923 resultados para Seeds mixture
Resumo:
The aim of this research is to investigate the influence of explosive ratio and type of sensitizer on the quality of explosive welds between copper and aluminium alloy plates. The welds were performed on a partially overlapping joint configuration using an emulsion explosive (EE) with two different sensitizers, hollow glass microspheres (HGMS) and expanded polystyrene spheres (EPS). Welds with an improved surface were achieved by using the HGMS sensitizer. A higher wave amplitude was registered in welds produced with the EPS sensitizer. In turn, the dimension of the molten pockets was influenced by the explosive ratio, increasing in size with increases in the values of this parameter. The intermetallic content of these zones varied according to the sensitizer type. Unlike the CuAl2 phase, the Cu-richer phases CuAl and Cu9Al4 were only identified in welds performed using the EPS sensitizer. An increase in hardness was observed at the interface of all welds, which resulted from both the presence of intermetallic phases and the plastic deformation of the materials promoted by the impact. This effect was most evident on the aluminium alloy side. All the welds had a greater strength than copper, i.e. the weakest material of the joint. (C) 2016 Elsevier Ltd. All rights reserved.
Resumo:
GOMES, Carlos E. M. et al. Effect of trypsin inhibitor from Crotalaria pallida seeds on Callosobruchus maculatus (cowpea weevil) and Ceratitis capitata (fruit fly). Plant Physiology and Biochemistry (Paris), v. 43, n. 12, p. 1095-1102, 2005.ISSN 0981-9428. DOI:10.1016/j.plaphy.2005.11.004.
Resumo:
Environmental impacts of wind energy facilities increasingly cause concern, a central issue being bats and birds killed by rotor blades. Two approaches have been employed to assess collision rates: carcass searches and surveys of animals prone to collisions. Carcass searches can provide an estimate for the actual number of animals being killed but they offer little information on the relation between collision rates and, for example, weather parameters due to the time of death not being precisely known. In contrast, a density index of animals exposed to collision is sufficient to analyse the parameters influencing the collision rate. However, quantification of the collision rate from animal density indices (e.g. acoustic bat activity or bird migration traffic rates) remains difficult. We combine carcass search data with animal density indices in a mixture model to investigate collision rates. In a simulation study we show that the collision rates estimated by our model were at least as precise as conventional estimates based solely on carcass search data. Furthermore, if certain conditions are met, the model can be used to predict the collision rate from density indices alone, without data from carcass searches. This can reduce the time and effort required to estimate collision rates. We applied the model to bat carcass search data obtained at 30 wind turbines in 15 wind facilities in Germany. We used acoustic bat activity and wind speed as predictors for the collision rate. The model estimates correlated well with conventional estimators. Our model can be used to predict the average collision rate. It enables an analysis of the effect of parameters such as rotor diameter or turbine type on the collision rate. The model can also be used in turbine-specific curtailment algorithms that predict the collision rate and reduce this rate with a minimal loss of energy production.
Resumo:
Understanding how aquatic species grow is fundamental in fisheries because stock assessment often relies on growth dependent statistical models. Length-frequency-based methods become important when more applicable data for growth model estimation are either not available or very expensive. In this article, we develop a new framework for growth estimation from length-frequency data using a generalized von Bertalanffy growth model (VBGM) framework that allows for time-dependent covariates to be incorporated. A finite mixture of normal distributions is used to model the length-frequency cohorts of each month with the means constrained to follow a VBGM. The variances of the finite mixture components are constrained to be a function of mean length, reducing the number of parameters and allowing for an estimate of the variance at any length. To optimize the likelihood, we use a minorization–maximization (MM) algorithm with a Nelder–Mead sub-step. This work was motivated by the decline in catches of the blue swimmer crab (BSC) (Portunus armatus) off the east coast of Queensland, Australia. We test the method with a simulation study and then apply it to the BSC fishery data.
Resumo:
Abstract not available
Resumo:
A espécie Spondias tuberosa Arr. Cam. (umbuzeiro) destaca-se como uma das espécies arbóreas de maior potencial do semiárido brasileiro. Apesar de sua relevante importância socioeconômica e ambiental, há falta de estudos voltados para o estabelecimento de um modelo de produção de mudas da espécie. O objetivo desse trabalho foi avaliar a produção de mudas de Spondias tuberosa utilizando diferentes substratos e tamanho de recipientes. O experimento foi conduzido no viveiro do Laboratório de Ecologia Vegetal (LEV) do Centro de Ciências Agrárias (CCA) da Universidade Federal da Paraíba (UFPB), Areia - PB. O delineamento experimental usado foi em blocos casualizados em esquema fatorial 2 x 7 e parcelas subdivididas, sendo que os recipientes representaram as parcelas e os substratos as subparcelas. Foram utilizados substratos formulados a partir da mistura de terra de subsolo (37,5-100%), areia lavada (12,5- 25%) e esterco bovino curtido (10-50%). Os recipientes utilizados foram sacos de polietileno preto com volumes de 1900 cm3 (15 x 27 cm) e 5000 cm3 (25 x 26 cm). Para a obtenção das plântulas, sementes de Spondias tuberosa foram semeadas em sementeira de alvenaria até a repicagem (90 dias após o semeio). Aos 78 dias, após a repicagem, as mudas foram avaliadas quanto à altura, diâmetro do colo, relação altura/ diâmetro do colo, diâmetro do xilopódio, comprimento de raiz, massa seca da parte aérea e raiz. Os dados obtidos foram submetidos à análise de variância e ao teste F, sendo as médias comparadas pelo teste de Tukey ao nível de 5% de probabilidade, utilizando o software SISVAR®. Os substratos com esterco bovino curtido proporcionaram os maiores valores em altura e comprimento de raiz. Para a produção de mudas de Spondias tuberosa, é recomendado o substrato contendo terra de subsolo (45%) + Areia (15%) + Esterco bovino (40%).
