Production and dissolution rates of earthworm-secreted calcium carbonate

Earthworms secrete granules of calcium carbonate. These are potentially important in soil biogeochemical cycles and are routinely recorded in archaeological studies of Quaternary soils. Production rates of calcium carbonate granules by the earthworm Lumbricus terrestris L. were determined over 27 days in a range of soils with differing chemical properties (pH, organic matter content, water holding capacity, bulk composition, cation exchange capacity and exchangeable cations). Production rate varied between soils, lay in the range 0–0.043 mmolCaCO3 (0–4.3 mg) earthworm−1 d−1 with an average rate of 8 × 10−3 mmolCaCO3 (0.8 mg) earthworm−1 d−1 and was significantly correlated (r = 0.68, P ≤ 0.01) with soil pH. In a second experiment lasting 315 days earthworms repeatedly (over periods of 39–57 days) produced comparable masses of granules. Converting individual earthworm granule production rates into fluxes expressed on per hectare of land per year basis depends heavily on estimates of earthworm numbers. Using values of 10–20 L. terrestris m−2 suggests a rate of 18– 3139 molCaCO3 ha−1 yr−1. Data obtained from flow-through dissolution experiments suggest that at near neutral pH, granule geometric surface areanormalised dissolution rates are similar to those for other biogenic and inorganic calcium carbonate. Fits of the data to the dissolution relationship r = k(1 − ˝)n where r = dissolution rate, k = a rate constant, ˝ = relative saturation and n = the reaction order gave values of k = 1.72 × 10−10 mol cm−2 s−1 and n = 1.8 for the geometric surface area-normalised rates and k = 3.51 × 10−13 mol cm−2 s−1 and n = 1.8 for the BET surface area-normalised rates. In 196 day leaching column experiments trends in granule dissolution rate referenced to soil chemistry corresponded to predictions made by the SLIM model for dissolution of limestone in soil. If soil solution approaches saturation with respect to calcium carbonate granule dissolution will slow or even stop and granules be preserved indefinitely. Granules have the potential to be a small but significant component of the biogeochemical cycling of C and Ca in soil.

Dielectric properties of process cheese from 0.3 to 3 Ghz

Dielectric properties of 16 process cheeses were determined over the frequency range 0.3-3 GHz. The effect of temperature on the dielectric properties of process cheeses were investigated at temperature intervals of 10 degrees C between 5 and 85 degrees C. Results showed that the dielectric constant decreased gradually as frequency increased, for all cheeses. The dielectric loss factor (epsilon") decreased from above 125 to below 12 as frequency increased. epsilon' was highest at 5 degrees C and generally decreased up to a temperature between 55 and 75 degrees C. epsilon" generally increased with increasing temperature for high and medium moisture/fat ratio cheeses. epsilon" decreased with temperature between 5 and 55 degrees C and then increased, for low moisture/fat ratio cheese. Partial least square regression models indicated that epsilon' and epsilon" could be used as a quality control screening application to measure moisture content and inorganic salt content of process cheese, respectively. (c) 2005 Elsevier Ltd. All rights reserved..

Correlation between process cheese meltability determined by sensory analysis, computer vision method and Olson and Price test

The meltabilities of 14 process cheese samples were determined at 2 and 4 weeks after manufacture using sensory analysis, a computer vision method, and the Olson and Price test. Sensory analysis meltability correlated with both computer vision meltability (R-2 = 0.71, P < 0.001) and Olson and Price meltability (R-2 = 0.69, P < 0.001). There was a marked lack of correlation between the computer vision method and the Olson and Price test. This study showed that the Olson and Price test gave greater repeatability than the computer vision method. Results showed process cheese meltability decreased with increasing inorganic salt content and with lower moisture/fat ratios. There was very little evidence in this study to show that process cheese meltability changed between 2 and 4 weeks after manufacture..

Prediction of moisture, calorific value, ash and carbon content of two dedicated bioenergy crops using near-infrared spectroscopy

The potential of near infrared spectroscopy in conjunction with partial least squares regression to predict Miscanthus xgiganteus and short rotation coppice willow quality indices was examined. Moisture, calorific value, ash and carbon content were predicted with a root mean square error of cross validation of 0.90% (R2 = 0.99), 0.13 MJ/kg (R2 = 0.99), 0.42% (R2 = 0.58), and 0.57% (R2 = 0.88), respectively. The moisture and calorific value prediction models had excellent accuracy while the carbon and ash models were fair and poor, respectively. The results indicate that near infrared spectroscopy has the potential to predict quality indices of dedicated energy crops, however the models must be further validated on a wider range of samples prior to implementation. The utilization of such models would assist in the optimal use of the feedstock based on its biomass properties.

