Purification and properties of β-glucosidase from a thermophilic fungus Humicola lanuginosa (Griffon and Maublanc) Bunce

An extracellular β-glucosidase (EC 3.2.1.21) has been purified to homogeneity from the culture filtrate of a thermophilic fungus, Humicola lanuginosa (Griffon and Maublanc) Bunce, using duplicating paper as the carbon source. The enzyme was purified 82-fold with a 43% yield by ion-exchange chromatography and gel filtration. The molecular weight of the protein was estimated to be 135,000 by gel filtration and 110,000 by electrophoresis. The sedimentation coefficient was 10.5 S. It was an acidic protein containing high amounts of acidic amino acid residues. It was poor in sulphur-containing amino acids. It also contained 9% carbohydrate. The enzyme activity was optimum at pH 4.5 and at 60°C. The enzyme was stable in the pH range 6–9 for 24 h at 25°C. The enzyme had similar affinities towards cellobiose and p-nitrophenyl-β-d-glucoside with Km values of 0.44 mM and 0.50 mM, respectively. The enzyme was capable of hydrolysing larchwood xylan, xylobiose and p-nitrophenyl-β-d-xyloside, though to a lesser extent. The enzyme was specific for the β-configuration and glucose moiety in the substrate.

Accelerating Waves in Polar Coronal Holes as Seen by EIS and SUMER

We present EIS/Hinode and SUMER/SOHO observations of propagating disturbances detected in coronal lines in inter-plume and plume regions of a polar coronal hole. The observation was carried out on 2007 November 13 as part of the JOP196/HOP045 program. The SUMER spectroscopic observation gives information about fluctuations in radiance and on both resolved (Doppler shift) and unresolved (Doppler width) line-of-sight velocities, whereas EIS 40 `'wide slot images detect fluctuations only in radiance but maximize the probability of overlapping field of view between the two instruments. From distance-time radiance maps, we detect the presence of propagating waves in a polar inter-plume region with a period of 15-20 minutes and a propagation speed increasing from 130 +/- 14 km s(-1) just above the limb to 330 +/- 140 km s(-1) around 160 `' above the limb. These waves can be traced to originate from a bright region of the on-disk part of the coronal hole where the propagation speed is in the range of 25 +/- 1.3 to 38 +/- 4.5 km s(-1), with the same periodicity. These on-disk bright regions can be visualized as the base of the coronal funnels. The adjacent plume region also shows the presence of propagating disturbances with the same range of periodicity but with propagation speeds in the range of 135 +/- 18 to 165 +/- 43 km s(-1) only. A comparison between the distance-time radiance map of the two regions indicates that the waves within the plumes are not observable (may be getting dissipated) far off-limb, whereas this is not the case in the inter-plume region. A correlation analysis was also performed to find out the time delay between the oscillations at several heights in the off-limb region, finding results consistent with those from the analysis of the distance-timemaps. To our knowledge, this result provides first spectroscopic evidence of the acceleration of propagating disturbances in the polar region close to the Sun (within 1.2 R/R-circle dot), which provides clues to the understanding of the origin of these waves. We suggest that the waves are likely either Alfvenic or fast magnetoacoustic in the inter-plume region and slow magnetoacoustic in the plume region. This may lead to the conclusion that inter-plumes are a preferred channel for the acceleration of the fast solar wind.

Isoscalar axial-vector renormalization constant and polarized proton structure function

The isoscalar axial-vector renormalization constant is reevaluated using the QCD sum-rule method. It is found to be substantially different from the anomaly-free octet axial-vector u¯γμγ5+d¯γμγ5-2s¯γμγ5 coupling. Combining this determination with the known values of the isovector coupling GA and the F/D ratio for the octet current, we find the integral of the polarized proton structure function to be Gp=Fgp1(x)dx=0.135, in agreement with recent measurement by the European Muon Collaboration.

Geometry changes induced by negative hyperconjugative interactions involving carbonyl and thiocarbonyl groups

MNDO geometry optimizations have been carried out on a series of acyclic and cyclic unsymmetrically disubstituted carbonyl and thiocarbonyl compounds. The C=X unit shows a consistent and often sizeable tilt towards one of the substituents, following the order O > Snot, vert, similarN > C > B. Reference ab initio calculations and available experimental results support the MNDO results. The effect, which is particularly dramatic in small rings, is attributed primarily to favorable negative hyperconjugative interaction between the lone pair on X and a low lying adjacent σ* orbital. Such an interaction can lead to highly distorted structures, including perhaps to a planar molecule with an inverted sp2 carbon center.

