Métodos de desacoplo de antenas PIFA en terminales móviles

[ES]Hoy en día, los sistemas de comunicación inalámbricos soportan un amplio número de servicios como la voz, datos y vídeos que requieren unas grandes tasas de transmisión. Por ello la mejora de la calidad del enlace que ofrecen los sistemas MIMO es clave. El problema surge al colocar varias antenas en un terminal móvil sin que aparezca un acoplamiento entre las distintas antenas que evite el correcto funcionamiento de estas. En este documento se realizará un estudio de los diferentes métodos de desacoplo entre antenas PIFA (Planar Inverted-F antenna) en un terminal móvil.

Injection Locked Clocking and Transmitter Equalization Techniques for Chip to Chip Interconnects

Semiconductor technology scaling has enabled drastic growth in the computational capacity of integrated circuits (ICs). This constant growth drives an increasing demand for high bandwidth communication between ICs. Electrical channel bandwidth has not been able to keep up with this demand, making I/O link design more challenging. Interconnects which employ optical channels have negligible frequency dependent loss and provide a potential solution to this I/O bandwidth problem. Apart from the type of channel, efficient high-speed communication also relies on generation and distribution of multi-phase, high-speed, and high-quality clock signals. In the multi-gigahertz frequency range, conventional clocking techniques have encountered several design challenges in terms of power consumption, skew and jitter. Injection-locking is a promising technique to address these design challenges for gigahertz clocking. However, its small locking range has been a major contributor in preventing its ubiquitous acceptance.

In the first part of this dissertation we describe a wideband injection locking scheme in an LC oscillator. Phase locked loop (PLL) and injection locking elements are combined symbiotically to achieve wide locking range while retaining the simplicity of the latter. This method does not require a phase frequency detector or a loop filter to achieve phase lock. A mathematical analysis of the system is presented and the expression for new locking range is derived. A locking range of 13.4 GHz–17.2 GHz (25%) and an average jitter tracking bandwidth of up to 400 MHz are measured in a high-Q LC oscillator. This architecture is used to generate quadrature phases from a single clock without any frequency division. It also provides high frequency jitter filtering while retaining the low frequency correlated jitter essential for forwarded clock receivers.

To improve the locking range of an injection locked ring oscillator; QLL (Quadrature locked loop) is introduced. The inherent dynamics of injection locked quadrature ring oscillator are used to improve its locking range from 5% (7-7.4GHz) to 90% (4-11GHz). The QLL is used to generate accurate clock phases for a four channel optical receiver using a forwarded clock at quarter-rate. The QLL drives an injection locked oscillator (ILO) at each channel without any repeaters for local quadrature clock generation. Each local ILO has deskew capability for phase alignment. The optical-receiver uses the inherent frequency to voltage conversion provided by the QLL to dynamically body bias its devices. A wide locking range of the QLL helps to achieve a reliable data-rate of 16-32Gb/s and adaptive body biasing aids in maintaining an ultra-low power consumption of 153pJ/bit.

From the optical receiver we move on to discussing a non-linear equalization technique for a vertical-cavity surface-emitting laser (VCSEL) based optical transmitter, to enable low-power, high-speed optical transmission. A non-linear time domain optical model of the VCSEL is built and evaluated for accuracy. The modelling shows that, while conventional FIR-based pre-emphasis works well for LTI electrical channels, it is not optimum for the non-linear optical frequency response of the VCSEL. Based on the simulations of the model an optimum equalization methodology is derived. The equalization technique is used to achieve a data-rate of 20Gb/s with power efficiency of 0.77pJ/bit.

Diseño de un array de antenas en tecnología microstrip

[ES]Este trabajo de fin de grado trata sobre el diseño de un array de antenas en tecnología microstrip para ser utilizado en la banda de 5 GHz del estándar de tecnologías inalámbricas IEEE 802.11a. Se buscará aplicar la teoría de arrays para conseguir la mayor ganancia posible, pero al mismo tiempo tratando de obtener un gran ancho de banda para que la antena sea óptima dentro de la mayor parte posible de la banda especificada. El proyecto partirá de un único parche microstrip para posteriormente ir evolucionando el diseño hasta llegar a un array de 2x2 elementos. Al primer diseño se le irán añadiendo progresivamente todos los componentes necesarios (red de adaptación, desfasadores, mayor número de parches, etc.) para poder ir estudiando las simulaciones a la vez que el diseño progresa. Todos los diseños se realizarán con el software ADS (Advanced Design System) de la compañía Agilent Technologies. Finalmente se fabricará el array diseñado y se medirá para contrastarlo con las simulaciones.

