Synthesis of an Al/MgAl2O4 in situ metal matrix composite from silica gel

An aluminum/MgAl2O4 in situ metal matrix composite has been synthesized using silica gel containing B98% SiO2 in an Al–5Mg alloy. The thermodynamics and kinetics of MgAl2O4 formation have been discussed in detail. A transition phase of composition between MgO and MgAl2O4 has been detected in the SEM-EDS analysis of the particles extracted from the composite by a 25% NaOH solution. This confirms the gradual transformation of MgO to MgAl2O4 by the reaction 3SiO2(s)12MgO(s)14Al(l)-2MgAl2O4(s)13Si(l). The stoichiometry, n, of MgAl2O4 has been found to sustain close to 1 and the crystallite growth of MgAl2O4 has been stopped at DB30 nm in the composites held at 7501C up to 10 h.

Combined in situ neutron diffraction and acoustic emission of twin nucleation & twin growth in extruded ZM20 Mg alloy

In the present work in situ neutron diffraction and acoustic emission were used concurrently to study deformation twinning in two ZM20 Mg alloys with significantly different grain sizes at room temperature. The combination of these techniques allows differentionation between the twin nucleation and the twin growth mechanisms. It is shown, that yielding and immediate post-yielding plasticity in compression is governed primarily by twin nucleation, whereas the plasticity at higher strains is governed by twin growth. The current results further suggest that yielding by twinning happens in a slightly different manner in the fine-grained as compared to the coarse-grained alloy.

Wireless sensor networks for in-situ image validation for water and nutrient management

Water and Nitrogen (N) are critical inputs for crop production. Remote sensing data collected from multiple scales, including ground-based, aerial, and satellite, can be used for the formulation of an efficient and cost effective algorithm for the detection of N and water stress. Formulation and validation of such techniques require continuous acquisition of ground based spectral data over the canopy enabling field measurements to coincide exactly with aerial and satellite observations. In this context, a wireless sensor in situ network was developed and this paper describes the results of the first phase of the experiment along with the details of sensor development and instrumentation set up. The sensor network was established based on different spatial sampling strategies and each sensor collected spectral data in seven narrow wavebands (470, 550, 670, 700, 720, 750, 790 nm) critical for monitoring crop growth. Spectral measurements recorded at required intervals (up to 30 seconds) were relayed through a multi-hop wireless network to a base computer at the field site. These data were then accessed by the remote sensing centre computing system through broad band internet. Comparison of the data from the WSN and an industry standard ground based hyperspectral radiometer indicated that there were no significant differences in the spectral measurements for all the wavebands except for 790nm. Combining sensor and wireless technologies provides a robust means of aerial and satellite data calibration and an enhanced understanding of issues of variations in the scale for the effective water and nutrient management in wheat.

In situ photopolymerization of a gel ionic liquid electrolyte in the presence of iodine and its use in dye sensitized solar cells

We report for the first time an in situ photopolymerization of model co-monomers, 2-hydroxyethyl methacrylate (HEMA) and tetra (ethylene glycol) diacrylate (TEGDA), in an IL electrolyte containing I₂ for DSSCs. TiO₂ nanoparticles were used as the photo-initiator and co-gelator in a charge transfer polymerization reaction. The gel-IL polymer obtained was characterized in terms of the diffusion properties of the electrolyte. Preliminary results from DSSCs assembled using the gel-IL electrolyte showed energy conversion efficiency of 3.9% at 1 sun (AM1.5) and 5.0% at 0.39 sun illumination.

In-situ confocal Raman monitoring of evaporation process during protein crystallization

We have introduced an in-situ Raman monitoring technique to investigate the crystallization process inside protein drops. In addition to a conventional vapour-diffusion process, a novel procedure which actively stimulates the evaporation from a protein drop during crystallization was also evaluated, with lysozyme as a model protein. In contrast to the conventional vapour-diffusion condition, the evaporation-stimulated growth of crystals was initiated in a simple dehydration scheme and completed within a significantly shorter time. To gain an understanding of crystallization behaviours under the conditions with and without such evaporation stimulation, confocal Raman spectroscopy combined with linear regression analysis was used to monitor both lysozyme and HEPES buffer concentrations in real time. The confocal measurements having a high spatial resolution and good linear response revealed areas of local inhomogeneity in protein concentration when the crystallization started. The acquired concentration profiles indicated that (1)ÿthe evaporation-stimulated crystallization proceeded with protein concentrations lower than those under conventional vapour diffusion, and (2)ÿcrystals under the evaporation-stimulated condition were noticeable within an early stage of crystallization before the protein concentration approached its maximum value. The HEPES concentration profiles, on the other hand, increased steadily towards the end of the process regardless of the conditions used for crystallization. In particular, the observed local inhomogeneities specific to protein distribution suggested an accumulation mechanism of protein molecules that initiates the nucleation of crystals.

In situ synchrotron SAXS study of polymerizable microemulsions

We present for the first time a real-time small-angle X-ray scattering (SAXS) study of the structural transition of fluid microemulsion to solid polymerized material in a silicone polymerizable microemulsion system. A reactive methacrylate-terminated siloxane macromonomer (MTSM, Mn ∼ 1000 g/mol) was synthesized and used for microemulsion formulations comprising MTSM (oil phase), water, and a mixture of nonionic surfactant (Teric G9A8) with isopropanol. In situ synchrotron SAXS was used to investigate time-dependent nanostructure evolution during the polymerization reaction, which was directly initiated by X-ray radiation. The SAXS data were analyzed using both the Teubner-Strey model and the core-shell model. The results obtained by the Teubner-Strey model showed that the domain size (d) decreased while the correlation length (ξ) increased upon polymerization. The analysis in terms of the core-shell model displayed that adding water to the precursor microemulsion caused the water droplets to start swelling, which resulted in the discontinuity of water in oil microemulsion. There exhibited large differences in morphologies of polymerized materials from the microemulsion formulations with different water and surfactant contents. The core and shell sizes of water droplets decreased during the course of polymerization when there was 15 wt % or more water in the microemulsion formulation; the polymerized material thus exhibited increasingly discrete granular morphology. When there was 10 wt % or less water content in the precursor microemulsion, the rearrangement of water domains could be minimized during the course of polymerization and transparent polymerized material was obtained.

