Body composition and basal metabolic rate in pre-school children : no sex difference

This work is licensed under a Creative Commons Attribution-NonCommercial 3.0 Unported License which allows users to read, copy, distribute and make derivative works for non-commercial purposes from the material, as long as the author of the original work is cited properly.

CO induced surface segregation as a means of improving surface composition and enhancing performance of CuPd bimetallic catalysts

Date of Acceptance: 01/06/2015 We thank the University of Aberdeen for financial support and A.I. McNab (University of Aberdeen) for discussions involving the calculation of surface sites.

Chitosan gel film bandages: correlating structure, composition, and antimicrobial properties

Chitosan gel films were successfully obtained by evaporation cast from chitosan solutions in aqueous acidic solutions of organic acids (lactic and acetic acid) as gel film bandages, with a range of additives that directly influence film morphology and porosity. We show that the structure and composition of a wide range of 128 thin gel films, is correlated to the antimicrobial properties, their biocompatibility and resistance to biodegradation. Infrared spectroscopy and solid-state 13C nuclear magnetic resonance spectroscopy was used to correlate film molecular structure and composition to good antimicrobial properties against 10 of the most prevalent Gram positive and Gram negative bacteria. Chitosan gel films reduce the number of colonies after 24 h of incubation by factors of ∼105–107 CFU/mL, compared with controls. For each of these films, the structure and preparation condition has a direct relationship to antimicrobial activity and effectiveness. These gel film bandages also show excellent stability against biodegradation with lysozyme under physiological conditions (5% weight loss over a period of 1 month, 2% in the first week), allowing use during the entire healing process. These chitosan thin films and subsequent derivatives hold potential as low-cost, dissolvable bandages, or second skin, with antimicrobial properties that prohibit the most relevant intrahospital bacteria that infest burn injuries.

Microbial community composition and bacterioplankton at time series station Helgoland Roads, North Sea

A process of global importance in carbon cycling is the remineralization of algae biomass by heterotrophic bacteria, most notably during massive marine algae blooms. Such blooms can trigger secondary blooms of planktonic bacteria that consist of swift successions of distinct bacterial clades, most prominently members of the Flavobacteriia, Gammaproteobacteria and the alphaproteobacterial Roseobacter clade. This study explores such successions during spring phytoplankton blooms in the southern North Sea (German Bight) for four consecutive years. The surface water samples were taken at Helgoland Island about 40 km offshore in the southeastern North Sea in the German Bight at the station 'Kabeltonne' (54° 11.3' N, 7° 54.0' E) between the main island and the minor island, Düne (German for 'dune') using small research vessels (http://www.awi.de/en/expedition/ships/more-ships.html). Water depths at this site fluctuate from 6 to 10 m over the tidal cycle. Samples were processed as described previously (Teeling et al., 2012; doi:10.7554/eLife.11888.001) in the laboratory of the Biological Station Helgoland within less than two hours after sampling. Assessment of absolute cell numbers and bacterioplankton community composition was carried out as described previously (Thiele et al., 2011; doi:10.1016/B978-0-444-53199-5.00056-7). To obtain total cell numbers, DNA of formaldehyde fixed cells filtered on 0.2 mm pore sized filters was stained with 4',6-diamidino-2-phenylindole (DAPI). Fluorescently labeled cells were subsequently counted on filter sections using an epifluores-cence microscope. Likewise, bacterioplankton community composition was assessed by catalyzedreporter deposition fluorescence in situ hybridization (CARD-FISH) of formaldehyde fixed cells on 0.2 mm pore sized filters.

Organic carbon and nitrogen, sediment composition, and clay mineralogy of Deep Sea Drilling Project Site 603, western Atlantic Ocean

Sediment and interstitial water samples recovered during DSDP Leg 93 at Site 603 (lower continental rise off Cape Hatteras) were analyzed for a series of geochemical facies indicators to elucidate the nature and origin of the sedimentary material. Special emphasis was given to middle Cretaceous organic-matter-rich turbidite sequences of Aptian to Turanian age. Organic carbon content ranges from nil in pelagic claystone samples to 4.2% (total rock) in middle Cretaceous carbonaceous mudstones of turbiditic origin. The organic matter is of marine algal origin with significant contributions of terrigenous matter via turbidites. Maturation indices (vitrinite reflectance) reveal that the terrestrial humic material is reworked. Maturity of autochthonous material (i.e., primary vitrinite) falls in the range of 0.3 to 0.6% Carbohydrate, hydrocarbon, and microscopic investigations reveal moderate to high microbial degradation. Unlike deep-basin black shales of the South and North Atlantic, organic-carbon-rich members of the Hatteras Formation lack trace metal enrichment. Dissolved organic carbon (DOC) in interstitial water samples ranges from 34.4 ppm in a sandstone sample to 126.2 ppm in an organic-matter-rich carbonaceous claystone sample. One to two percent of DOC is carbohydratecarbon.