合成孔径激光成像雷达(Ⅰ):离焦和相位偏置望远镜接收天线

把合成孔径激光成像雷达的目标衍射区分为三个区域,提出采用离焦或者附加空间相位调制板的光学接收望远镜补偿回波像差。当目标处于菲涅耳衍射区时可采用离焦或偏置望远镜补偿回波二次项离焦像差并产生用于孔径合成的二次项相位历程;目标处于夫琅和费衍射区时可以采用离焦或偏置望远镜补偿回波二次项离焦像差但不产生相位历程;目标处于瑞利-索末菲衍射区域时不可能补偿回波高阶像差。

合成孔径激光成像雷达(Ⅱ):空间相位偏置发射望远镜

报道一种可以进行空间相位偏置的光学望远镜,用作合成孔径激光成像雷达中的光学发射天线。在望远镜内放置相位调制平板,控制望远镜的离焦量和位相调制平板的相位函数,能够在激光望远镜的照明区产生可控制的附加空间相位二次项,灵活改变激光照明波前,以在目标回波接收信号中产生雷达运动方向上的所需的二次项相位历程,因此能够实现特定的方位向成像分辨率。

A metal-mirror-based reflecting polarizing beam splitter

We theoretically investigated the design of a metal-mirror-based reflecting polarizing beam splitter (RPBS). The metal mirror is a silver slab, which is embedded in the substrate of a rectangular silica transmission grating. By using a modal analysis and rigorous coupled-wave analysis, an RPBS grating is designed for operation at 1550 nm. When it is illuminated in Littrow mounting, the transverse electric (TE) and transverse magnetic (TM) waves will be mainly reflected in the minus-first and zeroth orders, respectively. Moreover, a wideband RPBS grating is obtained by adopting the simulated annealing algorithm. The RPBS gratings exhibit high diffraction efficiencies (similar to 95%) and high extinction ratios over a certain angle and wavelength range, especially for the minus-first-order reflection. This kind of RPBS should be useful in practical optical applications.

Molecular Antennas and Photoactive Nanomaterials based on Energy Transfer Processes

110 p.

High-density holographic recording parameters under different wavelength of a two dyes-sensitized photopolymer

The high-density holographic recording parameters of a novel two dyes-sensitized photopolymer under different exposure wavelengths are studied. The results show that the maximum diffraction efficiency, exposure sensitivity, maximum refraction index modulation, dynamic range, and the exposure time constant increases with the increase of the exposure wavelength. The analysis indicates that the scattering has an important role in the forming of the holographic grating. (c) 2005 Elsevier GmbH. All rights reserved.

Diseño de antenas array para comunicación entre vehículos.

[ES]El objetivo final del trabajo fin de grado, que se expone en este documento, trata sobre el diseño de un array de antena de microstrip, con la intención de que se utilice para aplicaciones de comunicación entre vehículos que trabajen en la banda de los 5 GHz, bajo el estándar ITS-G5/IEEE 802.11p, además de su fabricación y medición posterior para poder compararlos con las simulaciones. Se buscará que la ganancia de la antena sea la máxima posible pero tratando de conseguir a su vez el mayor ancho de banda dentro del rango de frecuencias requerido. Para el diseño se partirá de un único parche y se le irán añadiendo los demás componentes progresivamente (reflectores, desfasadores, mayor número de parches, transformadores λ/4, etc.) y se irán estudiando sus simulaciones. Todas estas simulaciones se realizarán con el programa HFSS.

Superbroadband 1310 nm emission from bismuth and tantalum codoped germanium oxide glasses

Near-infrared broadband emission from bismuth-tantalum-codoped germanium oxide glasses was observed at room temperature when the glasses were pumped by an 808 nm laser diode. The emission band covered the 0, E, S, C, and L bands (1260-1625 nm), with a maximum peak at similar to 1310 nm, a FWHM broader than 400 nm, and a lifetime longer than 200 lis. The observed broadband luminescence was attributed to bismuth clusters in the glasses. Bismuth-tantalum-codoped germanium oxide glass might be promising as amplification media for broadly tunable lasers and wideband amplifiers in optical communications. (c) 2005 Optical Society of America.

