Electrochemical study of gramicidin D forming ion-permeable channels in the bilayer lipid membranes

Gramicidin within the lipid bilayer matrix is a well-known channel-forming polypeptide, but the mechanism of the ions across the membrane induced by gramicidin is not well understood. We found that at very low concentration of gramicidin in a bilayer lipid membrane, the channel behavior was controlled by the voltage applied across the membrane. When the voltage is higher than 75 mV, the channel is closing, while lower than 75 mV, the channel is opening. But when the concentration of the gramicidin in the BLMs is high, the channel behavior is changed into voltage-independent. (C) 1998 Elsevier Science Ltd. All rights reserved.

聚(ε-己内酯)/聚(d,l-丙交酯)共混物膜在酶促降解过程中的形态变化

聚（ε┐己内酯）／聚（ｄ，ｌ┐丙交酯）共混物膜在酶促降解过程中的形态变化张杰甘志华＊梁奇志景遐斌（吉林工业大学理学院应用化学系长春）（中国科学院长春应用化学研究所长春１３００２２）关键词聚己酸内酯－聚丙交酯共混物，酶促降解，形态１９９７－１０－３０收…

生物降解ε-己内酯/d,l-丙交酯共聚物的合成与表征

采用一种新型的稀土配位化合物Ｙ（ＣＦ３ＣＯＯ）３／Ａｌ（ｉ－Ｂｕ）３为催化剂，制备了不同组成的ε－己内酯／ｄ，ｌ－丙交酯共聚物，并用ＧＰＣ、ＮＭＲ和ＤＳＣ表征了共聚物的结构．结果表明通过改变初始投料中两种单体的比例，可以调节共聚酯的化学结构，而共聚物的形态则受结构影响很大．

介体型双酶D-氨基酸传感器的制备

用一种全氟代磺酸酯阳离子交换树酯(East-man AQ-55),将D-氨基酸氧化酶(DAAO),辣根过氧化物酶(HRP)以及1,1′-二(α-羟基乙基)二茂铁(BHFc)同时包埋在玻碳电极(GCE)表面,制成双酶D-氨基酸电流式传感器。电极的工作电位为+0.18V(vs.SCE)响应时间小于50s。对于D-丙氨酸来说,测定的最适宜pH为7.8,测定的线性范围为0.05～0.75mmol/L该电极具有良好的重现性,可以连续使用200次。

固体ASm_2I_5的d-f跃迁荧光和反射光谱(A=K,Rb,Cs,T1)

本文系统地研究了化合物ASm_2I_5(A=K,Rb,Cs,T1)固体粉末的荧光光谱和反射光谱.讨论了Sm~(2+)在立方晶体场中的分裂能随着碱金属离子半径的增大而减小和f-d激发能随着A-I(A=Rb,T1)键的共价性增加而明显降低的现象.并从晶场效应和化学键性质两个方面解释了ASm_2I_5(A=K,Rb,Cs)和ASm_2I_5(A=Rb,T1)中的Sm~(2+)荧光光谱分别发生蓝移和红移的现象.

希土D—葡萄糖酸配合物的红外和拉曼光谱及结构的研究

十五种希土D-葡萄糖酸配合物的红外和拉曼光谱非常相似,结构类同,配合物的糖酸谱带明显展宽,羧酸根的对称和反对称振动谱带相差200cm~(-1),与希土离子单齿配位,糖酸为β构型,吡喃环上的O_1和O_5也参予配位,希土离子配位数是9。

Impact of spatial resolution and spatial difference accuracy on the performance of Arakawa A-D grids