Direct Writing of Copper Film Patterns by Laser-Induced Decomposition of Copper Acetate

Direct writing of patterns is being widely attempted in the field of microelectronic circuit/device manufacture. Use of this technique eliminates the need for employing photolithographic process. Laser induced direct writing can be achieved by (i) Photochemical reaction [i] , (ii) Evaporation from target material [2], and (iii) decomposition.Micron size features of palladium and copper through decomposition of palladium acetate and copper formate respectively on quartz and silicon using Argon ion laser have been reported [3,4] .In this commuication we report a technique for both single line and large area depositon of copper through decomposition of copper acetate,(CH3COO)2Cu, on alumina substrates.Nd:YAG laser known for its reliability and low maintenance cost as compared to excimer and other gas lasers is used. This technique offers an attractive and economical alternative for manufacture of thin film microcircuits.

2,4-Lutidine-1-oxide complexes of lanthanide perchlorates

2,4-Lutidine-1-oxide (2,4-LutO) complexes of lanthanide perchlorates of the formulae Ln2(2,4-LutO)13(ClO4)6 (Ln = Pr and Nd) and Ln2(2,4-LutO)15 (ClO4)6 (Ln = La, Tb, Dy, Ho and Yb) have been prepared and characterised by chemical analysis, IR, NMR, conductance and electronic spectral data. Proton NMR data along with the IR data show that the ligand coordinates to the metal ion through the oxygen. Conductance data of the complexes in acetone and nitrobenzene indicate that the perchlorate is not coordinated to the metal ion.

Bonding isomerism in the chelate-exchange reactions of isonitroso-β-keto-imino isomeric nickel(ii) mixed ligand complexes

A novel chelate exchange reaction, leading to the formation of a series of N-alkyl substituent dependent mixed ligand isomeric complexes of the type Ni(R-AB)(AC') and Ni(R-AC)(AB') (Figure 1) are discussed. Here, AB and AC denote two different N-bonded isonitroso-β-keto-imino ligand moieties, while AB' and AC' are the corresponding O-bonded ligand moieties and R is an N-alkyl substituent. The isomeric complexes are suggested to be monomeric, neutral and diamagnetic with an asymmetric square planar geometry. The bonding isomerism of the isonitroso group in these complexes is discussed on the basis of the infrared and proton magnetic resonance spectral studies. A probable mechanism for the preparative route is also proposed.

Noise minimization in RC-active filters using generalized impedance converters

A procedure has been given for minimizing the total output noise of a Generalized Impedance Converter (GIC), subject to constraints dictated by signal handling capability of the Operational Amplifiers and ease of microcircuit fabrication. The noise reduction is achieved only by the adjustment of RC elements of the GIC, and the total output noise after optimization in the example cited is close to the theoretical lower limit. The output noise of a higher-order filter can be reduced by RC-optimizing the individual GIC's of the active realization. Experimental results on a 20–24 kHz channel bank band-pass filter demonstrate the effectiveness of the above procedure.

Chemical approaches to penicillin allergy—V. Nature of reaction between rabbit antigen (CRP-penicillin conjugate) and rabbit antipenicillin antibody

The availability of an electrophoretically homogeneous rabbit penicillin carrier receptor protein (CRP) and rabbit antipenicillin antibody afforded an idealin vitro system to calculate the thermodynamic parameters of the binding of14C benzyl penicillin CRP conjugate (antigen) to the purified rabbit antipenicillin antibody. The thermodynamic parameters of this antigen-antibody reaction has been studied by radio-active assay method by using millipore filter. Equilibrium constant (K) of this reaction has been found to be 2·853×109M−2 and corresponding free energy (ΔG) at 4°C and 37°C has been calculated to be −12·02 and −13·5 kcal/mole, enthalpy (ΔH) and entropy (ΔS) has been found to be 361 kcal/mole and +30 eu/mole respectively. Competitive binding studies of CRP-analogue conjugates with the divalent rabbit antibody has been carried out in the presence of14C-penicilloyl CRP. It was found that 7-deoxy penicillin-CRP complex and 6-amino penicilloyl CRP conjugate binds to the antibody with energies stronger than that with the14C-penicilloyl CRP. All the other analogue conjugates are much weaker in interfering with the binding of the penicilloyl CRP with the antibody. The conjugate of methicillin,o-nitro benzyl penicillin and ticarcillin with CRP do not materially interfere in the process.

