Elevated atmospheric CO2 concentration increases rice blast severity

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Influence of ethanol, acidity and chloride concentration on the corrosion resistance of AISI 316L stainless steel

The influence of ethanol, sulfuric acid and chloride on the corrosion resistance of 316L stainless steel was investigated by means of polarization curves and electrochemical impedance spectroscopy measurements. Over the studied range, the steel corrosion potential was independent of H2SO 4 and NaCl concentrations in aqueous solution. On the other hand, in solution containing 65 wt.% ethanol and 35 wt.% water, the corrosion potentials were higher than those obtained in aqueous solution. Besides, the steel corrosion potential was affected by the addition of H2SO4 and NaCl in solution. In solutions with and without ethanol, plus 0.35 wt.% NaCl, the presence of 1 wt.% H2SO4 inhibited the appearance of pitting corrosion. © 2013 Sociedade Brasileira de Química.

TiO2-Cu photocatalysts: A study on the long- and short-range chemical environment of the dopant

In this study, the short- and long-range chemical environments of Cu dopant in TiO2 photocatalyst have been investigated. The Cu-doped and undoped TiO2 specimens were prepared by the sol-gel approach employing CuSO4·5H2O and Ti(O-iPr)4 precursors and subjecting the dried gels to thermal treatment at 400 and 500 C. The photocatalytic activity, investigated by methylene blue degradation under sunlight irradiation, showed a significantly higher efficiency of Cu-doped samples than that of pure TiO2. The X-ray diffraction results showed the presence of anatase phase for samples prepared at 400 and 500 C. No crystalline CuSO4 phase was detected below 500 C. It was also found that doping decreases the crystallite size in the (004) and (101) directions. Infrared spectroscopy results indicated that the chemical environment of sulfate changes as a function of thermal treatment, and UV-vis spectra showed that the band gap decreases with thermal treatment and Cu doping, showing the lowest value for the 400 C sample. X-ray absorption fine structure measurements and analysis refinements revealed that even after thermal treatment and photocatalytic assays, the Cu2+ local order is similar to that of CuSO4, containing, however, oxygen vacancies. X-ray photoelectron spectroscopy data, limited to the near surface region of the catalyst, evidenced, besides CuSO4, the presence of Cu1+ and CuO phases, indicating the active role of Cu in the TiO2 lattice. © 2013 Springer Science+Business Media New York.

Influence of the indium concentration on microstructural and electrical properties of proton conducting NiO-BaCe0.9-xIn xY0.1O3-δ cermet anodes for IT-SOFC application

Optimization of the major properties of anodes based on proton conductors, such as microstructure, conductivity and chemical stability, is yet to be achieved. In this study we investigated the influence of indium on the chemical stability, microstructural and electrical characteristics of proton conducting NiO-BaCe0.9-xInxY0.1O 3-δ (NiO-BCIYx) anodes. Four compositions of cermet anode substrates NiO-BCIYx were prepared using the method of evaporation and decomposition of solutions and suspensions (EDSS). Sintered anode substrates were reduced and their microstructural and electrical properties were examined before and after reduction as a function of the amount of indium. Anode substrates tested on chemical stability in the CO2 atmosphere showed high stability compared to anode substrates based on commonly used doped barium cerates. Microstructural properties of the anode pellets before and after testing in CO2 were investigated using X-ray diffraction analysis. Impedance spectroscopy measurements were used for evaluation of electrical properties of the anode pellets and the conductivity values of reduced anodes of more than 14 S cm-1 at 600 °C confirmed percolations through Ni particles. Under fuel cell operating conditions, the cell with a Ni-BCIY20 anode achieved the highest performance, demonstrating a peak power density 223 mW/cm2 at 700 °C confirming the functionality of Ni-BCIY anodes.© 2013 Elsevier B.V. All rights reserved.

