Learning in higher education: strategies to overcome challenges faced by adult students - lessons drawn from two studies in portugal

Int’l J. of Information and Communication Technology Education, 3(2), 1-14, April-June 2007

Improving the learning experience and learning environment of adults in Higher Education – Project LIHE: the Portuguese case

Project LIHE: the Portuguese Case. ESREA Fourth Access Network Conference – “Equity, Access and Participation: Research, Policy and Practice”. Edinburgh (Scotland), 11 – 13 December, 2003.

Cyclic deformation of bidisperse two-dimensional foams

In-plane deformation of foams was studied experimentally by subjecting bidisperse foams to cycles of traction and compression at a prescribed rate. Each foam contained bubbles of two sizes with given area ratio and one of three initial arrangements: sorted perpendicular to the axis of deformation (iso-strain), sorted parallel to the axis of deformation (iso-stress), or randomly mixed. Image analysis was used to measure the characteristics of the foams, including the number of edges separating small from large bubbles N-sl, the perimeter (surface energy), the distribution of the number of sides of the bubbles, and the topological disorder mu(2)(N). Foams that were initially mixed were found to remain mixed after the deformation. The response of sorted foams, however, depended on the initial geometry, including the area fraction of small bubbles and the total number of bubbles. For a given experiment we found that (i) the perimeter of a sorted foam varied little; (ii) each foam tended towards a mixed state, measured through the saturation of N-sl; and (iii) the topological disorder mu(2)(N) increased up to an "equilibrium" value. The results of different experiments showed that (i) the change in disorder, Delta mu(2)(N), decreased with the area fraction of small bubbles under iso-strain, but was independent of it under iso-stress; and (ii) Delta mu(2)(N) increased with Delta N-sl under iso-strain, but was again independent of it under iso-stress. We offer explanations for these effects in terms of elementary topological processes induced by the deformations that occur at the bubble scale.

Grid Integration of Offshore Wind Farms Using Modular Marx Multilevel Converters

This paper proposes the use of a Modular Marx Multilevel Converter, as a solution for energy integration between an offshore Wind Farm and the power grid network. The Marx modular multilevel converter is based on the Marx generator, and solves two typical problems in this type of multilevel topologies: modularity and dc capacitor voltage balancing. This paper details the strategy for dc capacitor voltage equalization. The dynamic models of the converter and power grid are presented in order to design the converter ac output voltages and the dc capacitor voltage controller. The average current control is presented and used for power flow control, harmonics and reactive power compensation. Simulation results are presented in order to show the effectiveness of the proposed (MC)-C-3 topology.

Valor em risco (VAR - value at risk): metodologias não paramétricas

O VAR (Value at Risk) ,valor em risco, é a perda máxima provável de uma carteira para um nível de confiança determinado, num horizonte temporal especificado.

O tratamento dos activos biológicos nas microentidades

Dissertação para a obtenção do Grau de Mestre em Contabilidade e Finanças Orientador: Dr. Paulo Filipe Teixeira Aguiar

Activos fixos tangíveis numa empresa industrial do ramo automóvel transição para o SNC

Dissertação para a obtenção do grau de mestre em Contabilidade e Finanças Orientador: Mestre António Costa Reis

O papel do fundo de maneio das pequenas e médias empresas

Dissertação de Mestrado em Finanças Empresariais

A novel framework for modeling value for the customer, an essay on negotiation

This paper proposes a novel framework for modelling the Value for the Customer, the so-called the Conceptual Model for Decomposing Value for the Customer (CMDVC). This conceptual model is first validated through an exploratory case study where the authors validate both the proposed constructs of the model and their relations. In a second step the authors propose a mathematical formulation for the CMDVC as well as a computational method. This has enabled the final quantitative discussion of how the CMDVC can be applied and used in the enterprise environment, and the final validation by the people in the enterprise. Along this research, we were able to confirm that the results of this novel quantitative approach to model the Value for the Customer is consistent with the company's empirical experience. The paper further discusses the merits and limitations of this approach, proposing that the model is likely to bring value to support not only the contract preparation at an Ex-Ante Negotiation Phase, as demonstrated, but also along the actual negotiation process, as finally confirmed by an enterprise testimonial.

Conceptual model for decomposing the value for the customer

Value has been defined in different theoretical contexts as need, desire, interest, standard /criteria, beliefs, attitudes, and preferences. The creation of value is key to any business, and any business activity is about exchanging some tangible and/or intangible good or service and having its value accepted and rewarded by customers or clients, either inside the enterprise or collaborative network or outside. “Perhaps surprising then is that firms often do not know how to define value, or how to measure it” (Anderson and Narus, 1998 cited by [1]). Woodruff echoed that we need “richer customer value theory” for providing an “important tool for locking onto the critical things that managers need to know”. In addition, he emphasized, “we need customer value theory that delves deeply into customer’s world of product use in their situations” [2]. In this sense, we proposed and validated a novel “Conceptual Model for Decomposing the Value for the Customer”. To this end, we were aware that time has a direct impact on customer perceived value, and the suppliers’ and customers’ perceptions change from the pre-purchase to the post-purchase phases, causing some uncertainty and doubts.We wanted to break down value into all its components, as well as every built and used assets (both endogenous and/or exogenous perspectives). This component analysis was then transposed into a mathematical formulation using the Fuzzy Analytic Hierarchy Process (AHP), so that the uncertainty and vagueness of value perceptions could be embedded in this model that relates used and built assets in the tangible and intangible deliverable exchange among the involved parties, with their actual value perceptions.

Are severe occlusal problems more frequent in permanent than deciduous dentition?

OBJECTIVE: To determine the prevalence and severity of occlusal problems in populations at the ages of deciduous and permanent dentition and to carry out a meta-analysis to estimate the weighted odds ratio for occlusal problems comparing both groups. METHODS: Data of a probabilistic sample (n=985) of schoolchildren aged 5 and 12 from an epidemiological study in the municipality of São Paulo, Brazil, were analyzed using univariate logistic regression (MLR). Results of cross-sectional study data published in the last 70 years were examined in the meta-analysis. RESULTS: The prevalence of occlusal problems increased from 49.0% (95% CI =47.4%-50.6%) in the deciduous dentition to 71.3% (95% CI =70.3%-72.3%) in the permanent dentition (p<0.001). Dentition was the only variable significantly associated to the severity of malocclusion (OR=1.87; 95% CI =1.43-2.45; p<0.001). The variables sex, type of school and ethnic group were not significant. The meta-analysis showed that a weighted OR of 1.95 (1.91; 1.98) when compared the second dentition period with deciduous and mixed dentition. CONCLUSIONS: In planning oral health services, some activities are indicated to reduce the proportion of moderate/severe malocclusion to levels that are socially more acceptable and economically sustainable.

Otimização da imagem em tomografia computorizada no exame de tórax

Mestrado em Radiações Aplicadas às Tecnologias da Saúde. Área de especialização: Imagem Digital.

A entrada na profissão do educador de infância: percursos singulares

Dissertação apresentada à Escola Superior de Educação de Lisboa para obtenção do grau de Mestre em Ciências da Educação - Especialidade Supervisão em Educação

Entre o público e o privado: a escolha da escola pelos país

Dissertação apresentada à Escola Superior de Educação de Lisboa para obtenção do grau de mestre em Ciências de Educação – Especialização em Administração Escolar

Da formação inicial à inserção na profissão

Dissertação apresentada à Escola Superior de Educação de Lisboa Para a obtenção do Grau de Mestre em Ciências da Educação - Especialidade Supervisão em Educação