Periodontal ligament influence on the stress distribution in a removable partial denture supported by implant: a finite element analysis

Objective: The non-homogenous aspect of periodontal ligament (PDL) has been examined using finite element analysis (FEA) to better simulate PDL behavior. The aim of this study was to assess, by 2-D FEA, the influence of non-homogenous PDL on the stress distribution when the free-end saddle removable partial denture (RPD) is partially supported by an osseointegrated implant. Material and Methods: Six finite element (FE) models of a partially edentulous mandible were created to represent two types of PDL (non-homogenous and homogenous) and two types of RPD (conventional RPD, supported by tooth and fibromucosa; and modified RPD, supported by tooth and implant [10.00x3.75 mm]). Two additional FE models without RPD were used as control models. The non-homogenous PDL was modeled using beam elements to simulate the crest, horizontal, oblique and apical fibers. The load (50 N) was applied in each cusp simultaneously. Regarding boundary conditions the border of alveolar ridge was fixed along the x axis. The FE software (Ansys 10.0) was used to compute the stress fields, and the von Mises stress criterion (sigma vM) was applied to analyze the results. Results: The peak of sigma vM in non-homogenous PDL was higher than that for the homogenous condition. The benefits of implants were enhanced for the non-homogenous PDL condition, with drastic sigma vM reduction on the posterior half of the alveolar ridge. The implant did not reduce the stress on the support tooth for both PDL conditions. Conclusion: The PDL modeled in the non-homogeneous form increased the benefits of the osseointegrated implant in comparison with the homogeneous condition. Using the non-homogenous PDL, the presence of osseointegrated implant did not reduce the stress on the supporting tooth.

Histological and three-dimensional evaluation of osseointegration to nanostructured calcium phosphate-coated implants

Nanostructures on implant surfaces have been shown to enhance osseointegration; however, commonly used evaluation techniques are probably not sufficiently sensitive to fully determine the effects of this process. This study aimed to observe the osseointegration properties of nanostructured calcium phosphate (CaP)-coated implants, by using a combination of three-dimensional imaging and conventional histology. Titanium implants were coated with stable CaP nanoparticles using an immersion technique followed by heat treatment. Uncoated implants were used as the control. After topographical and chemical characterizations, implants were inserted into the rabbit femur. After 2 and 4 weeks, the samples were retrieved for micro-computed tomography and histomorphometric evaluation. Scanning electron microscopy evaluation indicated that the implant surface was modified at the nanoscale by CaP to obtain surface textured with rod-shaped structures. Relative to the control, the bone-to-implant contact for the CaP-coated implant was significantly higher at 4 weeks after the implant surgery. Further, corresponding 3-D images showed active bone formation surrounding the implant. 3-D quantification and 2-D histology demonstrated statistical correlation; moreover, 3-D quantification indicated a statistical decrease in bone density in the non-coated control implant group between 2 and 4 weeks after the surgery. The application of 3-D evaluation further clarified the temporal characteristics and biological reaction of implants in bone. (C) 2011 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.

Influence of the Light-Curing Unit, Storage Time and Shade of a Dental Composite Resin on the Fluorescence

The aim of this study was to determine the influence of three light-curing units, storage times and colors of the dental composite resin on the fluorescence. The specimens (diameter 10.0 +/- 0.1 mm, thickness 1.0 +/- 0.1 mm) were made using a stainless steel mold. The mold was filled with the microhybrid composite resin and a polyethylene film covered each side of the mold. After this, a glass slide was placed on the top of the mold. To standardize the top surface of the specimens a circular weight (1 kg) with an orifice to pass the light tip of the LCU was placed on the top surface and photo-activated during 40 s. Five specimens were made for each group. The groups were divided into 9 groups following the LCUs (one QTH and two LEDs), storage times (immediately after curing, 24 hours, 7 and 30 days) and colors (shades: A(2)E, A(2)D, and TC) of the composite resin. After photo-activation, the specimens were storage in artificial saliva during the storage times proposed to each group at 37 C and 100% humidity. The analysis of variance (ANOVA) and Tukey's post-hoc tests showed no significant difference between storage times (immediately, 24 hours and 30 days) (P > 0.05). The means of fluorescence had difference significant to color and light-curing unit used to all period of storage (P < 0.05). The colors had difference significant between them (shades: A2D < A2E < TC) (P < 0.05). The Ultraled (LED) and Ultralux (QTH) when used the TC shade showed higher than Radii (LED), however to A2E shade and A2D shade any difference were found (P > 0.05).

Follicle deviation and ovulatory capacity in Bos indicus heifers

The objectives of Experiment I were to determine the interval from ovulation to deviation, and diameter of the dominant follicle (DF) and largest subordinate follicle (SF) at deviation in Nelore (Bos indicus) heifers by two methods (observed and calculated). Heifers (n = 12) were examined ultrasonographically every 12 h from ovulation (Day 0) to Day 5. The time of deviation and diameter of the DF and largest SF at deviation did not differ (P > 0.05) between observed and calculated methods. Overall, deviation occurred 2.5 +/- 0.2 d (mean +/- S.E.M.) after ovulation, and diameters for DF and largest SF at deviation were 6.2 +/- 0.2 and 5.9 +/- 0.2 mm, respectively. Experiment 2 was designed to determine the size at which the DF acquires ovulatory capacity in B. indicus heifers. Twenty-nine heifers were monitored every 24 h by ultrasonography, from ovulation until the DF reached diameters of 7.0-8.4 mm (n = 9), 8.5-10.0 mm (n = 10), or >10.0 mm (n = 10). At that time, heifers were treated with 25 mg of pLH and monitored by ultrasonography every 12 h for 48 h. Ovulation occurred in 3 of 9, 8 of 10, and 9 of 10 heifers, respectively (P < 0.05). In summary, there was no significant difference between observed and calculated methods of determining the beginning of follicle deviation. Deviation occurred 2.5 d after ovulation when the DF reached 6.2 mm, and ovulatory capacity was acquired by DF as small as 7.0 mm. (c) 2008 Elsevier B.V. All rights reserved.

