Heat flow ratios of stations from the Iberian abyssal plain (Table 1)

New heat flow observations have been made in the Iberia abyssal plain off the Galicia margin along the transeat of Ocean Drilling Program Leg 149 drill sites. in order to investigate the nature of this unusually wide and deep continet-ocean transition region. Our results indicate the presence of three separate zones. Average values of 47.5 +/- 3 mW/m in the westernmost zone III agree with predictions of standard oceanic lithospheric models for its estimated age of 126 Ma. In contrast, the heat flow within zone II is 5-15 mW/m higher than predicted. assuming that the mantle heat flow remains constant across the basin. This region of high values is coincident with the location of a major intra-crustal "S"-type reflector east of ODP Site 900. and the anomaly is consistent with the presence of 2-3 km of primarily upper continental crust above the reflector, with concentrations of radiogenic components similar to those from granodiorite samplles dredged off Galicia Bank. It is not, however, consistent with the low values of heat production measured on gabbroic sanhples from its western end at ODP Site 900. In zone I, detailed measurements across the tilted fault block south of ODP Site 901 show consistent variations which closely match predictions due to the effects of basement structure and sediment deposition. There is no evidence for variations due to vertical convective transport along the dipping basement fault block. Once corrected for these variations. measurements in zone I yield average values that agree quite well with previous measurements across Calicia Bank. indicating no systematic landward increase in heat flow with decreasing amounts of continental, extension.

(Table 1) Vertical turbulent eddy diffusivity of selected stations from the Nathaniel B. Palmer cruise NBP09-01

Dissolved iron (DFe) and total dissolvable Fe (TDFe) were measured in January-February 2009 in Pine Island Bay, as well as in the Pine Island and Amundsen polynyas (Amundsen Sea, Southern Ocean). Iron (Fe) has been shown to be a limiting nutrient for phytoplankton growth, even in the productive continental shelves surrounding the Antarctic continent. However, the polynyas of the Amundsen Sea harbor the highest concentrations of phytoplankton anywhere in Antarctica. Here we present data showing the likely sources of Fe that enable such a productive and long lasting phytoplankton bloom. Circumpolar Deep Water (CDW) flows over the bottom of the shelf into the Pine Island Bay where DFe and TDFe were observed to increase from 0.2 to 0.4 nM DFe and from 0.3-4.0 to 7-14 nM TDFe, respectively. At the southern end of Pine Island Bay, the CDW upwelled under the Pine Island Glacier, bringing nutrients (including Fe) to the surface and melting the base of the glacier. Concentrations of DFe in waters near the Pine Island Glacier and the more westward lying Crosson, Dotson, and Getz Ice Shelves varied between 0.40 and 1.31 nM, depending on the relative magnitude of upwelling, turbulent mixing, and melting. These values represent maximum concentrations since associated ligands (which increase the solubility of Fe in seawater) were saturated with Fe (Thuroczy et al., 2012, doi:10.1016/j.dsr2.2012.03.009). The TDFe concentrations were very high compared to what previously has been measured in the Southern Ocean, varying between 3 and 106 nM. In the Pine Island Polynya, macronutrients and DFe were consumed by the phytoplankton bloom and concentrations were very low. We calculate that atmospheric dust contributed < 1% of the Fe necessary to sustain the phytoplankton bloom, while vertical turbulent eddy diffusion from the sediment, sea ice melt, and upwelling contributed 1.0-3.8%, 0.7-2.9%, and 0.4-1.7%, respectively. The largest source was Fe input from the PIG, which could satisfy the total Fe demand by the phytoplankton bloom by lateral advection of Fe over a range of 150 km from the glacier. The role of TDFe as a phytoplankton nutrient remains unclear, perhaps representing an important indirect Fe source via dissolution and complexation by dissolved organic ligands (Gerringa et al., 2000, doi:10.1016/S0304-4203(99)00092-4; Borer et al., 2005, doi:10.1016/j.marchem.2004.08.006).

(Table 1) Apparent ages from 40Ar/39Ar heating steps for DSDP Hole 72-516F basalts

Submarine basalts are difficult to date accurately by the potassium-argon method. Dalrymple and Moore (1968) and Dymond (1970), for example, showed that, when the conventional K-Ar method is used, pillow lavas may contain excess 40Ar. Use of the 40Ar/39Ar step-heating method has not overcome the problem, as had been hoped, and has produced some conflicting results. Ozima and Saito (1973) concluded that the excess 40Ar is retained only in high temperature sites, but Seidemann (1978) found that it could be released at all temperatures. Furthermore, addition of potassium, from seawater, to the rock after it has solidified can result in low ages (Seidemann, 1977), the opposite effect to that of excess 40Ar. Thus, apparent ages may be either greater or less than the age of extrusion. Because of this discouraging record, the present study was approached pragmatically, to investigate whether self-consistent results can be obtained by the 40Ar/39Ar step-heating method.

Composition of sediments, hydrothermal manifestations, interstitial waters, and aeolian material from the TAG Hydrothermal Field and Central Atlantic

The book is devoted to regularities of spatial distribution, mineralogy and geochemistry of hydrothermal and hydrothermal-sedimentary manifestations of the Mid-Atlantic Ridge rift zone.

Cenozoic palaeoclimate reconstructions from 35 sites in Central Europe

Continental climate evolution of Central Europe has been reconstructed quantitatively for the last 45 million years providing inferred data on mean annual temperature and precipitation, and winter and summer temperatures. Although some regional effects occur, the European Cenozoic continental climate record correlates well with the global oxygen isotope record from marine environments. During the last 45 million years, continental cooling is especially pronounced for inferred winter temperatures but hardly observable from summer temperatures. Correspondingly, Cenozoic cooling in Central Europe is directly associated with an increase of seasonality. In contrast, inferred Cenozoic mean annual precipitation remained relatively stable, indicating the importance of latent heat transport throughout the Cenozoic. Moreover, our data support the concept that changes in atmospheric CO2 concentrations, although linked to climate changes, were not the major driving force of Cenozoic cooling.