Identifying N60D mutation in omega subunit of Escherichia coli RNA polymerase by bottom-up proteomic approach

Escherichia coli RNA polymerase is a multi-subunit enzyme containing alpha(2)beta beta'omega sigma, which transcribes DNA template to intermediate RNA product in a sequence specific manner. Although most of the subunits are essential for its function, the smallest subunit omega (average molecular mass similar to 10,105 Da) can be deleted without affecting bacterial growth. Creating a mutant of the omega subunit can aid in improving the understanding of its role. Sequencing of rpoZ gene that codes for omega subunit from a mutant variant suggested a substitution mutation at position 60 of the protein: asparagine (N) -> aspartic acid (D). This mutation was verified at the protein level by following a typical mass spectrometry (MS) based bottom-up proteomic approach. Characterization of in-gel trypsin digested samples by reverse phase liquid chromatography (LC) coupled to electrospray ionization (ESI)-tandem mass spectrometry (MS/MS) enabled in ascertaining this mutation. Electron transfer dissociation (ETD) of triply charged (M + 3H)(3+)] tryptic peptides (residues 53-67]), EIEEGLINNQILDVR from wild-type and EIEEGLIDNQILDVR from mutant, facilitated in unambiguously determining the site of mutation at residue 60.

Corporate Brand Repositioning with CSR as the Differentiating Factor: A Study on Consumer Perceptions

Purpose – This research paper studies how the strategy of repositioning enables marketers to communicate CSR as their brand’s differentiating factor. It aims at understanding how consumer perceptions can be managed to generate brand value through corporate brand repositioning when CSR is the differentiating factor. The purpose of this paper is to answer the following research question: How can consumer perceptions be managed to generate brand value through corporate brand repositioning when CSR is the differentiating factor? The two research objectives were: 1. to build a model, which describes the different components of consumer perceptions involved in generation of brand value through repositioning when CSR is the differentiating factor, 2. to identify the most critical components in the context of the case company, IKEA for generation of brand value during the process of corporate brand repositioning Design/methodology/approach – This paper is based on the literature review covering the logic of brand value generation, repositioning strategy and consumer perceptions connected to CSR activities. A key concept of the positioning theory, the brand’s differentiating factor, was explored. Previous studies have concluded that desirability of the differentiating factor largely determines the level of brand value-creation for the target customers. The criterion of desirability is based on three dimensions: relevance, distinctiveness and believability. A model was built in terms of these desirability dimensions. This paper takes a case study approach where the predefined theoretical framework is tested using IKEA as the case company. When developing insights on the multifaceted nature of brand perceptions, personal interviews and individual probing are vital. They enable the interviewees to reflect on their feelings and perceptions with their own words. This is why the data collection was based on means-end type of questioning. Qualitative interviews were conducted with 12 consumers. Findings – The paper highlights five critical components that may determine whether IKEA will fail in its repositioning efforts. The majority of the critical components involved believability perceptions. Hence, according to the findings, establishing credibility and trustworthiness for the brand in the context of CSR seems primary. The most critical components identified of the believability aspect were: providing proof of responsible codes of conduct via conducting specific and concrete CSR actions, connecting the company’s products and the social cause, and building a linkage between the initial and new positioning while also weakening the old positioning. Originality/value – Marketers’ obligation is to prepare the company for future demands. Companies all over the globe have recognized the durable trend of responsibility and sustainability. Consumer´s worry about the environmental and social impact of modern lifestyles is growing. This is why Corporate Social Responsibility (CSR) provides brands an important source of differentiation and strength in the future. The strategy of repositioning enables marketers to communicate CSR as their brand’s differentiating factor. This study aimed at understanding how consumer perceptions can be managed to generate brand value through corporate brand repositioning when CSR is the differentiating factor.