Resumo:
The potential of swamp arum ( Lasimorpha senegalensis ) seeds as a low-cost adsorbent for the removal of Hg (II) ions from aqueous solution was investigated in this study. The influence of initial metal concentration on the percent adsorption of Hg (II) ions onto powdered swamp arum seeds was studied in a batch system and the filtrate was analyzed using Atomic Absorption Spectrometry (AAS). The percent adsorbed for 10, 20, 40, 60 and 80 mg/L of the aqueous solution were 97.7, 98.9, 99.3, 99.7, and 96.5% respectively. Three isotherms; Langmuir, Freundlich, and BET were used to model the equilibrium sorption of Hg (II) ions onto powdered swamp arum seeds, with a correlation coefficient of 0.998, 0.784 and0.842 respectively. The Langmuir model fitted the equilibrium data best, with a correlation coefficient of 0.998 and a maximum adsorption capacity qm, of 5.917 mg/g. Thus, indicating monolayer coverage on the adsorbent. The results showed that swamp arum seed have the potential to be applied as alternative lowcost biosorbent in the remediation of heavy metal contamination in waste water.
Resumo:
The nutritional and amino acid analysis of raw and fermented seeds of Parkia biglobosa were carried out. Parameters investigated include moisture, crude protein, crude fat, ash, crude fibre and mineral contents; and the effect of the degree of fermentation on these parameters was also investigated. The amino acid compositions of all the samples were evaluated and amino acid quality determined by calculating amino acid scores and the predicted protein efficiency ratio (P-PER). Results showed that the proximate composition was significantly affected by fermentation, although there was little difference between the parameters for the partially fermented and completely fermented samples. Based on dry matter percentage, protein content was in the 39.77 – 43.74 % range while crude fibre ranged between 5.55 – 7.42 %. The ash content was lowest in the raw sample (2.34 %), while the fermented samples had ash contents between 4.27 and 8.33 % for the fully fermented and the partially fermented seeds, respectively. The fat content increased from 8.65 % in the raw seed to 24.4 % and 27.6 % for the partially and completely fermented samples, respectively. Results of the amino acid analysis showed that the partially fermented sample had the lowest quantities of all amino acids determined and had lysine as the limiting amino acid, whereas the raw and completely fermented samples had very similar amino acid profile with amino acid scores of 100, indicating that there are no limiting amino acids. All the samples were rich in essential amino acids. The P-PER also showed that the partially fermented sample had the lowest protein efficiency while the raw seed had the highest. Mineral contents generally increased from the raw, through the partially fermented, to the completely fermented seeds and results showed the samples to be good sources of potassium (K), calcium (Ca), manganese (Mn) and copper (Cu) in addition to being complementary sources of other metals. Locust bean seed does not accumulate lead and is, therefore, safe for consumption without the potential of food poisoning.
Resumo:
2009
Resumo:
Background: Premature infants, who have to spend the first week of their lives in neonatal intensive care units (NICUs), experience pain and stress in numerous cases, and they are exposed to many invasive interventions. The studies have shown that uncontrolled pain experienced during early life has negative and long-term side effects, such as distress, and such experiences negatively affect the development of the central nervous system Objectives: The purpose of the study was to examine the effects of touching on infant pain perception and the effects of eutectic mixture of local anesthetic (EMLA) on the reduction of pain. Patients and Methods: Data for the study were collected between March and August 2012 from the neonatal clinic of a university hospital located in eastern Turkey. The population of the study consisted of premature infants who were undergoing treatment, completed the first month and who were approved for Hepatitis B vaccine. The study consisted of two experimental groups and one control group. Information forms, intervention follow-up forms, and Premature Infant Pain Profile (PIPP) were used to collect the data. EMLA cream was applied on the vastus lateralis muscles of the first experimental group before the vaccination. The second experimental group was vaccinated by imitation (placebo), without a needle tip or medicine. Vaccination was carried out using instrumental touch in this group. A routine vaccination was applied in the control group. Results: Mean pain scores of the group to which EMLA was applied were lower in a statistically significant way (P < 0.05) compared to the pain scores of the other groups. Moreover, it was determined that even though invasive intervention was not applied to the newborns, the touching caused them to feel pain just as in the placebo group (P < 0.005). Conclusions: The results demonstrated that EMLA was an effective method for reducing pain in premature newborns, and the use of instrumental touch for invasive intervention stimulated the pain perception in the newborns.