beta-delayed proton decays of Sm-133 and Yb-149

Sm-133 was produced via fusion evaporation in the reaction Ca-40+Ru-96. Its P-delayed proton decay was studied by means of "p-gamma" coincidence in combination with a He-jet tape transport system, including half-lives, proton energy spectra, gamma-transitions following the proton emissions, and the branching ratios to the low-lying states in the grand-daughter nuclei. The possible spins and parities of 133Sm were extracted by fitting the experimental data with a statistical model calculation. The configuration-constrained nuclear potential energy surfaces of Sm-133 were calculated by using the Woods-Saxon Strutinsky method. Comparing the experimental and calculated results, the spins and parities Of Sm-133 were assigned to be 5/2(+) and 1/2(-), which is reconciled with our published simple (EC+beta(+)) decay scheme Of Sm-113 in 2001. In addition, our experimental data on the beta-delayed proton decay of Yb-149 reported in Eur. Phys. J., 2001, A12: 1-4 was also analyzed by using the same method. The spin and parity of Yb-149 was assigned to be 1/2-.

4KG-M制冷机做冷源的自循环氦液化装置研制；Development of helium liquefaction self-circulation system with 4 K G-M cryocoolers

采用5台1.5W/4.2KG-M制冷机(日本住友RDK415D)并联研制出了1台方便实验室使用的小型氦液化装置,并为其建立了性能测量实验台。实验结果表明:液氦温度为4.17K(饱和压力为96kPa)时,氦液化率为74L/d;液氦温度为4.42K(饱和压力为121kPa)时,液化率为116L/d,经拟合,在4.2K(饱和压力为100kPa)时液化率为83L/d,并且通过100小时以上的连续运行,说明该氦液化装置自循环性能良好。通过实验发现:实测氦液化率远大于制冷机冷头制冷量对应的计算氦液化率。分析认为:G-M制冷机气缸壁对氦气预冷是提高实际氦液化率的主要因素。

Pt-based anode catalysts for direct ethanol fuel cells

In the present work, several carbon supported PtSn and PtSnRu catalysts were prepared with different atomic ratios and tested in direct ethanol fuel cells (DEFC) operated at lower temperature (T=90 degreesC). XRD and TEM results indicate that all of these catalysts consist of uniform nano-sized particles of narrow distribution and the average particle sizes are always less than 3.0 nm. As the content of Sn increases, the Pt lattice parameter becomes longer. Single direct ethanol fuel cell tests were used to evaluate the performance of carbon supported PtSn catalysts for ethanol electro-oxidation. It was found that the addition of Sn can enhance the activity towards ethanol electro-oxidation. It is also found that a single DEFC of Pt/Sn atomic ratioless than or equal to2, "Pt1Sn1/C, Pt3Sn2/C, and Pt2Sn1/C" shows better performance than those with Pt3Sn1/C and Pt4Sn1/C. But even adopting the least active PtSn catalyst, Pt4Sn1/C, the DEFC also exhibits higher performance than that with the commercial Pt1Ru1/C, which is dominatingly used in PEMFC at present as anode catalyst for both methanol electro-oxidation and CO-tolerance. At 90 degreesC, the DEFC exhibits the best performance when Pt2Sn1/C is adopted as anode catalysts. This distinct difference in DEFC performance between the catalysts examined here is attributed to the so-called bifunctional mechanism and to the electronic interaction between Pt and Sn. It is thought that -OHads, Surface Pt active sites and the ohmic effect of PtSn/C catalyst determines the electro-oxidation activity of PtSn catalysts with different Pt/Sn ratios. (C) 2004 Elsevier B.V. All rights reserved.

Preparation and characterization of monolithic columns for capillary electrochromatography with weak electroosmotic flow

Monolithic columns of capillary electrochromatography (CEC) with weak electroosmotic flow (EOF) have been prepared by in situ polymerization of butyl methacrylate and ethylene dimethacrylate, without any charged groups in the reaction mixture. The reproducibility of such columns has been proved good no matter whether they are prepared in the same batch or in different batches. In the case of BMA-EDMA monoliths, besides the traditional ternary mixture - 1-propanol, 1,4-butanediol, and water, binary porogenic solvents with only alcohols have also been adopted. Compared with ternary porogenic solvents, the design with binary ones allows for fine control of the pore diameter and the formation of the specific surface of the monolithic polymers. The composition of porogenic reagents has also been shown to have an effect on EOF in the column systems. In addition, the Joule heat effect in such columns has been studied by varying the inner diameter of columns. Through the separation of acidic compounds, monolithic columns with low EOF have shown potential in the analysis of charged samples.

