Effect of clinical use of nickel-titanium springs

Introduction: Our objectives were to determine whether there are changes on the load deflection rate (L/DP) and the average force (FP) of the superelastic pseudoplateau, and whether permanent deformation is changed in nickel-titanium closed-coil springs (CCSs) after 6 months of clinical use. Methods: Twenty-two nickel-titanium CCSs (Sentalloy 100 g; Dentsply GAC, York, Pa) were subjected to tensile mechanical testing at 37 degrees C on activations varying from 3.2 to 16.0 mm before and after 6 months of clinical use. A regression line was fitted over the most horizontal area of the unloading part of the stress-strain graph of every CCS, and its slope was used as L/DP. The FP was determined by the midpoint of the longest segment of the curve that could be fit within the regression line with a R-2 of at least 0.999, and permanent deformation was determined graphically by obtaining the strain value when the measured stress reached zero. The data were analyzed by 3 analyses of variance at 2 levels, with 5% of significance. Results: Time and activation significantly influenced the variables tested (P < 0.001). Time increased the L/DP and permanent deformation but decreased the FP. Activation decreased L/DP, FP, and permanent deformation. Significant interactions between time and activation were detected for FP (P = 0.013) and deformation (P < 0.001). Conclusions: After 6 months of active clinical use, the analyzed springs had a significant but small increase in their L/DP; FP dropped up to 88%, and the CCSs deformed up to 1.26 mm.

Nanoelectrocatalytic oxidation of lactic acid using nickel nanoparticles

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Electropolymerization using binuclear nickel(II) Schiff base complexes bearing N4O4 donors as supramolecular building blocks

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Influência de tratamentos termo-mecânicos na estrutura e microestrutura da liga Ti-10%pNi obtida por fusão a arco

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Preparation and thermal decomposition of solid state cobalt, nickel, copper and zinc chelates of ethylenediaminetetraacetic acid

Solid state chelates of general formula H-2[M(EDTA)] . nH2O, where M is Co, Ni, Cu or Zn, and EDTA is ethylenediaminetetraacetate, were prepared. Thermogravimetry-derivative thermogravimetry (TG-DTG), differential thermal analysis (DTA) and complexometry were used to characterize and to study the thermal stability and thermal decomposition of these compounds.

Thermal analysis of coordination compounds. Part 1. Thermodecomposition of nickel(II) triphenylphosphine complexes with halides, nitrate, and thiocyanate

The compounds [NiX 2(PPh 3) 2] (where X is Cl -, Br -, I -, NO - 3, NCS -; and PPh 3 is triphenylphosphine) were prepared and characterized by infrared and atomic absorption spectroscopies and by carbon and hydrogen analyses. Simultaneous thermogravimetric (TG) and derivative thermogravimetric (DTG) curves of these complexes were recorded in air. The decrease in mass observed indicates conversion of the complexes to oxides. The thermal decomposition of the halogen and nitrate complexes occurred in a number of steps; the thiocyanate complex decomposed in a single step. © 1994.

Correlation between i.r. spectra and thermal decomposition of cobalt(II), nickel(II), copper(II) and mercury(II) complexes with piperidinedithiocarbamate and pyrrolidinedithiocarbamate

The thermal decomposition of pyrrolidinedithiocarbamate and piperidinedithiocarbamate complexes of CoII, NiII, CuII and HgII have been studied by thermogravimetry and differential scanning calorimetry. The decomposition intermediates and final products were identified by their X-ray diffraction patterns. The i.r. spectra are discussed in terms of the thermal decomposition pathways.

Determination of furanic aldehydes in sugarcane bagasse by high-performance liquid chromatography with pulsed amperometric detection using a modified electrode with nickel nanoparticles

A glassy carbon electrode chemically modified with nickel nanoparticles coupled with reversed-phase chromatography with pulsed amperometric detection was used for the quantitative analysis of furanic aldehydes in a real sample of sugarcane bagasse hydrolysate. Chromatographic separation was carried out in isocratic conditions (acetonitrile/water, 1:9) with a flow rate of 1.0 mL/min, a detection potential of -50 mV vs. Pd, and the process was completed within 4 min. The analytical curves presented limits of detection of 4.0 × 10(-7) mol/L and 4.3 × 10(-7) mol/L, limits of quantification of 1.3 × 10(-6) and 1.4 × 10(-6) mol/L, amperometric sensitivities of 2.2 × 10(6) nA mol/L and 2.7 × 10(6) nA mol/L for furfural and 5-hydroxymethylfurfural, respectively. The values obtained in this sample by the standard addition method were 1.54 ± 0.02 g/kg for 5-hydroxymethylfurfural and 11.5 ± 0.2 g/kg for furfural. The results demonstrate that this new proposed method can be used for the quick detection of furanic aldehydes without the interference of other electroactive species, besides having other remarkable merits that include excellent peak resolution, analytical repeatability, sensitivity, and accuracy.