The voice of the consumer speaks forcefully in brand identity: user-generated content forces smart marketers to listen

User-generated content (UGC) is attracting a great deal of interest - some of it effective, some misguided. This article reviews the marketing-related factors that gave rise to UGC, tracing the relevant development of market orientation, social interaction, word of mouth, brand relationships, consumer creativity, co-creation, and customization, largely through the pages of the Journal of Advertising Research over the last 40 (or so) of its 50 years. The authors then discuss the characteristic features of UGC and how they differ from (and are similar to) these concepts. The insights thus gained will help practitioners and researchers understand what UGC is (and is not) and how it should (and should not) be used.

Modelling of the natural chlorine cycling in a coniferous stand: implications for chlorine-36 behaviour in a contaminated forest environment

Considered as one of the most available radionuclide in soileplant system, 36Cl is of potential concern for long-term management of radioactive wastes, due to its high mobility and its long half-life. To evaluate the risk of dispersion and accumulation of 36Cl in the biosphere as a consequence of a potential contamination, there is a need for an appropriate understanding of the chlorine cycling dynamics in the ecosystems. To date, a small number of studies have investigated the chlorine transfer in the ecosystem including the transformation of chloride to organic chlorine but, to our knowledge, none have modelled this cycle. In this study, a model involving inorganic as well as organic pools in soils has been developed and parameterised to describe the biogeochemical fate of chlorine in a pine forest. The model has been evaluated for stable chlorine by performing a range of sensitivity analyses and by comparing the simulated to the observed values. Finally a range of contamination scenarios, which differ in terms of external supply, exposure time and source, has been simulated to estimate the possible accumulation of 36Cl within the different compartments of the coniferous stand. The sensitivity study supports the relevancy of the model and its compartments, and has highlighted the chlorine transfers affecting the most the residence time of chlorine in the stand. Compared to observations, the model simulates realistic values for the chlorine content within the different forest compartments. For both atmospheric and underground contamination scenarios most of the chlorine can be found in its organic form in the soil. However, in case of an underground source, about two times less chlorine accumulates in the system and proportionally more chlorine leaves the system through drainage than through volatilisation.

Performance of palm- based fat blends with a low saturated fat content in puff pastry

Four fat blends based on palm fractions in combination with high oleic sunflower oil (HOSF) with a relatively low saturated fatty acid content (29.2±0.85%, i.e. less than 50% of that of butter) were prepared. The saturated fat was located in different triacylglycerols (TAG) structures in each blend. Principal saturated TAG were derived from palm stearin (POs, containing tripalmitoyl glycerol - PPP), palm mid fraction (PMF, containing 1,3-dipalmitoyl-2-oleoyl glycerol - POP) and interesterified PMF (inPMF, containing PPP, POP and rac-1,2-dipalmitoyl-3-oleoyl glycerol - PPO). Thus, in blend 1, composed of POs and HOSF, the saturates resided principally in PPP. In blend 2, composed of POs, PMF and HOSF, the principal saturate-containing TAG were PPP and POP. Blend 3, composed of inPMF and HOSF, was similar to blend 2 except that the disaturated TAG comprised a 2:1 mixture of PPO:POP. Finally, blend 4, a mixture of PMF and HOSF, had saturates present mainly as POP. The physical properties and the functionality of blends, as shortenings for puff pastry laminated in a warm bakery environment (20-30°C), were compared with each other, and with butter. Puff pastry prepared with blend 1 (POs:HOSF 29:71) and blend 4 (PMF:HOSF 41:59), was very hard; blend 2 (POs:PMF:HOSF 13:19:68) was most similar to butter in the compressibility of the baked product and it performed well in an independent baking trial; blend 3 (inPMF:HOSF 40:60) gave a product that required a higher force for compression than butter.

Memo to marketers: quantitative evidence for change: how user-generated content really affects brands

Developed in response to the new challenges of the social Web, this study investigates how involvement with brand-related user-generated content (UGC) affects consumers’ perceptions of brands. The authors develop a model that provides new insights into the links between drivers of UGC creation, involvement, and consumer-based brand equity. Expert opinions were sought on a hypothesized model, which further was tested through data from an online survey of 202 consumers. The results provide guidance for managerial initiatives involving UGC campaigns for brand building. The findings indicate that consumer perceptions of co-creation, community, and self-concept have a positive impact on UGC involvement that, in turn, positively affects consumer based brand equity. These empirical results have significant implications for avoiding problems and building deeper relationships between consumers and brands in the age of social media.

