Experimental results on gravity driven fully condensing flows in vertical tubes, their agreement with theory, and their differences with shear driven flows' boundary-condition sensitivities

This doctoral thesis presents the experimental results along with a suitable synthesis with computational/theoretical results towards development of a reliable heat transfer correlation for a specific annular condensation flow regime inside a vertical tube. For fully condensing flows of pure vapor (FC-72) inside a vertical cylindrical tube of 6.6 mm diameter and 0.7 m length, the experimental measurements are shown to yield values of average heat transfer co-efficient, and approximate length of full condensation. The experimental conditions cover: mass flux G over a range of 2.9 kg/m2-s ≤ G ≤ 87.7 kg/m2-s, temperature difference ∆T (saturation temperature at the inlet pressure minus the mean condensing surface temperature) of 5 ºC to 45 ºC, and cases for which the length of full condensation xFC is in the range of 0 < xFC < 0.7 m. The range of flow conditions over which there is good agreement (within 15%) with the theory and its modeling assumptions has been identified. Additionally, the ranges of flow conditions for which there are significant discrepancies (between 15 -30% and greater than 30%) with theory have also been identified. The paper also refers to a brief set of key experimental results with regard to sensitivity of the flow to time-varying or quasi-steady (i.e. steady in the mean) impositions of pressure at both the inlet and the outlet. The experimental results support the updated theoretical/computational results that gravity dominated condensing flows do not allow such elliptic impositions.

Analyzing the effects of vertical acceleration and deceleration in multi-phase, debris-flow sediment-column experiments / by Christine Marie Williams.

Water-saturated debris flows are among some of the most destructive mass movements. Their complex nature presents a challenge for quantitative description and modeling. In order to improve understanding of the dynamics of these flows, it is important to seek a simplified dynamic system underlying their behavior. Models currently in use to describe the motion of debris flows employ depth-averaged equations of motion, typically assuming negligible effects from vertical acceleration. However, in many cases debris flows experience significant vertical acceleration as they move across irregular surfaces, and it has been proposed that friction associated with vertical forces and liquefaction merit inclusion in any comprehensive mechanical model. The intent of this work is to determine the effect of vertical acceleration through a series of laboratory experiments designed to simulate debris flows, testing a recent model for debris flows experimentally. In the experiments, a mass of water-saturated sediment is released suddenly from a holding container, and parameters including rate of collapse, pore-fluid pressure, and bed load are monitored. Experiments are simplified to axial geometry so that variables act solely in the vertical dimension. Steady state equations to infer motion of the moving sediment mass are not sufficient to model accurately the independent solid and fluid constituents in these experiments. The model developed in this work more accurately predicts the bed-normal stress of a saturated sediment mass in motion and illustrates the importance of acceleration and deceleration.

Multi-software modeling technique for field distribution propagation through an optical vertical interconnect assembly

Embedded siloxane polymer waveguides have shown promising results for use in optical backplanes. They exhibit high temperature stability, low optical absorption, and require common processing techniques. A challenging aspect of this technology is out-of-plane coupling of the waveguides. A multi-software approach to modeling an optical vertical interconnect (via) is proposed. This approach utilizes the beam propagation method to generate varied modal field distribution structures which are then propagated through a via model using the angular spectrum propagation technique. Simulation results show average losses between 2.5 and 4.5 dB for different initial input conditions. Certain configurations show losses of less than 3 dB and it is shown that in an input/output pair of vias, average losses per via may be lower than the targeted 3 dB.

Estimation of vertical groundwater fluxes into a streambed through continuous temperature profile monitoring and the relationship of groundwater fluxes to coaster brook trout spawning habitat

