Geochemistry and stable isotope record of the hydtrothermally altered lower sheeted dike complex in ODP Hole 140-504B

Drilling during Legs 137 and 140 of the Ocean Drilling Program deepened Hole 504B, the only hole to penetrate through the volcanic section and into the underlying hydrothermally altered sheeted dike complex, by 438.1 m to a total depth of 2000.4 meters below seafloor. This paper presents the secondary mineralogy, bulk-rock sulfur contents, and stable isotopic (O, S) compositions, plus oxygen isotopic compositions of secondary minerals from the lower sheeted dike complex drilled during Legs 137 and 140. Various evidence indicates higher temperatures of hydrothermal alteration in the lower dikes than in the upper dikes, including: the local presence of secondary clinopyroxene in the lower dikes; secondary anorthite and hornblende in the lower dikes vs. mainly actinolite and albite-oligoclase in the upper dikes; generally increasing Al and Ti contents of amphibole downward in the dike section; and greater 18O depletions of the lower dikes (d18O = 3.6-5.0 per mil) compared with the upper dikes. Early high-temperature alteration stages (T = 350°-500°C) resulted in 18O depletions and losses of metals (Cu, Zn) and sulfur from the rocks. Local incorporation of reduced seawater sulfate led to elevated d34S values of sulfide in the rocks (up to 2.5 per mil). Quartz + epidote formed in crosscutting veins at temperatures of 310°-320°C from more evolved fluids (d18O = 1 per mil). Late-stage lower-temperature (~250°C) reactions producing albite, prehnite, and zeolites in the rocks caused slight 18O enrichments, but these were insufficient to offset the 18O depletions caused by earlier higher-temperature reactions. Addition of anhydrite to the rocks during seawater recharge led to increased S contents of rocks that had previously lost S during axial hydrothermal alteration, and to further increases in d34S values of total S in the rocks (up to 12 per mil). Despite the evidence for seawater recharge to near the base of the sheeted dike complex, the paucity of late zeolites in the lower dikes suggests that late-stage, off-axis circulation was mainly restricted to the volcanics and shallowest dikes, or to localized high-permeability zones (faults) at depth.

Chronostratigraphy of eastern Mediterranen Sea sediment cores

An Accelerator Mass Spectrometry (AMS) 14C dated multiparameter event stratigraphy is developed for the Aegean Sea on the basis of highly resolved (centimeter to subcentimeter) multiproxy data collected from four late glacial to Holocene sediment cores. We quantify the degree of proportionality and synchroneity of sediment accumulation in these cores and use this framework to optimize the confidence levels in regional marine, radiocarbon-based chronostratigraphies. The applicability of the framework to published, lower-resolution records from the Aegean Sea is assessed. Next this is extended into the wider eastern Mediterranean, using new and previously published high-resolution data from the northern Levantine and Adriatic cores. We determine that the magnitude of uncertainties in the intercore comparison of AMS 14C datings based on planktonic foraminifera in the eastern Mediterranean is of the order of ±240 years (2 SE). These uncertainties are attributed to synsedimentary and postsedimentary processes that affect the materials dated. This study also offers a background age control that allows for vital refinements to radiocarbon-based chronostratigraphy in the eastern Mediterranean, with the potential for similar frameworks to be developed for any other well-studied region.

