Accelerated and real-time creep and creep-rupture results for aramid fibers

This article presents results from conventional creep tests (CCT) and two accelerated test methods (the stepped isothermal method (SIM) and the stepped isostress method (SSM)) to determine the creep and creep-rupture behavior of two different aramid fibers, Kevlar 49 and Technora. CCT are regarded as the true behavior of the yarn, but they are impractical for long-term use where failures are expected only after many years. All the tests were carried out on the same batches of yarns, and using the same clamping arrangements, so the tests should be directly comparable. For both materials, SIM testing gives good agreement with CCT and gave stress-rupture lifetimes that followed the same trend. However, there was significant variation for SSM testing, especially when testing Technora fibers. The results indicate that Kevlar has a creep strain capacity that is almost independent of stress, whereas Technora shows a creep strain capacity that depends on stress. Its creep strain capacity is approximately two to three times that of Kevlar 49. The accelerated test methods give indirect estimates for the activation energy and the activation volume of the fibers. The activation energy for Technora is about 20% higher than that for Kevlar, meaning that it is less sensitive to the effects of increasing temperature. The activation volume for both materials was similar, and in both cases, stress dependent. Copyright © 2012 Wiley Periodicals, Inc.

Creep and strength retention of aramid fibers

Creep tests at ambient conditions have been carried out on Kevlar 49 and Technora yarns covering a wide stress spectrum (10-70% average breaking load) for a long period of time (up to a year). The results confirm that Kevlar 49 and Technora yarns show a nonlinear behavior at stresses below 40% of the breaking load and a linear behavior at stresses above 40%. The strength retention following creep for Kevlar 49 and Technora has also been examined. The results show a significant difference in the behavior of the two materials. Kevlar 49 appears to lose strength almost linearly with time, while Technora seems to lose strength much more rapidly. These results would have significant implications for design. © 2012 Wiley Periodicals, Inc. J Appl Polym Sci, 2012 Copyright © 2012 Wiley Periodicals, Inc.

基于人工湿地的循环水产养殖系统工艺设计及净化效能

该研究首次将复合垂直流人工湿地同池塘养殖结合,通过构建养殖-湿地生态系统,验证人工湿地对水产养殖用水和废水净化与回用的可行性。近9个月的新建人工湿地运行结果表明,水力负荷从313、469、625 mm/d增加到781mm/d,人工湿地对TSS、CODC r和BOD5去除率的变动范围分别为80.5%~82.9%、45.2%~64.2%和61.0%~77.0%,对NH4+-N、NO3--N、TN去除率的变动范围分别为51.5%~67.8%-、90.6%~40.0%和29.1%~68.6%,对TP和IP的去除率

人工湿地-氧化塘工艺组合对氮和磷去除效果研究

本文在小试规模上,研究了下行流湿地、推流床湿地、氧化塘和兼性塘四种处理单元的四种工艺组合对氮、磷的去除效果,研究结果表明:下行流湿地+氧化塘工艺组合具有较好的充氧效果,推流床湿地后置也可以提高出水的溶解氧。四种工艺组合对离子和TP、IP的去除无显著差异。人工湿地中硝化作用的发生有利于NH+4 N的去除,增加氧化塘可以提高系统的硝化能力,但同时也会增加出水中的NO-3 N浓度。

复合垂直流构建湿地基质酶活性与污水净化效果

构建湿地是 2 0世纪 70年代兴起的处理污水的生态工程 ,由于其具有建造、运行和日常管理费用低廉 ,处理效果稳定 ,且适用面广 ,越来越受到世界各国的重视。这种污水处理技术在发展中国家有着十分广泛的应用前景。本文研究与揭示了复合垂直流构建湿地基质中的磷酸酶和脲酶活性及与污水净化效果的关系 :1不同类型湿地基质酶活性不同 ,甚至不同月份的酶活性也不相同。2不同深度基质中的酶活性是不相同的。 3基质磷酸酶的活性与复合垂直流构建湿地对污水中总磷 ( TP)、无机磷 ( IP)以及化学需氧量 ( CODCr)的