(Table 1) Li, B and Sr isotopic composition and concentration in ODP Leg 209 samples

Spinel harzburgites from ODP Leg 209 (Sites 1272A, 1274A) drilled at the Mid-Atlantic ridge between 14°N and 16°N are highly serpentinized (50-100%), but still preserve relics of primary phases (olivine >= orthopyroxene >> clinopyroxene). We determined whole-rock B and Li isotope compositions in order to constrain the effect of serpentinization on d11B and d7Li. Our data indicate that during serpentinization Li is leached from the rock, while B is added. The samples from ODP Leg 209 show the heaviest d11B (+29.6 to +40.52 per mil) and lightest d7Li (-28.46 to +7.17 per mil) found so far in oceanic mantle. High 87Sr/86Sr ratios (0.708536 to 0.709130) indicate moderate water/rock ratios (3 to 273, on the average 39), in line with the high degree of serpentinization observed. Applying the known fractionation factors for 11B/10B and 7Li/6Li between seawater and silicates, serpentinized peridotite in equilibrium with seawater at conditions corresponding to those of the studied drill holes (pH: 8.2; temperature: 200 °C) should have d11B of +21.52 per mil and d7Li of +9.7 per mil. As the data from ODP Leg 209 are clearly not in line with this, we modelled a process of seawater-rock interaction where d11B and d7Li of seawater evolve during penetration into the oceanic plate. Assuming chemical equilibrium between fluid and a rock with d11B and d7Li of ODP Leg 209 samples, we obtain d11B and d7Li values of +50 to +60 per mil, -2 to +12 per mil, respectively, for the coexisting fluid. In the oceanic domain, no hydrothermal fluids with such high d11B have yet been found, but are predicted by theoretical calculations. Combining the calculated water/rock ratios with the d7Li and d11B evolution in the fluid, shows that modification of d7Li during serpentinization requires higher water/rock ratios than modification of d11B. Extremely heavy d11B in serpentinized oceanic mantle can potentially be transported into subduction zones, as the B budget of the oceanic plate is dominated by serpentinites. Extremely light d7Li is unlikely to survive as the Li budget is dominated by the oceanic crust, even at small fractions.

(Table 1) Magnetic susceptibility, lithologic composition and stable isotope record for ODP Hole 132-810C

Site 810 was drilled atop Shatsky Rise during Ocean Drilling Program (ODP) Leg 132. The principal objective at Site 810 was to drill interbedded cherts and chalks of Mesozoic age using the diamond coring system (DCS). The objective was not achieved because of difficulties in setting up the reentry cone on the seafloor; however, a shortened section of Cretaceous-Cenozoic nannofossil ooze was recovered with the advanced piston corer (APC). Although the section is interrupted by hiatuses, the upper 50 m carry detailed information relating to biogenic productivity, water chemistry, and eolian input during the Pliocene and Pleistocene. Four holes were drilled at Site 810. Hole 810A consists of a single mud-line core for an ongoing ODP geriatric study. The second hole (Hole 810B) was washed to 60 mbsf (without core recovery) to provide information required for setting the 16-in. casing attached to the reentry cone. Hole 810C penetrated 136.1 mbsf, mostly with the APC, with a total recovery of 143.81 m of nannofossil ooze. A reentry cone was placed over Hole 810D but no casing was successfully suspended in the hole and no sediment was cored. This data report presents the results of shore-based high-resolution analyses of carbonate and oxygen isotopic variations in the upper 50 m of the section at Site 810 and compares these variations with the shipboard determinations of magnetic susceptibility and GRAPE bulk density from the multisensor track.

