Evaluation of two mineral trioxide aggregate compounds as pulp-capping agents in human teeth

Aim: The present randomized, controlled prospective study evaluated the histomorphological response of human dental pulps capped with two grey mineral trioxide aggregate (MTA) compounds. Methodology: Pulp exposures were performed on the occlusal floor of 40 human permanent pre-molars. The pulp was capped either with ProRoot (Dentsply) or MTA-Angelus (Angelus) and restored with zinc oxide eugenol cement. After 30 and 60 days, teeth were extracted and processed for histological examination and the effects on the pulp were scored. The data were subjected to Kruskal-Wallis and Conover tests (α = 0.05). Results: In five out of the 40 teeth bacteria were present in pulp tissue. No significant difference was observed between the two materials (P > 0.05) in terms of overall histological features (hard tissue bridge, inflammatory response, giant cells and particles of capping materials). Overall, 94% and 88% of the specimens capped with MTA-Angelus and ProRoot, respectively, showed either total or partial hard tissue bridge formation (P > 0.05). Conclusions: Both commercial materials ProRoot (Dentsply) and MTA-Angelus (Angelus) produced similar responses in the pulp when used for pulp capping in intact, caries-free teeth. © 2009 International Endodontic Journal.

Correlação entre a densidade mineral óssea e níveis séricos de cálcio, fósforo e fosfatase alcalina total em gatos após tirotoxicose experimental

Hyperthyroidism is and endocrinal dysfunction characterized by excessive serum concentrations of thyroid gland hormones, which can cause several effects on the bone tissue in humans and in animals. For a better characterization of thyrotoxicosis effects on bone metabolism, 16 cats were induced into hyperthyroid state. Results showed that, in some moments a major bone demineralization of the right distal radium estremity promoted an elevation of the serum levels of phosphorus and total alkaline phosphatase.

Utilização do coque verde de petróleo da Petrobras em substituição parcial ao carvão mineral das misturas injetadas em altos fornos

The Petrobras produced green petroleum coke (GPC) is a carbon rich fuel, virtually ash-free, with low sulfur content, and is a fuel suitable to replace metallurgical coke in blast furnaces. The GPC was tested in a pulverized coal injection simulator built in the Volta Redonda research center. It presented a low burning efficiency due to low volatile material content and high substitution rate by the carbon content. The tests were carried out in blast furnaces with ≤ 50% Petrobras GPC in the coal blends. The injected coal/CVP mixtures produced no negative side effects in the blast furnace grinding systems, pneumatic conveying, or operating process. The mixture burning process inside the blast furnace showed a decrease in fuel consumption, with a significant reduction in metallurgical coke consumption. The industrial-scale tests of the GPC mixtures did not reach the 70% maximum for lack of the GPC feedstock, which is necessary to continue with standard coal mixtures.

Viabilidade de aplicação das coberturas argilosas da região de Alfenas na indústra cerâmica

The region of Alfenas, in the state of Minas Gerais, Brazil, is predominantly constituted of Pre-Cambrian rocks with well developed alteration profiles in association with colluvial and alluvial sediments. No study to date has examined in detail its potential use in the ceramic industry. The scarce knowledge of its mineralogical and technological properties limits its value and consequently its industrial use. Until now, these clay materials have been used in a rudimental manner, in small scale in the fabrication of red tiles. The present study aimed at analyzing these clays mineralogically (X-ray diffraction), chemically (major and minor elements by X-ray fluorescence and organic carbon analysis) and technologically (pressing granulometric distribution; mechanical resistence; water absorption, apparent porosity; linear firing shrinkage; color of firing and others) in order to better understand the raw material and develop adequate technological applications. The best results of ceramic properties were the samples with higher organic content (more plastic clays) and higher values of Al2O3 (kaolinite and gibbsite) and Fe2O3 as well lower SiO2 content and finer grain size which contribute to a better sinterization.

Bone mineral density on conventional and digitized images under different parameters of digitization and storage

Aim: To assess the bone mineral density on conventional and digitized images, comparing whether different parameters of digitization and storage change these values. Methods: Twenty radiographs were taken from five partially dentulous dry mandibles with an aluminum 7-mm stepwedge placed on the superior edge of the film. After processing, the films were digitized with a resolution of 600 and 2,400 d.p.i. and saved as TIFF and JPEG files. On every conventional and digitized image, circular regions of interest were selected for densitometry and radiographic contrast analysis. Results: Pearson's correlation coefficient showed a significant and strong mean gray values association between digitized and conventional images, differing from radiographic contrast that did not show a significant association. ANOVA did not reveal a statistically significant difference in bone density and radiographic contrast among the four digitized image groups, but the conventional image contrast was significantly lower. Conclusions: Bone mineral density did not differ in both conventional and digitized images. The parameters of image compression and resolution, tested in this study, did not change the results of densitometry and digitization process increased the radiographic contrast.

Química mineral e estimativas de pressão e temperatura em rochas metassedimentares do grupo araxá na região de morrinhos, sul do estado de goiás

In the Morrinhos region, Goiás state, Brazil, the rocks of the Araxá Group have mineral assemblages related to the metamorphic peak which occurred in this region and is typical of the amphibolite facies (kyanite zone). These rocks are associated with the initial stage of the main ductile deformation that occurred in this area. Thermobarometric calculations, including the associations, garnet + plagioclase + biotite + muscovite; garnet + plagioclase +biotite + muscovite + kyanite; garnet + plagioclase + biotite + muscovite + amphibole, with quartz in excess, indicate that the metamorphic peak occurred at temperatures of approximately 610°C and pressures in the order of 10 kbar. The P-T path is probably clockwise and is in agreement with the tectonic conditions observed in collisional settings.