Maternal flow-mediated dilation and nitrite concentration during third trimester of pregnancy and postpartum period

Objectives. To compare maternal flow-mediated dilation (FMD) of the brachial artery and nitrite concentration between third trimester of pregnancy (3rdT) and postpartum (PP) period. Additionally, we will evaluate whether FMD correlates with nitrite concentration in both periods. Methods. Eligibility criteria was healthy women with singleton pregnancy, gestational age >28 weeks, nonsmokers, and no personal or family history of vascular disease. Each women was examined during 3rdT and between 8 and 12 weeks PP to evaluate FMD and nitrite concentration in whole blood. Women not examined in both periods were excluded. Values between both periods were compared using paired t tests. Correlation between FMD and nitrite was examined by Pearson correlation coefficient. Significance level set as p<0.05. Results. We invited 42 pregnant women. Among them, 35 were eligible and 7 of them were excluded for not attending the PP evaluation resulting in 28 participants analyzed. We found no significant change in FMD (10.39±5.57% vs. 8.42±4.21%; p=0.11; 3rdT vs. PP, respectively) and no significant change in nitrite concentration (257.41±122.95nmol/L vs. 237.16±90.01nmol/L; p=0.28). Baseline brachial artery diameter had a significant reduction (3.11±0.30 to 2.75±0.34mm; p<0.01). No significant correlation between FMD and nitrite during 3rdT (r=-0.13; p=0.50) or PP (r=0.14; p=0.48) was found. Conclusions. We did not observe significant changes in both FMD and nitrite concentration between third trimester and the PP period. FMD did not correlate with nitrite in both periods. More studies are needed to confirm our findings. © Informa Healthcare USA, Inc.

Influence of the concentration of polyols on the rheological and spectral characteristics of guar gum

Polyols are widely used as sugar substitutes and provide texture to foods. Guar gum has many applications in food industry such as increasing product viscosity and improving texture. Knowledge of rheological properties of gum/polyol systems is important to permit replacing sugar while maintaining product texture. In this work, rheological properties of 0.1, 0.5 and 1 g/100 g guar solutions containing 10 and 40 g/100 g of maltitol, sorbitol, or xylitol were studied. The behavior of these mixtures was evaluated by steady and oscillatory shear measurements, and after a freezing/thawing cycle. Apparent viscosity of guar solutions increased with addition of polyols and with the increase in their concentrations, except for 40 g/100 g sorbitol addition to 1 g/100 g guar gum, in which the apparent viscosity decreased. Addition of polyols also increased the dynamic moduli of the systems. In mixtures of guar with 40 g/100 g polyol, the phase angle (δ) was below unity, but was dependent on frequency, which is characteristic of concentrated solutions with a certain degree of structuring. FTIR spectroscopy was studied to provide information on possible interactions between guar gum and polyols. Analyses carried out after freezing/thawing showed no changes in the viscoelastic behavior of the solutions. © 2013 Elsevier Ltd.

The systematic significance of floral morphology, nectaries, and nectar concentration in epiphytic cacti of tribes Hylocereeae and Rhipsalideae (Cactaceae)

A long-standing interest in cactus taxonomy has existed since the Linnaean generation, but an appreciation of the reproductive biology of cacti started early in the 1900s. Numerous studies indicate that plant reproductive traits provide valuable systematic information. Despite the extensive reproductive versatility and specializations in breeding systems coupled with the striking floral shapes, the reproductive biology of the Cactaceae has been investigated in approximately 10% of its species. Hence, the systematic value of architectural design and organization of internal floral parts has remained virtually unexplored in the family. This study represents the most extensive survey of flower and nectary morphology in the Cactaceae focusing on tribes Hylocereeae and Rhipsalideae (subfamily Cactoideae). Our objectives were (1) to conduct comparative morphological analyses of flowers and floral nectaries and (2) to compare nectar solute concentration in these two tribes consisting of holo- and semi-epiphytic species. Flower morphology, nectary types, and sugar concentration of nectar have strong taxonomic implications at the tribal, generic and specific levels. Foremost, three types of nectaries were found, namely chamber nectary (with the open and diffuse subtypes), furrow nectary (including the holder nectary subtype), and annular nectary. All Hylocereeae species possess chamber nectaries, in which the nectarial tissue has both trichomes and stomata. The Rhipsalideae are distinguished by two kinds of floral nectaries: furrow and annular, both nectary types with stomata only. The annular nectary type characterizes the genus Rhipsalis. Nectar concentration is another significant taxonomic indicator separating the Hylocereeae and Rhipsalideae and establishing trends linked to nectar sugar concentration and amount of nectar production in relation to flower size. There is an inverse relationship between flower size and amount of nectar production in the smaller Rhipsalideae flowers, in which nectar concentration is more than two-fold higher despite the smaller volume of nectar produced when compared to the large Hylocereeae flowers. Variability of nectary morphology and nectar concentration was also evaluated as potential synapomorphic characters in recent phylogenies of these tribes. In conclusion, our data provide strong evidence of the systematic value of floral nectaries and nectar sugar concentration in the Cactaceae, particularly at different taxonomic levels in the Hylocereeae and Rhipsalideae. © 2013 Perspectives in Plant Ecology, Evolution and Systematics.