Improving intermediate pressure turbine performance by using a nonorthogonal stator

Intermediate pressure (IP) turbines in high bypass ratio civil aeroengines are characterized by a significant increase in radius and a low aspect ratio stator. Conventional aerodynamic designs for the IP turbine stator have had leading and trailing edges orthogonal to the hub and casing end walls. The IP turbine rotor, however, is stacked radially due to stress limits. These choices inevitably lead to a substantial gap between the IP stator and rotor at the outer diameter in a duct that is generally diffusing the flow due to the increasing radius. In this low Mach number study, the IP stator is redesigned, incorporating compound sweep so that the leading and trailing edges are no longer orthogonal to the end walls. Computational investigations showed that the nonorthogonal stator reduces the flow diffusion between the stator and rotor, which yields two benefits: The stator trailing edge velocity was reduced, as was the boundary layer growth on the casing end wall within the gap. Experimental measurements confirm that the turbine with the nonorthogonal stator has an increased efficiency by 0.49%, while also increasing the work output by 4.6%, at the design point. © 2014 by ASME.

Durability of similar self-compacting concrete batches produced in two different EU laboratories

The present study intends to evaluate the sensitivity of self-compacting concrete (SCC) mixtures, cast in two different laboratories of the European Union, with a focus on rheological parameters, mechanical characteristics and durability properties. Six SCC mixtures with different water-to-binder ratios and silica fume levels of cement replacement and two normally vibrated concrete (NVC) mixtures have been compared. It has been found that the reproducibility of similar mixtures is possible, when using different constituent materials that conform to the European Standards. Comparable rheological, mechanical and durability properties can be achieved. Open porosity and sorptivity appear to be more sensitive than chloride penetrability. © 2012 Elsevier Ltd. All rights reserved.

Reproducibility of self-compacting concrete batches between two different EU laboratories

Self Compacting Concrete (SCC) offers a wide variety of advantages during casting. Considering the worldwide uniformity of guidelines concerning the composition and casting instructions for the production of fresh SCC, there is a need to explore the reproducibility of similar self-compacting concrete batches between different countries. In the present study, the fresh properties of similar SCC batches produced in two different laboratories of the European Union are being compared and evaluated.

The search for the IFN-gamma receptor in fish: Functional and expression analysis of putative binding and signalling chains in rainbow trout Oncorhynchus mykiss

Interferons (IFNs), consisting of three major subfamilies, type I, type II (gamma) and type III (lambda) IFN, activate vertebrate antiviral defences once bound to their receptors. The three IFN subfamilies bind to different receptors, IFNAR1 and IFNAR2 for type I IFNs, IFN gamma R1 and IFN gamma R2 for type II IFN, and IL-28R1 and IL-10R2 for type III IFNs. In fish, although many types I and II IFN genes have been cloned, little is known about their receptors. In this report, two putative IFN-gamma receptor chains were identified and sequenced in rainbow trout (Oncorhynchus mykiss), and found to have many common characteristics with mammalian type II IFN receptor family members. The presented gene synteny analysis, phylogenetic tree analysis and ligand binding analysis all suggest that these molecules are the authentic IFN gamma Rs in fish. They are widely expressed in tissues, with IFN gamma R1 typically more highly expressed than IFN gamma R2. Using the trout RTG-2 cell line it was possible to show that the individual chains could be differentially modulated, with rIFN-gamma and rIL-1 beta down regulating IFN gamma R1 expression but up regulating IFN gamma R2 expression. Overexpression of the two receptor chains in RTG-2 cells revealed that the level of IFN gamma R2 transcript was crucial for responsiveness to rIFN-gamma, in terms of inducing gamma IP expression. Transfection experiments showed that the two putative receptors specifically bound to rIFN-gamma. These findings are discussed in the context of how the IFN gamma R may bind IFN-gamma in fish and the importance of the individual receptor chains to signal transduction. (c) 2009 Elsevier Ltd. All rights reserved.

