Concentration profiles in batch fermentation of hydrolyzed lignocellulose

Experimental data was obtained for profiling changes in concentrations of two inhibiting compounds in batch fermentation of a synthesized liquor resembling hydrolyzed lignocellulose, a furan (furfural) and a phenolic compound (vanillin), along with standard fermentation data, i.e. substrate, biomass and ethanol concentrations. The initial inhibitor concentrations and fermentation temperatures in the 18 experiments were varied according to a two-level complete center composite experimental design. Based upon these observed variations in the fermentative behavior, the fermentation kinetics were modeled, as published in the corresponding article, including microbial conversion rates of the inhibitive compounds into their less toxic derivatives.

(Table 1) Sulfur isotopes, total sulfur, and degree of oxidation of basalt samples from DSDP Hole 69-504B and 70-504B

About 150 basalt samples from Hole 504B, near the Costa Rica Rift were analyzed for sulfur content and sulfur-isotope composition. The basement in Hole 504B can be divided into an upper part, which has oxidative alteration (274.5-550 m below sea floor), and a lower part, which has nonoxidative alteration (550-835 m below sea floor) (the interval from 540 to 585 meters actually is transitional). This division is reflected in both the sulfur content and the sulfurisotope composition. Oxidative alteration of basalts by sea water at low temperatures has resulted in a depletion in sulfur in the upper part of the hole (mostly less than 600 ppm S) as compared to fresh sulfur-saturated oceanic tholeiites (900-1200 ppm S). High amounts of sulfur in the lower part of the hole are a result of precipitation of secondary pyrite under non-oxidative or weakly oxidative conditions from solutions which dissolved igneous sulfides. The average sulfur-isotope composition of the primary igneous sulfides is d34S = -0.01 per mil, which is close to the assumed mantle sulfur composition (d34S = 0 per mil. Pyrite and sulfate sulfur extracted together in a separate preparation step (as "pyrite-sulfate" sulfur) indicate addition of sea-water sulfate to the upper part of the basalts. The d34S of secondary pyrite isolated by hand-picking varies between -8.0 and +5.8 per mil; the "pyrite-sulfate" sulfur (d34S = -4.8 to +10.5 per mil), as well as that of the isolated pyrite, may have originated in the precipitation of pyrite from solutions containing sulfur from the dissolution of igneous sulfides, but addition of sulfur transported by hydrothermal solutions cannot be excluded.

Ion concentration and deduced chemical compounds of the GRIP and Dome Fuji ice cores, Greenland and Antarctica

We have proposed a method of deducing the chemical compounds found in deep polar ice cores by analyzing the balance between six major ions (Cl-, NO3-, SO4**2-, Na+, Mg2+, and Ca2+). The method is demonstrated for the Holocene and last glacial maximum regions of the Dome Fuji and GRIP ice cores. The dominant compounds depend only on the ion balance and the sequence of chemical reactions. In priority order, the principle salts are calcium sulfate, other sulfates, nitrate, chloride, and carbonate. The chemical abundances deduced by this method agree well with the results of Raman spectroscopy on individual salt inclusions. The abundances in the ice cores are shown to reflect differences in climatic periods (the acidic environment of the Holocene versus the reductive environment of the last glacial maximum) and regional conditions (the marine environment of Antarctica versus the continental environment of Greenland).

(Table T1) Radioelement concentration and radiogenic heat production of ODP Holes 173-1067A and 173-1068A

Mean values of radiogenic heat production are derived from measurements of radioelements on the following rock types: amphibolite (0.358 ± 0.118 µW/m**3) and tonalite gneiss (0.802 ± 0.039 µW/m**3) at Site 1067 and serpentinized peridotite (0.0108 ± 0.0003 µW/m**3) at Site 1068. The results for serpentinized peridotite and amphibolite are consistent with previous measurements on samples from Sites 897 and 900. These results suggest that the thin continental crust in this region would contribute very little to the conductive heat flow.