The possibility of lowering oil content of potato chips by combining atmospheric frying with postfrying vacuum application

Four protocols involving the application of low pressures, either toward the end of frying or after frying, were investigated with the aim of lowering the oil content of potato chips. Protocol 1 involving frying at atmospheric pressure followed by a 3 min draining time constituted the control. Protocol 2 involved lowering of pressure to 13.33 kPa, 40 s before the end of frying, followed by draining for 3 min at the same pressure. Protocol 3 was the same as protocol 2, except that the pressure was lowered 3 s before the end of frying. Protocol 4 involved lowering the pressure to 13.33 kPa after the product was lifted from the oil and holding it at this value over the draining time of 3 min. Protocol 4 gave a product having the lowest oil content (37.12 g oil/100 g defatted dry matter), while protocol 2 gave the product with highest oil content (71.10 g oil/100 g defatted dry matter), followed by those obtained using protocols 1 and 3(68.48 g oil/100 g defatted dry matter and 52.50 g oil/100 g defatted dry matter, respectively). Protocol 4 was further evaluated to study the effects of draining times and vacuum applied, and compared with the control. It was noted that over the modest range of pressures investigated, there was no significant effect of the vacuum applied on the oil content of the product. This study demonstrates that the oil content of potato chips can be lowered significantly by combining atmospheric frying with draining under vacuum.

Impact of the quantity and flavonoid content of fruits and vegetables on markers of intake in adults with an increased risk of cardiovascular disease: the FLAVURS Trial

Purpose Limited robust randomised controlled trials investigating fruit and vegetable (F&V) intake in people at risk of cardiovascular disease (CVD) exist. We aimed to design and validate a dietary strategy of increasing flavonoid-rich versus flavonoid-poor F&V consumption on nutrient biomarker profile. Methods A parallel, randomised, controlled, dose–response dietary intervention study. Participants with a CVD relative risk of 1.5 assessed by risk scores were randomly assigned to one of the 3 groups: habitual (control, CT), high-flavonoid (HF) or low-flavonoid (LF) diets. While the CT group (n = 57) consumed their habitual diet throughout, the HF (n = 58) and LF (n = 59) groups sequentially increased their daily F&V intake by an additional 2, 4 and 6 portions for 6-week periods during the 18-week study. Results Compliance to target numbers and types of F&V was broadly met and verified by dietary records, and plasma and urinary biomarkers. Mean (±SEM) number of F&V portions/day consumed by the HF and LF groups at baseline (3.8 ± 0.3 and 3.4 ± 0.3), 6 weeks (6.3 ± 0.4 and 5.8 ± 0.3), 12 weeks (7.0 ± 0.3 and 6.8 ± 0.3) and 18 weeks (7.6 ± 0.4 and 8.1 ± 0.4), respectively, was similar at baseline yet higher than the CT group (3.9 ± 0.3, 4.3 ± 0.3, 4.6 ± 0.4, 4.5 ± 0.3) (P = 0.015). There was a dose-dependent increase in dietary and urinary flavonoids in the HF group, with no change in other groups (P = 0.0001). Significantly higher dietary intakes of folate (P = 0.035), non-starch polysaccharides (P = 0.001), vitamin C (P = 0.0001) and carotenoids (P = 0.0001) were observed in both intervention groups compared with CT, which were broadly supported by nutrient biomarker analysis. Conclusions The success of improving nutrient profile by active encouragement of F&V intake in an intervention study implies the need for a more hands-on public health approach.

Analysis of growth physiology and phytochemical content of Eruca and Diplotaxis Cultivars under different light and temperature regimes

Rocket is a leafy brassicaceous salad crop that encompasses two major genera (Diplotaxis and Eruca) and many different cultivars. Rocket is a rich source of antioxidants and glucosinolates, many of which are produced as secondary products by the plant in response to stress. In this paper we examined the impact of temperature and light stress on several different cultivars of wild and salad rocket. Growth habit of the plants varied in response to stress and with different genotypes, reflecting the wide geographical distribution of the plant and the different environments to which the genera have naturally adapted. Preharvest environmental stress and genotype also had an impact on how well the cultivar was able to resist postharvest senescence, indicating that breeding or selection of senescence-resistant genotypes will be possible in the future. The abundance of key phytonutrients such as carotenoids and glucosinolates are also under genetic control. As genetic resources improve for rocket it will therefore be possible to develop a molecular breeding programme specifically targeted at improving stress resistance and nutritional levels of plant secondary products. Concomitantly, it has been shown in this paper that controlled levels of abiotic stress can potentially improve the levels of chlorophyll, carotenoids and antioxidant activity in this leafy vegetable.