We hypothesized that the spatial distribution of groundwater inflows through river bottom sediments is a critical factor associated with the selection of coaster brook trout (a life history variant of Salvelinus fontinalis,) spawning sites. An 80-m reach of the Salmon Trout River, in the Huron Mountains of the upper peninsula of Michigan, was selected to test the hypothesis based on long-term documentation of coaster brook trout spawning at this site. Throughout this site, the river is relatively similar along its length with regard to stream channel and substrate features. A monitoring well system consisting of an array of 27 wells was installed to measure subsurface temperatures underneath the riverbed over a 13-month period. The monitoring well locations were separated into areas where spawning has and has not been observed. Over 200,000 total temperature measurements were collected from 5 depths within each of the 27 monitoring wells. Temperatures within the substrate at the spawning area were generally cooler and less variable than river temperatures. Substrate temperatures in the non-spawning area were generally warmer, more variable, and closely tracked temporal variations in river temperatures. Temperature data were inverted to obtain subsurface groundwater velocities using a numerical approximation of the heat transfer equation. Approximately 45,000 estimates of groundwater velocities were obtained. Estimated velocities in the spawning and non-spawning areas confirmed that groundwater velocities in the spawning area were primarily in the upward direction, and were generally greater in magnitude than velocities in the non-spawning area. In the non-spawning area there was a greater occurrence of velocities in the downward direction, and velocity estimates were generally lesser in magnitude than in the spawning area. Both the temperature and velocity results confirm the hypothesis that spawning sites correspond to areas of significant groundwater influx to the river bed.

Vaccination with recombinant NcROP2 combined with recombinant NcMIC1 and NcMIC3 reduces cerebral infection and vertical transmission in mice experimentally infected with Neospora caninum tachyzoites

We investigated the protective potential of recombinant his-tagged antigens recNcMIC1, recNcMIC3 and recNcROP2, applied either as single vaccines or as vaccine combinations, in BALB/c mouse models for cerebral and fetal infection. Subsequently, mice were mated and challenged by i.p. inoculation of 2 x 10(6)Neospora caninum tachyzoites at day 7 of pregnancy. The mortality and morbidity of adult mice (non-pregnant and dams) and of the newborn pups was studied for a period of 40 days following birth. Vaccination of non-pregnant mice with recNcROP2 or combinations of recNcROP2 with recNcMIC antigens significantly reduced the numbers of mice suffering from clinical signs, and morbidity was completely prevented with the combination of all three antigens. Of the dams, the groups receiving either recNcROP2 alone or the combination of all three antigens did not exhibit any morbidity, the groups receiving ROP2 mixed with either MIC1 or MIC3 exhibited reduced numbers of deaths, and in the infection control group and the adjuvant group 50% and 43% of mice, respectively, succumbed to disease. For pups, the highest survival rates were noted for the groups receiving recNcROP2 (50%) and recNcROP2/NcMIC1/NcMIC3 (35%), while in the infection- and adjuvant- control groups all pups died, the latest at days 25 and 30, respectively. Quantification of parasite DNA by N. caninum-specific real-time PCR revealed consistently lower parasite burdens in brain tissue of pups from vaccinated groups compared with the controls. However, dense granule antigen 2 (GRA2) real-time reverse transcriptase-PCR on brain tissue of surviving pups (applied here to detect viable parasites) demonstrated that only the pups from the group vaccinated with all three antigens in combination appeared free of viable tachyzoites, while in all other groups viable parasites were still present. Serological analysis of humoral (total IgG, IgG1 and IgG2a) and serum cytokine (IL-4 and IFN-gamma) responses showed that this effect was associated with a Th-2-biased immune response, with a clearly elevated IL-4/IFN-gamma ratio in the mice receiving all three antigens in combination. In conclusion, a mixture of recombinant antigens representing important secretory micronemal and rhoptry proteins leads to a significant protection against vertical transmission of N. caninum in mice.

Distributed Control Nodes for Material Flow System Controls on the Example of Unit Load Conveyor and Sorter Facilities

The Chair of Transportation and Ware-housing at the University of Dortmund together with its industrial partner has developed and implemented a decentralized control system based on embedded technology and Internet standards. This innovative, highly flexible system uses autonomous software modules to control the flow of unit loads in real-time. The system is integrated into Chair’s test facility consisting of a wide range of conveying and sorting equipment. It is built for proof of concept purposes and will be used for further research in the fields of decentralized automation and embedded controls. This presentation describes the implementation of this decentralized control system.

Simulative study of the decentralized control of complex conveyor networks

Decentralised controls offer advantages for the implementation as well as the operation of controls of steady conveyors. Such concepts are mainly based on RFID. Due to the reduced expense for appliances and software, however, the plant behaviour cannot be determined as accurately as in centrally controlled systems. This article describes a simulation-based method by which the performances of these two control concepts can easily be evaluated in order to determine the suitability of the decentralised concept.

