Investigation on mechanism of critical cavitating flow in liquid jet pumps under operating limits

The critical cavitating flow in liquid jet pumps under operating limits is investigated in this paper. Measurements on the axial pressure distribution along the wall of jet pumps indicate that two-phase critical flow occurs in the throat pipe under operating limits. The entrained flow rate and the distribution of the wall pressure upstream lowest pressure section does not change when the outlet pressure is lower than a critical value. A liquid-vapor mixing shockwave is also observed under operating limits. The wave front moves back and forth in low frequency around the position of the lowest pressure. With the measured axial wall pressures, the Mach number of the two-phase cavitating flow is calculated. It's found that the maximum Mach number is very close to I under operating limits. Further analysis infers a cross-section where Mach number approaches to I near the wave front. Thus, the liquid-vapor mixture velocity should reach the local sound velocity and resulting in the occurrence of operating limits.

A numerical investigation on the flow physics of koi carp (Cyprinus carpio koi) burst-and-coast swimming

Abstract—Burst-and-coast is the most common locomotion type in freely routine swimming of koi carps (Cyprinus carpio koi), which consists of a burst phase and a coast phase in each cycle and mostly leads to a straight-line trajectory. Combining with the tracking experiment, the flow physics of koi carp’s burst-andcoast swimming is investigated using a novel integrated CFD method solving the body-fluid interaction problem. The dynamical equations of a deforming body are formulated. Following that, the loose-coupled equations of the body dynamics and the fluid dynamics are numerically solved with the integrated method. The two burst modes, MT (Multiple Tail-beat) and HT (Half Tail-beat), which have been reported by the experiments, are investigated by numerical simulations in this paper. The body kinematics is predicted and the flow physics is visualized, which are in good agreement with the corresponding experiments. Furthermore, the optimization on the energy cost and several critical control mechanisms in burst-and-coast swimming of koi carps are explored, by varying the parameters in its selfpropelled swimming. In this paper, energetics is measured by the two mechanical quantities, total output power CP and Froude efficiency Fr. Results and discussion show that from the standpoint of mechanical energy, burst-and-coast swimming does not actually save energy comparing with steady swimming at the same average speed, in that frequently changing of speed leads to decrease of efficiency.

Numerical investigation on a transition prediction model

A new transition prediction model is introduced, which couples the intermittency effect into the turbulence transport equations and takes the characteristics of fluid transition into consideration to mimic the exact process of transition. Test cases include a two-dimensional incompressible plate and a two-dimensional NACA0012 airfoil. Performance of this transition model for incompressible flows is studied, with numerical results consistent to experimental data. The requirement of grid resolution for this transition model is also studied.

Investigation on average void fraction for air/non-Newtonian power-law fluids two-phase flow in downward inclined pipes

The present work has been carried out to investigate on the average void fraction of gas/non-Newtonian fluids flow in downward inclined pipes. The influences of pipe inclination angle on the average void fraction were studied experimentally. A simple correlation, which incorporated the method of Vlachos et al. for gas/Newtonain fluid horizontal flow, the correction factor of Farooqi and Richardson and the pipe inclination angle, was proposed to predict the average void fraction of gas/non-Newtonian power-law stratified flow in downward inclined pipes. The correlation was based on 470 data points covering a wide range of flow rates for different systems at diverse angles. A good agreement was obtained between theory and data and the fitting results could describe the majority of the experimental data within ±20%.

A preliminary investigation into the post harvest losses of fish in Shiroro Lake area

The findings are presented of a study conducted to assess the post harvest losses in Shiroro Lake, Nigeria. The major objectives were to identify and quantify the types of losses, to provide recommendations that would enhance formulation of policy guidelines for utilization and exploitation of the declining fishery resources of the lake

An investigation of the effect of replacing fish meal with soyabean meal, groundnut cake and blood meal at varied proportion on growth and food utilization of the Clarias anguillaris fingerlings fed in outdoor hapas

Fingerlings of Clarias anguillaris obtained from a homogenous source through induce breeding and each with a mean weight of 2.8g were stocked in ten hapas each measuring 1.0x1.0m in outdoor concrete tank and were fed for eight (8) weeks. Results shows that the best growth rate was recorded among fingerlings fed fish meal as the only protein source (TD5) while DT2 containing soya bean, groundnut cake (40%), blood meal as the protein sources came next. The growth rate of fingerlings fed DT2 (40 % groundnut cake, 10% soyabean meal and 10% blood meal) was higher than those fed DT4 containing 10% fish meal but lower than those fed DT5 which has fish meal as its sole source of protein (53.0%). Analysis of various growth parameters like SGR, FCR and PER. shows that DT5 was the overall best diet but there was no significant statistical difference in weight gained by fish fed the five diets (P <0.05)