Detection of several carbohydrates using boron-doped diamond electrodes modified with nickel hydroxide nanoparticles

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Electrochemical investigation of the voltammetric determination of hydrochlorothiazide using a nickel hydroxide modified nickel electrode

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Modificação de nanopartículas de óxido de ferro por dextranas

A modificação de nanopartículas de óxido de ferro tem sido motivo de diversos estudos devido ao grande potencial em aplicações tecnológicas, em especial a área biomédica, pela aliança das propriedades magnéticas dos óxidos com a funcionalidade que a dextrana confere a esse material. O presente trabalho tem como objetivo sintetizar e caracterizar o sistema óxido de ferro/dextranas. O óxido de ferro foi obtido pela reação de co-precipitação de sais de ferro (II) e ferro (III) - na razão molar 1:2 - com hidróxido de sódio e a modificação das partículas magnéticas se deu por dois métodos: (I) a co-precipitação na presença de dextrana e carboximetil dextrana e (II) a co-precipitação seguida da modificação. Para modificação proposta pelo método (II) se fez necessário enxertar a dextrana em ácido acrílico, utilizando o íon Ce(IV) como iniciador da reação de polimerização. Nessa etapa se averiguou a concentração de iniciador ótima para a síntese e, através da técnica de espectroscopia de infravermelho, se pode confirmar a eficiência do enxerto. A concentração 0,3% de íon Ce(IV) apresentou melhor distribuição de tamanho, obtidos por análises de microscopia eletrônica de varredura e espalhamento de luz dinâmico, sendo escolhida para síntese junto a partícula magnética. A difratometria de raio X permitiu determinar a formação de estrutura cristalina da magnetita e maghemita, que são muito parecidas entre si, porém os espectros de infravermelho apontaram desdobramentos da ligação Fe - O característica da maghemita. A relação Fe2+/ Fe3+ obtida por espectrofotometria também resultou em oxidação. A estabilidade coloidal dos sistemas foi avaliada através de medidas de potencial zeta. A modificação da partícula magnética com carboximetil dextrana foi equivalente para os dois métodos empregados, entretanto a modificação com ...

Determinação de fósforo em biodiesel utilizando eletrodo quimicamente modificado com nanopartículas de ferro

Once petroleum is na exhaustible source of energy, alternative fuels are having more prominence. A much discussed option for replacing fossil fuels is the use of biofuels derived from oils or fats, especially biodiesel. The biodiesel preparation is through a reaction named transesterification, a reaction of triglycerides with a short chain alcohol with a catalyst, producing a mixture of fatty acid esters and glycerol. According to ANP (National Petroleum Agency) specifications, biodiesel can have contaminants due to the catalyst or oil used on its synthesis, such as phosphorus, wich can damage the catalytic converter and cause significant increase in the particles emission. This project aims to develop na alternative method using chemically modified electrodes with iron nanoparticles for determination of phosphorus in biodiesel. For the formation of the iron nanoparticles film on the surface of a glassy carbon electrode, was used a iron sulfate solution. The film was formed after 10 successive cycles, with a scanning speed of 50 mV s-1 and a potential range of -0,9 to -1,25 V. To reduce possible oxides on the surface and activate the electrode, it has been subjected to a cathodic polarization with a potential of -1,25 V for 15 minutes in a sodium hydroxide solution. In cyclic voltammograms obtained in the study of the speed of scanning, there is an increase in the intensity of the anodic and cathodic current peaks. The cathodic peak current varied linearly with the square root of scan rate, showing that the electrode is controlled by diffusion. After successive additions of phosphate there is a linear variation in the current peak in the concentration range of 1,0 x 10-7 a 1,0 x 10-6 mol L-1. To determine if the concentration of phosphorus in real sample, the method of adding standard was used by adding aliquots of phosphate ions in the solution containing soy biodiesel extracted with ....

Caracterização mecânica e microestrutural de juntas soldadas a laser em aços maraging com posterior tratamento térmico e termoquímico de superfície a plasma

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Oxidação e remoção de ferro e manganês em águas para fins de abastecimento público ou industrial: uma abordagem geral

The iron and manganese ions are present in a high frequency in water source in Brazil. Despite of the frequency in which such problems occur, the way the problem is faced is still traditional, i.e. focusing on oxidative process instead of solid-liquid separation. The treatment can be very simple, in groundwater, or very complex, when metals are present together with organic matter in water. This article presents a review of principal works besides some important aspects about iron and manganese in natural water, occurrence, forms in natural water, organic complexes, oxidation and removal applying solid/liquid separation processes. Further, a new strategy for iron and manganese removal is presented. The information described does not exhaust the matter, so a large bibliography was cited at the end of the article.

O uso das novas tecnologias informacionais no acervo do patrimônio industrial ferroviário: o caso da estrada de ferro noroeste do brasil de bauru

This paper addresses the issue of access the industrial heritagerailway information integrating the EFNOB in the city of Bauru / SP, through the use of new technologiesinformation. For constitute a major challenge in gathering, organizing, scanning and providing such documentary collection, the research aims to organize and disseminate information document, supported by new access technologies, aiming to preserve and create conditions for setting up a database of documents and cartographic this collection. This research is part of our project entitled "EFNOB Bauru: Center for Memory and Virtual Information", which in turn is part of the larger project, called "EFNOB / Bauru, Km 0," FAPESP / CONDEPHAAT. One of the cornerstones of the work is to collect, treat, select and the heritagedisseminate of movable and immovable EFNOB through the creation of a MemoryCentre and Industrial HeritageRailwayInformation of EFNOB.