922 resultados para Direct Pulp Capping
Resumo:
This thesis examines the impact of foreign direct investment (FDI) on Vietnamese economy based on Partial Adjustment Model and time series data from 1976 to 2004. FDI is shown to have not only short run but also long run effect on gross domestic product (GDP) of Vietnam. However, elasticity of GDP with respect to FDI is small and it will take many years to fully manifest itself. The impact of trade openness on GDP has also been examined and it is shown to be stronger than that of FDI. The paper offers a number of explanations and discusses briefly suggestions in order to increase the contribution of FDI to Vietnam’s economic development.
Resumo:
Four different trials of stratified three-layered fine paper, of sulphate pulp, were performed to investigate if stratified fine fraction or fibres from birch can improve the properties of a paper compared to a reference sheet. All trials had five different scenarios and each scenario was calendered with different linear load. All sheets had a grammage of 80 g/m2.In the first trial, the paper contained birch, pine and filler of calciumcarbonate (marble), and was manufactured with the pilot paper machine XPM and the stratified headbox Formator at RCF (Stora Enso Research Center in Falun). The furnish consisted of 75% birch and 25% pine.The second trial contained coated sheets with paper from trial one as the base paper. The coating slip contained calciumcarbonate and clay and the amount was approximately 10-12 g/m2.The third trial, also with birch and pine but without filler, was performed at STFI (Skogsindustrins Tekniska Forskningsinstitut in Stockholm) with the laboratory scaled paper machine StratEx and the stratified headbox AQ-vanes. The furnish consisted of 75% birch and 25% pine, except for one scenario which contained of 75% pine and 25% birch.The last trial contained fractionated pulp of birch and pine and was performed at STFI. 50% was fine fraction and 50% was coarse fraction.This test does not show any clear benefits of making stratified sheets of birch and pine when it comes to properties such as bending stiffness, tensile index and surface smoothness. The retention can be improved with birch in the surface plies. It is possible that the formation can be improved with birch in the surface plies and pine in the middle ply. It is also possible that fine fraction in the surface plies and coarse fraction in the middle ply can improve both surface smoothness and bending stiffness. The results in this test are shown with confidence intervals which points out the difficulties of analysing sheets manufactured with a pilot paper machine or a laboratory scaled paper machine.
Resumo:
This paper investigates the impact of inward FDI (Foreign Direct Investment) on international trade of China empirically on the country level by using panel data from 1984 to 2007. Two separate transformed models which are based on the gravity equation and refer to the econometric models of some previous studies, are used in this paper to estimate the effect of FDI inflows on exports and imports respectively. The estimation results confirmed the complementary relationship between FDI inflows and trade of China both on exports and imports, which has also been supported by previous empirical studies.
Resumo:
This thesis evaluates different sites for a weather measurement system and a suitable PV- simulation for University of Surabaya (UBAYA) in Indonesia/Java. The weather station is able to monitor all common weather phenomena including solar insolation. It is planned to use the data for scientific and educational purposes in the renewable energy studies. During evaluation and installation it falls into place that official specifications from global meteorological organizations could not be meet for some sensors caused by the conditions of UBAYA campus. After arranging the hardware the weather at the site was monitored for period of time. A comparison with different official sources from ground based and satellite bases measurements showed differences in wind and solar radiation. In some cases the monthly average solar insolation was deviating 42 % for satellite-based measurements. For the ground based it was less than 10 %. The average wind speed has a difference of 33 % compared to a source, which evaluated the wind power in Surabaya. The wind direction shows instabilities towards east compared with data from local weather station at the airport. PSET has the chance to get some investments to investigate photovoltaic on there own roof. With several simulations a suitable roof direction and the yearly and monthly outputs are shown. With a 7.7 kWpeak PV installation with the latest crystalline technology on the market 8.82 MWh/year could be achieved with weather data from 2012. Thin film technology could increase the value up to 9.13 MWh/year. However, the roofs have enough area to install PV. Finally the low price of electricity in Indonesia makes it not worth to feed in the energy into the public grid.
Resumo:
This study aims to investigate the relation between foreign direct investment (FDI) and per capita gross domestic product (GDP) in Pakistan. The study is based on a basic Cobb-Douglas production function. Population over age 15 to 64 is used as a proxy for labor in the investigation. The other variables used are gross capital formation, technological gap and a dummy variable measuring among other things political stability. We find positive correlation between GDP per capita in Pakistan and two variables, FDI and population over age 15 to 64. The GDP gap (gap between GDP of USA and GDP of Pakistan) is negatively correlated with GDP per capita as expected. Political instability, economic crisis, wars and polarization in the society have no significant impact on GDP per capita in the long run.