(Table 1) Gas molecules, isotopic composition and delta Deuterium in DSDP Holes 95-603D and 95-613

Methane is the major hydrocarbon gas measured in Vacutainer samples from Holes 603D and 613 ( C1/sumCn > 0.999). In Hole 613 the concentration of this dry hydrocarbon gas is highest (7.4 x 10 **5 ppm max.) in the upper 60 to 120 m, then decreases erratically to low trace levels by 261 m sub-bottom (lower Pliocene). No gas accumulations were observed in older sediments. Methane from both holes is strongly depleted in both 13C (d13C, - 75 to -85 per mil) and deuterium (D/H, - 175 to -262 per mil), indicating the biogenic origin of the methane. The C and H isotopic compositions support methanogenesis via the CO2-reduction pathway; this is also corroborated by the dissolved-sulfate and alkalinity minima at these depths. The relationship between D/H of the methane and coexisting interstitial water from Site 613 further show the methanogenesis to be primarily by CO2 reduction.

Argon, uranium, thorium and lead composition and ages of ODP Leg 180 sites

During Ocean Drilling Program (ODP) Leg 180, 11 sites were drilled in the vicinity of the Moresby Seamount to study processes associated with the transition from continental rifting to seafloor spreading in the Woodlark Basin. This paper presents thermochronologic (40Ar/39Ar, 238U/206Pb, and fission track) results from igneous rocks recovered during ODP Leg 180 that help constrain the latest Cretaceous to present-day tectonic development of the Woodlark Basin. Igneous rocks recovered (primarily from Sites 1109, 1114, 1117, and 1118) consist of predominantly diabase and metadiabase, with minor basalt and gabbro. Zircon ion microprobe analyses gave a 238U/206Pb age of 66.4 ± 1.5 Ma, interpreted to date crystallization of the diabase. 40Ar/39Ar plagioclase apparent ages vary considerably according to the degree to which the diabase was altered subsequent to crystallization. The least altered sample (from Site 1109) yielded a plagioclase isochron age of 58.9 ± 5.8 Ma, interpreted to represent cooling following intrusion. The most altered sample (from Site 1117) yielded an isochron age of 31.0 ± 0.9 Ma, interpreted to represent a maximum age for the timing of subsequent hydrothermal alteration. The diabase has not been thermally affected by Miocene-Pliocene rift-related events, supporting our inference that these rocks have remained at shallow and cool levels in the crust (i.e., upper plate) since they were partially reset as a result of middle Oligocene hydrothermal alteration. These results suggest that crustal extension in the vicinity of the Moresby Seamount, immediately west of the active seafloor spreading tip, is being accommodated by normal faulting within latest Cretaceous to early Paleocene oceanic crust. Felsic clasts provide additional evidence for middle Miocene and Pliocene magmatic events in the region. Two rhyolitic clasts (from Sites 1110 and 1111) gave zircon 238U/206Pb ages of 15.7 ± 0.4 Ma and provide evidence for Miocene volcanism in the region. 40Ar/39Ar total fusion ages on single grains of K-feldspar from these clasts yielded younger apparent ages of 12.5 ± 0.2 and 14.4 ± 0.6 Ma due to variable sericitization of K-feldspar phenocrysts. 238U/206Pb zircon, 40Ar/39Ar K-feldspar and biotite total fusion, and apatite fission track analysis of a microgranite clast (from Site 1108) provide evidence for the existence of a rapidly cooled 3.0 to 1.8 Ma granitic protolith. The clast may have been transported longitudinally from the west (e.g., from the D'Entrecasteaux Islands). Alternatively, it may have been derived from a more proximal, but presently unknown, source in the vicinity of the Moresby Seamount.

(Table 3, page 8) Chemical composition and physical cahracteristics of manganese nodules from the Pacific Ocean

This paper reviews the state of the art in processing and extraction of ocean floor manganese nodules. It briefly reviews the mining sites where the abundant rich nodules occur and also discusses the metal distribution in nodules in view of economical processing and extraction of these metal values. The paper discloses in a detailed manner the physical and chemical characteristics of nodules, including porosity, surface area, water content and the effect of temperature on crystal structure of major constituents of nodules. In the extraction aspect of nodules, the paper reviews two different extraction schemes revealed in the literature, namely hydrometallurgical treatment and pyrometallurgical treatment. The hydrometallurgical treatments include acid leaching, ammonia leaching, leaching with reducing agents and leaching after high temperature pre-treatments such as in sulfating rousting, while the pyrometallurgical processes include smelting, chlorination-vaporization and segregation. The paper also covers metal recovery processes from leach liquor. An economic survey of processing nodules has been made in terms of problems associated with metal-marketing, and impact of metal production from nodules on mineral industries.