This paper alms at illustrating the impact of spatial difference scheme and spatial resolution on the performance of Arakawa A-D grids in physical space. Linear shallow water equations are discretized and forecasted on Arakawa A-D grids for 120-minute using the ordinary second-order (M and fourth-order (C4) finite difference schemes with the grid spacing being 100 km, 10 km and I km, respectively. Then the forecasted results are compared with the exact solution, the result indicates that when the grid spacing is I kin, the inertial gravity wave can be simulated on any grid with the same results from C2 scheme or C4 scheme, namely the impact of variable configuration is neglectable; while the inertial gravity wave is simulated with lengthened grid spacing, the effects of different variable configurations are different. However, whether for C2 scheme or for C4 scheme, the RMS is minimal (maximal) on C (D) grid. At the same time it is also shown that when the difference accuracy increases from C2 scheme to C4 scheme, the resulted forecasts do not uniformly decrease, which is validated by the change of the group A velocity relative error from C2 scheme to C4 scheme. Therefore, the impact of the grid spacing is more important than that of the difference accuracy on the performance of Arakawa A-D grid.

Applications of improved 2-D numerical wave tanks in wave breaking

Song and Banner (2002, henceforth referred to as SB02) used a numerical wave tank (developed by Drimer and Agnon, and further refined by Segre, henceforth referred to as DAS) to study the wave breaking in the deep water, and proposed a dimensionless breaking threshold that based on the behaviour of the wave energy modulation and focusing during the evolution of the wave group. In this paper, two modified DAS models are used to further test the SB02's results, the first one (referred to MDAS1) corrected many integral calculation errors appeared in the DAS code, and the second one (referred to MDAS2) replaced the linear boundary element approximation of DAS into the cubic element on the free surface. Researches show that the results of MDAS1 are the same with those of DAS for the simulations of deep water wave breaking, but, the different values of the wavemaker amplitude, the breaking time and the maximum local average energy growth rate delta(max) for the marginal breaking cases are founded by MDAS2 and MDAS1. However, MDAS2 still satisfies the SB02' s breaking threshold. Furthermore, MDAS1 is utilized to study the marginal breaking case in the intermediate water depth when wave passes over a submerged slope, where the slope is given by 1 : 500, 1 : 300, 1 : 150 or 1 : 100. It is found that the maximum local energy density U increases significantly if the slope becomes steeper, and the delta(max) decreases weakly and increases intensively for the marginal recurrence case and marginal breaking case respectively. SB02's breaking threshold is still valid for the wave passing over a submerged slope gentler than 1 : 100 in the intermediate water depth.

磷虾声学评估系统——接收机及A/D转换器

本文所述为磷虾声学探测系统的一部分——接收机及高速A／D转换器。该系统的设计旨在克服过去南大洋科学考察所用声学评估系统信号补偿不够精确、动态范围较窄、实时处理能力较差等不足。接收机具有宽动态范围及精确的20LoG(R)和40LoG(R)损耗补偿，8位高速A／D转换将数据信号送计算机，使得生物量和声物反射能力的计算得以实时进行。

牦牛的分类学地位及起源研究:mtDNA D-loop序列的分析

牦牛的起源与属级分类学地位至今仍然存在一定的争议.我们测定了家养牦牛和野生牦牛线粒体控制区(D-loop)序列,并以此构建牦牛和牛属、野牛属、水牛属以及非洲水牛属相关种的系统发育树.研究结果表明线粒体D-loop区与Cyt b基因序列在构建牛族的系统发育具有同样重要的价值.系统发育关系显示野牛属的灭绝种草原野牛与现存种美洲野牛先聚合为一单系群,然后再和牦牛形成一单系分支,表明牦牛与野牛属的草原野牛、美洲野牛亲缘关系最近,具有最近的共同祖先,而与牛属的其它亚洲物种亲缘关系较远.因此,本研究不支持将牦牛独立为牦牛属--Poephagus,牛属与野牛属在分类上也应合并为一个属.基于上述研究结果和化石证据,我们进一步对牦牛起源的历史背景进行了讨论,认为牦牛与野牛属的分化是由于第四纪气候变化在欧亚大陆发生的,野牛通过白令陆桥进入北美;冰期结束后,由于欧亚大陆其它地区温度升高,牦牛只能局限分布在较为寒冷的青藏高原;而野牛属在北美先后分化为草原野牛和美洲野牛,前者可能是后者的直接祖先.

