Novel approaches for culturing hepatocytes for drug testing applications

Dissertation presented to obtain the Ph.D degree in Biochemisry, Biotechnology

Comparação dos métodos ENF e 4-ENF para determinação da tenacidade ao corte de juntas adesivas

Ao longo destes últimos anos as ligações adesivas têm vindo a verificar um aumento progressivo em aplicações estruturais em detrimento das ligações mecânicas convencionais. Esta alteração de paradigma deve-se às vantagens que as juntas adesivas possuem relativamente aos outros métodos de ligação. A mecânica da fratura e os Modelos de Dano Coesivo (MDC) são critérios comuns para prever a resistência em juntas adesivas e usam como parâmetros fundamentais as taxas de libertação de energia. Pelo facto do ensaio 4-Point End Notched Flexure (4-ENF), aplicado em juntas adesivas, ainda estar pouco estudado é de grande relevância um estudo acerca da sua viabilidade para a determinação da taxa crítica de libertação de energia de deformação ao corte (GIIc). Esta dissertação tem como objetivo principal efetuar uma comparação entre os métodos End- Notched Flexure (ENF) e 4-ENF na determinação de GIIc em juntas adesivas. Para tal foram utilizados 3 adesivos: Araldite® AV138, Araldite® 2015 e SikaForce® 7752. O trabalho experimental passou pela conceção e fabrico de uma ferramenta para realização do ensaio 4-ENF, seguindo-se o fabrico e a preparação dos provetes para os ensaios. Pelo facto do ensaio 4-ENF ainda se encontrar pouco divulgado em juntas adesivas, e não se encontrar normalizado, uma parte importante do trabalho passou pela pesquisa e análise em trabalhos de investigação e artigos científicos. A análise dos resultados foi realizada por comparação direta dos valores de GIIc com os resultados obtidos no ensaio ENF, sendo realizada por série de adesivo, através da comparação das curvas P-δ e curvas-R. Como resultado verificou-se que o ensaio 4-ENF em ligações adesivas não é o mais versátil para a determinação do valor de GIIc, e que apenas um método de obtenção de GIIc é viável. Este método é baseado na medição do comprimento de fenda (a). Ficou evidenciado que o ensaio ENF, devido a ser um ensaio normalizado, por apresentar um setup mais simples e por apresentar uma maior disponibilidade de métodos para a determinação do valor de GIIc, é o mais recomendado. Conclui-se assim que o ensaio 4-ENF, embora sendo uma alternativa ao ensaio ENF, tem aplicação mais limitada.

Impact of Syncope on Quality of Life: Validation of a Measure in Patients Undergoing Tilt Testing

INTRODUCTION AND OBJECTIVES: Recurrent syncope has a significant impact on quality of life. The development of measurement scales to assess this impact that are easy to use in clinical settings is crucial. The objective of the present study is a preliminary validation of the Impact of Syncope on Quality of Life questionnaire for the Portuguese population. METHODS: The instrument underwent a process of translation, validation, analysis of cultural appropriateness and cognitive debriefing. A population of 39 patients with a history of recurrent syncope (>1 year) who underwent tilt testing, aged 52.1 ± 16.4 years (21-83), 43.5% male, most in active employment (n=18) or retired (n=13), constituted a convenience sample. The resulting Portuguese version is similar to the original, with 12 items in a single aggregate score, and underwent statistical validation, with assessment of reliability, validity and stability over time. RESULTS: With regard to reliability, the internal consistency of the scale is 0.9. Assessment of convergent and discriminant validity showed statistically significant results (p<0.01). Regarding stability over time, a test-retest of this instrument at six months after tilt testing with 22 patients of the sample who had not undergone any clinical intervention found no statistically significant changes in quality of life. CONCLUSIONS: The results indicate that this instrument is of value for assessing quality of life in patients with recurrent syncope in Portugal.