(Table 1) Paleomagnetic of reoriented core pieces of IODP Hole 304-U1309D

Oceanic core complexes expose lower crustal and upper mantle rocks on the seafloor by tectonic unroofing in the footwalls of large-slip detachment faults. The common occurrence of these structures in slow and ultra-slow spread oceanic crust suggests that they accommodate a significant component of plate divergence. However, the subsurface geometry of detachment faults in oceanic core complexes remains unclear. Competing models involve either: (a) displacement on planar, low-angle faults with little tectonic rotation; or (b) progressive shallowing by rotation of initially steeply dipping faults as a result of flexural unloading (the "rolling-hinge" model). We address this debate using palaeomagnetic remanences as markers for tectonic rotation within a unique 1.4 km long footwall section of gabbroic rocks recovered by Integrated Ocean Drilling Program (IODP) sampling at Atlantis Massif oceanic core complex on the Mid-Atlantic Ridge (MAR). These rocks contain a complex record of multipolarity magnetizations that are unrelated to alteration and igneous stratigraphy in the sampled section and are inferred to result from progressive cooling of the footwall section over geomagnetic polarity chrons C1r.2r, C1r.1n (Jaramillo) and C1r.1r. For the first time we have independently reoriented drill-core samples of lower crustal gabbros, that were initially azimuthally unconstrained, to a true geographic reference frame by correlating structures in individual core pieces with those identified from oriented imagery of the borehole wall. This allows reorientation of the palaeomagnetic data, placing far more rigorous constraints on the tectonic history than those possible using only palaeomagnetic inclination data. Analysis of the reoriented high temperature reversed component of magnetization indicates a 46° ± 6° anticlockwise rotation of the footwall around a MAR-parallel horizontal axis trending 011° ± 6°. Reoriented lower temperature components of normal and reversed polarity suggest that much of this rotation occurred after the end of the Jaramillo chron (0.99 Ma). The data provide unequivocal confirmation of the key prediction of flexural, rolling-hinge models for oceanic core complexes, whereby oceanic detachment faults initiate at higher dips and rotate to their present day low-angle geometries as displacement increases.

Heat flow in the Black and Mediterranean seas

Results of heat-flow measurements in the western Black Sea and within the African-Sicilian region of the Mediterranean Sea are presented. New data reveal a well-defined correlation with the deep-seated geologic structure of the regions examined. A heat-flow anomaly within the Pantelleria graben, in the authors' opinion, is a consequence of connective heat transfer along channels of disjunctive faults.

(Table 3) Chemical composition of basalts from Kolbeinsey Ridge and adjacent areas

Petrochemical variations in composition of basalts along the axial part of the Kolbeinsey mid-ocean ridge were studied. It was found that principal mass of these basalts has tholeiitic composition. Alkalinity of these basalts increases near zones of transform transverse faults; it increases likewise toward Iceland, and especially in the direction of Jan Mayen Island.

Physical models of dilatant normal faulting in jointed cohesive rocks

Dilatant faults often form in rocks containing pre-existing joints, but the effects of joints on fault segment linkage and fracture connectivity is not well understood. We present an analogue modeling study using cohesive powder with pre-formed joint sets in the upper layer, varying the angle between joints and a rigid basement fault. We analyze interpreted map-view photographs at maximum displacement for damage zone width, number of connected joints, number of secondary fractures, degree of segmentation and area fraction of massively dilatant fractures. Particle imaging velocimetry helps provide insights on deformation history of the experiments and illustrate the localization pattern of fault segments. Results show that with increasing angle between joint-set and basement-fault strike the number of secondary fractures and the number of connected joints increases, while the area fraction of massively dilatant fractures shows only a minor increase. Models without pre-existing joints show far lower area fractions of massively dilatant fractures while forming distinctly more secondary fractures.

AMS 14C and calibrated ages of sediment core GeoB10426-1

Newly acquired bathymetric and seismic reflection data have revealed mass-transport deposits (MTDs) on the northeastern Cretan margin in the active Hellenic subduction zone. These include a stack of two submarine landslides within the Malia Basin with a total volume of approximately 4.6 km**3 covering an area of about 135 km**2. These two MTDs have different geometry, internal deformations and transport structures. The older and stratigraphic lower MTD is interpreted as a debrite that fills a large part of the Malia Basin, while the second, younger MTD, with an age of at least 12.6 cal. ka B.P., indicate a thick, lens-shaped, partially translational landslide. This MTD comprises multiple slide masses with internal structure varying from highly deformed to nearly undeformed. The reconstructed source area of the older MTD is located in the westernmost Malia Basin. The source area of the younger MTD is identified in multiple headwalls at the slope-basin-transition in 450 m water depth. Numerous faults with an orientation almost parallel to the southwest-northeast-trending basin axis occur along the northern and southern boundaries of the Malia Basin and have caused a partial steepening of the slope-basin-transition. The possible triggers for slope failure and mass-wasting include (i) seismicity and (ii) movement of the uplifting island of Crete from neotectonics of the Hellenic subduction zone, and (iii) slip of clay-mineral-rich or ash-bearing layers during fluid involvement.