Detection of serum and mucosal antibody production and antibody secreting cells (ASCs) in large yellow croaker (Pseudosciaena crocea) following vaccination with Vibrio harveyi via different routes

The kinetics of mucosal and serum antibody response is well as antibody secreting cells (ASCs) production were studied in large yellow croaker following vaccination with inactivated Vibrio harveyi by different routes: oral administration. intraperitoneal (IP) injection and immersion. Indirect ELISA was used to measure the antibody level in serum and cutaneous mucus, and ELISPOT was used to monitor the ASCs derived from gill, blood and head kidney. The data demonstrated that IP injection resulted in the highest antibody levels in the systemic circulation, whereas immersion induced significant antibody levels in mucous. As for the ASCs response, IP injection induced high numbers of ASCs in the head kidney and blood; oral intubation only induced a slight ASCs response in the head kidney: immersion induced a much stronger ASCs response in the gill. These results indicate that mucosal antibodies following immersion immunization are independent of a systemic response and more sensitive, since it could be triggered earlier than serum antibodies. The mucosal antibodies following IP injection immunization may depend oil a systemic immune response. The protective effects of the three vaccination methods were compared by challenging with live V. harveyi. Survival of the three groups of vaccinated fish varied front 40 to 60%. while 100% mortality was found in control fish. Compared with IP and oral vaccination, immersion stimulated higher specific antibody titers in the mucosal system and achieved similar protection, so it is in effective and efficient method for immunizing a large number of fish against V harveyi (C) 2008 Elsevier B.V. All rights reserved.

Determination of the tilt and twist angles of curved GaN layers by high-resolution x-ray diffraction

The full-width at half-maximum (FWHM) of an x-ray rocking curve (XRC) has been used as a parameter to determine the tilt and twist angles of GaN layers. Nevertheless, when the thickness of GaN epilayer reaches several microns, the peak broadening due to curvature becomes non-negligible. In this paper, using the (0 0 l), l = 2, 4, 6, XRC to minimize the effects of wafer curvature was studied systematically. Also the method to determine the tilt angle of a curved GaN layer was proposed while the Williamson-Hall plot was unsuitable. It was found that the (0 0 6) XRC-FWHM had a significant advantage for high-quality GaN layers with the radius curvature of r less than 3.5 m. Furthermore, an extrapolating method of gaining a reliable tilt angle has also been proposed, with which the calculated error can be improved by 10% for r < 2 m crystals compared with the (0 0 6) XRC-FWHM. In skew geometry, we have demonstrated that the twist angles deriving from the (2 0 4) XRC-FWHM are in accord with those from the grazing incidence in-plane diffraction (IP-GID) method for significantly curved samples.

Effects of annealing ambient on the formation of compensation defects in InP

Positron annihilation lifetime (PAL) and photoinduced current transient spectroscopies (PICTS) have been employed to study the formation of compensation defects in undoped InP under different annealing processes with pure phosphorus (PP) ambience and iron phosphide (IP) ambience, respectively. The different annealing ambiences convert the as-grown n-type undoped InP into two types of semi-insulating (SI) states. The positron average lifetimes of as-grown InP, PP SI-InP, and IP SI-InP are found to be 246, 251, and 243 ps, respectively, which are all longer than the bulk lifetime of 240 ps, indicating the existence of vacancy-type positron-trapping defects. For as-grown InP, VInH4 complexes are the dominant defects. They dissociate into VInHn(0less than or equal tonless than or equal to3) acceptor vacancies under PP ambience annealing, compensating the residual shallow donors and turning the material semi-insulating. In forming IP SI-InP, diffusion of iron into V-In complexes under IP ambience annealing produces the substitutional compensation defect Fe-In, causing a shorter positron average lifetime. The PICTS measurements show that a group of vacancy-type defects has been suppressed by iron diffusion during the annealing process, which is in good agreement with the PAL results. (C) 2003 American Institute of Physics.