A preliminary investigation into the effect of different storage methods on the keeping quality of smoked Oreochromis niloticus

The study was carried out to asses the nutritional qualities of smoked O. niloticus and to discover the best methods of storage to minimize spoilage and infestation of smoked fish. Result showed that the protein contents in A and D decreased while the protein contents of b and C increased. The lipid content increased only in A while it decreased in B-C and D. The moisture content generally increased over the period of storage and there was an increase in ash content only in C while it decreased in A, B and D. The samples packed in polythene bag suffered about 35% mould infection and a few were attached by rodents with some fouling. Samples packed in jute bag were in good condition but were slightly attached by insect. All samples packed in carton and basket were still in good state but there were insect attack in those packed in carton

Numerical and Experimental Investigation On The Prevention of Co Deflagration

The exhaust gases from industrial furnaces contain a huge amount of heat and chemical enthalpy. However, it is hard to recover this energy since exhaust gases invariably contain combustible components such as carbon monoxide (CC). If the CO is unexpectedly ignited during the heat recovery process, deflagration or even detonation could occur, with serious consequences such as complete destruction of the equipment. In order to safely utilize the heat energy contained in exhaust gas, danger of its explosion must be fully avoided. The mechanism of gas deflagration and its prevention must therefore be studied. In this paper, we describe a numerical and experimental investigation of the deflagration process in a semi-opened tube. The results show that, upon ignition, a low-pressure wave initially spreads within the tube and then deflagration begins. For the purpose of preventing deflagration, an appropriate amount of nitrogen was injected into the tube at a fixed position. Both simulation and experimental results have shown that the injection of inert gas can successfully interrupt the deflagration process. The peak value of the deflagration pressure can thereby be reduced by around 50%. (C) 2008 Elsevier Ltd. All rights reserved.

An investigation into the value of yam (Dioscorea rotundata) peels as energy source in the diet of Oreochromis niloticus fry fed in indoor glass aquaria

The study was designed to investigate the value of the peels of yam (Dioscorea rotundata) as energy source in the diet of Oreochromis niloticus fry and to investigate the level of inclusion of this peels that will give optimum growth performance. Four diets, three levels of yam peels and a control, was prepared and tested on O. niloticus fry (mean weight of 0.27g) for ten weeks. Fifteen (15) O. niloticus fry were grouped in each of the glass aquaria, measuring 60x30x3Ocm and with a maximum capacity of 52 liters of water. The fry were fed twice daily at 10% biomass. The fry were weighed weekly to determine weight increment or otherwise and the quality of feed was adjusted accordingly. DTl (70% yam peels and 30% yellow maize) in the carbohydrate mixture gave the best performance. The fry fed this diet, gained a mean weight of 1.20g for the period of the experiment. The poorest performance in terms of growth was from fry fed the control diet (100% yellow maize in the carbohydrate mixture). Fry fed this diet gained mean weight of 0.80g for the duration of the experiment. Analysis of the various growth indices like SGR, PER, FCR and NPU shows that DTl was the overall best diet with an SGR value of I. 92 and FCR of 54.10. The difference in weight gain by fry fed the three levels of yam peels diet and the control diet (100% yellow maize) was not statistically significant (P>0.05)

Investigation of transient process and steady output of lasing without inversion

The transient evolution processes and steady outputs of continuous wave lasing without inversion (LWI) and self-pulsing LWI in a resonant open V type three-level system are studied. It was found that the two kinds of LWI have some obvious differences not only from the steady outputs but also from the transient evolution processes. The effects of the unsaturated gain coefficient, cavity loss coefficient, ratio of the atomic injection rates and atomic exit rate on the transient evolution processes and steady outputs are discussed.

Time-resolved investigation of low-density plasma channels produced by a kilohertz femtosecond laser in air

By employing pump-probe back longitudinal diffractometry, the electron density and decay dynamics of a weak plasma channel created by a 1-KHz fs laser in air has been investigated. With ultrashort laser pulses of 50 fs and low energy of 0.6 mJ, we observe weak plasma channels with a length similar to 2 cm in air. An analytical reconstruction method of electron density has been analyzed, which is sensitive to the phase shift and channel size. The electron density in the weak plasma channel is extracted to be about 4x10(16) cm(-3). The diameters of the plasma channel and the filament are about 50 and 150 mu m, respectively, and the measurable electron density can be extended to less than 10(15) cm(-3). Moreover, a different time-frequency technique called linearly chirped longitudinal diffractometry is proposed to time-resolved investigate ultrafast ionization dynamics of laser-irradiated gas, laser interaction with cluster beam, etc.