(Table A1) Calcium carbonate content of boreholes Kirchrode I and II

The technical details of drilling and coring at the Kirchrode I and II sites are presented. At these sites, a sequence of claystones and marlstones from an Albian shelf basin was recovered. Constraints on the ages of the sediments in the two boreholes are provided by the occurrence of the inoceramid bivalve Actinoceramus sulcatus, the first appearance of which is used to define the Middle/Upper Albian boundary and by observed facies changes that can be correlated to the established lithostratigraphy. The cores from the two boreholes provide a rather complete, 285-m-long sequence of the Upper Albian, with a 155.5-m-long overlap. Analysis of the tectonic structures showed considerable shortening in the Middle and Lower Albian part of the sequence due to normal faulting. Of the Upper Albian, only the lowermost part is affected by faults. The increase in sedimentation rates of terrigenous detritus and of marine biogenic carbonate, which occurs in the basal part of the C. auritus Subzone, is interpreted to reflect a regional change to a more humid climate and regional tectonic movements (uplift of the Rhenish Bohemian massif, subsidence of the Lower Saxony basin intensified locally by halokinetic movements). The further increase in marine productivity in the latest Albian may be related to upwelling of more nutrient-rich deep water along submarine relief in this shelf sea. Identification of Milankovitch cyclicity documented by the fluctuating CaCO3 contents of the sediments is used (i) to constrain the minimum time represented by the Upper Albian deposits, and (ii) to determine the duration of the sea level cycles (Cycle V: >=1.6 Ma, Cycle VI: >=2 Ma), and (iii) to establish the duration of the Late Albian ammonite subzones (e.g. Callihoplites auritus Subzone: 2.1 Ma). Average sedimentation rates determined from the identified 100-ka eccentricity cycles show a stepwise increase in sedimentation rates from 1-2 cm/1000 a in the Lower Albian dark claystones to 7-13 cm/1000 a in the late Late Albian. In addition to the general deepening trend through the Late Albian, two, nearly completely documented 3rd-order sea-level cycles in the Upper Albian of Kirchrode I were recognised, plus another one, cut short by faulting, at the base of the Upper Albian (documented in Kirchrode II). These global sea-level cycles were identified on the basis (a) of the sequence of the abundance maxima of selected benthos and plankton groups, (b) of trends in the fluctuations of the CaCO3 content, and (c) of the abundance of glauconite. The transgression periods in this Upper Albian deep shelf-basin are characterised by intensified circulation. This intensified circulation is found to have affected first the surface-near waters, resulting e.g. in an increase in the abundance of immigrant plankton and nekton species from the Tethys. At a later stage the deep water was affected, supporting then an increased population of suspension-feeding benthos, and causing condensation and erosion in the sediment at the sea floor.

SERI laser scanner system /

A Laser Scanner System (LSS) produces a photoresponse map and can be used for the nondestructive detection of nonuniformities in the photoresponse of a semiconductor device. At SERI the photoresponse maps are used to identify solar cell faults including microcracks, metallization breaks, regions of poor contact between metallization and the underlying emitter surface, and variations in emitter sheet resistance.

Character and recency of faulting, San Diego metropolitan area, California /

Mode of access: Internet.

State-of-the-art for assessing earthquake hazards in the United States.

Includes abstract.

Interpretation of aeromagnetic data in southwest Connecticut, and evidence for faulting along the northern fall line /

"NUREG/CR-2128."

The Penobscot lineament zone, Maine /

"NUREG/CR-2291."

Details of machine tool design.

Elementary principles of cone pulleys and belts, by W.L. Cheney -- Cone pulley radii, by J.J. Harman -- Strength of countershafts, by F.B. Kleinhans -- Tumbler gear design, by J. Edgar -- Faults of iron castings, by F.E. Cardullo -- Proportions of machines built in a series of sizes, by S.H. Moore.

The stories of Senex, or, Little histories of little people /

Cf. Moon, M. Harris (1992), 446.