatures is reported. 99.999% pure Al wires of 375 mum in diameter, were ultrasonically bonded to silicon dies coated with a 5mum thick Al metallisation at 25degC (room temperature), 100degC and 200degC, respectively (with the same bonding parameters). The wire bonded samples were then subjected to thermal cycling in air from -60degC to +150degC. The degradation rate of the wire bonds was assessed by means of bond shear test and via microstructural characterisation. Prior to thermal cycling, the shear strength of all of the wire bonds was approximately equal to the shear strength of pure aluminum and independent of bonding temperature. During thermal cycling, however, the shear strength of room temperature bonded samples was observed to decrease more rapidly (as compared to bonds formed at 100degC and 200degC) as a result of a high crack propagation rate across the bonding area. In addition, modification of the grain structure at the bonding interface was also observed with bonding temperature, leading to changes in the mechanical properties of the wire. The heat and pressure induced by the high temperature bonding is believed to promote grain recovery and recrystallisation, softening the wires through removal of the dislocations and plastic strain energy. Coarse grains formed at the bonding interface after bonding at elevated temperatures may also contribute to greater resistance for crack propagation, thus lowering the wire bond degradation rate

Recovery of Bacillus thuringiensis in vegetative form from the phylloplane of clover (Trifolium hybridum) during a growing season

Two media were developed which specifically allow the cultivation of Bacillus thuringiensis while it is in the vegetative as opposed to the spore form. Using these media B. thuringiensis was shown conclusively for the first time to exist in an active form on the phylloplane. The profile of its appearance in vegetative and spore form was followed over a growing season on clover (Trifolium hybridum) in the field. Three simultaneous and sudden rises and declines of both spore and vegetative cell densities were observed. The most common other spore-former on these leaves was Bacillus cereus but the fluctuations in appearance of these two very closely related species were not co-incident. Using specific PCR primers a considerable diversity of cry toxin gene types was found in isolates that had been recovered in vegetative form ([`]vegetative isolates') with the majority possessing multiple [delta]-endotoxin genes while some had only one of those tested. Bioassays against a lepidopteran insect of purified [delta]-endotoxins showed that they were no more potent than those from a laboratory-adapted strain. PCR primers for an internal region of the vip3A gene produced amplification in 70% of the vegetative isolates compared to 25% of the laboratory-adapted strains tested.

Guide to the coastal and surface zooplankton of the south-western Indian Ocean. Occasional Publication of the Marine Biological Association 15

A guide compiled as an aid to researchers in the identification of the coastal and shallow water, south-western Indian Ocean pelagic zooplankton, as much of the identification literature covering this area of amazing biodiversity is currently spread through the scientific literature and not accessible without extensive library resources. Most zooplankton groups, except fish larvae and eggs, have been covered, but some specialist groups have not yet been dealt with in great detail. However, a selection of representative members of most groups have been given, so that organisms can at least be assigned to perhaps a particular genus within the main group. The species list is based on zooplankton sampling carried out round the coastal areas of the islands of Mahé and Aldabra (Seychelles), Rodrigues (Mauritius), Madagascar and from a sampling transect between Seychelles and Rodrigues. The guide therefore includes a high proportion of the island-coastal and surface water zooplankton of the whole Indian Ocean. The location where a particular species has been sampled has been noted and some species that have not been sampled, but are known to occur in the region, have been included. Comprehensive taxonomic information has not been presented, but sufficient information should be given to identify each species. Keys have not yet been included for genera, as further species will be added. A bibliography of relevant plankton references has also been included.

Recovery of a biodiversity action plans species in northwest England: possible role of climate change, artificial habitat and water quality amelioration. Occasional Publication of the Marine Biological Association 16

The honeycomb reef worm Sabellaria alveolata is recognised as being an important component of intertidal communities. It is a priority habitat within the UK Biodiversity Action Plan and as a biogenic reef forming species is covered by Annex 1 of the EC habitats directive. S. alveolata has a lusitanean (southern) distribution, being largely restricted to the south and west coasts of England. A broad-scale survey of S. alveolata distribution along the north-west coasts was undertaken in 2003/2004. These records were then compared with previous distribution records, mainly those collected by Cunningham in 1984. More detailed mapping was carried out at Hilbre Island at the mouth of the River Dee, due to recent reports that S. alveolata had become re-established there after a long absence.