D型肉毒杀鼠素防治高原鼠兔灭效试验

针对江河源退化草地治理与示范项目要求，在果洛州玛沁县大武乡格多牧委会人工和半人工草场上，使用D型肉毒杀鼠素对高原鼠兔Ochotona curzoniae进行现场药效试验和大面积灭鼠。结果表明，0．1％和0.2％D型内毒杀鼠素毒饵时鼠兔具有良好的灭杀效果，且不污染环境，无二次中毒，对保护鼠粪天敌，维持生态平衡，控制害鼠种群数量回升，减少扩散，使治理后的草场植被再次免遭破坏等方面均具良好作用．

2-(2-Phenyl-1H-phenanthro-[9,10-d]imidazole-1-yl)-acetic acid (PPIA) and its application for determination of amines by high performance liquid chromatography with fluorescence detection and identification with mass spectroscopy/atmospheric pressure chemical ionization

A simple, sensitive, and mild method for the determination of amino compounds based on a condensation reaction with 1-ethyl-3-(3-dimethylaminopropyl)-carbodiimide hydrochloride (EDC-HCI) as the dehydrant with fluorescence detection has been developed. Amines were derivatized to their acidamides with labeling reagent 2-(2-phenyl-1H-phenanthro-[9,10-d]imidazole-1-yl)-acetic acid (PPIA). Studies on derivatization conditions indicated that the coupling reaction proceeded rapidly and smoothly in the presence of a base catalyst in acetonitrile to give the corresponding sensitively fluorescent derivatives with an excitation maximum at lambda(ex) 260nm and an emission maximum at lambda(em) 380nm. The labeled derivatives exhibited high stability and were enough to be efficiently analyzed by high-performance liquid chromatography. Identification of derivatives was carried out by online post-column mass spectrometry (LC/APCI-MS/MS) and showed an intense protonated molecular ion corresponding m/z [MH](+) under APCI in positive-ion mode. At the same time, the fluorescence properties of derivatives in various solvents or at different temperature were investigated. The method, in conjunction with a gradient elution, offered a baseline resolution of the common amine derivatives on a reversed-phase Eclipse XDB-C-8 column. LC separation for the derivatized amines showed good reproducibility with acetonitrile-water as mobile phase. Detection limits calculated from 0.78 pmol injection, at a signal-to-noise ratio of 3, were 3.1-18.2 fmol. The mean intra- and inter-assay precision for all amine levels were < 3.85% and 2.11%, respectively. Excellent linear responses were observed with coefficients of > 0.9996. The established method for the determination of aliphatic amines from real wastewater and biological samples was satisfactory. (c) 2006 Elsevier B.V. All rights reserved.

New progress in R&D of lower olefin synthesis

This paper gives a brief review of R&D researches for light olefin synthesis directly and indirectly from synthesis gas in the Dalian Institute of Chemical Physics (DICP). The first pilot plant test was on methanol to olefin (MTO) reaction and was finished in 1993, which was based on ZSM-5-type catalyst and fixed bed reaction. In the meantime, a new indirect method designated as SDTO (syngas via dimethylether to olefin) was proposed. In this process, metal-acid bifunctional catalyst was applied for synthesis gas to dimethylether(DME) reaction, and modified SAPO-34 catalyst that was synthesized by a new low-cost method with optimal crystal size was used to convert DME to light olefin on a fluidized bed reactor. The pilot plant test on SDTO was performed and finished in 1995. Evaluation of the pilot plant data showed that 190-200 g of DME were yielded by single-pass for each standard cubic meter of synthesis gas. For the second reaction, 1.880 tons of DME or 2.615 tons of methanol produced 1 ton of light olefins, which constitutes of 0.533 ton of ethylene, 0.349 ton of propylene and 0.118 ton of butene. DICP also paid some attention on direct conversion of synthesis gas to light olefins. A semi-pilot plant test (catalyst 1.8 1) was finished in 1995 with a CO conversion > 70% and a C(2)(=)-C(4)(=) olefin selectivity 71-74% in 1000 h. (C) 2000 Published by Elsevier Science B.V. All rights reserved.