Preparation of gas-filled porous microparticles (GPPs) and microbubbles (MBs) by PGSS method

Dissertation to obtain the Master Degree in Biotechnology

The sum-of-the-parts method: An international application

A Work Project, presented as part of the requirements for the Award of a Masters Degree in Finance from the NOVA – School of Business and Economics

A Homemade Snare: An Alternative Method for Mechanical Removal of Dirofilaria Immitis in Dogs

Canine dirofilariosis is a life-threatening parasitic disease that is increasingly reported worldwide. Once diagnosed the main treatment goals are to improve the animal's clinical condition and to eliminate all life stages of the parasite with minimal posttreatment side effects. This can be achieved through mechanical, surgical, or chemotherapeutical approaches. Currently, manual extraction is the preferred method to remove adult heartworms due to its diminished invasiveness, reduced damage to the vascular endothelium, and shortened anaesthesia duration. However, it remains an expensive technique that can be highly traumatic. To address this issue, a nontraumatic homemade catheter-guided snare was developed for heartworm removal by adapting and folding a 0.014-inch coronary wire (BMW, Abbott Vascular). Transvenous heartworm extraction was performed on a dog severely infected with adult heartworms by inserting the modified snare into a 6-F Judkins right coronary guiding catheter BMW (Cordis) and advancing it into the right ventricle under fluoroscopic guidance. Fifteen adult specimens of Dirofilaria immitis were successfully extracted from the pulmonary artery and right ventricle without complications. To assure the death of both larvae and adults, postoperative treatment was successfully managed using ivermectin, doxycycline, and melarsomine, with no recurrence after surgery.

What is the best accounting method for financial assets?

A Work Project, presented as part of the requirements for the Award of a Masters Degree in Finance from the NOVA – School of Business and Economics

The use of different concentrations of leishmanial antigen in skin testing to evaluate delayed hypersensitivity in american cutaneous leishmaniasis

Three concentrations of Leishmania mexicana amazonensis sonicated whole promastigote antigen (30, 9.6 and 3 ug N in 0.1 ml) wereprepared and 0.1 ml of each inoculated intradermally intopatients who live in one endemic leishmaniasis region in Brazil. Patients were divided into groups with active cutaneous leishmaniasis (ACL), healed cutaneous leishmaniasis (HCL), mucosal leishmaniasis (ML), and Controls (C). Skin reactions were recorded by measuring induration 48 hours after inoculation. Skin tests using 9.6 ugN/0.1 mlyielded the best diagnostic resultssince 97% of 30 patients with active lesions (cutaneous or mucosal) and 83% with HCL showed reactions of 5 mm orgreater as compared with 4% Controls. Tests using 30ug N/O. 1 ml causedan unacceptable levei of skin reactions with necrosis (10% of ACL patients tested and 17% of HCL, respectively). Tests using 3 ug N/O. 1 ml were less sensitive since only 87% of patients with active lesions and 68% with HCL had reactions of 5mm orgreater. The 3 ug N/O. 1 ml dose was utilized to ask the questions whether skin delayed hypersensitivity decreased with time after the initial lesion and whether mucosal involvement is associated with enhaced hypersensitivity to leishmanial antigen. Decreased delayed hypersensitivity was noted only in those patients who had an initial lesion more than 30 years ago. The mean induration of the reaction in 10 patients with ML was 11.3 mm ± 7.15, in 41 patients with HCL, 9.27 mm ± 6.78 and in 20patients with ACL 10. 7 mm ± 6.10 mm. The percent of patients with 5 mm orgreater induration was ML 80%, HCL 71%, ACL 90%. Thus, we could not confirm an association between enhanced delayed hypersensitivity and mucosal involvement in leishmaniasis.

Credit risk stress testing: The Portuguese environment, macroeconomic scenarios and the estimation of losses for corporate sectors

A Work Project, presented as part of the requirements for the Award of a Masters Degree in Finance from the NOVA – School of Business and Economics

Testing for volatility persistence change: The effect of the credit crisis on the Portuguese banks

A Work Project, presented as part of the requirements for the Award of a Masters Degree in Finance from the NOVA – School of Business and Economics

Speed control of induction machine based on direct torque control method

Dissertação para obtenção do Grau de Mestre em Engenharia Electrotécnica e de Computadores

HIV-related discrimination in Sub-Sahran Africa: Explanatory characteristics and consequences on employment and HIV-testing

A Work Project, presented as part of the requirements for the Award of a Masters Degree in Economics from the NOVA – School of Business and Economics

A technology diffusion perspective of Enterprise Resource Planning across European Small and Medium Enterprises: from determinants to Use to Value

Tese apresentada como requisito parcial para obtenção do grau de Doutor em Gestão de Informação

Calibration, selection and mosaicing of SMART-1 AMIE images

Dissertação para obtenção do Grau de Mestre em Engenharia Electrotécnica e de Computadores