Geologia e Caracterização Tecnológica do Minério de Manganês da Mina Córrego do Cocho, Itapira (SP)

The objects of this study are three manganese ore deposits and one mine derived from lateritic weathering of gondites (spessartine quartzites). These deposits are associated with Mn-rich garnet metasediments of the Itapira Group (Paleoproterozoic) and the reserves were estimated at approximately 2.0 × 10 6 tons with an average grade of 23% MnO 2. The ore minerals are cryptomelane, pyrolusite, lithiophorite, spessartine and psilomelane. Several crystal shapes and textural characteristics were identifi ed in this study, which are related to the degree of liberation, as confi rmed by heavy media separation method. In this study, we determined the main characteristics of the liberation of manganese, which is concentrated in the fi ne grain-size fraction and is lost during ore dressing. Therefore, the low average content of MnO 2 (28%) is due to this loss, whereas at grain size of minus 0.074 mm, contents near 40% MnO 2 were observed. This suggests that the ore can be used for manufacturing manganese sulphate fertilizers. A comparative study with the ore deposits located at Ouro Fino (MG), mainly with the Caneleiras mine, showed that higher degree of liberation occurs in the coarse grain-size fractions (0.84 to 0.074 mm with MnO 2 content of 38%). As a consequence, the ore can be used for manufacturing Fe-Si-Mn alloys.

Composição mineral da carcaça e dos cortes da carcaça de ovinos jovens e adultos

Aiming to evaluate the mineral composition (iron, calcium and sodium) of the carcass and carcass cuts of meat from different ovine categories, 18 1/2 Ile de France 1/2 Polwarth sheeps (6 uncastrated lambs, 6 discarded ewes and 6 discarded wethers) were used. Animals were in grazing system based on Tifton - 85 pastures and were supplemented with concentrate. Lambs were slaughtered at 32 kg of live weight, at around 5 months of age. Ewes and wethers were slaughtered with 55 kg and 60 months of age. The iron values were differents between categories for those valued cuts muscles, with higher average to legs muscles from adults ovine of 3.86 mg/100g with regard to lambs of 1.91 mg/100g, respectively. The iron values of the muscles from half carcass didn't differ for that animal category, with 3.38 mg/100g average. The calcium values in muscles from half carcass and leg cut were higher to wethers (9.84 e 7.35 mg/100g), intermediaries to ewes (6.28 e 6.54 mg/100g) and smallers values to lambs (5.30 e 4.22 mg/100g). There wasn't differences for sodium values to valued categories and muscles, with values around 56.75 mg/100g. In conclusion, the sodium values are similar between animals categories and from differents carcass muscles and that the iron and calcium values present differences.

Effect of different radiopacifying agents on the physicochemical properties of white portland cement and white mineral trioxide aggregate

Introduction: The aim of this study was to evaluate the pH, calcium ion release, setting time, and solubility of white mineral trioxide aggregate (WMTA) and white Portland cement (WPC) combined with the following radiopacifying agents: bismuth oxide (BO), calcium tungstate (CT), and zirconium oxide (ZO). Methods: Fifty acrylic teeth with root-end filling material were immersed in ultrapure water for measurement of pH and calcium release (atomic absorption spectrophotometry) at 3, 24, 72, and 168 hours. For evaluation of setting time, each material was analyzed according to the American Society for Testing and Materials guidelines 266/08. The solubility test was performed according to American National Standards Institute/American Dental Association specification no. 57/2000. Solubility, setting time, and pH values were compared by using analysis of variance and Tukey test, and the values of calcium release were compared by the Kruskal-Wallis and Miller tests. The significance level was set at 5%. Results: The pH and calcium release were higher at 3 and 24 hours. WPC was the material with the higher values for both properties. WMTA had the greatest solubility among all materials (P <.05). All radiopacifiers increased the setting time of WPC, and WMTA had the shortest setting time among all materials (P < .05). Conclusions: All materials released calcium ions. Except for WPC/CT at 168 hours, all materials promoted an alkaline pH. On the basis of the obtained results, ZO and CT can be considered as potential radiopacifying agents to be used in combination with Portland cement. Copyright © 2012 American Association of Endodontists.

Determinação da densidade mineral e da elasticidade óssea após a aplicação de ondas de choque extracorpóreas no terceiro metacarpiano de equinos atletas

The porpoise of this study was to evaluate the effects of extracorporeal shock waves in third metacarpus bone from healthy horses by determination of bone elasticity. It were used 20 Thoroughbred horses, male and female, with two years old, on top of training and selected as the state healthy. At the beginning of the experiment (D0), all animals were submitted for evaluation of bone elasticity held in the third metacarpus bone. The animals were divided into two groups (Control Group - CG and Experimental Group - EG). The application of extracorporeal shock wave therapy (ESWT) was performed on the right forelimb of the animals in the experimental group in the same place evaluated for bone elasticity and was used apparatus for extracorporeal therapy of waves with 0.15 mJ/mm2 energy flux density and 2000 pulses with E6R20 probe, with focus feature of the shock wave of 20 mm. The ESWT were repeated every 21 days, a total of three sessions (D0, D21 and D42). The analysis of bone elasticity determination was realized at D21, D42 and D72. The average of speed ultrasound differed between groups at D21, D42 and D72, and the animals from EG had lower bone mineral density after applications of ESWT. There was also difference in the analysis of bone mass (Z-Score) between the groups at D21 and D42, which animals from EG showed a significant decrease in bone mass. The risk of fracture was higher in animals from experimental group at D21. It was concluded that ESWT is able to promote change in bone mineral density.