Pollination Biology of Jacaranda oxyphylla with an Emphasis on Staminode Function

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Proteomic characterization of the multiple forms of the PLAs from the venom of the social wasp Polybia paulista

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Profiling the Proteome of the Venom from the Social Wasp Polybia paulista: A Clue to Understand the Envenoming Mechanism

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Metabolic response to feeding in Tupinambis merianae: Circadian rhythm and a possible respiratory constraint

The diurnal tegu lizard Tupinambis merianae exhibits a marked circadian variation in metabolism that is characterized by the significant increase in metabolism during part of the day. These increases in metabolic rate, found in the fasting animal, are absent during the first 2 d after meal ingestion but reappear subsequently, and the daily increase in metabolic rate is added to the increase in metabolic rate caused by digestion. During the first 2 d after feeding, priority is given to digestion, while on the third and following days, the metabolic demands are clearly added to each other. This response seems to be a regulated response of the animal, which becomes less active after food ingestion, rather than an inability of the respiratory system to support simultaneous demands at the beginning of digestion. The body cavity of Tupinambis is divided into two compartments by a posthepatic septum (PHS). Animals that had their PHS surgically removed showed no significant alteration in the postprandial metabolic response compared to tegus with intact PHS. The maximal metabolic increment during digestion, the relative cost of meal digestion, and the duration of the process were virtually unaffected by the removal of the PHS.

Pseudechis australis Venomics: Adaptation for a Defense against Microbial Pathogens and Recruitment of Body Transferrin

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

The Venomics of Bothrops alternatus is a Pool of Acidic Proteins with Predominant Hemorrhagic and Coagulopathic Activities

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Snake Venomic of Crotalus durissus terrificus-Correlation with Pharmacological Activities

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Snake venomics of the Siamese Russell's viper (Daboia russelli siamensis) - Relation to pharmacological activities

The venom proteome of Daboia russelli siamensis, a snake of medical importance in several Asian countries, was analysed by 2-D electrophoresis, subsequent MS/MS and enzymatic assays. The proteome comprises toxins from six protein families: serine proteinases, metalloproteinases, phospholipases A(2), L-amino acid oxidases, vascular endothelial growth factors and C-type lectin-like proteins. The venom toxin composition correlates with the clinical manifestation of the Russell's viper bite and explains pathological effects of the venom such as coagulopathy, oedema, hypotensive, necrotic and tissue damaging effects. The vast majority of toxins are potentially involved in coagulopathy and neurotoxic effects. The predominant venom components are proteinases capable of activating blood coagulation factors and promoting a rapid clotting of the blood, and neurotoxic phospholipase A(2)s. The analysis of the venom protein composition provides a catalogue of secreted toxins. The proteome of D. r. siamensis exhibits a lower level of toxin diversity than the proteomes of other viperid snakes. In comparison to the venoms of Vipera ammodytes ammodytes and Vipera ammodytes meridionalis, the venom from D. r. siamensis showed quantitative differences in the proteolytic, phospholipase A2, L-amino acid oxidase and alkaline phosphatase activities. (c) 2009 Published by Elsevier B.V.

Critical temperature for first-order phase transitions in confined systems

We consider the Euclidean D-dimensional -lambda vertical bar phi vertical bar(4)+eta vertical bar rho vertical bar(6) (lambda,eta > 0) model with d (d <= D) compactified dimensions. Introducing temperature by means of the Ginzburg-Landau prescription in the mass term of the Hamiltonian, this model can be interpreted as describing a first-order phase transition for a system in a region of the D-dimensional space, limited by d pairs of parallel planes, orthogonal to the coordinates axis x(1), x(2),..., x(d). The planes in each pair are separated by distances L-1, L-2, ... , L-d. We obtain an expression for the transition temperature as a function of the size of the system, T-c({L-i}), i = 1, 2, ..., d. For D = 3 we particularize this formula, taking L-1 = L-2 = ... = L-d = L for the physically interesting cases d = 1 (a film), d = 2 (an infinitely long wire having a square cross-section), and for d = 3 (a cube). For completeness, the corresponding formulas for second-order transitions are also presented. Comparison with experimental data for superconducting films and wires shows qualitative agreement with our theoretical expressions.

The cohomology of superspace, pure spinors and invariant integrals

The superform construction of supersymmetric invariants, which consists of integrating the top component of a closed superform over spacetime, is reviewed. The cohomological methods necessary for the analysis of closed superforms are discussed and some further theoretical developments presented. The method is applied to higher-order corrections in heterotic string theory up to alpha'(3). Some partial results on N = 2, d = 10 and N = 1, d = 11 are also given.

Ten-dimensional super-Yang-Mills with nine off-shell supersymmetries

After adding 7 auxiliary scalars to the d = 10 super-Yang-Mills action, 9 of the 16 supersymmetries close off-shell. In this Letter, these 9 supersymmetry generators are related by dimensional reduction to scalar and vector topological symmetry in N = 2, d = 8 twisted super-Yang-Mills. Furthermore, a gauge-invariant superspace action is constructed for d = 10 super-Yang-Mills where the superfelds depend on 9 anticommuting theta variables. (c) 2007 Published by Elsevier B.V.