Influence of ethanol and glycerol concentration over functional and structural properties of zein-oleic acid films

This study was performed in order to determine the effect of the addition of different concentrations of glycerol and ethanol over functional and structural properties of zein-oleic acid films. Films were prepared from zein and oleic acid formulations, containing: 0, 10, 20 and 30% (w/w) of glycerol as plasticizer and 75, 80, 85, 90 and 95% (v/v) of ethanol as zein solvent. Water vapor permeability (WVP) at 4 and 24 C, opacity, water solubility and structural behavior of the film were assessed. The film water barrier properties, WVP and water solubility, were increased when higher ethanol concentration and lower glycerol concentration were used. Furthermore, WVP at 4 C was lower than WVP at 24 C due to the crystalline solid state of oleic acid at lower temperatures. Likewise, opacity, homogeneity and structure of the composite film were improved as ethanol increased and glycerol lowered. © 2013 Elsevier B.V. All rights reserved.

Haiti, les dimensions de la concentration geographique

Inclut la bibliographie

Concentration in liner shipping: its causes and impacts for ports and shipping services in developing regions

Includes bibliography

Concentration in liner shipping

Containerization, telecommunication, globalization and privatization are among the most important recent trends that have affected shipping. Concentration is another trend which is expected to have a major impact. This refers to the increasing control in the hands of a small number of companies who hold an increasing market share. Although at first this process may be associated with dominant positions and abuse of monopoly power, in reality, the advantages for the economies of Latin America and the Caribbean should by far outweigh the disadvantages. This edition of the FAL Bulletin presents some of the findings of a recent study prepared by the ECLAC Transport Unit, entitled, Concentration in liner shipping - its causes and impacts for ports and shipping services in developing regions, LC/G.2027 , August 1998.

Determinants of ownership concentration in the Chilean stock market

Includes bibliography.

Evolution of the concentration of phenolic compounds in cachaça during aging in an oak (Quercus sp.) barrel

Cachaça is a traditional and popular Brazilian drink obtained by distilling fermented sugar cane juice. Among the steps involved in its production, natural aging in wood containers for a certain period of time can lead to alterations in the chemical composition, aroma, flavor and color of the beverage. The present work sought to determine the concentration of phenolic compounds after different periods of aging of the cachaça in an oak (Quercus sp.) barrel. Periodic collections during the aging period were performed, and thirteen selected phenolic compounds were determined by high performance liquid chromatography with a diode-array detector (HPLC-DAD). A progressive increase in the concentration of the compounds analyzed was observed, with syringaldehyde and gallic acid as the compounds encountered in the highest concentration.

Propriedades e mecanismos de cintilação dos materiais 'GD''AL''O IND.3' e ('GD''LU')'AL''O IND.3' dopados com 'EU POT. 3+', 'TB POT. 3+' e 'PR POT. 3+'

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Rising concentration in Asia-Latin American value chains: Can small firms turn the tide?

Dynamic Asia has overtaken the European Union as Latin America and the Caribbean’s second largest export market, after the United States. However, the region’s exports to Asia remain concentrated in few commodities involving a small number of large firms. This book explores the present and future scope for the participation of small and medium-sized enterprises (SMEs) in biregional trade and value chains and the measures that can be taken to make those chains more inclusive and sustainable. SMEs have a low direct presence in the region’s export flows and their participation in the supplier networks of multinational companies is weak. This volume reviews several supplier development programmes (SDPs) adopted in various countries in Asia and Latin America to increase SME linkages with multinational firms. These programmes, many of which are public-private initiatives, aim to boost SME productivity and enhance their participation in value chains.