The Synthesis and Characterization of a Novel (E,E)-Dioxime and its Mono- and Heterotrinuclear Complexes Containing an 18-Membered Dioxadithiadiazamacrocycle

The novel (E,E)-dioxime, 5,6:17,18-dibenzo-11,12-(4-nitrobenzo)-2,3-bis(hydroxyimino)-7,16-dithia-10,13-dioxa-1,4-diazacyclooctadecane) (H2L), has been synthesized from reaction of (E,E)-dichloroglyoxime (1) with 2,3:14,15-dibenzo 8,9-(4-nitrobenzo)-4,13-dithia-7,10-dioxa-1,16-diazahegzadecane (2). The mononuclear Co(III) complex (4) of this dioxime was prepared by oxidation of the cobalt (II) complex. The -capped Co(III) complex (5) was synthesized by using a precursor Co(III) complex and boron trifluoride dietherate. The heterotrinuclear complexes (6) and (7) were prepared by reaction of (5) with NiCl2·6H2O and CdCl2·H2O, respectively. In addition, the homotrinuclear Cu(II) complex (8), has also been prepared by the reaction of this dioxime with CuCl2·H2O. The structures of the dioxime and its complexes were identified by using elemental analysis, 1H- and 13C-NMR, IR, and mass spectral data.

文冠果壳苷对侧脑室注射Aβ_(1-42)致小鼠学习记忆障碍的改善作用

目的研究文冠果壳苷对侧脑室注射β肽淀粉样蛋白1-4(2Aβ1-42)小鼠学习记忆障碍的改善作用,并初步探讨了其作用机制。方法通过避暗和水迷宫实验检测了小鼠的学习记忆能力;使用分光光度计检测小鼠大脑组织中乙酰胆碱酯酶(AchE)和胆碱乙酰转移酶(ChAT)活性的变化。结果小鼠侧脑室注射凝聚态Aβ1-42显著降低了小鼠被动回避学习记忆能力及空间学习记忆能力(P<0.01),并且小鼠大脑AchE和ChAT活性显著降低(P均<0.05);而文冠果壳苷能够显著减少避暗错误次数,延长潜伏期(分别P<0.05、P<0.01);剂量依赖性地缩短水迷宫实验中小鼠到达安全台的游泳时间(分别P<0.05、P<0.01),不同程度地抑制Aβ1-42模型小鼠的AchE和ChAT活性的降低(P<0.05和<0.01)。结论文冠果壳苷对侧脑室注射Aβ1-42小鼠学习记忆障碍具有显著的改善作用,其作用机制可能与保护中枢胆碱能神经细胞,改善中枢胆碱能神经系统功能等有关。

Synthesis of isomeric bis(amine anhydride)s for novel poly(amine imide)s by Pd-catalyzed amination of 4-chlorophthalic anhydride

Two novel bis(amine anhydride) monomers, N,N'-bis(3,4-dicarboxyphenyl)-1,4-phenylenediamine dianhydride I and N,/N'-bis(3,4-dicarboxyphenyl)-1,3-phenylenediamine dianhydride 11, were prepared via palladium-catalyzed amination reaction of 4-chloro-N-methylphthaliniide with 1,4-phenylenediamine or 1,3-phenylenediamine, followed by alkaline hydrolysis of the intermediate bis(amine imide)s and subsequent dehydration of the resulting tetraacids. A series of new poly(amine imide)s were prepared from the synthesized dianhydride monomers with various diamines in NMP via conventional two-step method.

Crystallization behavior of a thermoplastic polyimide derived from 3,3 ',4,4 '-oxydiphthalic dianhydride and 4,4 '-oxydianiline

Nonisothermal and isothermal crystallization kinetics of an aromatic thermoplastic polyimide derived from 3,3',4,4'-oxydiphthalic dianhydride and 4,4'-oxydianiline have been investigated by means of differential scanning calorimetry (DSC) and wide-angle X-ray diffraction. The results for nonisothermal crystallization study showed that a weak melting peak appeared during the first heating process, whereas no crystallization peak appeared in the DSC curve during the subsequent cooling process. On the other hand, the study for the isothermal crystallization in the temperature range of 260-330 degrees C showed that a new exothermic peak appeared at lower temperature for the samples crystallized for 100 min at 300 degrees C.

Synthesis and characterization of phenylene-thiophene all-conjugated diblock copolymers

Grignard metathesis (GRIM) polymerization for all-conjugated diblock copolymers comprising poly (2,5-dihexyloxy-1,4-phenylene) (PPP) and poly(3-hexylthiophene) (P3HT) blocks were systematically studied with LiCl as additive and 1,2-bis (diphenylphosphino) ethane nickel dichloride (Ni(dppe)Cl-2) or 1,3-bis(diphenylphosphino) propane nickel dichloride (Ni(dppp)Cl-2) as catalyst. It was found that the addition order of the monomers was crucial for the success of copolymerization. With the monomer addition in the order of phenyl and then thienyl Grignard reagents, all-conjugated PPP-b-P3HT diblock copolymers with different block ratios were successfully synthesized. In contrast, the inverted addition order only afforded a mixture containing both block copolymers and deactivated or end-capped homopolymers.