O modo fantástico em Mário de Sá-Carneiro

O presente trabalho discute como os conceitos do Fantástico se desenvolvem na obra em prosa do escritor modernista português Mário de Sá-Carneiro, comparando duas perspectivas teóricas distintivas sobre o tema. Uma dessas possibilidades implica perceber o Fantástico como um gênero literário numa perspectiva histórica , admitindo-o de forma mais restrita e restritiva; outra, como um modo discursivo numa perspectiva a-histórica , de caráter mais abrangente e acolhedor. A partir desses diferentes pressupostos, objetiva-se, estudando um conjunto de quatro narrativas curtas do autor (Loucura e Incesto, do livro Princípio, e A grande sombra e A estranha morte do Professor Antena, de Céu de fogo), averiguar a forma como Sá-Carneiro, valendo-se do recurso às estratégias de construção narrativa do Fantástico, além de poeta, torna-se um ícone da prosa portuguesa na viragem do século XIX para o XX, estabelecendo um referencial para a Literatura Fantástica em Portugal. Para realizar este estudo, foram utilizados conceitos teóricos de Tzvetan Todorov, Filipe Furtado, Irène Bessière e, tangencialmente, de outros variados estudiosos do Fantástico da contemporaneidade

Aplicação da metodologia de GPR (Radar de Penetração no Solo) com tratamento no programa Reflexw dos cordões cenozóicos da planície costeira de Itaguaí, Rio de Janeiro

Esta pesquisa investigou a formação de depósitos arenosos localizados na planície costeira da Baixada de Sepetiba, em Itaguaí, estado do Rio de Janeiro. A deposição sedimentar e a evolução desta área, na Baixada de Sepetiba tem sido estudada nas três últimas décadas, principalmente, porque é um ambiente de depósitos arenosos antigo de idade Holocênica a Pleistocênica que corresponde a uma linha de praia, originada com eventos transgressivos e/ou regressivos que tiveram seu ápice durante o Quaternário. A metodologia de Radar de Penetração no Solo (GPR) é usada, principalmente nos casos de trabalho em que se estuda um ambiente costeiro arenoso. Este campo da Geofísica tem sido usado para examinar características, tais como: a espessura de depósitos arenosos, a profundidade de um aqüífero, a detecção de uma rocha ou um aqüífero, e determina a direção de progradação. Esta pesquisa usa técnicas de radar de penetração no solo (GPR) para analisar as estruturas, em subsuperfície desde que o ambiente estudado seja definido como linha de costa, as margens de uma lagoa mixohalina, chamada Baía de Sepetiba. Neste trabalho realizamos um total de 11 perfis, que foram processados pelo software ReflexWin. Durante o processamento do dado aplicamos alguns filtros, tais como: subtract-mean (dewow), bandpassfrequency e ganhos. E as melhores imagens dos perfis foram realizadas usando-se uma antena de 200 MHz (canal 1) e outra antena de 80 MHz. Neste caso, obtivemos imagens de alta resolução a uma profundidade de até 25 metros.

Photosynthetic responses of trees in high-elevation forests: comparing evergreen species along an elevation gradient in the Central Andes

Plant growth at extremely high elevations is constrained by high daily thermal amplitude, strong solar radiation and water scarcity. These conditions are particularly harsh in the tropics, where the highest elevation treelines occur. In this environment, the maintenance of a positive carbon balance involves protecting the photosynthetic apparatus and taking advantage of any climatically favourable periods. To characterize photoprotective mechanisms at such high elevations, and particularly to address the question of whether these mechanisms are the same as those previously described in woody plants along extratropical treelines, we have studied photosynthetic responses in Polylepis tarapacana Philippi in the central Andes (18 degrees S) along an elevational gradient from 4300 to 4900 m. For comparative purposes, this gradient has been complemented with a lower elevation site (3700 m) where another Polylepis species (P. rugulosa Bitter) occurs. During the daily cycle, two periods of photosynthetic activity were observed: one during the morning when, despite low temperatures, assimilation was high; and the second starting at noon when the stomata closed because of a rise in the vapour pressure deficit and thermal dissipation is prevalent over photosynthesis. From dawn to noon there was a decrease in the content of antenna pigments (chlorophyll b and neoxanthin), together with an increase in the content of xanthophyll cycle carotenoids. These results could be caused by a reduction in the antenna size along with an increase in photoprotection. Additionally, photoprotection was enhanced by a partial overnight retention of de-epoxized xanthophylls. The unique combination of all of these mechanisms made possible the efficient use of the favourable conditions during the morning while still providing enough protection for the rest of the day. This strategy differs completely from that of extratropical mountain trees, which uncouple light-harvesting and energy-use during long periods of unfavourable, winter conditions.