Cloud Computing in the EU Policy Sphere Interoperability, Vertical Integration and the Internal Market

Cloud computing is a new development that is based on the premise that data and applications are stored centrally and can be accessed through the Internet. Thisarticle sets up a broad analysis of how the emergence of clouds relates to European competition law, network regulation and electronic commerce regulation, which we relate to challenges for the further development of cloud services in Europe: interoperability and data portability between clouds; issues relating to vertical integration between clouds and Internet Service Providers; and potential problems for clouds to operate on the European Internal Market. We find that these issues are not adequately addressed across the legal frameworks that we analyse, and argue for further research into how to better facilitate innovative convergent services such as cloud computing through European policy – especially in light of the ambitious digital agenda that the European Commission has set out.

Aufbau hochfunktionaler Intralogistik-Knoten mittels kleinskaliger Module als Cognitive Conveyor

Kleinskalige, multifunktionale Module haben ein hohes Potential bei der wirtschaftlichen und flexiblen Gestaltung intralogistischer Systeme mit hoher Funktionalität. Durch dezentrale Steuerung und eigener Intelligenz der Module ist das System frei skalierbar und der Installationsaufwand wird minimiert. Mittels eines neuartigen Konzeptes der Datenkommunikation für Stetigförderer erfolgt der Informationsaustausch drahtlos mit Hilfe optoelektrischer Elemente. Die Kleinskaligkeit der Transportmodule gegenüber der Transporteinheit im Zusammenhang mit dem Steuerungskonzept erlaubt eine selektive Beschaltung der Module nach Bedarf und damit eine optimierte Energieausnutzung im Betrieb. Prototypen auf Basis von Schwenkrollen mit integrierter Antriebstechnik und Steuerung lassen das Potential des Prinzips erkennen. Das neu entwickelte Konzept der Schrägscheibe hilft bei der anspruchsvollen Integration der Antriebstechnik in das Modul durch das Prinzip der koaxialen Aktoren. Durch omnidirektionalen Funktionsumfang der Module entsteht im Zusammenschluss zu einer Modulmatrix ein hochflexibel einsetzbares Intralogistik-Modul. Die Vernetzung dieser hochfunktionalen Knoten durch einfache Fördertechnik bietet die Möglichkeit einfacher Planung flexibler Logistiksysteme.

Novel calculation method for chain conveyor systems

Sidexflexing plastic chains are used increasingly in material handling due to their highly flexible conveying design and layout options. These systems are often equipped with so called modular belts. Due to their specific force transmission, detailed calculation methods are not yet available. In the following, a generally valid calculation approach is derived and its difference to existing solutions shown by examples.

Vertical integration and information sharing — an empirical investigation in the German apparel industry

Despite the astounding success of the fast fashion retailers, the management practices leading to these results have not been subject to extensive research so far. Given this background, we analyze the impact of information sharing and vertical integration on the performance of 51 German apparel companies. We find that the positive impact of vertical integration is mediated by information sharing, i.e. that the ability to improve the information flow is a key success factor of vertically integrated apparel supply chains. Thus, the success of an expansion strategy based on vertical integration critically depends on effective ways to share logistical information.

Upper ocean vertical supply: A neglected primary factor controlling the distribution of neodymium concentrations of open ocean surface waters?

Neodymium (Nd) isotopes are an important geochemical tool to trace the present and past water mass mixing as well as continental inputs. The distribution of Nd concentrations in open ocean surface waters (0�100 m) is generally assumed to be controlled by lateral mixing of Nd from coastal surface currents and by removal through reversible particle scavenging. However, using 228Ra activity as an indicator of coastal water mass influence, surface water Nd concentration data available on key oceanic transects as a whole do not support the above scenario. From a global compilation of available data, we find that more stratified regions are generally associated with low surface Nd concentrations. This implies that upper ocean vertical supply may be an as yet neglected primary factor in determining the basin-scale variations of surface water Nd concentrations. Similar to the mechanism of nutrients supply, it is likely that stratification inhibits vertical supply of Nd from the subsurface thermocline waters and thus the magnitude of Nd flux to the surface layer. Consistently, the estimated required input flux of Nd to the surface layer to maintain the observed concentrations could be nearly two orders of magnitudes larger than riverine/dust flux, and also larger than the model-based estimation on shelf-derived coastal flux. In addition, preliminary results from modeling experiments reveal that the input from shallow boundary sources, riverine input, and release from dust are actually not the primary factors controlling Nd concentrations most notably in the Pacific and Southern Ocean surface waters.