In-situ cadmium phytoremediation using solanum nigrum L. : the bio-accumulation characteristics trail

In this study, Solanum nigrum L. was used in-situ for Cd phytoremediation in Cd polluted soil on Shenyang Zhangshi Irrigation area (SZIA) in 2008. The performance of the plant over the whole growth stage was assessed. Results showed, during the whole experimental stage, the aboveground biomass of single Solanum nigrum L. grew by a factor of 190, from 1.6 ± 0.4 g to 300.3 ± 30.2 g with 141.2 times extracted Cd increase from 0.025 ± 0.001 to 3.53 ± 0.16 mg. Both the distribution of biomass and amount of extracted Cd in the aboveground part of the plant changed according to the growth of the plant. Particularly, the percentage of biomass and extracted Cd in the stem increased from 20% to 80% and from 11% to 69%, respectively. The bioconcentration factor and transfer factor both varied significantly during the growth of the plant and the lowest values were measured at the flowering stage (0.94 ± 0.31 and 3.48 ± 1.14 respectively). The results in this paper provide reference values for the future research on the application of Solanum nigrum L. in phytoremediation and on chemical or/and agricultural strategies for phytoextraction efficiency enhancement.

The inclusion of ‘then-test’ questions in post-test questionnaires alters post-test responses: a randomized study of bias in health program evaluation

Objectives Program evaluations are frequently based on ‘then-test’ data, i.e., pre-test collected in retrospect. While the application of the then-test has practical advantages, little is known about the validity of then-test data. Because of the collection of then-test in close proximity to post-test questions, this study was aimed at exploring whether the presence of then-test questions in post-test questionnaires influenced subjects’ responses to post-test.
Patients and methods To test the influence of then-test questions, we designed a randomized three-group study in the context of chronic disease self-management programs. Interventions had comparable goals and philosophies, and all 949 study participants filled out identical Health Education Impact Questionnaires (heiQ) at pre-test. At post-test, participants were then randomized to one of the following three groups: Group A responded to post-test questions only (n = 331); Group B filled out transition questions in addition to post-test (n = 304); and Group C filled out then-test questions in addition to post-test (n = 314).
Results Significant post-test differences were found in six of eight heiQ scales, with respondents who filled out then test questions reporting significantly higher post-test scores than respondents of the other groups.
Conclusions This study provides evidence that the inclusion of then-test questions alters post-test responses,
suggesting that change scores based on then-test data be interpreted with care.

The in situ physiology of "Nostocoida limicola" II, a filamentous bacterial morphotype in bulking activated sludge, using fluorescence in situ hybridization and microautoradiography

The in situ physiology of the actinobacterial bulking and foaming filamentous bacterium "Nostocoida limicola" II was studied by fluorescence in situ hybridization/microautoradiography. Substrate assimilation patterns of pure cultures of this bacterium were different to those seen in activated sludge biomass samples. There was no evidence to suggest that "N. limicola" II preferred hydrophobic substrates, but evidence was produced to support the view that it is metabolically active under anaerobic conditions in activated sludge.

Structure and thermal stability of natural rubber reinforced with in situ generated zinc sorbate

In situ prepared zinc disorbate (ZDS) in natural rubber (NR) by the reaction of zinc oxide and sorbic acid was used to reinforce the dicumyl peroxide-cured NR vulcanizate. The changes in mechanical properties of NR vulcanizates after ageing and were determined and the structures and thermal stability of vulcanizates were also analyzed using scanning electron microscope and thermal gravimetric analyzer. The change ratios in tensile strength and elongation at break of NR vulcanizate with theoretic formation of ZDS of 21phr can be increased to -33 from -44 and -27 from -38 after ageing and the initial weight loss temperature of NR vulcanizate can be increased for about 7°C as compared to un-reinforced NR vulcanizate, indicating that the antioxidative behavior and thermal stability of NR can be improved significantly with theoretic formation of ZDS of 21phr.

Real-time, in-situ, extinction spectroscopy studies on silver-nanoseed formation

In this paper, real-time extinction spectroscopy was employed to analyze in situ the fast formation process of silver seeds. The influencing factors for silver-seed formation, including the concentration of the reducer (NaBH 4), the amount of stabilizer (citrate), and the addition procedure of NaBH4, were evaluated. The configuration of the surface plasmon resonance (SPR) spectra of silver nanoparticles, which reflected the morphology of the produced silver seeds, was found to be distinctly affected by the NaBH4 concentration. Homogeneous silver nanoparticles were obtained when the added NaBH4 was lower in concentration than 2.00 mM. In contrast, higher concentrations of reducing agent (>3.00 mM NaBH4) resulted in uneven silver nanoparticles. Mie theory was applied to clarify the correlation of the SPR and the size of the silver seeds. Repeated additions of a small amount of the reducing agent could increase the monodispersity and isotropy of silver seeds. Real-time extinction spectroscopy is a convenient technique that achieves the in-situ and nondestructive measurement of intermediates in the formation process of silver nanoseeds.